Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “experimentation”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 415 records · Page 23
All sourcesNASA NTRSDOE OSTI
NASA NTRS1972

An analytical and experimental investigation of rotating, non-capillary heat pipes

An approximate theoretical model is derived for laminar film condensation on the inside of a rotating, truncated cone, and is used to predict the heat transfer performance of rotating, non-capillary heat pipes for a wide variety of parametric conditions. Experimental results are presented for water, ethyl alcohol, and freon-113 in a stainless steel heat pipe rotating to speeds of 2800 rpm. Results show that these devices can be used effectively to transfer large quantities of heat in rotating systems. Predicted results agree to within + or - 20 percent of the experimental data. Dropwise condensation, instead of film condensation, improves heat pipe performance while the presence of non-condensible gases impairs performance.

Marto, P. J.↗
NASA NTRS1972

Vibration and loads in hingeless rotors. Volume 2: Experimental data

Descriptions, geometry, and technical data covering three rotor systems are presented. Tables of experimental data gathered during wind tunnel testing of two of the systems are included. Both analyzed experimental data, ready for comparison with theory, and the basic reduced data from which they were obtained are reported.

Watts, G. A.↗
NASA NTRS1973

A proposed experimental method for interpreting Doppler effect measurements and determining their precision

The principal problem in the measurement of the Doppler reactivity effect is separating it from the thermal reactivity effects of the expansion of the heated sample. It is shown in this proposal that the thermal effects of sample expansion can be experimentally determined by making additional measurements with porous samples having the same mass and/or volume as the primary sample. By combining these results with independent measurements of the linear temperature coefficient and the computed temperature dependence of the Doppler coefficient the magnitude of the Doppler coefficient may be extracted from the data. These addiational measurements are also useful to experimentally determine the precision of the reactivity oscillator technique used to measure the reactivity effects of the heated sample.

Klann, P. G.↗
NASA NTRS1973

Theoretical and experimental studies of reentry plasmas

A viscous shock-layer analysis was developed and used to calculate nonequilibrium-flow species distributions in the plasma layer of the RAM vehicle. The theoretical electron-density results obtained are in good agreement with those measured in flight. A circular-aperture flush-mounted antenna was used to obtain a comparison between theoretical and experimental antenna admittance in the presence of ionized boundary layers of low collision frequency. The electron-temperature and electron-density distributions in the boundary layer were independently measured. The antenna admittance was measured using a four-probe microwave reflectometer and these measured values were found to be in good agreement with those predicted. Measurements were also performed with another type of circular-aperture antenna and good agreement was obtained between the calculations and the experimental results. A theoretical analysis has been completed which permits calculation of the nonequilibrium, viscous shock-layer flow field for a sphere-cone body. Results are presented for two different bodies at several different altitudes illustrating the influences of bluntness and chemical nonequilibrium on several gas dynamic parameters of interest. Plane-wave transmission coefficients were calculated for an approximate space-shuttle body using a typical trajectory.

Dunn, M. G.↗
NASA NTRS1973

Experimental investigation of orthotropic panel flutter at arbitrary yaw angles, and comparison with theory

Flutter characteristics for yaw angles between 15 deg and 90 deg were determined experimentally for two types of corrugation-stiffened panels: those with weak twisting stiffness and those with strong twisting stiffness. By mounting the panels on a remotely controlled turntable, good definition of the flutter boundaries was obtained by rotating the panels into and out of flutter. Flutter tests were conducted at M = 2 and M = 1.6. Before testing, vibration tests and analyses were also performed. The experimental flutter data is compared with flutter theory for orthotropic panels utilizing quasi-steady aerodynamics. Five different corrugated panels were tested consisting of one single skin panel having a length-to-width ratio of 5 on clamped supports and four different square double skin panels on discrete flexible supports. The investigation indicated that flutter speed for corrugated panels is highly dependent on yaw angle. Reasonable flutter correlation between analysis and test was obtained for moderate yaw angles, but extreme sensitivity to structural parameters made the correlation at large yaw angles uncertain.

Shyprykevich, P.↗
NASA NTRS1973

Study of an experimental technique for application to structural dynamic problems

An experimental program was conducted to determine the feasibility of using subscale plastic models to determine the response of full-scale aerospace structural components to impulsive, pyrotechnic loadings. A monocoque cylinder was impulsively loaded around the circumference of one end, causing a compressive stress wave to propagate in the axial direction. The resulting structural responses of two configurations of the cylinder (with and without a cutout) were recorded by photoelasticity, strain gages, and accelerometers. A maximum dynamic stress concentration was photoelastically determined and the accelerations calculated from strain-gage data were in good agreement with those recorded by accelerometers. It is concluded that reliable, quantitative structural response data can be obtained by the experimental techniques described in this report.

