Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “limiting techniques”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 433 records · Page 24
All sourcesNASA NTRSDOE OSTI
NASA NTRS1975

The accuracy of far-field noise obtained by the mathematical extrapolation of near-field noise data

Results are described of an analytical study of the accuracy and limitations of a technique that permits the mathematical extrapolation of near-field noise data to far-field conditions. The effects of the following variables on predictive accuracy of the far-field pressure were examined: (1) number of near-field microphones; (2) length of source distribution; (3) complexity of near-field and far-field distributions; (4) source-to-microphone distance; and (5) uncertainties in microphone data and imprecision in the location of the near-field microphones. It is shown that the most important parameters describing predictive accuracy are the number of microphones, the ratio of source length to acoustic wavelength, (L/wavelength), and the error in location of near-field microphones. If microphone measurement and location errors are not included, then far-field pressures can be accurately predicted up to L/wavelength values of 15 using approximately 50 microphones. For maximum microphone location errors of + or - 1 cm, only an accuracy of + or - 2-1/2 db can be attained with approximately 40 microphones for the highest L/wavelength of 10.

Ahtye, W. F.↗
NASA NTRS1974

Computation of steady axisymmetric flow using a one-dimensional time-dependent method

An iterative numerical method for computing steady, three dimensional, viscous, compressible flow fields, about aerodynamic bodies was studied. In order to develop the iterative method economically, the primary emphasis was directed towards supersonic, axisymmetric flow. However, the technique readily extends to three spatial dimensions. The viscous flow field about a cone-cylinder-flare body was calculated and compared to existing experimental data. Numerical predictions of the cone boundary layer and the flow field shock wave structure agreed with corresponding measurements. A separation was calculated at the cylinder-flare junction in six iterations; however, the size of the vortex did not correspond to the measured size. It was estimated that fifty iterations would be required to properly define the vortex. It was concluded that the iteration technique is of limited value for plane two dimensional and axisymmetrix flows, but of great value for three-dimensional flows.

Walitt, L.↗
NASA NTRS1976

Development and evaluation of a Hadamard transform imaging spectrometer and a Hadamard transform thermal imager

A spectrometric imager and a thermal imager, which achieve multiplexing by the use of binary optical encoding masks, were developed. The masks are based on orthogonal, pseudorandom digital codes derived from Hadamard matrices. Spatial and/or spectral data is obtained in the form of a Hadamard transform of the spatial and/or spectral scene; computer algorithms are then used to decode the data and reconstruct images of the original scene. The hardware, algorithms and processing/display facility are described. A number of spatial and spatial/spectral images are presented. The achievement of a signal-to-noise improvement due to the signal multiplexing was also demonstrated. An analysis of the results indicates both the situations for which the multiplex advantage may be gained, and the limitations of the technique. A number of potential applications of the spectrometric imager are discussed.

Harwit, M.↗
NASA NTRS1975

The accuracy of far-field noise obtained by the mathematical extrapolation of near-field noise data

Results are presented for an analytical study of the accuracy and limitations of a technique that permits the mathematical extrapolation of near-field noise data to far-field conditions. The effects of the following variables on predictive accuracy of the far-field pressure were examined: (1) number of near-field microphones; (2) length of source distribution; (3) complexity of near-field and far-field distributions; (4) source-to-microphone distance; and (5) uncertainties in microphone data and imprecision in the location of the near-field microphones. It is shown that the most important parameters describing predictive accuracy are the number of microphones, the ratio of source length to acoustic wavelength (L/lambda), and the error in location of near-field microphones. For maximum microphone location errors of plus or minus 1 cm, only an accuracy of plus or minus 2.5 dB can be attained with approximately 40 microphones for the highest L/lambda of 10.

Ahtye, W. F.↗
NASA NTRS1976

Delineation of geological problems for use in urban planning

Activities of the University of Alabama in support of state and local planning commissions are reported. Demonstrations were given of the various types of remotely sensed images available from U-2, Skylab, and LANDSAT; and their uses and limitations were discussed. Techniques to be used in determining flood prone areas were provided for environmental studies. A rapid, inexpensive method for study was developed by which imagery is copied on 35 mm film and projected on existing topographic maps for measuring delta volume and growth.

Hughes, T. H.↗
NASA NTRS1977

Implications of outer-zone radiations on operations in the geostationary region utilizing the AE4 environmental model

The radiation exposure in the region of geostationary orbits is examined in search for means of optimizing human performance. It is found that the use of slightly inclined circular orbits is one means by which exposure and spacesuit thickness requirements can be reduced. Another effective technique is to limit the extravehicular activity to those days when the short term fluctuations result in low exposure. Space-suit shielding approaching 1/2 sq cm or less may be possible by utilizing work stoppages and inclined orbits. If aluminum and other low-atomic-number materials are used to construct the habitat, then excessive wall thicknesses are required. If special bremsstrahlung shielding is used, then the habitat shield may be reduced to as low as 2 g/sq cm. Numerous tables and graphs are presented for future analysis of dose in the geostationary region.

