Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Boundary layer flow”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 451 records · Page 25
All sourcesNASA NTRSDOE OSTI
NASA NTRS2000

Sweep and Compressibility Effects on Active Separation Control at High Reynolds Numbers

This paper explores the effects of compressibility, sweep and excitation location on active separation control at high Reynolds numbers. The model, which was tested in a cryogenic pressurized wind tunnel, simulates the upper surface of a 20% thick GlauertGoldschmied type airfoil at zero angle of attack. The flow is fully turbulent since the tunnel sidewall boundary layer flows over the model. Without control, the flow separates at the highly convex area and a large turbulent separation bubble is formed. Periodic excitation is applied to gradually eliminate the separation bubble. Two alternative blowing slot locations as well as the effect of compressibility, sweep and steady suction or blowing were studied. During the test the Reynolds numbers ranged from 2 to 40 million and Mach numbers ranged from 0.2 to 0.7. Sweep angles were 0 and 30 deg. It was found that excitation must be introduced slightly upstream of the separation region regardless of the sweep angle at low Mach number. Introduction of excitation upstream of the shock wave is more effective than at its foot. Compressibility reduces the ability of steady mass transfer and periodic excitation to control the separation bubble but excitation has an effect on the integral parameters, which is similar to that observed in low Mach numbers. The conventional swept flow scaling is valid for fully and even partially attached flow, but different scaling is required for the separated 3D flow. The effectiveness of the active control is not reduced by sweep. Detailed flow field dynamics are described in the accompanying paper.

Seifert, Avi↗
NASA NTRS1981

Study of the development of natural instabilities in a laminar boundary layer in incompressible flow

Natural instabilities which are created in a laminar boundary layer and which consist of intermittent wave trains were studied. The spectral analysis of these fluctuations makes it possible to localize them in terms of frequency and to isolate their spectrum of amplitude modulation. The variation in terms of abscissa value and ordinate value of these instabilities is compared with the results derived from the solution of the Orr-Sommerfeld equation.

Burnel, S.↗
NASA NTRS2008

Compressible Boundary Layer Predictions at High Reynolds Number using Hybrid LES/RANS Methods

Simulations of compressible boundary layer flow at three different Reynolds numbers (Re(sub delta) = 5.59x10(exp 4), 1.78x10(exp 5), and 1.58x10(exp 6) are performed using a hybrid large-eddy/Reynolds-averaged Navier-Stokes method. Variations in the recycling/rescaling method, the higher-order extension, the choice of primitive variables, the RANS/LES transition parameters, and the mesh resolution are considered in order to assess the model. The results indicate that the present model can provide good predictions of the mean flow properties and second-moment statistics of the boundary layers considered. Normalized Reynolds stresses in the outer layer are found to be independent of Reynolds number, similar to incompressible turbulent boundary layers.

Choi, Jung-Il↗
NASA NTRS1975

Interaction between a shock wave and a turbulent boundary layer in transonic flow

Interaction between a shock wave and an unseparated turbulent boundary layer is considered. The method of matched asymptotic expansions is used, with solutions valid in the double limit as Reynolds number tends to infinity and Mach number tends to unity. The shock is weak enough that interaction effects can be considered as perturbations to the undisturbed flow; the case considered is that where the sonic line is near the outer edge of the boundary layer. It is shown that, with order estimates for Reynolds stress perturbations, the induced wall pressure distribution can be calculated using only the two outer interaction regions, independent of a specific closure condition and that this solution is in fact a turbulent free interaction solution. A detailed analysis of the inner regions, for which an eddy viscosity model for the Reynolds shear stress is used, provides a description of the variations in velocity, temperature and density near and at the wall.

Adamson, T. C., Jr.↗
NASA NTRS1989

The response of a laminar boundary layer in supersonic flow to small amplitude progressive waves

The effect of a small amplitude progressive wave on the laminar boundary layer on a semi-infinite flat plate, due to a uniform supersonic freestream flow, is considered. The perturbation to the flow divides into two streamwise zones. In the first, relatively close to the leading edge of the plate, on a transverse scale comparable to the boundary layer thickness, the perturbation flow is described by a form of the unsteady linearized compressible boundary layer equations. In the freestream, this component of flow is governed by the wave equation, the solution of which provides the outer velocity conditions for the boundary layer. This system is solved numerically, and also the asymptotic structure in the far downstream limit is studied. This reveals a breakdown and a subsequent second streamwise zone, where the flow disturbance is predominantly inviscid. The two zones are shown to match in a proper asymptotic sense.

