Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “SIGNALS”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 397 records · Page 22
All sourcesNASA NTRSDOE OSTI
NASA NTRS1974

Optimizing signal-to-error ratio in standing wave ultrasonic measurements

Standing wave ultrasonic techniques for the measurement of very small changes in acoustic attenuation and phase velocity are discussed. Enhanced sensitivity to these small changes was achieved by making the specimen part of a composite ultrasonic resonator. It was found that a point of maximum sensitivity on the response of such an ultrasonic resonator need not coincide with a point of maximum signal-to-error ratio. A model is presented and analyzed which takes into account error due to long term (low frequency) noise effects such as gain drifts and dc level shifts. This model yields a quantitative value for the signal-to-error ratio in which the signal is defined as the ideal change in the monitored response and the error as the difference between the experimentally measured change and the signal. The specific frequency dependent forms for the ultrasonic response and the sensitivity enhancement factor were used to predict the operating point on a mechanical resonance corresponding to maximum signal-to-error ratio.

Brown, J. J.↗
NASA NTRS1975

Modulator for tone and binary signals

Tones and binary information are transmitted as phase variations on a carrier wave of constant amplitude and frequency. The carrier and tones are applied to a balanced modulator for deriving an output signal including a pair of sidebands relative to the carrier. The carrier is phase modulated by a digital signal so that it is + or - 90 deg out of phase with the predetermined phase of the carrier. The carrier is combined in an algebraic summing device with the phase modulated signal and the balanced modulator output signal. The output of the algebraic summing device is hard limited to derive a constant amplitude and frequency signal having very narrow bandwidth requirements. At a receiver, the tones and binary data are detected with a phase locked loop having a voltage controlled oscillator driving a pair of orthogonal detection channels.

Mcchesney, J. R.↗
NASA NTRS1976

Design criteria for noncoherent Gaussian channels with MFSK signaling and coding

This paper presents data and criteria to assess and guide the design of modems for coded noncoherent communication systems subject to practical system constraints of power, bandwidth, noise spectral density, coherence time, and number of orthogonal signals M. Three basic receiver types are analyzed for the noncoherent multifrequency-shift keying (MFSK) additive white Gaussian noise channel: hard decision, unquantized (optimum), and quantized (soft decision). Channel capacity and computational cutoff rate are computed for each type and presented as functions of the predetection signal-to-noise ratio and the number of orthogonal signals. This relates the channel constraints of power, bandwidth, coherence time, and noise power to the optimum choice of signal duration and signal number.

Butman, S. A.↗
NASA NTRS1976

Modeling laser velocimeter signals as triply stochastic Poisson processes

Previous models of laser Doppler velocimeter (LDV) systems have not adequately described dual-scatter signals in a manner useful for analysis and simulation of low-level photon-limited signals. At low photon rates, an LDV signal at the output of a photomultiplier tube is a compound nonhomogeneous filtered Poisson process, whose intensity function is another (slower) Poisson process with the nonstationary rate and frequency parameters controlled by a random flow (slowest) process. In the present paper, generalized Poisson shot noise models are developed for low-level LDV signals. Theoretical results useful in detection error analysis and simulation are presented, along with measurements of burst amplitude statistics. Computer generated simulations illustrate the difference between Gaussian and Poisson models of low-level signals.

Mayo, W. T., Jr.↗
NASA NTRS1978

System and method for tracking a signal source

A system for tracking moving signal sources is disclosed which is particularly adaptable for use in tracking stage performers. A miniature transmitter is attached to the person or object to be tracked and emits a detectable signal of a predetermined frequency. A plurality of detectors positioned in a preset pattern sense the signal and supply output information to a phase detector which applies signals representing the angular orientation of the transmitter to a computer. The computer provides command signals to a servo network which drives a device such as a motor driven mirror reflecting the beam of a spotlight, to track the moving transmitter.

Mogavero, L. N.↗
NASA NTRS1980

Digital encoding of NTSC color video signals using adaptive delta modulation

This paper presents the initial results of our study of the use of adaptive delta modulation to encode color signals. The techniques considered include direct encoding of the color video signal, encoding of each of the three color components, i.e., R, G and B, and encoding of the chrominance and luminance signals I, Y and Q. It is shown that at any transmitted bit rate between 8 Mb/s and 24 Mb/s the best quality picture reproduction occurs when the I, Y and Q signals are encoded and the poorest quality picture reproduction occurs when the composite video signal is encoded. Furthermore, the differences in quality are significant.

