Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “LUMINESCENCE”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 415 records · Page 23
All sourcesNASA NTRSDOE OSTI
NASA NTRS1975

Boron Arsenide and Boron Phosphide for High Temperature and Luminescent Devices

The crystal growth of boron arsenide and boron phosphide in the form of bulk crystals and epitaxial layers on suitable substrates is discussed. The physical, chemical, and electrical properties of the crystals and epitaxial layers are examined. Bulk crystals of boron arsenide were prepared by the chemical transport technique, and their carrier concentration and Hall mobility were measured. The growth of boron arsenide crystals from high temperature solutions was attempted without success. Bulk crystals of boron phosphide were also prepared by chemical transport and solution growth techniques. Techniques required for the fabrication of boron phosphide devices such as junction shaping, diffusion, and contact formation were investigated. Alloying techniques were developed for the formation of low-resistance ohmic contacts to boron phosphide. Four types of boron phosphide devices were fabricated: (1) metal-insulator-boron phosphide structures, (2) Schottky barriers; (3) boron phosphide-silicon carbide heterojunctions; and (4) p-n homojunctions. Easily visible red electroluminescence was observed from both epitaxial and solution grown p-n junctions.

Chu, T. L.↗
NASA NTRS1989

Light echoes and transient luminescence near SN 1987A

The discovery of two new light echoes from sheets of material behind supernova 1987A and present images of the progenitor's circumstellar shell are reported, indicating diffuse echoes from the star's red giant wind. The echo sheets' geometry explains well the behavior of SN 1987's 10-micron flux, but the circumstellar shell appears to be 70 percent larger than the prediction from the analysis of narrow UV emission lines. The sheets' recombination time show them relatively thin and dense. The data also constrain the existence of any fourth star in the Sanduleak -69 deg 202 system and show that the feature reported 8 arcsecs from the supernova is probably not an echo from a thin sheet in SN 1987A's foreground.

Crotts, Arlin P. S.↗
NASA NTRS1993

Boundary layer transition detection by luminescence imaging

In recent experiments we have demonstrated the feasibility of a new approach to boundary layer transition detection. This new approach employs the temperature dependence of certain photoluminescent materials in the form of a surface coating or 'paint' to detect the change in heat transfer characteristics that accompany boundary layer transition. The feasibility experiments were conducted for low subsonic to transonic Mach numbers on two-dimensional airfoil and flat plate configurations. Paint derived transition locations were determined and compared to those obtained from Preston pressure probe measurements. Artificial heating of the models was used to obtain transition temperature signatures suitable for the instrumentation available to us. Initial estimates show, however, that passive kinetic heating at high Mach numbers is a promising alternative.

Mclachlan, B. G.↗
NASA NTRS1951

On ionization and luminescence in flames

An explanation based upon reaction kinetics is presented to account for the deviation of measured ionization levels obtained from reflection experiments from the values computed assuming chemical equilibrium. The heat transfer to the unburned fuel is also considered.

Sanger, E↗
NASA NTRS1994

Making Porous Luminescent Regions In Silicon Wafers

Regions damaged by ion implantation stain-etched. Porous regions within single-crystal silicon wafers fabricated by straightforward stain-etching process. Regions exhibit visible photoluminescence at room temperature and might constitute basis of novel class of optoelectronic devices. Stain-etching process has advantages over recently investigated anodic-etching process. Process works on both n-doped and p-doped silicon wafers. Related development reported in article, "Porous Si(x)Ge(1-x) Layers Within Single Crystals of Si," (NPO-18836).

Fathauer, Robert W.↗
NASA NTRS1998

Rotating Pressure and Temperature Measurements on Scale Model Fans Using Luminescent Paints

Pressure and temperature sensitive paint (PSP, TSP) technology is a rapidly developing measurement technique that is widely accepted in external aerodynamic wind tunnel measurements. Almost all quantitative full field measurements have been on stationary surfaces. Rotating pressure and temperature measurements were successfully acquired during scale-model fan tests in the NASA Lewis Research Center 9 foot by 15 foot low speed wind tunnel at speeds as high as 9500 RPM. The use of PSP and TSP on rotating surfaces presents additional challenges to data acquisition. This paper describes in detail the techniques used to acquire global rotating pressure and temperature measurements and overcome the problems associated with this type of measurement. These include illumination and detection problems associated with moving surfaces, temperature dependence of PSP and limited emitted light available from short duration illumination sources. Solutions to these problems as well as pressure and temperature results will be discussed.

Bencic, Timothy J.↗
NASA NTRS2000

The Preparation Conditions of Chromium Doped ZnSe and Their Effect on The Infrared Luminescence Properties

We report the investigation by photoluminescence lifetime measurements of the near-IR emissions from a series of chromium-doped ZnSe samples, correlated to their preparation conditions. The samples were polycrystalline or single crystals prepared by post growth diffusion doping or single crystals doped during growth by the Physical Vapor Transport method. Room temperature lifetime values between 6 and 8 microseconds were measured for samples with Cr (2+) concentrations from low 10 (exp 17) to high 10 (exp 18) per cubic centimeter range. Lifetime data taken down to 78 K was found to be rather temperature independent, reconfirming previous reports indicating a quantum yield of the corresponding emission of close to 100% at room temperature. A strong decrease in the room temperature lifetime was found for chromium concentrations higher than 10 (exp 19) per cubic centimeter.

