Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “AMPLIFICATION”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 415 records · Page 23

Apollo 9 multiband photography experiment S065

Fourier analysis was applied to microdensitometer scans of a selected region of one SO65 frame in each of the three black-and-white bands. The approach was unique because a somewhat arbitrary section of the image was used and not limited to available targets as in edge analysis. Comparison of duplicates and calculation of absolute SO65 MTF were done by applying linear systems theory to the spatial spectra of the image scans. It was found that the duplication process was nonlinear and resulted in general amplification of spatial frequency modulation. However, the increase in modulation was offset by a corresponding increase in the granularity of the copies. The amount of increase seemed to be related to the initial granularity, but a direct relationship was not verified. Band-to-band comparison of image quality was achieved in the form of signal-to-noise ratio curves as a function of spatial frequency for each band. From this standpoint the DD band was an order of magnitude better than the other two. These were several factors that restricted the analysis of the Apollo 9 imagery. Among these were the lack of precise sensitometric and optical system data on the high altitude photography. In addition it was determined that there was only one simultaneous pair of high altitude and SO65 frames. Finally, the original SO65 photography was not available for scanning (for obvious reasons), thus eliminating a reference base for granularity and SO65 MTF determination.

Schowengerdt, R. A.↗

Shock interference heating in hypersonic flows.

This paper presents results of a theoretical and experimental study of shock interference heating which encompassed a variety of basic body shapes and flow conditions. Measurements of pressure and heat transfer were obtained in four wind tunnels at NASA-Langley Research Center. These data cover the Mach number range from 6 to 20, and specific heat ratio range from 1.20 to 1.67. Peak heating measurements up to 17 times ordinary stagnation point rates and pressure peaks up to 8 times freestream pitot pressure were recorded. Numerical results from computer codes developed for each of the six types of interference compare favorably with most of the experimental data. A theoretical parametric study determined the effects of Mach number, specific heat ratio, and impinging shock strength on amplification of pressure and heat transfer. The results of this study show that shock interference is important for hypersonic vehicles such as the Space Shuttle. The problem is aggravated by changes along the flight path of the particular type of interference and the location of regions of peak heat transfer and pressure.

Hains, F. D.↗

The plasma physics of the Jovian decameter radiation.

We have assumed that the decameter radiation from Jupiter is produced near the local electron gyrofrequency and is amplified as it propagates out of the Jovian magnetosphere. We have derived the growth rate for radiation that propagates almost perpendicular to the direction of the magnetic field. When the electrons are described by a loss-cone distribution function, the growth rate is large enough to lead to a large amplification factor over a source of 100-4000 km, depending on the choice of parameters. Because we expect low-energy electrons to be trapped in the Jovian dipole field regardless of the position of the satellite Io, we maintain that this model provides a plausible mechanism for the decametric radiation not associated with Io.

Goldstein, M. L.↗

A wide-band Gunn-effect CW waveguide amplifier.

Broad-band CW amplification with Gunn diodes in waveguide circuits has been obtained, with power gains typically between 10 and 15 dB and half-power bandwidths of more than 1 GHz. It is found that amplifier performance can be modeled with fair accuracy using a rough characterization for the diode parameters.

Sene, A.↗

Response of convectively controlled burning to nonlinear disturbances.

A process where energy release rate is proportional to the square root of the Reynolds number of a burning particle or surface is used to demonstrate some distinctive dynamic properties of a disturbed convectively controlled burning process. The instantaneous energy release rates caused by assumed periodic flow field disturbances are numerically evaluated and examined. Correlation coefficients which express the energy released in-phase with the pressure disturbance are evaluated and analytical solutions for these coefficients are derived. The response of the process is shown to be highly sensitive to the harmonic distortion of the disturbance. For some disturbances the energy released in-phase with the pressure disturbance is an order of magnitude larger than that for linear (sinusoidal) disturbances. The results show that harmonic distortion increases the coupling between the burning process and the flow field. This amplifying effect of harmonic distortion is suppressed when a disturbance becomes steep-fronted; therefore, steepening can act to limit the equilibrium amplitudes in disturbed systems. Amplification is also suppressed when the velocity disturbance is phase shifted with respect to the pressure disturbance or when the process is exposed to a high steady velocity.

Heidmann, M. F.↗

A new dry biomedical electrode

Electronic circuitry contains new operational amplifier which incorporates monolithic super-gain transistors. Electrode does not provide voltage amplification; instead, it acts as current amplifier to make it possible to pick up electrical potentials from surface of highly resistant dry skin.

Luce, R. S.↗

Data-matched filter

After amplification and normalization, incoming data bits are fed, alternately, to pair of integrators. While one integrator is operating, content of other is on hold, sample, and dump. Clock derived in bit-timing extractor times and controls integrators. Frequency of clock is one-half data rate.

Scheinberg, N. R.↗

Microwave device investigations

Materials, devices and novel schemes for generation, amplification and detection of microwave and millimeter wave energy are studied. Considered are: (1) Schottky-barrier microwave devices; (2) intermodulation products in IMPATT diode amplifiers; and (3) harmonic generation using Read diode varactors.

