Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “frequency measurement”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 433 records · Page 24

Improvements in search and rescue distress alerting and locating using satellites

This paper describes a system concept for search and rescue which is capable of making a major contribution to saving lives and reducing the search time for downed aircraft. In addition, a beacon location experiment is described using the Amateur Radio Satellite Corporation Oscar-6 and Oscar-7 spacecraft. The purpose of this experiment was to demonstrate the system concept above by determining the geographical location of a low power 'distress beacon' via satellite based on a single pass of Doppler frequency measurements. Preliminary results are presented showing beacon location recovery on the order of 10 km with indications that an order of magnitude improvement is entirely possible. This experiment is in support of NASA's current exploration into the role satellites might play in providing much needed improvements in the reliability, coverage and accuracy of present search and rescue procedures.

Brandel, D. L.↗

Acoustic measurements of a large cavity in a wind tunnel

Acoustic measurements were made with inside and far-field microphones. Correlation of measured frequencies with available theories indicates that existing theories are applicable over a broader range than previously shown. The cavity configuration with a partial covering downstream amplified tonal intensities. The frequency of the tones depended on cavity size, not on cavity open area. Introducing upstream disturbances decreased the amplitude of the cavity tones.

Scheiman, J.↗

The design and demonstration of an advanced data collection/position locating system, addendum

The theoretical background for a coherent demodulator for minimum shift keying signals generated by the advanced data collection/position locating system breadboard is presented along with a discussion of the design concept. Various tests and test results, obtained with the breadboard system described, include evaluation of bit-error rate performance, acquisition time, clock recovery, recycle time, frequency measurement accuracy, and mutual interference.

Source record↗

DIAL with heterodyne detection including speckle noise: Aircraft/shuttle measurements of O3, H2O, and NH3 with pulsed tunable CO2lasers

A parametric analysis of DIAL sensitivity with heterodyne detection is presented and comparisons with direct detection are discussed. Examples are given for monitoring vertical distributions of O3, H2O, and NH3 using a ground-, aircraft-, or shuttle-based pulsed tunable CO2 laser DIAL system. Results indicate that maximum sensitivity at minimum laser energy per measurement requires multiple pulse operation with the energy per pulse selected so that the measured photon rate is approximately equal to the detector IF bandwidth. Measurement sensitivities can be maximized and interference effects minimized by fine adjustment of measurement frequencies using the tunability of high pressure lasers. The use of rare isotope lasers minimizes loss due to CO2 atmospheric absorption.

Brockman, P.↗

Unprecented syntonization and syncronization accuracy via simultaneous viewing with GPS receivers: Construction characteristics of an NBS/GPS receiver

The National Bureau of Standards/Global Positioning System (NBS/GPS) receiver is discussed. It is designed around the concept of obtaining high accuracy, low cost time and frequency comparisons between remote frequency standards and clocks with the intent to aid international time and frequency coordination. Preliminary tests of this comparison technique between Boulder, CO and Washington, D.C indicate the ability to do accurate time transfer to better that 10 ns, and frequency measurements to better than 1 part in 10 to the 14th power. The hardware and software of the receiver is detailed. The receiver is fully automatic with a built-in 0.1 ns resolution time interval counter. A microprocessor does data processing. Satellite signal stabilities are routinely at the 5 ns level for 15 s averages, and the internal receiver stabilities are at the 1 ns level.

Davis, D. D.↗

ISEE 1 observations of thermal plasma in the vicinity of the plasmasphere during periods of quieting magnetic activity

An investigation of thermal plasma behavior in the vicinity of the plasmasphere during periods of quieting magnetic activity was conducted by combining thermal ion observations made with the plasma composition experiment on ISEE 1 with plasma density profiles obtained from plasma frequency measurements made with the same satellite's plasma wave experiment. During periods in which the magnetic activity quiets, the two regions characterized by H(+):He(+):O(+) (isotropic) and H(+):O(+):He(+) (field-aligned) ion species distributions (in order of dominance) are separated by a new region in which low-energy H(+) and He(+) are found flowing along the magnetic field lines. At other times, following quieting magnetic activity, distributions having peak fluxes at 90 deg pitch angle are observed in this region.

