Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “effect measure”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 415 records · Page 23
All sourcesNASA NTRSDOE OSTI
NASA NTRS1993

Another Nulling Hall-Effect Current-Measuring Circuit

Lightweight, low-power circuit provides noncontact measurement of alternating or direct current of many ampheres in main conductor. Advantages of circuit over other nulling Hall-effect current-measuring circuits is stability and accuracy increased by putting both analog-to-digital and digital-to-analog converters in nulling feedback loop. Converters and rest of circuit designed for operation at sampling rate of 100 kHz, but rate changed to alter time or frequency response of circuit.

Thibodeau, Phillip E.↗
NASA NTRS1992

Variation of seismic slip in the Gulf of California and the possible effect on geodetic measurements of Pacific-North American plate motion

A simple dislocation model is used to evaluate the variation of seismic slip in the Gulf of California and the possible effect on geodetic measurements of Pacific-North American plate motion by means of an estimation of the surface displacements due to typical transform events in the gulf. The results of this numerical calculation suggest that if a large transform event (about 1.5 x 10 exp 26 dyne cm) were to occur within 100 to 200 km of a geodetic baseline, the relative distance measurements could be affected by up to 15 mm. This is marginally at the error level of a few millimeters plus 2 parts in 10 exp 8 of baseline length for GOMEX measurements, which thus are sensitive only to the far-field displacement along the plate boundary.

Tajima, Fumiko↗
NASA NTRS1980

Analysis of flight test measurements in ground effect

Three sources of errors, introduced into the air-data measurements of altitude and airspeed as a result of ground proximity, are evaluated. It is shown that the primary error results from ground constraint of the wing lifting pattern. Smaller errors result from constraint of the flow over the fuselage and of the engine exhaust. Equations are derived to provide corrections for the three error contributions. The equations are general and can be applied to airplanes of different geometries operating in different conditions. Applications illustrating different types of flight operations (takeoff and landing) are presented using CV-990 data. Applications illustrating the effect of different static orifice locations (fuselage and nose-boom) are presented with YC-15 data. Finally, an application to trajectory reconstruction is illustrated using DC-10 data.

Parks, E. K.↗
NASA NTRS1977

Some measured and calculated effects of a tip vortex modification device on impulsive noise

The results of a recent wind tunnel test program to evaluate the effectiveness of the Tip Air Mass Injection (TAMI) system in modifying the blade tip vortex occurring during helicopter flight is described with attention to the effect of this modification on the impulsive noise. The measurement program is explained, and the correlation between experimental and predicted results is discussed. Topics considered include the effect of descent rate on noise pressure time histories, the effect of air mass injection on noise, and the analysis based on a dB(A) weighted approach. Impulsive noise generated by the interaction of a helicopter rotor blade and the concentrated tip vortex during forward flight descent is a primary contributor to acoustic annoyance as it draws early attention to the presence of the helicopter.

Pegg, R. J.↗
NASA NTRS1975

Methods for correcting microwave scattering and emission measurements for atmospheric effects

The author has identified the following significant results. Algorithms were developed to permit correction of scattering coefficient and brightness temperature for the Skylab S193 Radscat for the effects of cloud attenuation. These algorithms depend upon a measurement of the vertically polarized excess brightness temperature at 50 deg incidence angle. This excess temperature is converted to an equivalent 50 deg attenuation, which may then be used to estimate the horizontally polarized excess brightness temperature and reduced scattering coefficient at 50 deg. For angles other than 50 deg, the correction also requires use of the variation of emissivity with salinity and water temperature.

Komen, M.↗
NASA NTRS1980

An analysis of source structure effects in radio interferometry measurements

To begin a study of structure effects, this report presents a theoretical framework, proposes an effective position approach to structure corrections based on brightness distribution measurements, and analyzes examples of analytical and measured brightness distributions. Other topics include the effect of the frequency dependence of a brightness distribution on bandwidth synthesis (BWS) delay, the determination of the absolute location of a measured brightness distribution, and structure effects in dual frequency calibration of charged particle delays. For the 10 measured distributions analyzed, it was found that the structure effect in BWS delay at X-band (3.6 cm) can reach 30 cm, but typically falls in the range of 0 to 5 cm. A trial limit equation that is dependent on visibility was successfully tested against the 10 measured brightness distributions (seven sources). If the validity of this particular equation for an upper limit can be established for nearly all sources, the structure effect in BWS delay could be greatly reduced without supplementary measurements of brightness distributions.

