Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Solar Analysis”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 397 records · Page 22
All sourcesNASA NTRSDOE OSTI
DOE OSTI2020

PV Field Reliability Status--Analysis of 100,000 Solar Systems

In this paper, we analyzed annual production data from 100 000 photovoltaic systems as well as comments relating to their performance and maintenance. Our analysis revealed that 80% to 90% of all systems performed within 10% of the predicted production or better. Also, 56% of the systems were still performing above P50 or the median at 5 years. However, a small but significant tail of about 7000 systems perform below P90 expectations. In general, residential systems have a lower rate of failure than utility or commercial systems. Despite higher rates of component failures, utility systems lose less power than residential or commercial systems. This outcome is likely due to closer monitoring and better operations and maintenance practices. Inverters are still the components that reportedly fail most often (4%-6%), but other failures such as unspecified repair and meters cause more production loss. Reported module failures are relatively rare (0.2%) and are within the range of historical values. Installation quality affects performance and safety as indicated by data showing connector, wiring, breaker, and fuse failures due to undersizing, electrical design, and improper connection. Lastly, early detection of degradation and proactive response resulted in less impact on production than reactive, unplanned repairs.

14 SOLAR ENERGY↗
DOE OSTI2022

Fast Quasi-Static Time-Series Simulation for Accurate PV Inverter Semiconductor Fatigue Analysis with a Long-Term Solar Profile

Power system simulations with long-term data typically have large time steps varying from one second to a few minutes. However, for PV inverter semiconductors, the minimum thermal stress cycle occurs over the fundamental grid frequency (50 or 60 Hz). This requires the time step of the fatigue simulation to be around 100 µs. This small time step requires long computation times to process yearly power production profiles. This paper proposes a fast fatigue simulation for inverter semiconductors using the quasi-static time series (QSTS) simulation concept. The proposed simulation calculates the steady state of the semiconductor junction temperature by using a Fast Fourier Transform (FFT). The small thermal cycling during a switching period and even over the fundamental waveform is disregarded to further accelerate the simulation speed. The resulting time step of the fatigue simulation is 15 minutes, which is consistent with the solar dataset. The error of the proposed simulation is 0.16% compared to the fatigue simulation results using the complete thermal stress profile. A PV inverter that responds to a Transactive Energy System (TES) is simulated to demonstrate the use of the proposed fatigue simulation. The proposed simulation has the potential to co-simulate with system level simulation tools that also adopt the QSTS concept.

Liu, Yunting↗
DOE OSTI2024

Solar neutrino measurements using the full data period of Super-Kamiokande-IV

An analysis of solar neutrino data from the fourth phase of Super-Kamiokande (SK-IV) from October 2008 to May 2018 is performed and the results are presented. The observation time of the dataset of SK-IV corresponds to 2970 days and the total live time for all four phases is 5805 days. For more precise solar neutrino measurements, several improvements are applied in this analysis: lowering the data acquisition threshold in May 2015, further reduction of the spallation background using neutron clustering events, precise energy reconstruction considering the time variation of the PMT gain. The observed number of solar neutrino events in 3.49–19.49 MeV electron kinetic energy region during SK-IV is 65,443 − 388 + 390 ( stat . ) ± 925 ( syst . ) events. Corresponding B 8 solar neutrino flux is ( 2.314 ± 0.014 ( stat . ) ± 0.040 ( syst . ) ) × 10 6 cm − 2 s − 1 , assuming a pure electron-neutrino flavor component without neutrino oscillations. The flux combined with all SK phases up to SK-IV is ( 2.336 ± 0.011 ( stat . ) ± 0.043 ( syst . ) ) × 10 6 cm − 2 s − 1 . Based on the neutrino oscillation analysis from all solar experiments, including the SK 5805 days dataset, the best-fit neutrino oscillation parameters are sin 2 θ 12 , solar = 0.306 ± 0.013 and Δ m 21 , solar 2 = ( 6.1 0 − 0.81 + 0.95 ) × 10 − 5 eV 2 , with a deviation of about 1.5 σ from the Δ m 21 2 parameter obtained by KamLAND. The best-fit neutrino oscillation parameters obtained from all solar experiments and KamLAND are sin 2 θ 12 , global = 0.307 ± 0.012 and Δ m 21 , global 2 = ( 7.5 0 − 0.18 + 0.19 ) × 10 − 5 eV 2 . Published by the American Physical Society 2024

79 ASTRONOMY AND ASTROPHYSICS↗
DOE OSTI2017

Hybrid Geo-Solar GeoVision Case Study Analysis: CSP power plant with geothermal boiler feedwater heating

While stand-alone geothermal power plants provide reliable 24/7 baseload operation, most systems are subject to slow resource decline, and air-cooled plant performance suffers in hot weather. Stand-alone solar thermal power plants operate using a consistent, albeit intermittent, solar resource that requires thermal storage for reliability. Hybrid geothermal-solar power plants offer a number of potential advantages including boosted power generation during daylight hours when demand is typically greatest, the ability to share a common power block, and no requirement for thermal storage. The GeoVision hybrid systems analysis focused on aspects of hybrid technology that can increase the utilization of geothermal energy. Important aspects of the hybrid systems analysis therefore include evaluating conditions where hybrid technologies could decrease the costs of geothermal power generation and/or increase the viability of low temperature geothermal resources.