Choudhury, K. K. D.↗

Analysis of the backscatter spectrum in an ionospheric modification experiment

Predictions of the backscatter spectrum are compared, including effects of ionospheric inhomogeneity with experimental observations of incoherent backscatter from an artificially heated region. Calculations show that the strongest backscatter echo received is not, in fact, from the reflection level, but from a region some distance below (about 0.5 km for an experiment carried out at Arecibo), where the pump wave from a HF transmitter approximately 100 kW) is below the threshold for parametric amplification. By taking the standing wave pattern of the pump into account, asymmetry is explained of the up-shifted and down-shifted plasma lines in the backscatter spectrum, and the several peaks typically observed in the region of the spectrum near the HF transmitter frequency.

Kim, H.↗

Data acquisition and editing for the celestial mechanics experiment

A radio tracking subsystem is reported in which the critical elements are the frequency standard and its distribution subsystem, as they ultimately limit the accuracy of both range and Doppler measurements. A rubidium vapor standard serves as the primary reference. After frequency multiplication to S-band and additional amplification, the carrier is transmitted to the spacecraft where a phase-locked receiver-transmitter system filters the signal, introduces a slight frequency shift, and retransmits it to the ground. Doppler is measured by comparing the received frequency with that being transmitted.

Martin, W. L.↗

Aircraft wake dissipation by sinusoidal instability and vortex breakdown.

Sinusoidal instability of aircraft trailing vortices was induced by differentially oscillating inboard and outboard flaps on a model wing in a ship towing tank. Measured amplification rates qualitatively agree with theoretical predictions. Axial velocities in the vortex core were directed towards the wing and measured to be approximately 25% of the tow speed. Vortex breakdown was observed to occur along trailers undergoing sinusoidal instability near but ahead (towards the wing) of positions of maximum trailer separation. It is shown that axisymmetric pressure gradients are imposed along the vortex core by the other sinusoidally deformed trailer and are responsible for the observed changes in core diameter. A theoretical model predicts the short-time behavior of the vortex core and shows that the response of the vortex depends crucially on the axial velocity in the vortex.

Bilanin, A. J.↗

Design and performance characteristics of the Vertical Temperature Profile Radiometer /VTPR/ for atmospheric temperature soundings.

Description of the design and operation of a radiometer which derives atmospheric temperature profiles on the basis of spectral measurements in eight optical filter channels. The radiometer achieves its eight-channel capability by sequentially viewing the eight optical filters mounted in a rotating filter wheel, with a single IR detector and electronic amplification channel processing the signal for all the filters. The advantages and disadvantages of this sequential approach as compared to eight 'parallel' radiometric channels are discussed. The proposed radiometer provides a relative calibration accuracy between seven out of the eight channels of better than 0.1% rms of the full dynamic range. The absolute accuracy achievable between in-flight calibrations of six minutes, or between two-hour calibrations using optical temperature correction factors, is better than an rms value of 0.15% of full scale. The radiometric correlation between the in-flight calibration source of the instrument and a reference standard blackbody is better than an rms value of 0.5% of full scale.

Falbel, G.↗

Thin-film temperature sensor.

A new device has been developed for sensing small and rapid temperature changes accompanying biochemical reactions. The active element consists of an evaporated thin-film capacitor having a relatively strong temperature dependence. This dependence is derived from electron trapping effects in the thin amorphous dielectric film. A voltage output of at least 50 mV/deg can be obtained prior to amplification by using a resonant ac bridge circuit operating at 100 kHz. The corresponding noise output for a 10 kHz bandwidth can with an optimum circuit be as low as 4 microvolts. Therefore, the minimum detectable temperature change would be 80 microdegrees at 10 kHz. Rapid thermal response is assured by supporting the thin-film capacitor on a thin anodic tantalum oxide film suspended across an electrolytically etched window in a tantalum foil.

Maserjian, J.↗

RCS jet-flow field interaction effects on the aerodynamics of the space shuttle orbiter

A study was conducted to determine the external effects caused by operation of the reaction control system during entry of the space shuttle orbiter. The effects of jet plume-external flow interactions were emphasized. Force data were obtained for the basic airframe characteristics plus induced effects when the reaction control system is operating. Resulting control amplification and/or coupling were derived and their effects on the aerodynamic stability and control of the orbiter and the reaction control system thrust were determined.

Rausch, J. R.↗

Developable images produced by X-rays using the nickel-hypophosphite system. 3: The latent image and trapped hydrogen

The hydrogen trapped in X-irradiated hypophosphites, phosphites, formates, oxalates, a phosphate, and some organic compounds was vacuum extracted and measured quantitatively with a mass spectrometer. After extraction, normally developable salts were found to be still developable. Thus, the latent image is not the trapped hydrogen but a species of the type HPO(-)2. The amplification factor for irradiated hypophosphites is about 100. A narrow range of wavelengths (at about 0.07 nm, 0.7 A) is responsible for the formation of the latent image.

May, C. E.↗

Fluidics research, including vortex and jet pipe valves

The research at the Systems and Control Laboratory is reported. Topics discussed include: response characteristics of laminar fluidic amplifiers, power amplification with a vortex valve, pulse-supply-mode fluidics, speed control system employing a jet pipe valve, and the fluidics reference center.

Source record↗

Multifunction audio digitizer

An illustrative embodiment of the invention includes apparatus which simultaneously produces both direct delta modulation and pulse code modulation. An input signal, after amplification, is supplied to a window comparator which supplies a polarity control signal to gate the output of a clock to the appropriate input of a binary up-down counter. The control signals provide direct delta modulation while the up-down counter output provides pulse code modulation.

Monford, L. G., Jr.↗