Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Transients”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 397 records · Page 22
All sourcesNASA NTRSDOE OSTI
NASA NTRS1974

Digital computer study of nuclear reactor thermal transients during startup of 60-kWe Brayton power conversion system

A digital computer study was made of reactor thermal transients during startup of the Brayton power conversion loop of a 60-kWe reactor Brayton power system. A startup procedure requiring the least Brayton system complication was tried first; this procedure caused violations of design limits on key reactor variables. Several modifications of this procedure were then found which caused no design limit violations. These modifications involved: (1) using a slower rate of increase in gas flow; (2) increasing the initial reactor power level to make the reactor respond faster; and (3) appropriate reactor control drum manipulation during the startup transient.

Jefferies, K. S.↗
NASA NTRS1973

Transient boiling heat transfer in saturated liquid nitrogen and F113 at standard and zero gravity

Transient and steady state nucleate boiling in saturated LN2 and F113 at standard and near zero gravity conditions were investigated for the horizontal up, vertical and horizontal down orientations of the heating surface. Two distinct regimes of heat transfer mechanisms were observed during the interval from the step increase of power input to the onset of nucleate boiling: the conduction and convection dominated regimes. The time duration in each regime was considerably shorter with LN2 than with F113, and decreased as heat flux increased, as gravity was reduced, and as the orientation was changed from horizontal up to horizontal down. In transient boiling, boiling initiates at a single point following the step increase in power, and then spreads over the surface. The delay time for the inception of boiling at the first site, and the velocity of spread of boiling varies depending upon the heat flux, orientation, body force, surface roughness and liquid properties, and are a consequence of changes in boundary layer temperature levels associated with changes in natural convection. Following the step increase in power input, surface temperature overshoot and undershoot occur before the steady state boiling temperature level is established.

Oker, E.↗
NASA NTRS1974

Effects of a transient sea surface temperature anomaly on the energetics of the Mintz-Arakawa model atmosphere

The possible response of the atmosphere, as simulated by the two level Mintz-Arakawa global general circulation model, to a transient North Pacific sea surface temperature anomaly is investigated in terms of the energetics both in the spatial and wave number domains. Results indicate that the transient SST variations of reasonable magnitude in the North Pacific Ocean can induce a disturbing effect on the global energetics both in the spatial and wave number domains. The ability of the two level Mintz-Arakawa model to simulate the atmospheric energetics is also examined. Except in the tropics, the model exhibits a reasonable and realistic energy budget.

Chow, S. H.↗
NASA NTRS1974

Computer experiments on periodic systems identification using rotor blade transient flapping-torsion responses at high advance ratio

Systems identification methods have recently been applied to rotorcraft to estimate stability derivatives from transient flight control response data. While these applications assumed a linear constant coefficient representation of the rotorcraft, the computer experiments described in this paper used transient responses in flap-bending and torsion of a rotor blade at high advance ratio which is a rapidly time varying periodic system.

Hohenemser, K. H.↗
NASA NTRS1973

The initiation of boiling during pressure transients

The initiation of boiling of water on metal surfaces during pressure transients has been investigated. The data were obtained by a new technique in which light beam fluctuations and a pressure signal were simultaneously recorded on a dual beam oscilloscope. The results obtained agreed with those obtained using high speed photography. It was found that, for water temperatures between 90-150 C, the wall superheat required to initiate boiling during a rapid pressure transient was significantly higher than required when the pressure was slowly reduced. This result is explained by assuming that a finite time is necessary for vapor to fill the cavity at which the bubble originates. Experimental measurements of this time are in reasonably good agreement with calculations based on the proposed theory. The theory includes a new procedure for estimating the coefficient of vaporization.

Weisman, J.↗
NASA NTRS1974

Transient and steady-state velocity of domain walls for a complete range of drive fields

Approximate analytic solutions for transient and steady-state 180 deg domain wall motion in bulk magnetic material are obtained from the dynamic torque equations with a Gilbert damping term. The results for the Walker region in which the transient solution approaches the familiar Walker steady-state solution are presented in a slightly new form for completeness. An analytic solution corresponding to larger drive fields predicts an oscillatory motion with an average value which decreases with drive field for reasonable values of the damping parameter. These results agree with those obtained by a computer solution of the torque equation and those obtained with the assumption of a very large anisotropy field.

