Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Antennas”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 397 records · Page 22
All sourcesNASA NTRSDOE OSTI
NASA NTRS1972

A technique for measurement of earth station antenna G/T by radio stars and Applications Technology Satellites.

A new technique has been developed to accurately measure the G/T of a small aperture antenna using geostationary satellites and the well established radio star method. A large aperture antenna having the capability of accurately measuring its G/T by using a radio star of known power density is used to obtain an accurate G/T to use as a reference. The CNR of both the large and small aperture antennas are then measured using an Applications Technology Satellite (ATS). After normalizing the two C/N ratios to the large antenna system noise temperature the G/T or the gain G of the small aperture antenna can then be determined.

Kochevar, H. J.↗
NASA NTRS1973

Error analysis for Mariner Venus/Mercury 1973 conducted at the JPL Mesa west antenna range

Theoretical analysis and experimental data are combined to yield the errors to be used with antenna gain, antenna patterns, and RF cable insertion loss measurements for the Mariner Venus-Mercury 1973 Flight Project. These errors apply to measurements conducted at the JPL Mesa, West Antenna Range, on the high gain antenna, low gain antenna, and RF coaxial cables.

Vincent, N. L.↗
NASA NTRS1973

Measurement techniques for antennas in dissipative media.

Methods used to simulate dissipative media environments for antennas are reported, and special techniques are developed to determine the electrical properties of antennas in such media. A new device for measuring antenna input admittance is presented which permits a simple measurement of admittance over a broad frequency range where conventional methods are cumbersome in field use. An apparatus for measuring antenna current and charge distributions is described, and the associated probing errors are discussed. Measured admittances and current and charge distributions are compared with current theories for thin wire linear and loop antennas in the dissipative media and are found to be in good agreement.

Scott, L. D.↗
NASA NTRS1973

Synthesis of multiple shaped beam antenna patterns

Results are presented of research into the problem of finding an excitation of a given antenna such that the desired radiation pattern is approximated to within acceptable limits. This is to be done in such a fashion that boundary conditions involving hardware limitations may be inserted into the problem. The intended application is synthesis of multiple shaped beam antennas. Since this is perhaps the most difficult synthesis problem an antenna engineer is likely to encounter, the approach taken was to include as a by-product capability for synthesizing simpler patterns. The synthesis technique has been almost totally computerized. The class of antennas which may be synthesized with the computer program are those which may be represented as planar (continuous or discrete) current distributions. The technique is not limited in this sense and could indeed by extended to include, for example, the synthesis of conformal arrays or current distributions on the surface of reflectors. The antenna types which the program is set up to synthesize are: line source, rectangular aperture, circular aperture, linear array, rectangular array, and arbitrary planar array.

Stutzman, W. L.↗
NASA NTRS1973

Task three: Report: STDN Antenna and preamplifier cost tradeoff study

The general goal of this task, STDN Antenna and Preamplifier G/T Study, was to determine cost-effective combinations of antennas and preamplifiers for several sets of conditions for frequency, antenna elevation angle, and rain. The output of the study includes design curves and tables which indicate the best choice of antenna size and preamplifier type to provide a given G/T performance. The report indicates how to evaluate the cost effectiveness of proposed improvements to a given station. Certain parametric variations are presented to emphasize the improvement available by reducing RF losses and improving the antenna feed.

