Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Recycle”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 451 records · Page 25

Sulfur poisoning of hydrocarbon oxidation by palladium

Using a differential bed recycle reactor the oxidation of ethane and diethyl ketone by a Pd catalyst was studied at the 0-30 ppm level in air. In both cases first order kinetics were observed. The ethane oxidation rate was characterized n the Arrhenius form by a pre-exponential of 1.0 x 10 to the 8th power cm/sec and an E sub a of 27 kcal/mole. The diethyl ketone oxidation rate was characterized by a pre-exponential of 5.7 x -1000 cm/sec and E sub a of 14 kcal/mole. Poisoning of ethan oxidation was also investigated by hydrogen sulfide and to a smaller extent by the refrigerants Freon 22 and Gentron 142-B. Poisoning by Gentron 142-B was much more severe than by hydrogen sulfide. Kinetic experiments indicated that only the pre-exponential was changing.

Baumgartner, A. J.↗

Performance documentation of the Engineering Model 30 cm diameter Thruster

Presented are the results of extensive testing of two 30-cm ion thrusters which are virtually identical to the 900 series Engineering Model Thruster in an ongoing 15,000-hour life test. Included are performance data for the nominal full-power (2650 W) operating point; performance sensitivities to discharge voltage, discharge losses, accelerator voltage, and magnetic baffle current; and several power throttling techniques (maximum Isp, maximum thrust/power ratio, and two cases in between). Criteria for throttling are specified in terms of the screen power supply envelope, thruster operating limits, and control stability. In addition, reduced requirements for successful high voltage recycles are presented.

Bechtel, R. T.↗

Laser absorption spectroscopy - Method for monitoring complex trace gas mixtures

A frequency stabilized CO2 laser was used for accurate determinations of the absorption coefficients of various gases in the wavelength region from 9 to 11 microns. The gases investigated were representative of the types of contaminants expected to build up in recycled atmospheres. These absorption coefficients were then used in determining the presence and amount of the gases in prepared mixtures. The effect of interferences on the minimum detectable concentration of the gases was measured. The accuracies of various methods of solution were also evaluated.

Green, B. D.↗

A thermochemical data bank for cycle analysis

The use of the computer program PAC-2 to produce a thermodynamic data bank for various materials used in water-splitting cycles is described. The sources of raw data and a listing of 439 materials for which data are presently available are presented. This paper also discusses the use of the data bank in conjunction with two other programs, CEC-72 and HYDRGN. The integration of these three programs implement an evaluation procedure for thermochemical water splitting cycles. CEC-72 is a program used to predict the equilibrium composition of the various chemical reactions in the cycle. HYDRGN is a program which is used to calculate changes in thermodynamic properties, work of separation, amount of recycle, internal heat regeneration, total thermal energy and process thermal efficiency for a thermochemical cycle.

Carty, R.↗

Agglutinates and carbon accumulation in Apollo 17 lunar soils

A critical review of maturity with respect to the abundance of implanted solar wind elements (SWE) in lunar soils indicates: (1) that the Rosiwal Principle has limited applicability in determining implantation of SWE in lunar soils, and (2) that despite a depletion of SWE in agglutinitic glass, agglutinates are enriched in SWE due to the presence of buried surfaces of numerous clasts within agglutinates. A statistical analysis of published data of several Apollo 17 soils indicates that the abundance of carbon and, by analogy, the abundance of other SWE are correlatable with the agglutinate content and the mean grain size of lunar soils. Microscopic examination of more than 5000 grains of agglutinates in polished thin sections reveals a wide range of variability in the mineralogy, grain size distribution, degree of recycling, etc., of the clast population in agglutinates. This indicates that the volume-correlated SWE content of agglutinates may vary and need not be constant.

Basu, A.↗

Volatile element depletion and K-39/K-41 fractionation in lunar soils

Evidence for selective loss and isotopic fractionation (in the case of K) of volatile elements during formation of agglutinates by micrometeoritic bombardment of lunar soils is presented. Concentrations and isotopic compositions of volatile elements (K, Rb, Pb) and nonvolatile elements (U, Th, Ba, Sr, rare earths) in separates taken from soils 14163, 14259, 15041, 68501, and 71500 are examined. Rayleigh fractionation calculations applied to K-39/K-41 isotopic data indicate ten-fold recycling of bulk soil, to account for observed isotopic anomalies. The lunar soil fines fraction seems to be a site of deposition for volatile or labile Pb produced during agglutination. Local fines (below 75 microns) are viewed as representative of the parent material for agglutinates formed in situ by micrometeoritic impact. Magnetic separation of agglutinates from soil 68501 revealed a bimodal population, with one class comprising welded blocky magnetic glasses.

