Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Spreading”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 451 records · Page 25

Light Scattered from Polished Optical Surfaces: Wings of the Point Spread Function

Random figure errors from the polishing process plus particles on the main mirrors in a telescope cause an extended point spread function (PSF) declining approximately as the inverse square of the sine of the angle from a star from about 100 micro-rad to a right angle. The decline in at least one case, and probably in general, proceeds as the inverse cube at smaller angles where the usual focal plane aperture radius is chosen. The photometric error due to misalignment by one Airy ring spacing with an aperture of n rings depends on the net variance in the figure. It is approximately 60/(n+1)(3) when using the data of Kormendy (1973). A typical value is 6 x 10 to the -5th power per ring of misalignment with n = 100 rings. The encircled power may be modulated on a time scale of hours by parts per thousand in a wavelength dependent manner due to relative humidity effects on mirror dust. The scattering according to an inverse power law is due to a random walk in aberration height caused by a multitude of facets and slope errors left by the polishing process. A deviation from such a law at grazing emergence may permit monitoring the dust effects.

Kenknight, C. E.↗

Thematic Mapper Protoflight Model Line Spread Function

The Thematic Mapper (TM) Protoflight Model Spatial Line Spread Function (LSF) was not measured before launch. Therefore, methodology are developed to characterize LSF with protoflight model optics and electronics measurements that were made before launch. Direct prelaunch LSF measurements that were made from the flight model TM verified the protoflight TM LSF simulation. Results for two selected protoflight TM channels are presented here. It is shown that LSF data for the other ninety-four channels could be generated in the same fashion.

Schueler, C.↗

A model for equatorial explosive spread F

Explosive spread F was first described by Woodman and LaHoz (1976). In such events the 50 MHz radar signal rises at Jicamarca to 10-20 dB above the noise level within a few milliseconds but then disappears within 100 ms or less. It has been suggested that electric fields from thunderstorms might drive a plasma instability which could cause these echoes, and recent observations (Woodman and Kudeki, 1984) provide convincing evidence for this triggering. Here, the instability mechanism is discussed and it is shown that transient thunderstorm electric fields comparable to those recently observed by rockets in the midlatitude ionosphere could excite a rapidly growing two-stream plasma instability that is driven by the ExB drift of the F region electrons in the short period (less than the ion gyroperiod) before the ions reach the same velocity.

Kelley, M. C.↗

Ice-lubricated gravity spreading of the Olympus Mons aureole deposits

The huge aureole deposits and the perimeter scarp of Olympus Mons in the Tharsis region of Mars were first observed by Mariner 9. It is pointed out that no other Martian volcano approaches the size of Olympus. Hypotheses of aureole formation are discussed and evaluated. It is concluded that gravity-sliding and gravity-spreading models for the Olympus Mons aureoles can account qualitatively for the observations regarding surface morphology, structure, and size. The presence of the basal scarp can also be understood. However, the proposed models require detachment between the aureoles and the substrate. In the present investigation, the proposal is made that widespread detachment may have occurred within a basal layer containing approximately 10 percent by volume of interstitial or interbedded ice.

Tanaka, K. L.↗

Evidence for spreading in the lower Kam Group of the Yellowknife greenstone belt: Implications for Archaean basin evolution in the Slave Province

The Yellowknife greenstone belt is the western margin of an Archean turbidite-filled basin bordered on the east by the Cameron River and Beaulieu River volcanic belts (Henderson, 1981; Lambert, 1982). This model implies that rifting was entirely ensialic and did not proceed beyond the graben stage. Volcanism is assumed to have been restricted to the boundary faults, and the basin was floored by a downfaulted granitic basement. On the other hand, the enormous thickness of submarine volcanic rocks and the presence of a spreading complex at the base of the Kam Group suggest that volcanic rocks were much more widespread than indicated by their present distribution. Rather than resembling volcanic sequences in intracratonic graben structures, the Kam Group and its tectonic setting within the Yellowknife greenstone belt have greater affinities to the Rocas Verdes of southern Chile, Mesozoic ophiolites, that were formed in an arc-related marginal basin setting. The similarities of these ophiolites with some Archean volcanic sequences was previously recognized, and served as basis for their marginal-basin model of greenstone belts. The discovery of a multiple and sheeted dike complex in the Kam Group confirms that features typical of Phanerozoic ophiolites are indeed preserved in some greenstone belts and provides further field evidence in support of such a model.