Duck, Peter W.↗
NASA NTRS1987

A multiple-time-scale turbulence model based on variable partitioning of turbulent kinetic energy spectrum

A multiple-time-scale turbulence model of a single point closure and a simplified split-spectrum method is presented. In the model, the effect of the ratio of the production rate to the dissipation rate on eddy viscosity is modeled by use of the multiple-time-scales and a variable partitioning of the turbulent kinetic energy spectrum. The concept of a variable partitioning of the turbulent kinetic energy spectrum and the rest of the model details are based on the previously reported algebraic stress turbulence model. Example problems considered include: a fully developed channel flow, a plane jet exhausting into a moving stream, a wall jet flow, and a weakly coupled wake-boundary layer interaction flow. The computational results compared favorably with those obtained by using the algebraic stress turbulence model as well as experimental data. The present turbulence model, as well as the algebraic stress turbulence model, yielded significantly improved computational results for the complex turbulent boundary layer flows, such as the wall jet flow and the wake boundary layer interaction flow, compared with available computational results obtained by using the standard kappa-epsilon turbulence model.

Kim, S.-W.↗
NASA NTRS1989

A multiple-time-scale turbulence model based on variable partitioning of the turbulent kinetic energy spectrum

A multiple-time-scale turbulence model of a single point closure and a simplified split-spectrum method is presented. In the model, the effect of the ratio of the production rate to the dissipation rate on eddy viscosity is modeled by use of the multiple-time-scales and a variable partitioning of the turbulent kinetic energy spectrum. The concept of a variable partitioning of the turbulent kinetic energy spectrum and the rest of the model details are based on the previously reported algebraic stress turbulence model. Example problems considered include: a fully developed channel flow, a plane jet exhausting into a moving stream, a wall jet flow, and a weakly coupled wake-boundary layer interaction flow. The computational results compared favorably with those obtained by using the algebraic stress turbulence model as well as experimental data. The present turbulence model, as well as the algebraic stress turbulence model, yielded significantly improved computational results for the complex turbulent boundary layer flows, such as the wall jet flow and the wake boundary layer interaction flow, compared with available computational results obtained by using the standard kappa-epsilon turbulence model.

Kim, S.-W.↗
NASA NTRS2007

Characteristics of Boundary Layer Transition in a Multi-Stage Low-Pressure Turbine

An experimental investigation of boundary layer transition in a multi-stage turbine has been completed using surface-mounted hot-film sensors. Tests were carried out using the two-stage Low Speed Research Turbine of the Aerodynamics Research Laboratory of GE Aircraft Engines. Blading in this facility models current, state-of-the-art low pressure turbine configurations. The instrumentation technique involved arrays of densely-packed hot-film sensors on the surfaces of second stage rotor and nozzle blades. The arrays were located at mid-span on both the suction and pressure surfaces. Boundary layer measurements were acquired over a complete range of relevant Reynolds numbers. Data acquisition capabilities provided means for detailed data interrogation in both time and frequency domains. Data indicate that significant regions of laminar and transitional boundary layer flow exist on the rotor and nozzle suction surfaces. Evidence of relaminarization both near the leading edge of the suction surface and along much of the pressure surface was observed. Measurements also reveal the nature of the turbulent bursts occuring within and between the wake segments convecting through the blade row. The complex character of boundary layer transition resulting from flow unsteadiness due to nozzle/nozzle, rotor/nozzle, and nozzle/rotor wake interactions are elucidated using these data. These measurements underscore the need to provide turbomachinery designers with models of boundary layer transition to facilitate accurate prediction of aerodynamic loss and heat transfer.