Bourne, H. C., Jr.↗
NASA NTRS1975

Finite difference methods for transient signal propagation in stratified dispersive media

Explicit difference equations are presented for the solution of a signal of arbitrary waveform propagating in an ohmic dielectric, a cold plasma, a Debye model dielectric, and a Lorentz model dielectric. These difference equations are derived from the governing time-dependent integro-differential equations for the electric fields by a finite difference method. A special difference equation is derived for the grid point at the boundary of two different media. Employing this difference equation, transient signal propagation in an inhomogeneous media can be solved provided that the medium is approximated in a step-wise fashion. The solutions are generated simply by marching on in time. It is concluded that while the classical transform methods will remain useful in certain cases, with the development of the finite difference methods described, an extensive class of problems of transient signal propagating in stratified dispersive media can be effectively solved by numerical methods.

Lam, D. H.↗
NASA NTRS1975

The light curve of a transient X-ray source

The Ariel-V satellite monitored the X-ray light curve of A1524-62 almost continuously from 40 days prior to maximum light until its disappearance below the effective experimental sensitivity. The source exhibited maximum light on approximately 4 December 1974, at a level of 0.9 the apparent magnitude of the Crab Nebula in the energy band 3-6 keV. Although similar to previously reported transient sources with a decay time constant of approximately 2 months, the source exhibited an extended, variable pre-flare on-state of about 1 month at a level of greater than approximately 0.1 maximum light. The four bright (greater than 0.2 of the Crab Nebula) transient sources observed during the first half-year of Ariel-V operation are indicative of a galactic disk distribution, and a luminosity at maximum in excess of 10 to the 37th power ergs/sec.

Kaluzienski, L. J.↗
NASA NTRS1974

Transient and steady-state velocity of domain walls for a complete range of drive fields

Approximate analytic solutions for transient and steady-state 180 deg domain-wall motion in bulk magnetic material are obtained from the dynamic torque equations with a Gilbert damping term. The results for the Walker region in which the transient solution approaches the familiar Walker steady-state solution are presented in a slightly new form for completeness. An analytic solution corresponding to larger drive fields predicts an oscillatory motion with an average value of the velocity which decreases with drive field for reasonable values of the damping parameter. These results agree with those obtained by others from a computer solution of the torque equation and those obtained by others with the assumption of a very large anisotropy field.

Bourne, H. C., Jr.↗
NASA NTRS1975

Transient flight flutter test of a wing with tip tanks

Wing flutter was encountered during flight testing of the F2H-2 airplane with full wing tip tanks. As a result, more refined theoretical analysis as well as flight flutter tests were initated to establish corrective measures and to experimentally verify the stability of the improved system. The results from the flight flutter tests, utilizing the transient response technique, are presented. The method of excitation consisted of abrupt deflections of the ailerons resulting from stick bangs and data were measured by wing tip accelerometers. A comparison of the results with theoretical predictions is presented and indicates that reasonably good correlation was obtained. The influence on wing flutter of tip tank fuel transfer cycle, which was incorporated to control the center of gravity range of the tank during defueling, is indicated by the measured results and compared with the theory. The final configuration utilized a transfer cycle which was proven stable as a result of flight flutter testing. It is concluded that transient response measurements resulting from stick bangs provide a reasonably reliable and safe technique of flight flutter testing for wings with external tanks or heavy stores.

Werdes, R. J.↗
NASA NTRS1975

Shuttle LOX loading transient study. Task 2 milestone report. National space and technology laboratories (NSTL) LOX loading facility analysis

Transient thermodynamic analyses were made of the LOX loading system proposed for the space shuttle main propulsion test article (MPTA). This system is made up of a LOX replenish system and a main LOX line which include the barge tank, the lines, pumps, and valves between the barge and the orbiter (ORB) ground service equipment (GSE) interface, the MPTA fill system, the space shuttle main engine (SSME) chilldown bleed system, and the GSE vent system. System analyses include predictions of system performance sensitivity to operating sequence and LOX flowrate, temperature, and quality at the ORB/GSE interface. The transient thermodynamic conditions at the SSME feed line entrance, ET entrance (tank bottom), and the SSME bleed/GSE vent TEE are also included. The analyses are based on continuous SSME bleed flow during GSE facility chilldown.

Glasgow, V. L.↗
NASA NTRS1975

STOL aircraft transient ground effects. Part 1: Fundamental analytical study

The first phases of a fundamental analytical study of STOL ground effects were presented. Ground effects were studied in two dimensions to establish the importance of nonlinear effects, to examine transient aspects of ascent and descent near the ground, and to study the modelling of the jet impingement on the ground. Powered lift system effects were treated using the jet-flap analogy. The status of a three-dimensional jet-wing ground effect method was presented. It was shown, for two-dimensional unblown airfoils, that the transient effects are small and are primarily due to airfoil/freestream/ground orientation rather than to unsteady effects. The three-dimensional study showed phenomena similar to the two-dimensional results. For unblown wings, the wing/freestream/ground orientation effects were shown to be of the same order of magnitude as for unblown airfoils. This may be used to study the nonplanar, nonlinear, jet-wing ground effect.