Wilson, J. W.↗
NASA NTRS1977

Evaluation of algorithms for geological thermal-inertia mapping

The errors incurred in producing a thermal inertia map are of three general types: measurement, analysis, and model simplification. To emphasize the geophysical relevance of these errors, they were expressed in terms of uncertainty in thermal inertia and compared with the thermal inertia values of geologic materials. Thus the applications and practical limitations of the technique were illustrated. All errors were calculated using the parameter values appropriate to a site at the Raft River, Id. Although these error values serve to illustrate the magnitudes that can be expected from the three general types of errors, extrapolation to other sites should be done using parameter values particular to the area. Three surface temperature algorithms were evaluated: linear Fourier series, finite difference, and Laplace transform. In terms of resulting errors in thermal inertia, the Laplace transform method is the most accurate (260 TIU), the forward finite difference method is intermediate (300 TIU), and the linear Fourier series method the least accurate (460 TIU).

Miller, S. H.↗
NASA NTRS1977

Development of a high efficiency thin silicon solar cell

A key to the success of this program was the breakthrough development of a technology for producing ultra-thin silicon slices which are very flexible, resilient, and tolerant of moderate handling abuse. Experimental topics investigated were thinning technology, gaseous junction diffusion, aluminum back alloying, internal reflectance, tantalum oxide anti-reflective coating optimization, slice flexibility, handling techniques, production rate limiting steps, low temperature behavior, and radiation tolerance.

Lindmayer, J.↗
NASA NTRS1977

Edge effects in angle-ply composite laminates

This paper presents the results of a zeroth-order solution for edge effects in angle-ply composite laminates obtained using perturbation techniques and a limiting free body approach. The general solution for edge effects in laminates of arbitrary angle ply is applied to the special case of a (+ or - 45)s graphite/epoxy laminate. Interlaminar stress distributions are obtained as a function of the laminate thickness-to-width ratio and compared to finite difference results. The solution predicts stable, continuous stress distributions, determines finite maximum tensile interlaminar normal stress and provides mathematical evidence for singular interlaminar shear stresses in (+ or - 45) graphite/epoxy laminates.

Hsu, P. W.↗
NASA NTRS1981

Detection of severe thunderstorms using short interval geosynchronous satellite data

The potential and limitations of using short interval (3-7 minutes) geosynchronous, infrared data to ascertain thunderstorm intensity, and therefore indirectly detect severe thunderstorms are discussed. Thunderstorms on four case study days were analyzed over selected areas and time periods using SMS/GOES data, and derived satellite based intensity parameters were compared to severe weather reports. Young, growing thunderstorms are intensity rated using the rate of decrease of the satellite observed cloud top minimum equivalent blackbody temperature. Since most storms cannot be observed until they penetrate through the cirrus overcast produced by previous convection, minimum cloud temperature and rate of blackbody temperature isotherm expansion are then used as intensity indicators. Results are presented and problems and limitations of the techniques and the data are examined. In addition, an analysis of cloud top height variations (as viewed by the satellite) in relation to tornado touchdown times and, in a few cases, to mesocyclone formation times is also presented.

Adler, R. F.↗
NASA NTRS1980

X-ray astronomical spectroscopy

The elementary spectral signatures of fundamental physical processes that might be operable in galactic and extragalactic X-ray sources are reviewed. Some of the instrument limitations of experimental techniques used in X-ray astronomical spectroscopy are described. X-ray spectroscopic measurements are examined for various types of X-ray-emitting objects, including degenerate and nondegenerate stellar systems, supernova remnants, clusters of galaxies, active galactic nuclei, and quasars.

Holt, S. S.↗
NASA NTRS1983

Statistical summaries of fatigue data for design purposes

Two methods are discussed for constructing a design curve on the safe side of fatigue data. Both the tolerance interval and equivalent prediction interval (EPI) concepts provide such a curve while accounting for both the distribution of the estimators in small samples and the data scatter. The EPI is also useful as a mechanism for providing necessary statistics on S-N data for a full reliability analysis which includes uncertainty in all fatigue design factors. Examples of statistical analyses of the general strain life relationship are presented. The tolerance limit and EPI techniques for defining a design curve are demonstrated. Examples usng WASPALOY B and RQC-100 data demonstrate that a reliability model could be constructed by considering the fatigue strength and fatigue ductility coefficients as two independent random variables. A technique given for establishing the fatigue strength for high cycle lives relies on an extrapolation technique and also accounts for "runners." A reliability model or design value can be specified.