Church, S. E.↗

The distribution of ammonia and its photochemical products on Jupiter

Altitude profiles of ammonia and its photochemical products are generated in the light of measurements of the Jovian temperature structure, eddy transport coefficient, improved chemical scheme, and rate constants. Realistic limits are placed on the concentration of hydrazine which may participate in the recycling of ammonia on Jupiter. The maximum hydrazine-ice production rate is calculated to be about 1.3 mg/sq m per Jovian day. The distribution of nitrogen gas is presented with and without supersaturation of hydrazine. The nitrogen mixing ratio near the ammonia cloud top is estimated to be in the range between 10 to the -9th and 10 to the -11th power. An appreciable latitudinal variation in the ammonia concentration is expected.

Atreya, S. K.↗

Pressurized feeding on the GEGAS system

A continuous process to feed coal directly into a pressurized gasifier is described. Coal fines are heated and mixed with a recycled tar binder and extruded through a novel die system against gasifier pressure. Performance data on a 2 in. system is given and scale up to a larger 6 in. system is described.

Furman, A. H.↗

Non-equilibrium radiation nuclear reactor

An externally moderated thermal nuclear reactor is disclosed which is designed to provide output power in the form of electromagnetic radiation. The reactor is a gaseous fueled nuclear cavity reactor device which can operate over wide ranges of temperature and pressure, and which includes the capability of processing and recycling waste products such as long-lived transuranium actinides. The primary output of the device may be in the form of coherent radiation, so that the reactor may be utilized as a self-critical nuclear pumped laser.

Thom, K.↗

Low cost silicon solar array project silicon materials task

A program was established to develop a high temperature silicon production process using existing electric arc heater technology. Silicon tetrachloride and a reductant will be injected into an arc heated mixture of hydrogen and argon. Under these high temperature conditions, a very rapid reaction is expected to occur and proceed essentially to completion, yielding silicon and gaseous sodium chloride. Techniques for high temperature separation and collection of the molten silicon will be developed using standard engineering approaches, and the salt vapor will later be electrolytically separated into its elemental constituents for recycle. Preliminary technical evaluations and economic projections indicate not only that this process appears to be feasible, but that it also has the advantages of rapid, high capacity production of good quality molten silicon at a nominal cost.

Source record↗

Gas turbine engine with recirculating bleed

Carbon monoxide and unburned hydrocarbon emissions in a gas turbine engine are reduced by bleeding hot air from the engine cycle and introducing it back into the engine upstream of the bleed location and upstream of the combustor inlet. As this hot inlet air is recycled, the combustor inlet temperature rises rapidly at a constant engine thrust level. In most combustors, this will reduce carbon monoxide and unburned hydrocarbon emissions significantly. The preferred locations for hot air extraction are at the compressor discharge or from within the turbine, whereas the preferred reentry location is at the compressor inlet.

Adamson, A. P.↗

Georgia Institute of Technology research on the Gas Core Actinide Transmutation Reactor (GCATR)

The program reviewed is a study of the feasibility, design, and optimization of the GCATR. The program is designed to take advantage of initial results and to continue work carried out on the Gas Core Breeder Reactor. The program complements NASA's program of developing UF6 fueled cavity reactors for power, nuclear pumped lasers, and other advanced technology applications. The program comprises: (1) General Studies--Parametric survey calculations performed to examine the effects of reactor spectrum and flux level on the actinide transmutation for GCATR conditions. The sensitivity of the results to neutron cross sections are to be assessed. Specifically, the parametric calculations of the actinide transmutation are to include the mass, isotope composition, fission and capture rates, reactivity effects, and neutron activity of recycled actinides. (2) GCATR Design Studies--This task is a major thrust of the proposed research program. Several subtasks are considered: optimization criteria studies of the blanket and fuel reprocessing, the actinide insertion and recirculation system, and the system integration. A brief review of the background of the GCATR and ongoing research is presented.