Goldhammer, M. I.↗
NASA NTRS1975

SSME turbopump technology improvements via transient rotordynamic analysis

The rotordynamic behavior of the high pressure oxygen turbopump and high pressure fuel pump was analyzed for the Space Shuttle Main Engine. The identification of potential rotordynamic problem areas which might arise during operation of these units prior to their testing was accomplished. Alternative procedures for correcting potential rotordynamic problems should they occur were investigated. An adequate analytic and physical understanding of the turbopump rotordynamics was developed to improve the probability of a correct diagnosis of rotordynamic problems from test data. Transient rotordynamic models were developed for both turbopumps. The transient models model the hydrodynamic forces of the turbopump seals. A linear stability analysis was performed for the turbopump rotordynamics models, which included gyroscopic effects, seal forces, speed-dependent bearing characteristics, and internal rotor damping. Results are presented and discussed.

Childs, D. W.↗
NASA NTRS1976

Transient effect of lubricant on elastohydro-dynamic film thickness

The inlet solution of the elastohydrodynamic lubricated rolling contact problem was obtained by considering lubricants with transient viscosity. The effect of the viscoelastic retardation time of the lubricant on the center film thickness was investigated. The effect of transient viscosity in response to a sudden pressure was found to be insignificant in determining the film thickness in elastohydrodynamic contacts.

Wang, K. L.↗
NASA NTRS1976

Experimental study of transient dynamics of a flexible rotor

The results of an experimental program to investigate the transient response of a flexible rotor are presented. The program consisted of a series of tests conducted on a rig with a rotor designed to operate above its first bending critical speed. The purpose of the tests was to obtain experimental data on the transient behavior of a flexible rotor under conditions simulating those which might occur in a jet aircraft engine. The scope of the program included tests to measure the response of both balanced and unbalanced rotors during steady-state operation, acceleration, deceleration, and simulated blade loss.

Hibner, D. H.↗
NASA NTRS1975

The light curve of a transient X-ray source

The Ariel-5 satellite has monitored the X-ray light curve of A1524-62 almost continuously from 40 days prior to maximum light until its disappearance below the effective experimental sensitivity. The source exhibited maximum light on Dec. 4, 1974, at a level of 0.9 the apparent magnitude of the Crab Nebula in the energy band 3-6 keV. Although similar to previously reported transient sources with a decay time constant of about 2 months, the source exhibited an extended, variable preflare on-state of about 1 month at a level of greater than 0.1 maximum light. The four bright (greater than 0.2 of the Crab Nebula) transient sources observed during the first half-year of Ariel-5 operation are indicative of a galactic disk distribution, a luminosity at maximum in excess of 10 to the 37-th power ergs/sec, a frequency of occurrence which may be as high as 100/yr, and a median decay time which is less than 1 month.

Kaluzienski, L. J.↗
NASA NTRS1975

Interpretations of the EOLE experiment. II - Spatial variation of transient and stationary modes

An upper tropospheric and hemispheric scale data set, resulting from the EOLE constant density balloon experiment (conducted between August 1971 and July 1972) is used to study the spatial variation of various measured and derived fields. The quality and density of the data set is shown to be sufficient for such a study during the Southern Hemisphere spring, summer and autumn of the data period but inadequate during winter. The stationary modes of the Southern Hemisphere are shown to be relatively weak compared to their Northern Hemisphere counterparts and possess distinct seasonal phase shifts. The transient fields, on the other hand, show definite longitudinal anomalies in their seasonal mean properties with magnitudes up to thrice the zonal average. The transient fields show little seasonal variability in position. Furthermore, it appears that most of their magnitude results from the contribution of a relatively few but extremely intense disturbances which appear to possess a fairly regular variability in the 18-23 day range.

Webster, P. J.↗
NASA NTRS1976

Rotor dynamic state and parameter identification from simulated forward flight transients, part 1

State and parameter identifications from simulated forward flight blade flapping measurements are presented. The transients were excited by progressing cyclic pitch stirring or by hub stirring with constant stirring acceleration. Rotor dynamic inflow models of varying degree of sophistication were used from a one parameter inflow model (equivalent Lock number) to an eight parameter inflow model. The maximum likelihood method with assumed fixed measurement error covariance matrix was applied. The rotor system equations for both fixed hub and tilting hub are given. The identified models were verified by comparing true responses with predicted responses. An optimum utilization of the simulated measurement data can be defined. From the numerical results it can be anticipated that brief periods of either accelerated cyclic pitch stirring or of hub stirring are sufficient to extract with adequate accuracy up to 8 rotor dynamic inflow parameters plus the blade Lock number from the transients.

Hohenemser, K. H.↗