Thomas, J. B.↗
NASA NTRS1996

Systematic Effects on Duration Measurements of Gamma-Ray Bursts

The parameters T(sub 90) and T(sub 50) have recently been introduced as a measurement of the duration of gamma-ray bursts. We present here a description of the method of measuring T(sub 90) and T(sub 50) and its application to gamma-ray bursts observed with the Burst and Transient Source Experiment (BATSE) onboard the Compton Gamma-Ray Observatory (CGRO). We use simulated as well as observed time profiles to address some of the possible systematic effects affecting individual T(sub 90) (T(sub 50)) measurements. We show that these systematic effects do not mimic those effects that would result from time dilation if the burst sources are at distances of several Gpc. We discuss the impact of these systematic effects on the T(sub 90) (T(sub 50)) distributions for the gamma-ray bursts observed with BATSE. We distinguish between various types of T(sub 90) (T(sub 50)) distributions, and discuss the ways in which distributions observed with different experiments can vary, even though the measurements for commonly observed bursts may be the same. We then discuss the distributions observed with BATSE and compare them to those observed with other experiments.

Koshut, Thomas M.↗
NASA NTRS2003

Convective Effects During Diffusivity Measurements in Liquids with An Applied Magnetic Field

Convective contamination of self-diffusion experiments with an applied magnetic field is considered using a two-dimensional axisymmetric model. Constant, uniform, and an additional non-uniform heat fluxes are imposed along the sidewall of the cylinder while constant heat loss occurs through the top and bottom. In this model, due to a very small thermal Peclet number, convective heat transfer is neglected, and the flow is steady and inertialess. Time-dependent concentration is solved for various values of the mass Peclet number, Pe(sub m), (the ratio between the convective transport rate and the diffusive transport rate) and different magnetic field strengths represented by the Hartmann number Ha. Normalized values of these diffusivities vs. effective Pe(sub m) are presented for different imposed temperature profiles. In all cases, the diffusivity value obtained through the simulated measurement increases as the effective Pe(sub m) increases. The numerical results suggest that an additional periodic flux, or hot and cold spots, can significantly decrease the convective contamination in our geometry.

Khine, Yu Yu↗
NASA NTRS1976

Turbulence excited frequency domain damping measurement and truncation effects

Existing frequency domain modal frequency and damping analysis methods are discussed. The effects of truncation in the Laplace and Fourier transform data analysis methods are described. Methods for eliminating truncation errors from measured damping are presented. Implications of truncation effects in fast Fourier transform analysis are discussed. Limited comparison with test data is presented.

Soovere, J.↗
NASA NTRS1987

Measurement of the effect of manufacturing deviations on natural laminar flow for a single engine general aviation airplane

Renewed interest in natural laminar flow (NLF) had rekindled designer concern that manufacuring deviations may destroy the effectiveness of NLF for an operational aircraft. Experiments are summarized that attemtped to measure total drag changes associated with three different wing surface conditions on an aircraft typical of current general aviation high performance singles. The speed power technique was first used in an attempt to quantify the changes in total drag. Predicted and measured boundary layer transition locations for three different wing surface conditions were also compared, using two different forms of flow visualization. The three flight test phases included: assessment of an unpainted airframe, flight tests of the same aircraft after painstakingly filling and sanding the wings to design contours, and similar measurement after this aricraft was painted. In each flight phase, transition locations were monitored using with sublimating chemicals or pigmented oil. Two-dimensional drag coefficients were estimated using the Eppler-Somers code and measured with a wake rake in a method very similar to Jones' pitot traverse method. The net change in two-dimensional drag coefficient was approximately 20 counts between the unpainted aircraft and the hand-smoothed aircraft for typical cruise flight conditions.

Source record↗
NASA NTRS1991

Heterodyne Doppler 1-micron lidar measurement of reduced effective telescope aperture due to atmospheric turbulence

A pulsed Nd:YAG bistatic focused-beam lidar allowing simultaneous heterodyne and direct detection of the same lidar returns has been experimentally employed to ascertain the effect of atmospheric turbulence on heterodyne and direct-detection lidar at 1 micron, by measuring the average carrier-to-noise ratio and statistical fluctuation level in the return signals under various experimental and atmospheric conditions. Atmospheric turbulence is found capable of reducing the lidar receiver's effective telescope aperture and heterodyne detection efficiency. This observed effective-aperture limitation functionally resembles predictions based on the Clifford and Wandzura (1981) heterodyne wavefront detection theory.