Wisler, Dave↗
NASA NTRS1986

Natural laminar flow and airplane stability and control

Location and mode of transition from laminar to turbulent boundary layer flow have a dominant effect on the aerodynamic characteristics of an airfoil section. The influences of these parameters on the sectional lift and drag characteristics of three airfoils are examined. Both analytical and experimental results demonstrate that when the boundary layer transitions near the leading edge as a result of surface roughness, extensive trailing-edge separation of the turbulent boundary layer may occur. If the airfoil has a relatively sharp leading-edge, leading-edge stall due to laminar separation can occur after the leading-edge suction peak is formed. These two-dimensional results are used to examine the effects of boundary layer transition behavior on airplane longitudinal and lateral-directional stability and control.

Vandam, Cornelis P.↗
NASA NTRS1990

Modulational stability of rotating-disk flow

The problem of modulational primary stability of rotating-disk boundary layer flow for stationary modes was studied by using the method of multiple scales. The system of equations for infinitesimal disturbances is solved by linear stability theory to determine the modulated solution which represents the time and azimuthal variations of the wave pattern. The solution for the amplitude of the most critical disturbance indicates that the disturbance spreads out as the flow time increases and grows exponentially at the center.

Riahi, Daniel N.↗
NASA NTRS1971

Heat addition to a subsonic boundary layer: A preliminary analytical study

A preliminary analytical study of the effects of heat addition to the subsonic boundary layer flow over a typical airfoil shape is presented. This phenomenon becomes of interest in the space shuttle mission since heat absorbed by the wing structure during re-entry will be rejected to the boundary layer during the subsequent low speed maneuvering and landing phase. A survey of existing literature and analytical solutions for both laminar and turbulent flow indicate that a heated surface generally destabilizes the boundary layer. Specifically, the boundary layer thickness is increased, the skin friction at the surface is decreased and the point of flow separation is moved forward. In addition, limited analytical results predict that the angle of attack at which a heated airfoil will stall is significantly less than the stall angle of an unheated wing. These effects could adversely affect the lift and drag, and thus the maneuvering capabilities of booster and orbiter shuttle vehicles.

Macha, J. M.↗
NASA NTRS1987

Numerical experiments on transition control in wall-bounded shear flows

Results are presented from a numerical simulation of transition control in plane channel and boundary layer flows. The analysis is based on a pseudo-spectral/finite difference semi-implicit solution procedure employed to numerically integrate the time-dependent, three-dimensional, incompressible Navier-Stokes equations in a doubly periodic domain. In the channel flow, it was found that the active periodic suction/blowing method was effective in controlling strongly three-dimensional disturbances. In the boundary layer, the preliminary analysis indicated that in the early stages, passive control by suction is as effective as active control to suppress instabilities. The current work is focused on a detailed comparison of active and passive control by suction/blowing in the boundary layer.

Biringen, S.↗
NASA NTRS1974

Nonlinear panel response by a Monte Carlo approach

The vibration of clamped and simply supported elastic panels due to subsonic and supersonic turbulent boundary-layer flows is investigated by a Monte Carlo technique. The resulting generalized random forces are simulated numerically from boundary-layer turbulence spectra, and the response analysis is performed in the time domain. The mutual interaction between panel motion and external and/or internal airflow is included. Response studies are performed with respect to rms response, probability structure, peak distribution, threshold crossing and spectral density. The effect on the response statistics of in-plane loading, static pressure differential, and cavity pressure is investigated.

Vaicaitis, R.↗
NASA NTRS1975

Effects of transducer flushness on fluctuating surface pressure measurements

The installation flushness of pressure transducers has been found to strongly influence the quality of fluctuating surface pressure data in supersonic-attached turbulent boundary-layer flow. A systematic investigation of the effects of flushness on surface pressure fluctuations beneath a 4-in.-thick boundary layer was conducted in a supersonic wind tunnel at Mach numbers of 1.68, 2.0, and 2.5. Flushness effects on transducer signal amplitude, power spectral density, coherence, and narrowband convection velocity was evaluated. Results show that a very slightly protruding transducer produces adverse effects on the desired pressure fluctuation measurements, whereas a submerged transducer produces small effects. Indications are that a more viable method for enhancing the uniformity and spatial correlation of fluctuating surface pressure data can be achieved by deliberately submerging transducers beneath a surface orifice about 0.010 in. deep.

Hanly, R. D.↗