Davidovici, S.↗
NASA NTRS1982

Computer modeling of multiple-channel input signals and intermodulation losses caused by nonlinear traveling wave tube amplifiers

The multiple channel input signal to a soft limiter amplifier as a traveling wave tube is represented as a finite, linear sum of Gaussian functions in the frequency domain. Linear regression is used to fit the channel shapes to a least squares residual error. Distortions in output signal, namely intermodulation products, are produced by the nonlinear gain characteristic of the amplifier and constitute the principal noise analyzed in this study. The signal to noise ratios are calculated for various input powers from saturation to 10 dB below saturation for two specific distributions of channels. A criterion for the truncation of the series expansion of the nonlinear transfer characteristic is given. It is found that he signal to noise ratios are very sensitive to the coefficients used in this expansion. Improper or incorrect truncation of the series leads to ambiguous results in the signal to noise ratios.

Stankiewicz, N.↗
NASA NTRS1982

Direct comparison of Viking 2.3-GHz signal phase fluctuation and columnar electron density between 2 and 160 solar radii

The relationship between solar wind induced signal phase fluctuation and solar wind columnar electron density has been the subject of intensive analysis during the last two decades. In this article, a sizeable volume of 2.3-GHz signal phase fluctuation and columnar electron density measurements separately and concurrently inferred from Viking spacecraft signals are compared as a function of solar geometry. These data demonstrate that signal phase fluctuation and columnar electron density are proportional over a very wide span of solar elongation angle. A radially dependent electron density model which provides a good fit to the columnar electron density measurements and, when appropriately scaled, to the signal phase fluctuation measurements, is given. This model is also in good agreement with K-coronameter observations at 2 solar radii (2r0), with pulsar time delay measurements at 10r0, and with spacecraft in situ electron density measurements at 1 AU.

Berman, A. L.↗
NASA NTRS1983

The apparent spectral broadening of VLF transmitter signals during transionospheric propagation

ISIS 1 and 2 and ISEE 1 VLF/ELF electric field wave data indicate the existence of a novel phenomenon, in which initially narrow band upgoing signals from ground-based VLF transmitters undergo a significant spectral broadening as they propagate through the ionosphere and protonosphere, up to altitudes in the 600-3800 km range. For transmitter signals in the 10-20 kHz range, the spectral broadening can be as high as 10 percent of the input signal's nominal frequency. In many cases, the bandwidth of the spectrally broadened signals is a strong function of the electric dipole antenna orientation with respect to the local direction of the earth's magnetic field. The unusual dispersion in the components of the spectrally broadened pulses suggests that the spectral broadening may be due to a Doppler shift effect in which the initial signals scatter from irregularities in the F region and couple into quasi-electrostatic modes of short wave length.

Bell, T. F.↗
NASA NTRS1984

Inverse Modelling to Obtain Head Movement Controller Signal

Experimentally obtained dynamics of time-optimal, horizontal head rotations have previously been simulated by a sixth order, nonlinear model driven by rectangular control signals. Electromyography (EMG) recordings have spects which differ in detail from the theoretical rectangular pulsed control signal. Control signals for time-optimal as well as sub-optimal horizontal head rotations were obtained by means of an inverse modelling procedures. With experimentally measured dynamical data serving as the input, this procedure inverts the model to produce the neurological control signals driving muscles and plant. The relationships between these controller signals, and EMG records should contribute to the understanding of the neurological control of movements.

Kim, W. S.↗
NASA NTRS1985

High-amplitude VLF transmitter signals and associated sidebands observed near the magnetic equatorial plane on the ISEE 1 satellite

New high-altitude ISEE 1 satellite observations of high-amplitude nonducted signals from the Omega navigation transmitter in North Dakota are reported. The amplitude of the signal was approximately 16-26 dB higher than that of similar signals observed at comparable locations on other days. Over the range L = 3.3-3.7, the transmitter pulses at 13.1 and 13.6 kHz were associated with sideband signals spaced in frequency roughly symmetrically about the carrier and generally reduced in amplitude by about 5 dB with respect to the carrier. The strongest sidebands were generally offset in frequency from the carrier by about + or - 55 Hz. Reasons are discussed for believing that the unusually high amplitude of the signals was due to wave amplification through the whistler-mode instability.

