Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “ANEMOMETER”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 451 records · Page 25
All sourcesNASA NTRSDOE OSTI
NASA NTRS1976

A laser velocimeter system for small radial turbomachinery

The paper describes the design and test of a laser Doppler velocimeter (LDV) to map the velocity fields in small high-speed turbomachinery. This instrument is presently being used as a diagnostic tool for the study of the basic fluid dynamics of the inducer, impeller and the diffuser regions of high-pressure-ratio small centrifugal compressors. The LDV instrumentation has been optimized to permit measurement of instantaneous velocities up to approximately 500 m/s within a rotating impeller. It is shown that LDV can make nondisturbing gas velocity measurements and surmount the difficulties found in applying other types of aerodynamic instrumentation, e.g., hot-wire anemometers, to this measurement problem.

Runstadler, P. W., Jr.↗
NASA NTRS1976

Turbulence measurement in transonic flow

The paper examines the response of a hot-wire anemometer in transonic flow in a variable-density closed-circuit wind tunnel and presents measurements obtained in a transonic turbulent boundary layer. Typical calibration curves are shown which indicate that, in contrast to previous work, the wire can be operated in a condition that will allow a single sensitivity to the velocity-density product rather than to density and velocity independently. Using these calibrations, measurements of fluctuating density and velocity obtained in a 0.8 M turbulent boundary layer are obtained. Agreement with independently obtained velocity fluctuations justifies both the calibration and data reduction procedures.

Rose, W. C.↗
NASA NTRS1976

An experimental study of a self-confined flow with ring-vorticity distribution

A new form of self-confined flow was investigated in which a recirculation zone forms away from any solid boundary. An inviscid flow analysis indicated that in a purely meridional axisymmetric flow a stationary, spherical, self-confined region should occur in the center of a streamlined divergent-convergent enlargement zone. The spherical confinement region would be at rest and at constant pressure. Experimental investigations were carried out in a specially built test apparatus to establish the desired confined flow. The streamlined divergent-convergent interior shape of the test section was fabricated according to the theoretical calculation for a particular streamline. The required inlet vorticity distribution was generated by producing a velocity profile with a shaped gauze screen in the straight pipe upstream of the test section. Fluid speed and turbulence intensity were measured with a constant-temperature hot-wire anemometer system. The measured results indicated a very orderly and stable flow field.

Lin, K. M.↗
NASA NTRS1976

Laser Doppler technology applied to atmospheric environmental operating problems

Carbon dioxide laser Doppler ground wind data were very favorably compared with data from standard anemometers. As a result of these measurements, two breadboard systems were developed for taking research data: a continuous wave velocimeter and a pulsed Doppler system. The scanning continuous wave laser Doppler velocimeter developed for detecting, tracking and measuring aircraft wake vortices was successfully tested at an airport where it located vortices to an accuracy of 3 meters at a range of 150 meters. The airborne pulsed laser Doppler system was developed to detect and measure clear air turbulence (CAT). This system was tested aboard an aircraft, but jet stream CAT was not encountered. However, low altitude turbulence in cumulus clouds near a mountain range was detected by the system and encountered by the aircraft at the predicted time.

Weaver, E. A.↗
NASA NTRS1977

Ground-based measurements of the wake vortex characteristics of a B747 aircraft in various configurations

A Boeing 747 aircraft flew 54 passes at low level over ground-based sensors. Vortex velocities were measured by a laser-Doppler velocimeter, an array of monostatic acoustic sounders, and an array of propeller anemometers. Flow visualization of the wake was achieved using smoke and balloon tracers. Preliminary results were obtained on the initial downwash field, the time for merging of the multiple vortices, the velocity fields, vortex decay, and the effects of spoilers and differential flap settings on the dissipation and structure of vortices.

Hallock, J. N.↗
NASA NTRS1977

Turbulence measurements in axisymmetric supersonic boundary layer flow in adverse pressure gradients

Mean flow and turbulence measurements are presented for adiabatic compressible turbulent boundary layer flow in adverse pressure gradients. The gradients were induced on the wall of an axially symmetric wind tunnel by contoured centerbodies mounted on the wind tunnel centerline. The boundary layer turbulence downstream of a boundary layer bleed section in a zero pressure gradient was also examined. The measurements were obtained using a constant temperature hot-wire anemometer. The adverse pressure gradients were found to significantly alter the turbulence properties of the boundary layer. With flow through the bleed holes there was a measureable decrease in the rms longitudinal velocity fluctuations near the wall and the turbulent shear stress in the boundary layer was reduced.

