Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Angle of Attack”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 415 records · Page 23
All sourcesNASA NTRSDOE OSTI
NASA NTRS1972

Determination of angles of attack and sideslip from radar data and a roll-stabilized platform

Equations for angles of attack and sideslip relative to both a rolling and nonrolling body axis system are derived for a flight vehicle for which radar and gyroscopic attitude data are available. The method is limited to application where a flat, nonrotating earth may be assumed. The gyro measures attitude relative to an inertial reference in an Euler angle sequence. In particular, a pitch, yaw, and roll sequence is used as an example in the derivation. Sample calculations based on flight data are presented to illustrate the method. Results obtained with the present gyro method are compared with another technique that uses onboard camera data.

Preisser, J. S.↗
NASA NTRS1993

Development of an engineering level prediction method for high angle of attack aerodynamics

The present work is concerned with predicting the unsteady flow considered to be the cause of the structural failure of twin vertical tail aircraft. An engineering tool has been produced for high angle of attack aerodynamics using the simplest physical models. The main innovation behind this work is its emphasis on the modeling of two key aspects of the dominant physics associated with high angle-of-attack airflows, namely unsteady separation and vortex breakdown.

Reisenthel, Patrick H.↗
NASA NTRS1987

Mach 6 experimental and theoretical stability and performance of a cruciform missile at angles of attack up to 65 degrees

An experimental and theoretical investigation of the longitudinal and lateral-directional stability and control of an axisymmetric cruciform-finned missile has been conducted at Mach 6. The angle-of-attack range extended from 20 to 65 deg to encompass maximum lift. Longitudinal stability, performance, and trim could be accurately predicted with the fins at a fin roll angle of 0 deg but not when the fins were at a fin roll angle of 45 deg. At this roll angle, windward fin choking occurred at angles of attack above 50 deg and reduced the effectiveness of the fins and caused pitch-up.

Edward R Hartman↗
NASA NTRS2013

A CFD Database for Airfoils and Wings at Post-Stall Angles of Attack

This paper presents selected results from an ongoing effort to develop an aerodynamic database from Reynolds-Averaged Navier-Stokes (RANS) computational analysis of airfoils and wings at stall and post-stall angles of attack. The data obtained from this effort will be used for validation and refinement of a low-order post-stall prediction method developed at NCSU, and to fill existing gaps in high angle of attack data in the literature. Such data could have potential applications in post-stall flight dynamics, helicopter aerodynamics and wind turbine aerodynamics. An overview of the NASA TetrUSS CFD package used for the RANS computational approach is presented. Detailed results for three airfoils are presented to compare their stall and post-stall behavior. The results for finite wings at stall and post-stall conditions focus on the effects of taper-ratio and sweep angle, with particular attention to whether the sectional flows can be approximated using two-dimensional flow over a stalled airfoil. While this approximation seems reasonable for unswept wings even at post-stall conditions, significant spanwise flow on stalled swept wings preclude the use of two-dimensional data to model sectional flows on swept wings. Thus, further effort is needed in low-order aerodynamic modeling of swept wings at stalled conditions.

Petrilli, Justin↗
NASA NTRS1986

Mach 6 experimental and theoretical stability and performance of a finned cylindrical body at angles of attack up to 65 deg

A theoretical and experimental investigation of the longitudinal and lateral-directional stability and control of a finned cylindrical body has been conducted at Mach 6. The angle-of-attack range extended from 20 to 65 deg. to encompass maximum lift. Stability, performance, and trim could be accurately predicted with the fins in the + arrangement but this was not the case when the fins were in the x orientation where windward fin choking occurred at angles of attack above 50 deg. reducing their effectiveness and causing pitch up.

Hartman, E. R.↗
NASA NTRS1991

Forebody tangential blowing for control at high angles of attack

A feasibility study to determine if the use of tangential leading edge blowing over the forebody could produce effective and practical control of the F-18 HARV aircraft at high angles of attack was conducted. A simplified model of the F-18 configuration using a vortex-lattice model was developed to obtain a better understanding of basic aerodynamic coupling effects and the influence of forebody circulation on lifting surface behavior. The effect of tangential blowing was estimated using existing wind tunnel data on normal forebody blowing and analytical studies of tangential blowing over conical forebodies. Incorporation of forebody blowing into the flight control system was investigated by adding this additional yaw control and sideforce generating actuator into the existing F-18 HARV simulation model. A control law was synthesized using LQG design methods that would schedule blowing rates as a function of vehicle sideslip, angle of attack, and roll and yaw rates.

Kroo, I.↗
NASA NTRS1991

Prediction of noise field of a propfan at angle of attack

A method for predicting the noise field of a propfan operating at an angle of attack to the oncoming flow is presented. The method takes advantage of the high-blade-count of the advanced propeller designs to provide an accurate and efficient formula for predicting their noise field. The formula, which is written in terms of the Airy function and its derivative, provides a very attractive alternative to the use of numerical integration. A preliminary comparison shows rather favorable agreement between the predictions from the present method and the experimental data.

Envia, Edmane↗
NASA NTRS1992

Measurements of the unsteady vortex flow over a wing-body at angle of attack

Measurements of the unsteady vortex flow over a wing-body at high angles of attack were carried out on a generic test model of a pointed body of revolution with double-delta wings. Vortex patterns and trajectories were quantified from digitized laser sheet video images. The velocity-field measurements showed the jetlike flow in the unburst vortex, unsteady secondary structures below the primary core, and then the reversed flow in the burst vortex. Results of hot-film anemometry revealed the presence of peak frequencies in the velocity spectra over the wing and near the trailing edge, which varied linearly with freestream speed and increased as the measurement point moved upstream. Good Strouhal correlation was found with previous results obtained for a smaller generic wing-body model.

