Photo-ionization cross section of beryllium near threshold.
Be photoionization cross section calculated noting autoionization dominance near threshold, 1P phase shift and resonances location
Altick, P. L.↗
SEARCH · Engineering Papers
Results for “CROSS SECTIONS”
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Si/n,p/ and Si/n,alpha/ reaction cross sections at 14.5 MeV neutron energy
Reaction cross sections of Si/n,p/ and Si/n,alpha/ at 14.5 MeV neutron energy
Singh, J. J.↗
Airborne laser acquisition of cross-section data
The feasibility of obtaining cross-section data from airborne remote sensing systems is investigated. Eleven test profiles in the Wolf River Basin, near Memphis, Tennessee, are selected. Each profile is characterized using conventional ground survey methods; under 'leaves-off' conditions, photogrammetric, airborne laser, and airborne radar data are obtained. Results indicate that valley profiles can be accurately characterized with an airborne laser system.
Collins, J. G.↗
Differential collision cross-sections for atomic oxygen
Differential collision cross-sections of O on N2 and other gases were measured to understand vehicle-environmental contamination effects in orbit. The following subject areas are also covered: groundbased scientific observations of rocket releases during NICARE-1; data compression study for the UVI; science priorities for UV imaging in the mid-1990's; and assessment of optimizations possible in UV imaging systems.
Torr, Douglas G.↗
Temperature dependence of ultraviolet absorption cross-sections of alternative hydrochlorofluorocarbons
Ultraviolet absorption cross-section of six alternative hydrochlorofluorocarbons (HCFC-21 HCFC-22, HCFC-123, HCFC-124, HCFC-141b and HCFC-142b1) have been measured between 170 and 260 nm for temperature ranging from 210 to 295 K. These data are compared with other available determinations performed at room temperature and their temperature dependence is discussed. Photodissociation coefficients are estimated and their temperature dependence is discussed. Impact of the photodissociation on the total atmospheric destruction of these compounds is illustrated.
Gillotay, D.↗
Revised Calculations of the Production Rates for Co Isotopes in Meteorites Using New Cross Sections for Neutron-induced Reactions
New cross section measurements for reactions induced by neutrons with energies greater than 70 MeV are used to calculate the production rates for cobalt isotopes in meteorites and these new calculations are compared to previous estimates. Additional information is contained in the original extended abstract.
Sisterson, J. M.↗
Electromagnetic Dissociation Cross Sections for High LET Fragments
Nuclear interaction cross sections are used in space radiation transport codes to calculate the probability of fragment emission in high energy nucleus-nucleus collisions. Strong interactions usually dominate in these collisions, but electromagnetic (EM) interactions can also sometimes be important. Strong interactions typically occur when the projectile nucleus hits a target nucleus, with a small impact parameter. For impact parameters larger than the sum of the nuclear radii, EM reactions dominate and the process is called electromagnetic dissociation (EMD) if one of the nuclei undergo fragmentation. Previous models of EMD have been used to calculate single proton (p) production, single neutron (n) production or light ion production, where a light ion is defined as an isotope of hydrogen (H) or helium (He), such as a deuteron (2H), a triton (3H), a helion (3He) or an alpha particle (4He). A new model is described which can also account for multiple nucleon production, such as 2p, 2n, 1p1n, 2p1n, 2p2n, etc. in addition to light ion production. Such processes are important to include for the following reasons. Consider, for example, the EMD reaction 56Fe + Al --> 52Cr + X + Al, for a 56Fe projectile impacting Al, which produces the high linear energy transfer (LET) fragment 52Cr. In this reaction, the most probable particles representing X are either 2p2n or 4He. Therefore, production of the high LET fragment 52Cr, must include the multiple nucleon production of 2p2n in addition to the light ion production of 4He. Previous models, such as the NUCFRG3 model, could only account for the 4He production process in this reaction and could not account for 2p2n. The new EMD model presented in this work accounts for both the light ion and multiple nucleon processes, and is therefore able to correctly account for the production of high LET products such as 52Cr. The model will be described and calculations will be presented that show the importance of light ion and multiple nucleon production. The work will also show that EMD reactions contribute most to those fragments with the highest LET.