14 SOLAR ENERGY↗
DOE OSTI2020

Measurement of shunt resistance and conduction band offset in Cu(In,Ga)Se 2 solar cells through joint analysis of temperature and intensity dependence of open-circuit voltage and photoluminescence

Joint analysis studies of open-circuit voltage and photoluminescence intensity (PL-I) are reported for CuIn 1-x GaxSe 2 (CIGSe) solar cells. A range of compositions are investigated, including constant x=0.35 and x=0.55 as well as a graded composition profile having a minimum of x=0.25. Both the open circuit voltage and PL-I are measured as functions of temperature and illumination intensity. With these two measurements, a full model-based fitting of the temperature and illumination dependence allows extraction of the effects of window layer band offset and shunt resistance, in addition to bulk and interface recombination parameters. Finally, to quantitatively analyze the two distinct measurements jointly, the absolute PL-I is measured to obtain quasi-Fermi-level splitting.

14 SOLAR ENERGY↗
NASA NTRS1977

Time delay occultation data of the Helios spacecrafts and preliminary analysis for probing the solar corona

S-band time delay measurements were collected from the spacecrafts Helios A and B during three solar occultations in 1975/76 within heliocentric distances of about 3 and 215 solar radii in terms of range, Doppler frequency shift, and electron content. A description is given concerning some characteristic features of the methods of measurement and data processing. Typical data sets are discussed to probe the electron density distribution near the sun (west and east limb as well) including the outer and extended corona. Steady-state and dynamical aspects of the solar corona are presented and compared with earth-bound K-coronagraph measurements. Using a weighted least squares estimation 3 parameters of an average coronal electron density profile are derived in a preliminary analysis to yield electron densities of about 130 billion; 100 million; 7 million/cu m at r?3; 65; 215 solar radii. Transient phenomena are discussed and a velocity of propagation v approximately 900 km/s for plasma ejecta from a solar flare is determined from an extraordinary set of Helios B electron content measurements on April 30/May 1, 1976.

Edenhofer, P.↗
DOE OSTI2014

Utility-Scale Solar 2013: An empirical analysis of project cost, performance, and pricing trends in the United States

Other than the SEGS I-IX parabolic trough projects built in the 1980s, virtually no large-scale or "utility-scale" solar projects-defined here to include any ground-mounted photovoltaic ("PV"), concentrating photovoltaic ("CPV"), or concentrating solar power ("CSP" or solar thermal) project larger than 5 MW AC -existed in the United States prior to 2007.

14 SOLAR ENERGY↗
NASA NTRS1984

The application of dimensional analysis to the problem of solar wind-magnetosphere energy coupling

The constraints imposed by dimensional analysis are used to find how the solar wind-magnetosphere energy transfer rate depends upon interplanetary parameters. The analyses assume that only magnetohydrodynamic processes are important in controlling the rate of energy transfer. The study utilizes ISEE-3 solar wind observations, the AE index, and UT from three 10-day intervals during the International Magnetospheric Study. Simple linear regression and histogram techniques are used to find the value of the magnetohydrodynamic coupling exponent, alpha, which is consistent with observations of magnetospheric response. Once alpha is estimated, the form of the solar wind energy transfer rate is obtained by substitution into an equation of the interplanetary variables whose exponents depend upon alpha.

Bargatze, L. F.↗
DOE OSTI2023

Degradation behavior of CIGS solar Cells: A parametric analysis

A parametric study of the effect of bulk and interface properties on device characteristics as a function of heat and light stress under open-circuit and short-circuit conditions is developed for Cu(In,Ga)(S,Se) 2 solar cells using SCAPS-1D simulator. The variables and interdependencies modeled include: (1) conduction band offset (CBO) between buffer and absorber; (2) buffer ionized donor density; (3) CIGS shallow acceptor density; (4) CIGS deep acceptor density; (5) CIGS shallow donor density; (6) ionized acceptor concentration in the ordered vacancy compound (OVC) CIGS/buffer interface; and (7) back contact work-function. An increase in absorber shallow acceptor or a decrease in shallow donor density results in an increase in net carrier density and open-circuit voltage (V OC ). Further, a decrease in V OC is observed with an increase in the deep acceptors or neutral midgap defects in the CIGS due to higher charge carrier recombination. A change of CBO from spike to cliff condition is a dominant mechanism of decreasing VOC with an interface defect density of 10 12 cm -2 . The minimum depletion width is found to be specifically sensitive to CBO and interface defect density. An inflection in the capacitance–voltage curves (in reverse bias) is observed with simultaneous increase in bulk deep acceptor density and shallow donor density near the back contact.

14 SOLAR ENERGY↗