Debry, Benoit↗
NASA NTRS1928

Wind tunnel force tests in wing systems through large angles of attack

Force tests on a systematic series of wing systems over a range of angle of attack from minus forty-five degrees to plus ninety degrees are covered in this report. The investigation was made on monoplane and biplane wing models to determine the effects of variations of tip shape, aspect ratio, flap setting, stagger, gap, decalage, sweepback, and airfoil profile.

Wenzinger, Carl J↗
NASA NTRS1949

An NACA Vane-Type Angle-of-Attack Indicator for use at Subsonic and Supersonic Speeds

A vane-type angle-of-attack indicator suitable for measurements at both subsonic and supersonic speeds has been developed by the National Advisory Committee for Aeronautics. A brief history is given of the development, and a wind-tunnel calibration of the indicator is presented, together with a discussion of the corrections to be applied to the indicated readings.

Mitchell, Jesse L.↗
NASA NTRS1994

Flow analysis for the nacelle of an advanced ducted propeller at high angle-of-attack and at cruise with boundary layer control

An axisymmetric panel code and a three dimensional Navier-Stokes code (used as an inviscid Euler code) were verified for low speed, high angle of attack flow conditions. A three dimensional Navier-Stokes code (used as an inviscid code), and an axisymmetric Navier-Stokes code (used as both viscous and inviscid code) were also assessed for high Mach number cruise conditions. The boundary layer calculations were made by using the results from the panel code or Euler calculation. The panel method can predict the internal surface pressure distributions very well if no shock exists. However, only Euler and Navier-Stokes calculations can provide a good prediction of the surface static pressure distribution including the pressure rise across the shock. Because of the high CPU time required for a three dimensional Navier-Stokes calculation, only the axisymmetric Navier-Stokes calculation was considered at cruise conditions. The use of suction and tangential blowing boundary layer control to eliminate the flow separation on the internal surface was demonstrated for low free stream Mach number and high angle of attack cases. The calculation also shows that transition from laminar flow to turbulent flow on the external cowl surface can be delayed by using suction boundary layer control at cruise flow conditions. The results were compared with experimental data where possible.

Hwang, D. P.↗
NASA NTRS1976

An investigation to determine the pressure distribution on the 0.0137 scale solid rocket booster forebody (MSFC model 467) at angles of attack at or near 90 deg and high Reynolds numbers in the MSFC High Reynolds Number Wind Tunnel (SA29F)

An aerodynamic investigation was conducted in the MSFC High Reynolds Number Wind Tunnel to determine the pressure distribution over the foresection of the current 146 inch diameter shuttle SRB. The test model consisted of a 0.0137 scale version of the SRB nose cone and a forward portion of the cylindrical body which was approximately 2.7 calibers in length. The pressure distributions are plotted as a function of longitudinal station ratioed to body diameter and circumferential location for each angle of attack and Mach number. A Reynolds number variation study was made for Mach numbers of 0.4 and 0.6 at an angle of attack of 270 deg and roll angle of 180 deg.

Ramsey, P. E.↗
NASA NTRS1993

Development of high-angle-of-attack nose-down pitch control margin design guidelines for combat aircraft

A broad research program to identify maneuvering requirements for advanced fighters and the corresponding design criteria to aid in making critical design tradeoffs is being conducted under the NASA High-Angle-of-Attack Technology Program (HATP). As part of this activity, NASA and the U.S. Navy are conducting cooperative research to develop high-angle-of-attack control margin requirements. This paper will summarize the status of this program. Following some background information, the simulation study conducted to develop a set of preliminary guidelines for nose-down pitch control is reviewed, and the results of some very limited flight tests are described.

Ogburn, Marilyn E.↗
NASA NTRS1972

Aerodynamic static stability characteristics, fin effectiveness, and fin location of the MSFC 33-foot pressure fed booster at high angles of attack

Experimental aerodynamic investigations were conducted in the NASA/MSFC 14 x 14 inch trisonic wind tunnel during early February 1972 on a 0.00280 scale model of the MSFC 33-foot diameter space shuttle pressure fed booster configuration. The basic configuration tested was a 40 deg cone/cylinder/7 deg frustrum designated the MSFC 33 foot pressure fed booster. Six component aerodynamic force and moment data were recorded over a Mach number range from 0.9 to 5.0 at angles of attack from +20 to +90 at 0 deg sideslip and over a sideslip range from -10 to +10 deg at 30, 50, 60 and 80 deg angles of attack. Primary configuration variables were fin deflection angle and vertical position on the frustrum.

Hamilton, T.↗
NASA NTRS2001

Inviscid Flow Computations of the Shuttle Orbiter for Mach 10 and 15 and Angle of Attack 40 to 60 Degrees

This report documents the results of a computational study done to compute the inviscid longitudinal aerodynamic characteristics of the Space Shuttle Orbiter for Mach numbers 10 and 15 at angles of attack of 40, 50, 55, and 60 degrees. These computations were done to provide limited aerodynamic data in support of the Orbiter contingency abort task. The Orbiter had all the control surfaces in the undeflected position. The unstructured grid software FELISA was used for these computations with the equilibrium air option. Normal and axial force coefficients and pitching moment coefficients were computed. The hinge moment coefficients of the body flap and the inboard and outboard elevons were also computed. These results were compared with Orbiter Air Data Book (OADB) data and those computed using GASP. The comparison with the GASP results showed very good agreement in Cm and Ca at all the points. The computed axial force coefficients were smaller than those computed by GASP. There were noticeable differences between the present results and those in the OADB at angles of attack greater than 50 degrees.

Prabhu, Ramadas K.↗