Norbury, John↗
Cross sections for the production of N2(+), N(+) + N2(2+) and N(2+) by electron impact on N2
Cross sections for the production of N2(+), N(+) + N2(2+) and N(2+) by electron impact on N2 have been measured for an energy range from threshold to 1000 eV. These cross sections have been fitted to an empirical formula for future use in modeling various plasmas. Considerable differences from some previous data have been found.
Krishnakumar, E.↗
Heat transfer in oscillating flows with sudden change in cross section
Oscillating fluid flow (zero mean) with heat transfer, between two parallel plates with a sudden change in cross section, was examined computationally. The flow was assumed to be laminar and incompressible with inflow velocity uniform over the channel cross section but varying sinusoidally with time. Over 30 different cases were examined; these cases cover wide ranges of Re sub max (187.5 to 30000), Va (1 to 350), expansion ratio (1:2, 1:4, 1:8, and 1:12) and A sub r (0.68 to 4). Three different geometric cases were considered (asymmetric expansion and/or contraction, symmetric expansion/contraction, and symmetric blunt body). The heat transfer cases were based on constant wall temperature at higher (heating) or lower (cooling) value than the inflow fluid temperature. As a result of the oscillating flow, the fluid undergoes sudden expansion in one half of the cycle and sudden contraction in the other half. One heating case is examined in detail, and conclusions are drawn from all the cases (documented in detail elsewhere). Instantaneous friction factors and heat transfer coefficients, for some ranges of Re sub max and Va, deviated substantially from those predicted with steady state correlations.
Ibrahim, Mounir↗
Measurements of Fe and Ar fragmentation cross sections
Measurements are reported of the yields of individual isotopes of Cr to Co(Z = 24 to 27) resulting from the fragmentation of Fe-56, and the isotopes of Mg to K(Z = 12 to 19) resulting from the fragmentation of Ar-40. Recent advances in the resolution and collecting power of cosmic ray instrumentation, have led to dramatic improvements in the precision of cosmic ray composition measurements, both elemental and isotopic. The interpretation of these measurements is presently limited by uncertainties in the fragmentation cross-sections needed to correct for nuclear interactions with the interstellar gas. Cosmic ray propagation codes now rely mainly on semi-empirical cross-section formulae developed by Silberberg and Tsao (S&T), which have a typical uncertainty of approximately 25%. Relative isotope yields from the fragmentation of approximately 380 MeV/nucleon Fe-56 e and approximately 210 MeV/nucleon Ar-40 r in CH2 targets, observed during the calibration of two cosmic ray spectrometers at the Lawrence Berkeley Laboratory Bevalac are reported. These are compared with calculated yeilds based on the S&T cross-section formulae.
Lau, K. H.↗
Oscillating flow and heat transfer in a channel with sudden cross section change
We have computationally examined oscillating flow (zero mean) between two parallel plates with a sudden change in cross section. The flow was assumed to be laminar incompressible with the inflow velocity uniform over the channel cross section but varying sinusoidally with time. The cases studied cover wide ranges of Re(sub max) (from 187.5 to 2000), Va (from 1 to 10.66), the expansion ratio (1:2 and 1:4) and A(sub r) (2 and 4). Also, three different geometric cases were discussed: (1) asymmetric expansion/contraction; (2) symmetric expansion/contraction; and (3) symmetric blunt body. For these oscillating flow conditions, the fluid undergoes sudden expansion in one-half of the cycle and sudden contraction inthe other half. The instantaneous friction factor, for some ranges of Re(sub max) and Va, deviated substantially from the steady-state friction factor for the same flow parameters. A region has been identified below which the flow is laminar quasi-steady. A videotape showing computer simulations of the oscillating flow demonstrates the usefulness of the current analyses in providing information on the transient hydraulic phenomena.
Ibrahim, Mounir↗
The reaction Mg/n, alpha/Ne at 14.1 and 14.7 MeV - Cross sections and implications for meteorites
Mass spectroscopic analysis of neutron-irradiated targets of natural magnesium yields cross sections of 59 + or - 14, 160 + or - 8, and 11.0 + or - 3.3 mb for Ne-20, Ne-21 and Ne-22, respectively, at 14.1 MeV and of 94 + or - 8, 152 or - 12, and 13.0 + or - 2.0 mb at 14.7 Mev. Using these cross sections, calculations modeling cosmic ray interactions in stony meteoroids of radii 20 and 26 cm predict that between the surface and the center the Ne-22/Ne-21 ratio falls more than 10% while the Ne-21 production rate rises about 30%. Calculations are compared with published neon measurements for the Keyes and St. Severin meteorites.