Gootzait, E.↗
NASA NTRS1977

Hot-wire anemometry in transonic flow

The use of hot-wire anemometry for obtaining fluctuating data in transonic flows has been evaluated. From hot-wire heat loss correlations based on previous transonic data, the sensitivity coefficients for velocity, density, and total temperature fluctuations have been calculated for a wide range of test conditions and sensor parameters. For sensor Reynolds number greater than 20 and high sensor overheat ratios, the velocity sensitivity remains independent of Mach number and equal to the density sensitivity. These conditions were verified by comparisons of predicted sensitivities with those from recent direct calibrations in transonic flows. Based on these results, techniques are presented to obtain meaningful measurements of fluctuating velocity, density, and Reynolds shear stress using hot-wire and hot-film anemometers. Example of these measurements are presented for two transonic boundary layers.

Horstman, C. C.↗
NASA NTRS1977

Features of a separating turbulent boundary layer in the vicinity of separation

Laser anemometer measurements using a directionally sensitive system were obtained for a nominally two-dimensional separating turbulent boundary layer produced by an adverse pressure gradient. An airfoil-type flow was generated in which the flow was accelerated and then decelerated until separation. The results include the skin friction, mean velocity profiles, turbulent shear stresses and intensities, spectra, dissipation rate, turbulent/non-turbulent interfacial intermittency, and eddy speeds.

Simpson, R. L.↗
NASA NTRS1977

Disrupted states of vortex flow and vortex breakdown

Flow visualization studies and laser Doppler anemometer measurements on swirling water flows reveal six distinct types of very large amplitude disturbance modes of the vortex core. Three, 'axisymmetric' and spiral vortex breakdowns, and the 'double helix,' have been described by others. A definite order of evolution in parameter space (Reynolds number and circulations) occurs, and is described. Puzzling responses of the axisymmetric and spiral vortex breakdowns to imposed flow transients reported previously are confirmed here, and are traced to the shedding of starting and stopping vortices from swirl vanes. Conclusions bearing upon the validity of some theories of vortex breakdown are possible from the data.

Faler, J. H.↗
NASA NTRS1977

Acoustic source location in the secondary mixing region of a jet-blown flap using a cross-correlation technique

An experimental investigation of the acoustic sources in the secondary mixing region of a laboratory-scale jet-flap was made using a causality correlation technique. The processed signal of a hot-film anemometer probe was cross correlated with the output signal of a far-field microphone. Axial acoustic source strength distributions were measured for three far-field microphone locations: plus or minus 45 deg in the flyover plane and 45 deg in the sideline plane. These measurements showed that the acoustic sources in the secondary mixing region are highly directional, radiating much more effectively to the -45 deg-microphone, located below the plane of the flap surface. A relative maximum in the acoustic source strength measured for the microphones in the flyover plane occurred very near the flap trailing edge, which may be due to an edge amplification effect predicted by the theoretical work of Ffowcs Williams and Hall.

Becker, R. S.↗
NASA NTRS1977

Mean Velocity, Turbulence Intensity and Turbulence Convection Velocity Measurements for a Convergent Nozzle in a Free Jet Wind Tunnel. Comprehensive Data Report

The effect of flight on the mean flow and turbulence properties of a 0.056m circular jet were determined in a free jet wind tunnel. The nozzle exit velocity was 122 m/sec, and the wind tunnel velocity was set at 0, 12, 37, and 61 m/sec. Measurements of flow properties including mean velocity, turbulence intensity and spectra, and eddy convection velocity were carried out using two linearized hot wire anemometers. This report contains the raw data and graphical presentations. The final technical report includes a description of the test facilities, test hardware, along with significant test results and conclusions.

