SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Microscopic origin of ferromagnetism in Cr-doped ZnTe. Figure shows parallel spins with large magnetic moment in a – c plane on Zn/Cr site. The ordered moment is due to orbital overlap between Te and Zn/Cr sites, highlighted by transparent circles.
Here, we report the synthesis of a novel quaternary Heusler alloy CoMnCrGa and its structural, magnetic, transport and electronic properties using both experimental and theoretical methods.
Monolayer iron oxides grown on metal substrates have widely been used as model systems in heterogeneous catalysis. By means of ambient-pressure scanning tunneling microscopy (AP-STM), we studied the in situ oxidation and reduction of FeO(111) grown on Au(111) by oxygen (O 2 ) and carbon monoxide (CO), respectively. Oxygen dislocation lines present on FeO islands are highly active for O 2 dissociation. X-ray photoelectron spectroscopy measurements distinctly reveal the reversible oxidation and reduction of FeO islands after sequential exposure to O 2 and CO. Here, our AP-STM results show that excess O atoms can be further incorporated on dislocation lines and react with CO, whereas the CO is not strong enough to reduce the FeO supported on Au(111) that is essential to retain the activity of oxygen dislocation lines.
The use of cryogenic silicon as a detector medium for dark matter searches is gaining popularity. Many of these searches are highly dependent on the value of the photoelectric absorption cross section of silicon at low temperatures, particularly near the silicon bandgap energy, where the searches are most sensitive to low mass dark matter candidates. While such cross section data have been lacking from the literature, previous dark matter search experiments have attempted to estimate this parameter by extrapolating it from higher temperature data. However, discrepancies in the high temperature data have led to order-of-magnitude differences in the extrapolations. In this paper, we resolve these discrepancies by using a novel technique to make a direct, low temperature measurement of the photoelectric absorption cross section of silicon at energies near the bandgap (1.2 eV–2.8 eV).
Incorporation of Se into Cd 1–x Zn x Te (CZT) to form the quaternary compound semiconductor Cd 1–x Zn x Te 1–y Se y (CZTS) has proven to be an effective solution for compensating the major flaws associated with CZT, including poor homogeneity and high concentrations of electronically active deep levels that limit the performance of CZT detectors. In order to investigate how deep levels are affected by the Se concentration in CZTS, we performed photoinduced current transient spectroscopy (PICTS) measurements on CZTS crystals grown by the traveling heater method (THM) with 10% atomic Zn and varying atomic percentage of Se from 1.5% to 7.0%. The PICTS scans for up to 4% Se showed an exponential reduction in the capture cross section of deep levels associated with Te secondary phases in conjunction with an increase in a deep level positioned near the mid-gap, which initially increases the electron trapping time before degrading again at higher Se concentrations. The PICTS peaks present in 7% Se were anomalous relative to the other crystals and are expected to originate from transition metal impurities found in the lower-purity CdSe precursor material.
Due to its tunable bandgap, anisotropic behavior, and superior thermoelectric properties, device applications using layered tellurene (Te) are becoming more attractive. Here, we report a thinning technique for exfoliated tellurene nanosheets using thermal annealing in an oxygen environment. We characterize different thinning parameters, including temperature and annealing time. Based on our measurements, we show that controlled layer thinning occurs in the narrow temperature range of 325–350 °C. We also show a reliable method to form β-tellurene oxide (β-TeO 2 ), which is an emerging wide bandgap semiconductor with promising electronic and optoelectronic properties. This wide bandgap semiconductor exhibits a broad photoluminescence (PL) spectrum with multiple peaks covering the range of 1.76–2.08 eV. This PL emission, coupled with Raman spectra, is strong evidence of the formation of 2D β-TeO 2 . We discuss the results obtained and the mechanisms of Te thinning and β-TeO 2 formation at different temperature regimes. We also discuss the optical bandgap of β-TeO 2 and show the existence of pronounced excitonic effects evident by the large exciton binding energy in this 2D β-TeO 2 system that reach 1.54–1.62 eV for bulk and monolayer, respectively. Our work can be utilized to have better control over the Te nanosheet thickness. It also sheds light on the formation of well-controlled β-TeO 2 layered semiconductors for electronic and optoelectronic applications.