Snell, R. F.↗
NASA NTRS1973

Analytical and experimental studies of shock interference heating in hypersonic flows

An analytical and experimental study is presented of the aerodynamic heating resulting from six types of shock interference patterns encountered in high speed flow. Centerline measurements of pressure and heat transfer distributions on basic bodies were obtained in four wind tunnels for Mach numbers from 6 to 20, specific heat ratios from 1.27 to 1.67, and free stream Reynolds numbers from 3 million to 25.6 million per meter. Peak heating and peak pressures up to 17 and 7.5 times stagnation values, respectively, were measured. In general, results obtained from semiempirical methods developed for each of the six types of interference agreed with the experimental peaks.

Keyes, J. W.↗
NASA NTRS1973

Experimental investigation of liquid propellant dynamics in a double cylindrical tank

Experimental data are presented for verifying the computer program for computing propellant oscillation modes and frequencies for tanks of any shape, fill level, or orientation. The experimental apparatus including the tank, support and excitation system, and instrumentation is described along with the procedures. Results showing slosh forces and moments are tabulated for different fill heights. It was found that for the vertical tank excited along the long axis, the frequencies of the higher modes are significantly higher than with the tank tilted. Little difference was noted for excitation along the short axis.

Ransleben, G. F., Jr.↗
NASA NTRS1973

A critical review of the experimental data for developed free turbulent shear layers

Experimental shear layer data are reviewed and the results are compared to numerical predictions for three test cases. It was concluded from the study that many, if not most, of the apparent inconsistencies which exist in the interpretation of the experimental data for free shear layers result from confusing data taken in developed turbulent flows with those taken in transitional or developing flows. Other conclusions drawn from the study include the following: (1) The effects of Mach number are more uncertain primarily because of limited data and the absence of any turbulence measurements for supersonic shear layers. (2) The data available for heterogeneous shear layers are not sufficient to clearly establish the effect of density ratio on mixing rate.

Birch, S. F.↗
NASA NTRS1973

Experimental stress analysis of large plastic deformations in a hollow sphere deformed by impact against a concrete block

An experimental plastic strain measurement system is presented for use on the surface of high velocity impact test models. The system was used on a hollow sphere tested in impact against a reinforced concrete block. True strains, deviatoric stresses, and true stresses were calculated from experimental measurements. The maximum strain measured in the model was small compared to the true failure strain obtained from static tensile tests of model material. This fact suggests that a much greater impact velocity would be required to cause failure of the model shell structure.

Morris, R. E.↗
NASA NTRS1973

Experimental and analytical determination of stability parameters for a balloon tethered in a wind

Experimental and analytical techniques for determining stability parameters for a balloon tethered in a steady wind are described. These techniques are applied to a particular 7.64-meter-long balloon, and the results are presented. The stability parameters of interest appear as coefficients in linearized stability equations and are derived from the various forces and moments acting on the balloon. In several cases the results from the experimental and analytical techniques are compared and suggestions are given as to which techniques are the most practical means of determining values for the stability parameters.

Redd, L. T.↗
NASA NTRS1973

Experimental investigation of boundary layers in an axisymmetric, Mach 2.5, mixed-compression inlet

An experimental investigation has been made of the boundary layer flow in a supersonic axisymmetric inlet. The inlet was designed for Mach 2.5 and had a 60 percent internal supersonic area contraction. Porous bleed regions were incorporated into both the cowl and centerbody for boundary-layer control. Five bleed configurations were studied; these included bleed regions upstream of, across, and downstream of the experimentally determined shock-impingement points. The tests were conducted at tunnel unit Reynolds numbers of 8.2 million and 2.7 million per meter. Static-pressure measurements were made along the internal inlet surfaces. In addition to locating the position of the shocks, these measurements also showed local regions of expansion resulting from the suction bleed. Boundary-layer profiles were measured with translating pitot pressure probes located on both sides of the shock-impingement points on the cowl and centerbody. These measurements showed that the boundary-layer profiles were distorted in the vicinity of the terminal shock.