Mccolgan, C. J.↗
NASA NTRS1978

Flow field analysis

The average mean wind speed integrated over a disk is shown to be extremely close to the mean value of wind speed which would be measured at the center of a disk for most geometries in which a WECS (Wind Energy Conversion System) would operate. Field test results are presented which compare instantaneous records of wind speed integrated over a disk with the wind speed measured at the center of the disk. The wind field that a rotating element would experience is presented which was synthesized from the outputs of an array of anemometers.

Cliff, W. C.↗
NASA NTRS1978

Estimation of the sea surface's two-scale backscatter parameters

The relationship between the sea-surface normalized radar cross section and the friction velocity vector is determined using a parametric two-scale scattering model. The model parameters are found from a nonlinear maximum likelihood estimation. The estimation is based on aircraft scatterometer measurements and the sea-surface anemometer measurements collected during the JONSWAP '75 experiment. The estimates of the ten model parameters converge to realistic values that are in good agreement with the available oceanographic data. The rms discrepancy between the model and the cross section measurements is 0.7 db, which is the rms sum of a 0.3 db average measurement error and a 0.6 db modeling error.

Wentz, F. J.↗
NASA NTRS1978

Mean velocity, turbulence intensity and turbulence convection velocity measurements for a convergent nozzle in a free jet wind tunnel

The effect of light on the mean flow and turbulence properties of a 0.056 m circular jet were determined in a free jet wind tunnel. The nozzle exit velocity was 122 m/sec, and the wind tunnel velocity was set at 0, 12, 37, and 61 m/sec. Measurements of flow properties including mean velocity, turbulence intensity and spectra, and eddy convection velocity were carried out using two linearized hot wire anemometers. Normalization factors were determined for the mean velocity and turbulence convection velocity.

Mccolgan, C. J.↗
NASA NTRS1977

On the hysteresis of the sea surface and its applicability to wave height predictions

Because of the low dissipation rate of wave energy on the ocean's surface, the wave height at some location and time must be dependent upon wind fields in existence there at previous times and upon swell propagated there from other regions. To study these relationships, significant wave height (SWH) measurements from the Geos-3 radar altimeter are used in conjunction with anemometer windspeed measurements from weather ships, L, C, and R. During the passage of large cyclonic disturbances near the fixed locations of these vessels in the North Atlantic in February 1976, distinct hysteresis profiles that characterize the sea's memory during generation and dissipation conditions are observed. Examples are given that demonstrate the influences of cyclone intensity, movement, velocity, and shape on the configuration of these profiles.

Parsons, C. L.↗
NASA NTRS1978

An experimental map of the internal structure of a vortex breakdown

The flow field of an 'axisymmetric' vortex breakdown has been mapped using a laser-Doppler anemometer. The interior of the recirculation zone is dominated by energetic, non-axisymmetric, low frequency periodic fluctuations. Spectra for a number of points inside this zone, as well as time-averaged swirl and axial velocity profiles both inside and outside the recirculation zone, have been obtained. The time-averaged streamlines in the interior show an unexpected two-celled structure attributed to the action of the fluctuations. Although the present experiment deals with one particular breakdown, flow-visualization studies indicate that the case examined is typical of the 'axisymmetric' form of breakdown over a range of flow conditions.

Faler, J. H.↗
NASA NTRS1979

Improved split-film vector anomometer

Split-film vector anemometer accurately measures magnitude and direction of fluid flow velocity in three-dimensional space using only one of three split films in three-prong split-film system. With procedure, one sensor develops all data previously required by three.

Scheiman, J.↗
NASA NTRS1979

Measurements of flow phenomena induced by suction through perforated and partially plugged surfaces

Efforts were directed towards completing construction of the windtunnel test section, assembling instrumentation, programming the data acquisition and reduction system, adjusting the streamwise pressure gradient of the test section, calibrating the hot-wire anemometer probe, and constructing and testing a smoke generator. The test section was installed in the wind tunnel and is completely operational. The streamwise pressure gradient was adjusted to be nominally zero at a free-stream velocity of 3.05 m/s (10 ft/s). This was accomplished by adjusting the upper wall of the test section to be slightly divergent. The change in static pressure between any two streamwise locations in the test section was less than one percent of the free-stream dynamic pressure. A suitable means was found for accurately calibrating the hot-wire probe which is used to measure boundary-layer velocity profiles and fluctuating velocities.

Wilkinson, S. P.↗