Horwitz, J. L.↗

Ion-beam-driven electrostatic ion cyclotron instabilities

Results are presented of a particle simulation study of the electrostatic ion-cyclotron (EIC) instability driven by a parallel ion beam. The results of this simulation study demonstrate the nonlinear consequences of nonresonant EIC waves destabilized by an ion beam parallel to the magnetic field for the case of a large beam velocity. As a consequence of the instability, it is shown that the beam ions are heated strongly in the perpendicular direction and suffer a strong anomalous friction via EIC waves which leads to the beam slowing down. Simulation results indicate that the anomalous slowing down of beam ions by EIC waves is much larger than that from the classical electron-drag, and the perpendicular collision frequency measured from perpendicular beam heating is as large as that from Bohm diffusion. It is concluded that the ion beam driven EIC wave is a viable mechanism for the transfer of ion parallel beam energy to the ion perpendicular energy.

Okuda, H.↗

Infrared heterodyne spectroscopy of seven gases in the vicinity of chlorine monoxide lines

Chlorine monoxide (ClO) is thought to play an important role in a photochemical cycle which causes the destruction of ozone in the earth's stratosphere. Since lines of the (1,0) fundamental of ClO lie near C-14O2-16, laser lines, IR heterodyne spectroscopy is potentially an important technique for monitoring the ClO abundance. However, due to the presence of lines from other trace atmospheric gases in this spectral range, the interpretation of such observations is ambiguous unless high resolution laboratory measurements support the identifications. Measured frequencies are reported for spectral lines of seven trace atmospheric gases which absorb near the C-14O2-16 laser transitions relevant to the detection of ClO by IR heterodyne spectroscopy.

Weaver, H. A.↗

Arcsecond positions for milliarcsecond VLBI nuclei of extragalactic radio sources. II - 207 sources

Time delay and fringe frequency measurements at 2.29 GHz have been obtained with VLBI on baselines of about 10,000 km, in order to determine the positions of milliarcsec nuclei in 207 extragalactic radio sources. Accuracy ranges are estimated to lie between 0.1 and 1.0 arcsec in both right ascension and declination, with all sources having uncertainties of less than 4 arcsec in both coordinates. These sources constitute part of an all-sky VLBI catalog of milliarcsec radio sources, for 752 of which arcsec positions have thus far been determined.

Morabito, D. D.↗

Detailed design of a variable volume hydrogen maser

Identification of the hydrogen maser design parameters include the shape of the bulk, q (quality parameter), tuning factors, materials to be used, and operational temperature to offset the wall shift. Expressions for the statistic error on the measured frequency were derived. Localized variations in the concentration of excited atoms were studied and how the shape of the container (the ratio of surface to volume in particular) affects their behavior.

Cervenka, P. O.↗

Calibration of diode laser spectra using a confocal etalon

The dual-beam diode laser spectrometer described by Jennings (1980) is adapted to use a 50-cm confocal etalon for frequency calibration. The collimated radiation from the laser is split at a wedged ZnSe window, and the reference beam is then focused at the midpoint of the etalon length. After the etalon, the reference beam is recollimated and continues its regular path to the monochromator and detectors. An aperture is placed before the etalon in order to limit the entrance beam diameter to approximately 5 mm. Both ends of the etalon are furnished with two-axis adjustments. Initial alignment is achieved using an He-Ne laser, and final optimization involves adjustment of the cavity length as well as the etalon pitch and yaw. The 50-cm confocal etalon produces fringes separated by 150 MHz (0.005/cm). With the aid of a CO2 laser, it is found to have fringe widths (FWHM) of 2 MHz. The confocal etalon makes it possible to improve the accuracy of relative frequency measurements in diode laser spectra and to check the spectral purity and stability of the laser during the recording of spectra.

Jennings, D. E.↗

Rocket observations of electron density in the nighttime E region using Faraday rotation

A rocket radio propagation experiment is described in which the electron density profile of the nighttime E region is obtained with an accuracy of 100 per cu cm. The factors limiting the accuracy of the experiment are found to be related to atmospheric and receiver noise and to the use of a magnetometer to determine the spin rate of the rocket. The Fourier analysis used for the frequency measurement may also contribute error under conditions of steep electron density gradients. The accuracy being achieved appears to be adequate for present applications of the experiment.