Reedy, R. C.↗
Unified nonlinear analysis for nonhomogeneous anisotropic beams with closed cross sections
A unified methodology for geometrically nonlinear analysis of nonhomogeneous, anisotropic beams is presented. A 2D cross-sectional analysis and a nonlinear 1D global deformation analysis are derived from the common framework of a 3D, geometrically nonlinear theory of elasticity. The only restrictions are that the strain and local rotation are small compared to unity and that warping displacements are small relative to the cross-sectional dimensions. It is concluded that the warping solutions can be affected by large deformation and that this could alter the incremental stiffnes of the section. It is shown that sectional constants derived from the published, linear analysis can be used in the present nonlinear, 1D analysis governing the global deformation of the beam, which is based on intrinsic equations for nonlinear beam behavior. Excellent correlation is obtained with published experimental results for both isotropic and anisotropic beams undergoing large deflections.
Atilgan, Ali R.↗
Crushing characteristics of composite tubes with 'near-elliptical' cross sections
An experimental investigation was conducted to determine whether the energy-absorption capability of near-elliptical cross-section composite tubular specimens is a function of included angle. Each half of the near-elliptical cross-section tube is a segment of a circle. The included angle is the angle created by radial lines extending from the center of the circular segment to the ends of the circular segment. Graphite- and Kevlar-reinforced epoxy material was used to fabricate specimens. Tube internal diameters were 2.54, 3.81, and 7.62 cm, and included angles were 180, 160, 135, and 90 degrees. Based upon the test results from these tubes, energy-absorption capability increased between 10 and 30 percent as included angle decreased between 180 and 90 degrees for the materials evaluated. Energy-absorption capability was a decreasing nonlinear function of the ratio of tube internal diameter to wall thickness.
Farley, Gary L.↗
Flow study in the cross sectional planes of a turbine scroll
A numerical study of the nonviscous flow characteristics in the cross-sectional planes of a radial inflow turbine scroll is presented. The velocity potential is used in the formulation to determine the flow velocity in these planes resulting from the continuous mass discharge. The effect of the through flow velocity is simulated by a continuous distribution of source/sink in the cross-section. A special iterative procedure is devised to handle the solution of the resulting Poisson's differential equation with Neumann boundary conditions in a domain with generally curved boundaries. The analysis is used to determine the effects of the radius of curvature, the location of the scroll section and its geometry on the flow characteristics in the turbine scroll.
Hamed, A.↗
Particle size measurements based on use of mean scattering cross sections.
Particle size measurements based on use of optical mean scattering cross sections
PARTICLE SIZE↗
Differential Cross Sections for the Electron Impact Excitation of the A(sup 3)(Sigma)(sub u)(sup +), B(sup 3)Pi(sub g), W(sup 3)(Delta)(sub u), B'(sup 3)(Sigma)(sub u)(sup -), a'(sup 1)Sigma(sub u)(sup -), a(sup 1)Pi(sub g), w(sup 1)Delta(sub u), and C(sup 3)Pi(sub u) States of N(sub 2)
Measurements of differential cross sections for the electron-impact excitation of molecular nitrogen from the ground X(sup 1)(Sigma)(sub g)(sup +)(v''=0)level to the A(sup 3)(Sigma)(sub u)(sup +)(v'), B(sup 3)Pi(sub g)(v'), W(sup 3)(Delta)(sub u)(v'),B'(sup 3)(Sigma)(sub u)(sup -)(v'), a(sup 1)(Pi)(sub g)(v'), w(sup 1)(Delta)(sub u)(v'), and C(sup 3)(Pi)(sub u)(v') levels are presented. The data are obtained at the incident energies of 10, 12.5, 15, 17.5, 20, 30, 50, and 100 eV over the angular range of 5(deg)-130(deg) in 5(deg) intervals. The individual electronic state excitation differential cross sections are obtained by unfolding electron energy-loss spectra of molecular nitrogen using available semiempirical Frank-Condon factors. The data are compared to previous measurements and to available theory. We also make several important suggestions regarding future work that, like the present, relies on the unfolding of electron energy-loss spectra for obtaining differential cross sections.
electron impact↗
An investigation of a method of determining antenna parameters by scattering cross section measurements
Error analysis of method for determining antenna parameters by scattering cross section measurements
ANTENNA↗