We produce beams of neutral titanium (Ti) atoms in their metastable 3d3(F4)4sa5F5 state by laser ablation into He, N2, and Ar buffer gases. The high temperatures associated with the ablation process populate the a5F5 level without the need for optical pumping. Remarkably, we observe that Ti atoms in the a5F5 state survive thousands of collisions with He and Ar buffer gas atoms without being quenched to lower-energy states. We study the yield of Ti atoms when ablated into buffer gases of varying species and pressure, quantify quenching rates and diffusion cross sections based on simple models, and provide insight into optimal design parameters for an ablation cell. Using a 3.3 cm ablation cell with interchangeable exit apertures, we produce metastable atom beams and quantify their brilliance and velocity distributions as functions of buffer gas pressure.
Monocrystalline silicon solar cells can achieve photoconversion efficiencies exceeding 26%; however, performance-limiting defects that trap carriers continue to be a challenge. In this work, we have characterized Si solar cells with tunneling SiO x /polycrystalline-Si (poly-Si) passivating contacts (TOPCon) on As-doped Czochralski Si wafers with electrically detected magnetic resonance (EDMR) spectroscopy. We fabricated 2 × 20 mm 2 TOPCon-like mini solar cells with edge passivation alongside larger 4 cm 2 sister cells and obtained similar device characteristics. We performed EDMR spectroscopy at 300 K on two minicells with different degrees of surface passivation based on the recombination parameter, J o , values of 40 and 310 fA/cm2. We optimized the resolution and the signal-to-noise ratio of the EDMR response of the minicells by varying the forward bias voltage and the magnetic field modulation amplitude. We detect two distinct signals with EDMR spectroscopy, an axial-like signal at g = 2.009, 2.0087, and 2.0015, and an isotropic signal at g = 2.0024, which we attribute to Si dangling bonds (P b0 and P b centers) and boron–oxygen related defects, respectively, at or near the c-Si/SiO x interface. The EDMR signals were lower for the cell with a lower value of J o , while the ratio of the two defect populations was very similar. The EDMR signal increases with forward bias but drops to zero at bias voltages >0.5 V, consistent with interface defects within or near the boron-doped emitter depletion region. Our study demonstrates a method to fabricate minicells that can be characterized with EDMR spectroscopy to detect industrially relevant defects in TOPCon cells.
Not Available
Severe plastic deformation of 304L stainless steel plate was carried out by friction stirring under an isothermal tool temperature at 825°C. The friction stirred zone showed extensive grain refinement, high fraction of low angle grain boundaries due to dislocation rearrangement, Σ3 and Σ9 special grain boundaries and discrete Fe–Cr–Mn-rich particles. Electrochemical polarisation measurements were done on the base metal (BM) and friction stir welded (FSW) specimens in the neutral and acidified 3.5% NaCl solutions. The BM showed marginally better pitting resistance in the neutral chloride solution than the FSW because of a larger fraction of special grain boundaries, and larger grain size. Whereas in acidified 3.5% NaCl solution, the FSW showed better corrosion resistance than the BM. Furthermore, the surface film of the FSW had a lower impedance and a lower defect concentration than the BM indicating higher diffusivity of point defects in the FSW.
Designing materials with advanced functionalities is the main focus of contemporary solid-state physics and chemistry. Research efforts worldwide are funneled into a few high-end goals, one of the oldest, and most fascinating of which is the search for an ambient temperature superconductor (A-SC). The reason is clear: superconductivity at ambient conditions implies being able to handle, measure and access a single, coherent, macroscopic quantum mechanical state without the limitations associated with cryogenics and pressurization. This would not only open exciting avenues for fundamental research, but also pave the road for a wide range of technological applications, affecting strategic areas such as energy conservation and climate change. In this roadmap we have collected contributions from many of the main actors working on superconductivity, and asked them to share their personal viewpoint on the field. The hope is that this article will serve not only as an instantaneous picture of the status of research, but also as a true roadmap defining the main long-term theoretical and experimental challenges that lie ahead. Interestingly, although the current research in superconductor design is dominated by conventional (phonon-mediated) superconductors, there seems to be a widespread consensus that achieving A-SC may require different pairing mechanisms.