Helmstaedt, H.↗

Monte Carlo study of the atmospheric spread function

Monte Carlo radiative transfer simulations are used to study the atmospheric spread function appropriate to satellite-based sensing of the earth's surface. The parameters which are explored include the nadir angle of view, the size distribution of the atmospheric aerosol, and the aerosol vertical profile.

Pearce, W. A.↗

Fourier transform techniques for the evaluation of the Thematic Mapper line spread function

An endeavor was made to use Fourier transform techniques to estimate the line spread function (LSF) of the Thematic Mapper (TM) from processed data. Data near the boundary of small fields from TM scenes were sampled, fitted to a theoretical curve, lowpass filtered, and then deconvolved to obtain the LSF. Lowpass filtering improved the truncation effect and eliminated the discontinuity at both ends of the data sequence.The selection of the cutoff frequency and the order of a lowpass filter is based on a newly defined criterion which tests the distortion of the processed edge by comparing it with the original edge. A parameter of the LSF, the equivalent width, is used to compare these LSF's deconvolved from sampled edge data with those evaluated by the derivative techniques. The calculated equivalent widths using the Fourier transform techniques for infrared bands are very close to TM design specifications.

Carnahan, W. H.↗

Spread spectrum communications. Volume 1, 2 & 3

The design and operation of spread-spectrum (SS) communication systems are examined in an introductory text intended for graduate engineering students and practicing engineers. Chapters are devoted to an overview of SS systems, the historical origins of SS, basic concepts and system models, antijam communication systems, pseudonoise generators, coherent direct-sequence systems, noncoherent frequency-hopped systems, coherent and differentially coherent modulation techniques, pseudonoise acquisition and tracking in direct-sequence receivers, time and frequency synchronization of frequency-hopped receivers, low-probability-of-intercept communication, and multiple-access communication. Graphs, diagrams, and photographs are provided.

Simon, M. K.↗

Acquisition Technique For Spread-Spectrum Codes

Ability to lock onto signal increased with minimal equipment. Technique proposed to improve acquisition of spread-spectrum (pseudonoise) coded signal modulated by digital data signal. Divides correlation time into subintervals, integrates over subintervals, passes integrator outputs through square-law detectors, and adds detector outputs over all subintervals to reach decision regarding detection of code. Reduces effect of data-bit transitions at price of non-coherent-combining loss.

Cheng, Unjeng↗

Spread-spectrum multiple access using wideband noncoherent MFSK

Two spread-spectrum multiple access systems which use wideband M-ary frequency shift keying (FSK) (MFSK) as the primary modulation are presented. A bit error rate performance analysis is presented and system throughput is calculated for sample C band and Ku band satellite systems. Sample link analyses are included to illustrate power and adjacent satellite interference considerations in practical multiple access systems.

Ha, Tri T.↗

Performance of a class of parallel spread-spectrum code acquisition schemes in the presence of data modulation

An acquisition procedure for data-modulated direct-sequence spread-spectrum systems is investigated. The correlation time is partitioned into subintervals, and the integration results in these subintervals are noncoherently combined for detection. The tradeoff between noncoherent combining loss and data modulation degradation guides the optimum choice of the number of subintervals. Two forms of data modulation are considered, namely, the alternate-data and random-data cases. The parallel acquisition schemes discussed allow multiple code-phase offsets to be examined at each test. The circular state diagram approach is used to analyze the performances of these schemes. The theory presented is valid for a class of such parallel schemes.

