Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Eutectic”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 433 records · Page 24
All sourcesNASA NTRSDOE OSTI
DOE OSTI2023

Time dependent chlorination of CeO 2 , La 2 O 3 and Nd 2 O 3 by ZrCl 4 dissolved in eutectic LiCl–KCl

Partial chlorination of CeO 2 , La 2 O 3 , and Nd 2 O 3 was achieved using ZrCl 4 dissolved in molten LiCl-KCl at 450°C over a period of 4-5 hr. ZrCl 4 was pre-volatilized into an argon stream to maintain a constant vapor pressure for equilibration with the salt. This approach was effective at maintaining the ZrCl 4 concentration at the solubility limit of 1.3 mol% in the molten salt throughout the duration of two of the chlorination experiments and within about 60% of the solubility limit in the third experiment. Based on the analysis of salt samples, fractional conversion after four hours of reaction for CeO 2 , and five hours for La 2 O 3 , and Nd 2 O 3 were calculated to be 0.97, 0.28, and 0.65 respectively. Assuming a shrinking core diffusion-limited model, the diffusivity of ZrCl 4 through the hypothesized ZrO 2 layer was calculated for the chlorination of CeO 2 , La 2 O 3 , and Nd 2 O 3 were 1.76 x 10 -10 cm 2 /sec, 7.85 x 10 -12 cm 2 /sec, and 7.42 x 10 -12 cm 2 /sec, respectively. Given the extremely low values calculated for diffusivity, it was concluded that the process is chemical reaction rate limited and that a complete reaction of each rare earth oxide could be achieved. Furthermore, a chemically controlled shrinking core model was shown to also fit the experimental data closely.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗
DOE OSTI2026

Electrochemical behavior of SnCl 2 and influence of Cu and Ni ions in molten LiCl−KCl−CaCl 2 eutectic

Reliable transport and thermodynamic data for multivalent ions in complex molten salts are scarce, limiting model fidelity for electrorefining and impurity control. Here, we report a comprehensive electrochemical characterization of SnCl₂ in LiCl–KCl–CaCl₂ (50.5–44.2–5.3 mol%) at 685 K, including the effects of Ni 2+ and Cu + impurities. Using cyclic voltammetry (CV), chronoamperometry (CA), and chronopotentiometry (CP), we quantified Sn 2+ and Ni 2+ diffusion with exceptional agreement across methods: Sn 2+ averaged (1.03 ± 0.10) × 10 −5 cm 2 s −1 , and Ni 2+ averaged (0.75 ± 0.19) × 10 −5 cm 2 s −1 . The tight confidence-interval overlap across CV, CA, and CP strengthens confidence in these values and is uncommon in molten chloride studies. Open-circuit-potential measurements provided standard apparent reduction potentials that closely match LiCl–KCl literature, indicating minimal shift with CaCl₂ present. The Sn 2+ /Sn couple behaves as a reversible two-electron soluble–insoluble process at 685 K; the Sn 4+ /Sn 2+ couple transitions to soluble–soluble behavior near 788 K, which may correlate with the decomposition of surface bound chlorostannates, though direct characterization remains to be established. In mixed systems, Cu+/Cu overlaps Sn 2+ /Sn, limiting Cusingle bondSn electroseparation, whereas the larger potential gap between Ni 2+ /Ni and Sn 2+ /Sn supports selective Ni removal. These internally consistent transport and thermodynamic data establish a validated basis for process modeling and optimization of Sn electrorefining and impurity management in LiCl–KCl–CaCl₂.

Berzins-Delahay↗