Clement, J. D.↗

A cycle timer for testing electric vehicles

A cycle timer was developed to assist the driver of an electric vehicle in more accurately following and repeating SAE driving schedules. These schedules require operating an electric vehicle in a selected stop-and-go driving cycle and repeating this cycle pattern until the vehicle ceases to meet the requirements of the cycle. The heart of the system is a programmable read-only memory (PROM) that has the required test profiles permanently recorded on plug-in cards, one card for each different driving schedule. The PROM generates a direct current analog signal that drives a speedometer displayed on one scale of a dual movement meter. The second scale of the dual movement meter displays the actual speed of the vehicle as recorded by the fifth wheel. The vehicle operator controls vehicle speed to match the desired profile speed. The PROM controls the recycle start time as well as the buzzer activation. The cycle programmer is powered by the test vehicle's 12-volt accessory battery, through a 5-volt regulator and a 12-volt dc-to-dc converter.

Soltis, R. F.↗

The design and demonstration of an advanced data collection/position locating system, addendum

The theoretical background for a coherent demodulator for minimum shift keying signals generated by the advanced data collection/position locating system breadboard is presented along with a discussion of the design concept. Various tests and test results, obtained with the breadboard system described, include evaluation of bit-error rate performance, acquisition time, clock recovery, recycle time, frequency measurement accuracy, and mutual interference.

Source record↗

A model for eruption behavior of a volcanic vent in eastern Mare Serenitatis

The origin is considered of droplets of ultramafic composition which are present in all soils collected from the mare surface at the Apollo 17 landing site. The droplets consist of homogeneous orange glass or their partially crystallized equivalent, the black droplets. These clastic deposits have a mean grain size of 40 micrometers. The droplet formation ages range from 3.5 to 3.83 b.y. It has been proposed that the droplets formed as a spray of low viscosity melt during lava fountaining. Based upon the thermal history as determined by studying olivine and particle shapes, two models for the formation of the sequence of droplets represented by samples 74001 and 74220 are presented. Both models assume, as proposed by Heiken et al. (1974), that the droplets were formed as a spray from a lava fountain and the compound forms were evidence for 'recycling' of solid, cooler droplets back into the fountain, encountering molten droplets before being deposited.

Heiken, G.↗

Evolution of a nitrogen atmosphere on Titan

Photochemical calculations indicate that if NH3 outgassed from Titan it should have been converted to a dense N2 atmosphere during the lifetime of the satellite. A crucial step in the process involves a gas phase reaction of N2H4 with H. The most favorable conditions for this step would be the intermediate production of a CH4-H2 greenhouse capable of raising the gas temperature to 150 K. Subsequently about 20 bars of N2 could have evolved. The pressure-induced opacity of 20 bars of N2 should suffice to explain the recently measured 200 K surface temperature. Unlike the situation on Jupiter, NH3 is not recycled on Titan by reactions involving N2 or N2H4. This may explain the failure of recent attempts to detect NH3 in the upper atmosphere of Titan.

Atreya, S. K.↗

Improved coal-slurry pipeline

High strength steel pipeline carries hot mixture of powdered coal and coal derived oil to electric-power-generating station. Slurry is processed along way to remove sulfur, ash, and nitrogen and to recycle part of oil. System eliminates hazards and limitations associated with anticipated coal/water-slurry pipelines.

Dowler, W. L.↗

Evaluation of selected chemical processes for production of low-cost silicon, phases 1 and 2

A miniplant, consisting of a 5 cm-diameter fluidized-bed reactor and associated equipment was used to study the deposition parameters, temperature, reactant composition, seed particle size, bed depth, reactant throughput, and methods of reactant introduction. It was confirmed that the permissible range of fluidized-bed temperature was limited at the lower end by zinc condensation (918 C) and at higher temperatures by rapidly decreasing conversion efficiency. Use of a graded bed temperature was shown to increase the conversion efficiency over that obtained in an isothermal bed. Other aspects of the process such as the condensation and fused-salt electrolysis of the ZnCl2 by-product for recycle of zinc and chlorine were studied to provide information required for design of a 50 MT/year experimental facility. In view of the favorable technical and economic indications obtained, it was recommended that construction and operation of the 50 MT/year experimental facility be implemented.

Blocher, J. M.↗