Many applications involving atmospheric pressure plasma-substrate interactions are enabled by the large fluxes of short-lived reactive species such as OH radicals to the substrate, nonetheless, the accurate measurement of radical densities and fluxes at substrates at atmospheric pressure has received little attention to date, particularly for surface ionization waves. We report the measurement of the OH density distribution in a surface discharge on a fused silica (quartz) substrate generated by an impinging atmospheric pressure plasma jet in dry and humid helium. The OH density is measured by microscopic laser induced fluorescence with a spatial resolution of 10 µm in the direction perpendicular to the quartz substrate. The measured OH diffusive flux varied for the investigated experimental conditions by almost three orders of magnitude and had a maximum value of 1.7 × 10 15 cm -2 s -1 . The corresponding surface loss probability of OH on the quartz surface was determined to be ~0.01. The high spatial resolution was required to accurately resolve the near surface gradient of OH radicals.
In order to tune the magnetic properties of the cleavable high-Curie temperature ferromagnet Fe$_{5-x}$GeTe 2 , the effect of increasing the electron count through arsenic substitution has been investigated. Small additions of arsenic (2.5% and 5%) seemingly enhance ferromagnetic order in polycrystalline samples by quenching fluctuations on one of the three magnetic sublattices, whereas larger As concentrations decrease the ferromagnetic Curie temperature (T C ) and saturation magnetization. Furthermore, this work also describes the growth and characterization of Fe 4.8 AsTe 2 single crystals that are structurally analogous to Fe$_{5-x}$GeTe 2 but with some phase stability complications. Magnetization measurements reveal dominant antiferromagnetic behavior in Fe 4.8 AsTe 2 with a Néel temperature of $T_{\textrm{N}} \approx$ 42 K. A field-induced spin-flop below T N results in a switch from negative to positive magnetoresistance, with significant hysteresis causing butterfly-shaped resistance loops. In addition to reporting the properties of Fe 4.8 AsTe 2 , this work shows the importance of manipulating the individual magnetic sublattices in Fe$_{5-x}$GeTe 2 and motivates further efforts to control the magnetic properties in related materials by fine tuning of the Fermi energy or crystal chemistry.
The exploration of two-dimensional (2D) van der Waals ferromagnets has revealed intriguing magnetic properties with significant potential for spintronics applications. In this study, we examine the magnetic properties of Co-doped Fe 5 GeTe 2 using x-ray photoemission electron microscopy (XPEEM) and x-ray magnetic circular dichroism (XMCD), complemented by density functional theory calculations. Our XPEEM measurements reveal that the Curie temperature (T c ) of a bilayer of (Co x Fe 1-x ) 5-δ GeTe 2 (with x = 0.28) reaches ∼300 K—a notable enhancement over most 2D ferromagnets in the ultrathin limit. Interestingly, the T c shows only a small dependence on film thickness (bulk T c ≈ 340 K), in line with the observed in-plane (IP) magnetic anisotropy and robust IP exchange coupling. XMCD measurements indicate that the spin moments for both Fe and Co are significantly reduced compared to the theoretical values. These insights highlight the potential of Co-doped Fe 5 GeTe 2 for stable, high-temperature ferromagnetic applications in 2D materials.
Metal-Organic Frameworks (MOFs) have emerged as a versatile class of materials with applications in gas storage and separation, catalysis, and drug delivery [1]. Understanding their damage mechanisms in under various environmental conditions is crucial for optimizing performance and stability [2]. This study employs a combination of Length Structural Coherence (LSC) analysis in electron scattering and Electron Energy Loss Spectroscopy (EELS) to elucidate the damage mechanisms in two representative MOFs. MIL101(Fe), and MIL101(Cr). Here, the primary objective is to reveal structural and chemical changes that occur under electron beam irradiation in Scanning Transmission Electron Microscopy (STEM), both in the pristine state and during in-situ CO and CO 2 adsorption. By combining LSC in Radial Distribution Function (RDF) analysis with EELS, comprehensive insights into the nanoscale alterations are obtained and correlated to the electron dose rate.