Smith, L. G.↗

Shuttle ku-band communications/radar technical concepts

Technical data on the Shuttle Orbiter K sub u-band communications/radar system are presented. The more challenging aspects of the system design and development are emphasized. The technical problems encountered and the advancements made in solving them are discussed. The radar functions are presented first. Requirements and design/implementation approaches are discussed. Advanced features are explained, including Doppler measurement, frequency diversity, multiple pulse repetition frequencies and pulse widths, and multiple modes. The communications functions that are presented include advances made because of the requirements for multiple communications modes. Spread spectrum, quadrature phase shift keying (QPSK), variable bit rates, and other advanced techniques are discussed. Performance results and conclusions reached are outlined.

Griffin, J. W.↗

Measurement of the Vertical Gradient of the Semidiurnal Tidal Wind Phase in Winter at the 95 Km Level

When supplemented by absolute reflection height measurements, low frequency wind measurements in the 90-100 km height range become truly competitive in comparison with the more widely used radar meteor wind observations. For example, height profiles of the wind parameters in the so-called meteor zone can be obtained due to the considerable interdiurnal variability of the average nighttime reflection heights controlled by geomagnetic activity. The phase of the semidiurnal tidal wind is particularly height-dependent. The measured vertical gradient of 1/4 h/km in winter corresponds to a vertical wavelength of about 50 km. Wind measurements in the upper atmosphere, at heights between 90 and 100 km, were carried out at the Collm Geophysical Observatory of Karl Marx University Leipzig for a number of years. These measurements use the closely-spaced receiver method and three measuring paths, on 179, 227, and 272 kHz. They take place every day between sunset and sunrise, i.e., nightly. A night in this sense may last as long as 18 hours in winter. Both the measurements and their evaluation are completely automatic, and the prevailing winds and tides are separated.

Schminder, R.↗

Preliminary results on passive eddy current damper technology for SSME turbomachinery

Some preliminary results have been obtained for the dynamic response of a rotor operating over a speed range of 800 to 10,000 rpm. Amplitude frequency plots show the lateral vibratory response of an unbalanced rotor with and without external damping. The mode of damping is by means of eddy currents generated with 4 c shaped permanent magnets installed at the lower bearing of a vertically oriented rotor. The lower ball bearing and its damper assembly are totally immersed in liquid nitrogen at a temperature of -197 deg C (-320 deg F). These preliminary results for a referenced or base line passive eddy current damper assembly show that the amplitude of synchronous vibration is reduced at the resonant frequency. Measured damping coefficients were calculated to phi = .086; this compares with a theoretically calculated value of phi = .079.

Cunningham, R. E.↗

A reexamination of soil textural effects on microwave emission and backscattering

Microwave frequency measurements of moist soil dielectric properties are noted to challenge the validity of percent-of-field-capacity as a moisture indicator that is independent of soil texture in terms of microwave sensitivity. In arriving at this view, gravimetric, volumetric, and percent-of-field-capacity were tested for their ability to reduce dielectric behavior divergence between soil textures at 1.4 and 5.0 GHz. The most congruent dielectric behavior between soil textures is found to occur when soil moisture is expressed on a volumetric basis that is proportional to the number of water dipoles/unit volume. An inadequate characterization of soil bulk density in the field, combined with the dependency of bulk density on water retention at field capacity, offers the most plausible explanation for the earlier conclusions.

Dobson, M. C.↗

A dual frequency microstrip antenna for Ka band

For fixed satellite communication systems at Ka band with downlink at 17.7 to 20.2 GHz and uplink at 27.5 to 30.0 GHz, the focused optics and the unfocused optics configurations with monolithic phased array feeds have often been used to provide multiple fixed and multiple scanning spot beam coverages. It appears that a dual frequency microstrip antenna capable of transmitting and receiving simultaneously is highly desirable as an array feed element. This paper describes some early efforts on the development and experimental testing of a dual frequency annular microstrip antenna. The antenna has potential application for use in conjunction with a monolithic microwave integrated circuit device as an active radiating element in a phased array of phased array feeds. The antenna is designed to resonate at TM sub 12 and TM sub 13 modes and tuned with a circumferential microstrip ring to vary the frequency ratio. Radiation characteristics at both the high and low frequencies are examined. Experimental results including radiating patterns and swept frequency measurements are presented.

Lee, R. Q.↗