Wirsching, P. H.↗
NASA NTRS1982

Measurement of ocean surface currents by synthetic aperture radar

Synthetic aperture radar (SAR) is a coherent imaging device which uses the Doppler-induced phase changes of the received signals to locate scatterers in the along-track direction. In principle, the recorded data can be analyzed to obtain the radial velocity of moving objects in the scene relative to the flight path of the SAR platform. The application of this concept for measuring ocean surface currents has been evaluated using data from SAR systems mounted in aircraft and spacecraft platforms. This paper describes the results of these experiments and summarizes the limitations of the technique using existing SAR systems. Considerations involved in the design of optimum systems for this application are also discussed.

Lyzenga, D. R.↗
NASA NTRS1984

The evolutionary trend in airborne and satellite radar altimeters

The manner in which airborne and satellite radar altimeters developed and where the trend is leading was investigated. The airborne altimeters have progressed from a broad beamed, narrow pulsed, nadir looking instrument, to a pulse compressed system that is computer controlled, to a scanning pencil beamed system which produce a topographic map of the surface beneath the aircraft in real time. It is suggested that the airborne systems lie in the use of multiple frequencies. The satellite altimeters evolve towards multifrequency systems with narrower effective pulses and higher pulse compression ratios to reduce peak transmitted power while improving resolution. Applications indicate wide swath systems using interferometric techniques or beam limited systems using 100 m diameter antennas.

Fedor, L. S.↗
NASA NTRS1984

Utilization of spaceborne SAR data for mapping

Recent developments in automated processing of digital SEASAT SAR imagery have made feasible the generation of large-scale high-resolution maps. Standard preprocessing of raw data into digital images results in geometrically distorted imagery. Computer algorithms have been developed for unsupervised pixel location, geometric rectification, and mosaicking of multiple-image frames without ground control points. These algorithms utilize knowledge of the spacecraft trajectory data, the imaging geometry, and the coherent properties of the sensor to generate the required processing parameters. This paper discusses the advantages as well as the inherent limitations of this technique, analyzes the associated errors, and presents results using SEASAT SAR imagery. Also discussed are the results of the recent shuttle imaging radar (SIR-A) experiment as well as a follow-on experiment (SIR-B) planned for 1984.

Curlander, J. C.↗
NASA NTRS1984

Diode laser 87Rb optical pumping in an evacuated wall-coated cell

The evacuated wall coated sealed cell coupled with diode laser optical pumping offers a number of attractive potential advantages for use in Rb or Cs atomic frequency standards. An investigation of systematic effects is required to explore possible limitations of the technique. The use of diode laser optical pumping of 87 Rb in an evacuated wall coated sealed cell is presented. Experimental results/discussion to be presented include the signal strength and line broadening of the 0 - 0 hyperfine resonance as a function of light intensity for the D1 optical transitions (F - F prime) - (2 1 prime) and (2 - 2 prime), shift of the 0 - 0 hyperfine frequency as a function of laser intensity and de-tuning from optical resonance, and diode laser frequency stabilization techniques.

Lee, W. K.↗
NASA NTRS1984

Using GPS and VLBI technology to maintain 14 digit synchronization

To facilitate the navigation of spacecraft to the outer planets, Jupiter and beyond, the JPL-NASA Deep Space Network (DSN) has implemented three ensembles of atomic clocks at widely separated locations. These clocks must be maintained, synchronized, to with a few parts in 10 to the 13th power of each other and, the entire group must be maintained, to a lesser degree, in synchronism with Coordinated Universal Time (UTC)NBS/USNO. Over the last 1 1/2 years the DSN has been using Global Positioning Satellites (GPS) and Very Long Baseline Interferometry (VLBI) technology to perform these critical Frequency and Time (F&T) synchronization tasks. A year of F&T synchronization data collected from the intercomparison of 3 sets of cesium and hydrogen maser driven clock ensembles through the use of GPS and VLBI techniques are covered. Also covered, are some of the problems met and limitations of these two techniques at their present level of technology.

Ward, S. C.↗
NASA NTRS1985

Cell Partition in Two Polymer Aqueous Phases

Partition of biological cells in two phase aqueous polymer systems is recognized as a powerful separation technique which is limited by gravity. The synthesis of new, selective polymer ligand conjugates to be used in affinity partition separations is of interest. The two most commonly used polymers in two phase partitioning are dextran and polyethylene glycol. A thorough review of the chemistry of these polymers was begun, particularly in the area of protein attachment. Preliminary studies indicate the importance in affinity partitioning of minimizing gravity induced randomizing forces in the phase separation process. The PEG-protein conjugates that were prepared appear to be ideally suited for achieving high quality purifications in a microgravity environment. An interesting spin-off of this synthetic work was the observation of catalytic activity for certain of our polymer derivatives.

Harris, J. M.↗