Cheng, Unjeng↗

Monolithic GaAs digitizer for space-based laser pulse spreading effect

A 6-bit 1-GHz digitizer was designed to analyze the 1-ns pulse spreading effects in a space based altimeter. The digitizer consisted of four 4-bit flash A/D converters and a 6-bit encoder. Also, the converter utilized four 4-bit converters and a 4-to-6 bit encoder to achieve 6 bit resolution at the 1 GHz sample rate. The design was unique because it utilized only the inverters and NOR gates for the converters and encoder, hence it could be fabricated using the existing state-of-the-art GaAs processing techniques. This GHz digitizer has many commercial applications. It could be applicable to: (1) digital microwave transmission system for the telecommunication industries, (2) pulse monitoring in high kinetic chemical reactions, (3) transient signals in the medical field, and (4) microwave signals in astronomy.

Lao, Bennig↗

The effects of radiative heat loss on microgravity flame spread

The effect of radiative heat loss from the surface of a solid material burning in a zero gravity environment in an opposed flow is studied through the use of a numerical model. Radiative heat loss is found to decrease the flame spread rate, the boundary layer thickness, and pyrolysis lengths. Blowoff extinction is predicted to occur at slower opposesd flow velocities than would occur if the radiative loss is not present. The radiative heat fluxes are comparable to the conduction fluxes, indicating the significance of the surface energy loss.

Fakheri, Ahmad↗

Divergent plate boundary characteristics and crustal spreading in Aphrodite Terra, Venus - A test of some predictions

Predictions concerning the divergence and crustal spreading in the Western Aphrodite Region of Venus are tested using published results from Arecibo, Venera 15/16, and Pioneer Venus data. It is found that the northern middle to high latitudes are characterized by a young average age, that there is a trend in the total number of craters per unit area from high values in the north polar regions to low values toward the equator, and that there is evidence for a latitudinal distribution of tectonic features of different types, with extensional features common in equatorial regions and compressional deformation features common in the northern middle to high latitudes.

Head, James W.↗

Effect of central obscuration on the LDR point spread function

It is well known that Gaussian apodization of an aperture reduces the sidelobe levels of its point spread function (PSF). In the limit where the standard deviation of the Gaussian function is much smaller than the diameter of the aperture, the sidelobes completely disappear. However, when Gaussian apodization is applied to the Large Deployable Reflector (LDR) array consisting of 84 hexagonal panels, it is found that the sidelobe level only decreases by about 2.5 dB. The reason for this is explained. The PSF is shown for an array consisting of 91 uniformly illuminated hexagonal apertures; this array is identical to the LDR array, except that the central hole in the LDR array is filled with seven additional panels. For comparison, the PSF of the uniformly illuminated LDR array is shown. Notice that it is already evident that the sidelobe structure of the LDR array is different from that of the full array of 91 panels. The PSF's of the same two arrays are shown, but with the illumination apodized with a Gaussian function to have 20 dB tapering at the edges of the arrays. While the sidelobes of the full array have decreased dramatically, those of the LDR array changed in structure, but stayed at almost the same level. This result is not completely surprising, since the Gaussian apodization tends to emphasize the contributions from the central portion of the array; exactly where the hole in the LDR array is located. The two most important conclusions are: the size of the central hole should be minimized, and a simple Gaussian apodization scheme to suppress the sidelobes in the PSF should not be used. A more suitable apodization scheme would be a Gaussian annular ring.

Vanzyl, Jakob J.↗

Intensity dependent spread theory

The Intensity Dependent Spread (IDS) procedure is an image-processing technique based on a model of the processing which occurs in the human visual system. IDS processing is relevant to many aspects of machine vision and image processing. For quantum limited images, it produces an ideal trade-off between spatial resolution and noise averaging, performs edge enhancement thus requiring only mean-crossing detection for the subsequent extraction of scene edges, and yields edge responses whose amplitudes are independent of scene illumination, depending only upon the ratio of the reflectance on the two sides of the edge. These properties suggest that the IDS process may provide significant bandwidth reduction while losing only minimal scene information when used as a preprocessor at or near the image plane.

Holben, Richard↗