Burger, A.↗
NASA NTRS2000

The Preparation Conditions of Chromium Doped ZnSe and Their Effect on the Infrared Luminescence Properties

We report the investigation by photoluminescence lifetime measurements of the near-IR emissions from a series of chromium-doped ZnSe samples, correlated to their preparation conditions. The samples were polycrystalline or single crystals prepared by post growth diffusion doping or single crystals doped during growth by the physical vapor transport method. Room temperature lifetime values between 6 and 8 micro seconds were measured for samples with Cr2+ from low 10(exp 17) to high 10(exp 18) / cubic cm range. Lifetime data taken down to 78 K was found to be rather temperature independent, reconfirming previous reports indicating a quantum yield of the corresponding emission of close to 100% at room temperature. A strong decrease in the room temperature lifetime was found for chromium concentrations higher than 10(exp 19) / cubic CM.

Burger, A.↗
NASA NTRS2002

Electron-Induced Luminescence and X-Ray Spectrometer (ELXS) System for Life Detection

The ELXS concept is a novel, portable, micro-instrument targeted for the detection of mineralogic signatures of past water and extinct life on the surface of planetary bodies such as Mars. It is designed to perform rapid, in situ spectroscopy consuming extremely low energy per measurement. Additional information is contained in the original extended abstract.

Jurewicz, S. R.↗
NASA NTRS2003

Synthesis and Luminescence of Yellow/Orange-Emitting Poly[tris(2,5-dihexyloxy-l,4-phenylenevinylene)-alt-(l,3-phenylenevinylene)]s

Soluble yellow/orange-emitting poly[tris(2,5-dihexyloxy-1,4-phenylenevinylene)-alt- (1,3-phenylenevinylene)] derivatives (6) have been synthesized and characterized. These polymers contain oligo(p-phenylene vinylene) chromophores of equal conjugation length, which are linked to a m-phenylene unit. Optical comparison between 6 and its model compound 8 at room and low temperature reveals the similarity in their absorption and fluorescence band structures. The vibronic band structure of 6 is assigned with the aid of the spectroscopic data for 8 at low temperature. Polymers 6 are electroluminescent with emission lambda (sub max), at approximately 565 nm. By using the device configuration of ITO/PEDOT/6/Ca, the polymer exhibits an external EL efficiency as high as 0.46%.

Liao, Liang↗
NASA NTRS2004

Stimulated Mid-Infrared Luminescence Experiment: Contribution to the Study of Pre-Earthquake Phenomena and UV Absorption by Interstellar Dust

The work performed under this proposal is based on the experimentally supported observation - or inference - that a small fraction of the oxygen anions in silicate minerals in igneous and high-grade metamorphic rocks on Earth may not be in the usual 2- oxidation state, O(sup 2-), but in a higher oxidation state, as O(sup -). If this is true, the same would likely apply to the fine dust that fills the diffuse interstellar medium. An (sup -) in a matrix of O(sup 2-) represents a defect electron in the valence band, also known as positive hole or p-hole for short. When two O(sup -) combine, they undergo spin-pairing and form a positive hole pair, PHP. Chemically speaking a PHP is a peroxy bond. In an oxide matrix a peroxy bond takes the form of a peroxy anion, O2(sup 2-). In a silicate matrix it probably exists in the form of peroxy links between adjacent [SiO4] tetrahedral, O3Si00\SiO3. From a physics perspective a PHP is an electrically inactive point defect, which contains dormant electronic charge carriers. When the peroxy bond breaks, p-hole charge carriers are released. These p-holes are diffusively mobile and spread through the O 2p-dominated valence band of the otherwise insulating mineral matrix.

Freund, Friedemann↗
NASA NTRS1998

Luminescent Paints Used for Rotating Temperature and Pressure Measurements on Scale-Model High-Bypass-Ratio Fans

NASA Lewis Research Center is a leader in the application of temperature- and pressuresensitive paints (TSP and PSP) in rotating environments. Tests were recently completed on several scale model, high-bypass-ratio turbofans in Lewis' 9- by 15-Foot Low-Speed Wind Tunnel. Two of the test objectives were to determine the aerodynamic and acoustic performance of the fan designs. Using TSP and PSP, researchers successfully achieved fullfield aerodynamic loading profiles. The visualized loading profiles may help researchers identify factors contributing to the fans' performance and to the acoustic characteristics associated with the flow physics on the surface of the blades.

Bencic, Timothy J.↗
NASA NTRS2002

Effects of proton irradiation on luminescence and carrier dynamics of self-assembled III-V quatum dots

The effects of proton irradiation (1.5 MeV) on photoluminescence intensities and carrier dynamics were compared between III-V quantum dots and similar quantum well structures. A significant enhancement in radiation tolerance is seen with three-dimensional quantum confinement. Measurements were carried out in different quantum dot (QD) structures, varying in material (InGaAs/GaAs and InAlAs/AlGaAs), QD surface density (4x10^8 to 3x10'^10 cm^-2), and substrate orientation [(100) and (311) B]. Similar trends were observed for all QD samples. A slight increase in PL emission after low to intermediate proton doses, are also observed in InGaAs/GaAs (100) QD structures. The latter is explained in terms of more efficient carrier transfer from the wetting layer via radiation-induced defects.

nanotechnology DLTS optical properties pn diodes q↗