Bell, T. F.↗
NASA NTRS1985

Direct-detection optical communication with color coded pulse position modulation signaling

The performance characteristics of a direct-detection optical communication system which is based on a laser transmitter which produces single light pulses at selected nonoverlapping optical center frequencies are discussed. The signal format, called color coded pulse position modulation (CCPPM), uses more of the total available response bandwidth characteristics of the photodetector than does ordinary PPM signaling. The advantages of CCPPM signaling are obtained at the expense of an increased optical bandwidth of the transmitted signal and a more complicated transmitter and receiver structure. When the signal format is used in conjunction with block length Reed-Solomon codes, high data rates and reliable high-speed optical communications under conditions of optimal energy efficiency are obtained.

Davidson, F.↗
NASA NTRS1986

Digital Signal Combining for Conference Calling

Signals combined with minimal noise by use of sums in read-only memories. Signals from subscribers A and B digitized, transmitted, and combined by addressing ROM. Combining operation electronic equivalent of looking up value of function of two variables in mathematical table. Combined digitized signal transmitted, converted to analog form, and delivered to subscriber C. System intended especially for combining number of separate audio signals into one signal for retransmission, as in telephone conference calling.

Byrne, F.↗
NASA NTRS1986

Digital Filter Separates Signal From Noise

Variance of signal-estimation error minimized. Mathematical technique extracts best estimates of signal component from periodic digital samples of signal plus noise. Technique combines Kalman- and smoothingfilter algorithms to minimize mean-square estimation error based on past, present, and predicted samples of signal plus noise. Technique useful in image analysis and other applications involving processing of noisy signals.

Lear, W. M.↗
NASA NTRS1985

Statistical Signal Analysis for Systems with Interferenced Inputs

A new approach is introduced, based on statistical signal analysis, which overcomes the error due to input signal interference. The model analyzed is given. The input signals u sub 1 (t) and u sub 2 (t) are assumed to be unknown. The measurable signals x sub 1 (t) and x sub 2 (t) are interferened according to the frequency response functions, H sub 12 (f) and H sub 21 (f). The goal of the analysis was to evaluate the power output due to each input, u sub 1 (t) and u sub 2 (t), for the case where both are applied to the same time. In addition, all frequency response functions are calculated. The interferenced system is described by a set of five equations with six unknown functions. An IBM XT Personal Computer, which was interfaced with the FFT, was used to solve the set of equations. The software was tested on an electrical two-input, one-output system. The results were excellent. The research presented includes the analysis of the acoustic radiation from a rectangular plate with two force inputs and the sound pressure as an output signal.

Bai, R. M.↗
NASA NTRS1986

Frequency domain laser velocimeter signal processor

The features and performance parameters of the frequency domain laser velocimeter signal processor (FDSP) for examining flow phenomena are described. A candidate for replacing the standard signal processor, the FDSP can function receiving bursts of as few as 150 photons in an instantaneous mode or down to a photon resolved regime for an averaging mode. the FDSP has a nonlinear A/D converter and data storage shift registers (high speed recorder group), an elliptic digital filter bank, a controlling microprocessor and frequency and signal gain control circuits (low speed data processing group). The high speed group amplifies, digitizes, identifies and stores burst waveforms and the low speed group identifies the signal frequency within the burst after the signal passes through digital filters. The FDSP can operate in a near-autonomous mode using photon correlation techniques and requires no human intervention for calibration.

Meyers, J. F.↗
NASA NTRS1986

Frequency domain laser velocimeter signal processor

A laser velocimeter frequency domain signal processor is described which utilizes smart instrumentation to configure itself to maximize measurement accuracy based on the determined characteristics of the input signals. The stystem provides the same measurement capabilities as the high-speed burst counter in instantaneous measurements of signal frequency, the same automatic gain control and automatic frequency control as the frequency tracker, and the same immunity to signal-to-noise derived errors as the photon correlator. Simulation results demonstrate measurement accuracies of better than 0.2 percent for signal frequencies up to 100 MHz.

Meyers, J. F.↗
NASA NTRS1987

Punch stretching process monitoring using acoustic emission signal analysis. II - Application of frequency domain deconvolution

The coloring effect on the acoustic emission signal due to the frequency response of the data acquisition/processing instrumentation may bias the interpretation of AE signal characteristics. In this paper, a frequency domain deconvolution technique, which involves the identification of the instrumentation transfer functions and multiplication of the AE signal spectrum by the inverse of these system functions, has been carried out. In this way, the change in AE signal characteristics can be better interpreted as the result of the change in only the states of the process. Punch stretching process was used as an example to demonstrate the application of the technique. Results showed that, through the deconvolution, the frequency characteristics of AE signals generated during the stretching became more distinctive and can be more effectively used as tools for process monitoring.

Liang, Steven Y.↗