Influence of H 2 O and H 2 S on the composition, activity, and stability of sulfided Mo, CoMo, and NiMo supported on MgAl 2 O 4 for hydrodeoxygenation of ethylene glycol
Here in this work, density functional theory (DFT), catalytic activity tests, and in-situ X-ray absorption spectroscopy (XAS) was performed to gain detailed insights into the activity and stability of MoS 2 , Ni-MoS 2 , and Co-MoS 2 catalysts used for hydrodeoxygenation (HDO) of ethylene glycol upon variation of the partial pressures of H 2 O and H 2 S. The results show high water tolerance of the catalysts and highlight the importance of promotion and H 2 S level during HDO. DFT calculations unraveled that the active edge of MoS 2 could be stabilized against SO exchanges by increasing the partial pressure of H 2 S or by promotion with either Ni or Co. The Mo, NiMo, and CoMo catalysts of the present study were all active and fairly selective for ethylene glycol HDO at 400 °C, 27 bar H 2 , and 550–2200 ppm H 2 S, and conversions of ≈50–100%. The unpromoted Mo/MgAl 2 O 4 catalyst had a lower stability and activity per gram catalyst than the promoted analogues. The NiMo and CoMo catalysts produced ethane, ethylene, and C1 cracking products with a C 2 /C 1 ratio of 1.5–2.0 at 550 ppm H 2 S. This ratio of HDO to cracking could be increased to ≈2 at 2200 ppm H 2 S which also stabilized the activity. Removing H 2 S from the feed caused severe catalyst deactivation. Both DFT and catalytic activity tests indicated that increasing the H 2 S concentration increased the concentration of SH groups on the catalyst, which correspondingly activated and stabilized the catalytic HDO performance. In-situ XAS further supported that the catalysts were tolerant towards water when exposed to increasing water concentration with H2O/H2S ratios up to 300 at 400–450 °C. Raman spectroscopy and XAS showed that MoS2 was present in the prepared catalysts as small and highly dispersed particles, probably owing to a strong interaction with the support. Linear combination fitting (LCF) analysis of the X-ray absorption near edge structure (XANES) spectra obtained during in-situ sulfidation showed that Ni was sulfided faster than Mo and CoMo, and that Mo was sulfided faster when promoted with Ni. Extended X-ray absorption fine structure (EXAFS) results showed the presence of MoS 2 in all sulfided catalysts. Lastly, sulfided CoMo was present as a mixture of CoMoS and Co 9 S 8 , whereas sulfided NiMo was present as NiMoS.