Chan, Kin Pui↗
NASA NTRS1988

Atmospheric effect on spectral signature - Measurements and corrections

Measurements of the atmospheric effect on the spectral signature of surface cover were conducted during hazy conditions over the Chesapeake Bay and its eastern shore. In the experiment the upward radiance was measured by an airborne scanning radiometer in nine spectral bands between 465 and 773 nm, above and below the haze layer. Simultaneous measurements of the aerosol optical thickness and its vertical distribution were conducted. The results of the measurements are used to study the spectral dependence of the atmospheric effect on remote sensing of water bodies and vegetated fields (forest, corn field, and pasture), and to verify theoretical predictions. It is suggested that the radiances over dark areas (e.g., water in the near IR and forest in the visible) can be used to derive the aerosol optical thickness as is done over oceans with the CZCS satellite images. Combined with climatological information, the derived optical thickness can be used to perform corrections of the atmospheric effect. Examples of the derivation of the aerosol optical thickness and correction of the upward radiances are given.

Kaufman, Yoram J.↗
NASA NTRS1995

NASA Tropical Rainfall Measurement Mission (TRMM): Effects of tropical rainfall on upper ocean dynamics, air-sea coupling and hydrologic cycle

This was a Tropical Rainfall Measurement Mission (TRMM) modeling, analysis and applications research project. Our broad scientific goals addressed three of the seven TRMM Priority Science Questions, specifically: What is the monthly average rainfall over the tropical ocean areas of about 10(exp 5) sq km, and how does this rain and its variability affect the structure and circulation of the tropical oceans? What is the relationship between precipitation and changes in the boundary conditions at the Earth's surface (e.g., sea surface temperature, soil properties, vegetation)? How can improved documentation of rainfall improve understanding of the hydrological cycle in the tropics?

Lagerloef, Gary↗
NASA NTRS1991

Thermomolecular effect on pressure measurements with orifices in transitional flow

Results are presented of a study carried out in order to verify a version of the method (presented at the 7th International Rarefied Gas Dynamics Symposium) for calculating the influence of thermomolecular flow on the pressures measured by means of orifices in walls exposed to rarefied gases. In these experiments, the 'orifice effect' is examined under conditions that are significantly different from those for which the semiempirical (SE) method of Kinslow and Potter (1971) was shown to be successful. Comparisons between the predicted results with flight data and the results obtained in the laboratory, combined with limited DSMC calculations, indicate that the SE method remains a useful tool which is relatively easy to apply and which gives good results when an appropriate energy accommodation coefficient is used.

Potter, J. L.↗
NASA NTRS1973

Method and apparatus for measuring solar activity and atmospheric radiation effects

A radiometric measuring system is described for observing solar activity, atmospheric attenuation, and atmospheric emission. Two highly directional microwave antennas are mounted side by-side on an equatorial mount which tracks the sun. One antenna is aimed directly at the sun to provide a sun temperature, and the other antenna is aimed at a slight angle to the sun antenna to provide a sky temperature reference. Signals from the two antennas are compared in a radiometric detecting system and provide information concerning solar activity and atmospheric attenuation and emission.

Haroules, G. G.↗
NASA NTRS1983

Multifrequency measurements of the effects of soil moisture, soil texture, and surface roughness

An experiment on remote sensing of soil moisture content was conducted over bare fields with microwave radiometers at the frequencies of 1.4, 5, and 10.7 GHz, during July-September of 1981. Three bare fields with different surface roughnesses and soil textures were prepared for the experiment. The experimental results show that the effect of surface roughness is to increase the soil's brightness temperature and to reduce the slope of regression between brightness temperature and moisture content. The slopes of regression for soils with different textures are found to be comparable and the effect of soil texture is reflected in the difference of regression line intercepts at brightness-temperature axis. Measurements on wet smooth bare fields give lower brightness temperatures at 5 than at 1.4 GHz. This phenomenon is not expected from current radiative transfer theory, using laboratory measurements of the relationship between permittivity and moisture content for different soil-water mixtures at frequencies of not greater than 5 GHz.

Wang, J. R.↗