Hingst, W. R.↗
NASA NTRS1973

An experimental investigation of two-phase liquid oxygen pumping

The results of an experimental program to explore the feasibility of pumping two-phase oxygen (liquid and gas) at the pump inlet are reported. Twenty-one cavitation tests were run on a standard J-2 oxygen pump at the MSFC Components Test Laboratory. All tests were run with liquid oxygen 5 to 10 K above the normal boiling point temperature. During ten tests run at approximately at the pump inlet were noted before complete pump performance 50 percent of the nominal operating speed, two phase conditions were achieved. Vapor volumes of 40 to 50 percent at the pump inlet were noted before complete pump performance loss. The experimental results compared to predictions. Nine cavitation tests run at the nominal pump speed over a 5 K temperature range showed progressively lower net positive suction head (NPSH) requirements as temperature was increased. Two-phase operation was not achieved. The temperature varying NPSH data were used to calculate thermodynamic effects on NPSH, and the results were compared to existing data.

Gross, L. A.↗
NASA NTRS1972

Experimental evaluation of a 600 lbf spacecraft rocket engine.

Experimental results are presented for a long-duration-capability (1000-sec), space-storable, bipropellant liquid rocket motor burning fluorine/hydrazine or FLOX/monomethylhydrazine. The interrelationship between injected mixture ratio and the per cent film cooling on vacuum specific impulse performance and chamber heat transfer is given. Experimental sea level measurements are used to predict space vacuum performance based upon simplified JANNAF reference procedures. Dynamic combustion stability is demonstrated over a wide range of operating conditions. Analytical results of char penetration, erosion, and ablative wall temperature distributions are presented for prototype chamber designs.

Hoehn, F. W.↗
NASA NTRS1973

Experimental verification of the energy dissipation mechanism in acoustic dampers.

An experimental program is described which verifies the theoretical model that acoustic damping devices undergoing high intensity oscillations dissipate energy via jet kinetic losses. Pressure measurements within the damping devices and flow duct together with detailed surveys of the jet velocities provide the experimental confirmation. The theory accounts for duct flow effects, both steady and unsteady, as well as the jet dissipation. Discrepancies between theory and experiment can be traced to neglect of higher order terms or ignoring the difficult wall friction term in the case of the quarter-wave tube.

Tang, P. K.↗
NASA NTRS1973

Experimental evaluation of remote manipulator systems.

The objectives of the experimental studies described include an evaluation of existing anthropomorphic manipulators and several controller/display combinations. Inherent limitations of the 12-M type manipulator are identified and recommendations are made concerning manipulator and work site designs that will permit servicing and maintenance tasks to be performed by manipulators. Regions needing additional analytical and experimental investigations are identified. The experiments conducted are concerned with thruster replacement, battery replacement, compartment inspection, antenna installation, fluid coupling, and maneuvering and docking.

Fornoff, H.↗
NASA NTRS1973

Theoretical and experimental investigation of the performance of a fan-in-wing VTOL configuration

The incompressible-flow momentum theory is extended to the case of lifting fans. The resulting theory includes many of the known experimentally determined characteristics of fan-in-wing aircraft. These characteristics include the negligible effect of forward speed on fan thrust, the large momentum drag, and the generally inefficient performance throughout the transition speed range. Although mutual interference between the fans and the wing was totally neglected, the theory is confirmed by experimental results for the configuration tested. Examination of the results of an investigation of wall interference leads to the conclusion that the large fan-induced lift reported in many earlier investigations was largely the result of neglecting wall interference in the reduction of wind-tunnel data.

Heyson, H. H.↗
NASA NTRS1973

Experimental hingeless rotor characteristics at low advance ratio with thrust

An experimental investigation to determine the dynamic characteristics of a hingeless rotor operating at moderate to high lift was conducted on a small scale, 7.5-foot diameter, four-bladed hingeless rotor model in a 7 x 10-foot wind tunnel. The primary objective of this research program was the empirical determination of the rotor steady-state and frequency responses to swashplate and body excitations. Collective pitch was set from 0 to 20 degrees, with the setting at a particular advance ratio limited by the cyclic pitch available for hub moment trim. Advance ratio varied from 0.00 to 0.36 for blades with nondimensional first-flap frequencies at 1.15, 1.28 and 1.33 times the rotor rotation frequency. Several conditions were run with the rotor operating in the transition regime. Rotor response at high lift is shown to be generally nonlinear in this region. As a secondary objective an experimental investigation of the rotor response to 4/revolution swashplate excitations at advance ratios of 0.2 to 0.85 and at a nondimensional, first-flap modal frequency of 1.34 was also conducted, using the 7 x 10-foot wind tunnel. It is shown that 4/revolution swashplate inputs are a method for substantially reducing rotor-induced, shafttransmitted vibratory forces.

London, R. J.↗