Source record↗
NASA NTRS1974

Aperture excited dielectric antennas

The results of a comprehensive experimental and theoretical study of the effect of placing dielectric objects over the aperture of waveguide antennas are presented. Experimental measurements of the radiation patterns, gain, impedance, near-field amplitude, and pattern and impedance coupling between pairs of antennas are given for various Plexiglas shapes, including the sphere and the cube, excited by rectangular, circular, and square waveguide feed apertures. The waveguide excitation of a dielectric sphere is modeled using the Huygens' source, and expressions for the resulting electric fields, directivity, and efficiency are derived. Calculations using this model show good overall agreement with experimental patterns and directivity measurements. The waveguide under an infinite dielectric slab is used as an impedance model. Calculations using this model agree qualitatively with the measured impedance data. It is concluded that dielectric loaded antennas such as the waveguide excited sphere, cube, or sphere-cylinder can produce directivities in excess of that obtained by a uniformly illuminated aperture of the same cross section, particularly for dielectric objects with dimensions of 2 wavelengths or less. It is also shown that for certain configurations coupling between two antennas of this type is less than that for the same antennas without dielectric loading.

Crosswell, W. F.↗
NASA NTRS1975

S-band omnidirectional antenna for the SERT-C satellite

The program to design an S-band omnidirectional antenna system for the SERT-C spacecraft is discussed. The program involved the tasks of antenna analyses by computer techniques, scale model radiation pattern measurements of a number of antenna systems, full-scale RF measurements, and the recommended design, including detailed drawings. A number of antenna elements were considered: the cavity-backed spiral, quadrifilar helix, and crossed-dipoles were chosen for in-depth studies. The final design consisted of a two-element array of cavity-backed spirals mounted on opposite sides of spacecraft and fed in-phase through a hybrid junction. This antenna system meets the coverage requirement of having a gain of at least minus 10 dBi over 50 percent of a 4 pi steradian sphere with the solar panels in operation. This coverage level is increased if the ground station has the capability to change polarization.

Bassett, H. L.↗
NASA NTRS1975

One-third scale model of an offset fed scanning antenna for the shuttle imaging microwave system

An experimental study is reported, involving the design, fabrication, and measurement of a one-third scale model of the 4m diameter parabolic torus reflector with a Gregorian feed for the SIMS application. Antenna pattern measurements of the model at 60 and 30 GHz are presented to verify the predictions of a geometrical optics analysis upon which the antenna design was based. It is shown that the antenna measurements bear out the geometrical optics analysis in every respect and that the Gregorian subreflector feed is usable at all frequencies above at least 10 Ghz in the full size SIMS antenna. The fabrication of the model antenna is discussed, including a computerized technique for fabricating the transcendental subreflector shape with a numerically controlled machine.

Gustincic, J. H.↗
NASA NTRS1975

Study of shuttle imaging microwave system antenna. Volume 1: Conceptual design

A detailed preliminary design and complete performance evaluation are presented of an 11-channel large aperture scanning radiometer antenna for the shuttle imaging microwave system (SIMS) program. Provisions for interfacing the antenna with the space shuttle orbiter are presented and discussed. A program plan for hardware development and a rough order of magnitude (ROM) cost are also included. The conceptual design of the antenna is presented. It consists of a four-meter diameter parabolic torus main reflector, which is a graphite/epoxy shell supported by a graphite/epoxy truss. A rotating feed wheel assembly supports six Gregorian subreflectors covering the upper eight frequency channels from 6.6 GHz through 118.7 GHz, and two three-channel prime forms feed assemblies for 0.6, 1.4, and 2.7 GHz. The feed wheel assembly also holds the radiometers and power supplies, and a drive system using a 400 Hz synchronous motor is described. The RF analysis of the antenna is performed using physical optics procedures for both the dual reflector Gregorian concept and the single reflector prime focus concept. A unique aberration correcting feed for 2.7 GHz is analyzed. A structural analysis is also included. The analyses indicate that the antenna will meet system requirements.

Wesley, R. W.↗
NASA NTRS1975

Shuttle orbiter S-band quad antenna switching evaluation

Automatic switching of the shuttle orbiter S-band quad antennas by the orbiter on-board computers was evaluated. The development and use of an extensive computer program to determine antenna switch position states as a function of time for various orbital activities is described. The selection of the optimum quad antenna element at any given time is based on the look angle to the appropriate Tracking Data Relay Satellite (TDRS). It is shown that a 2.4 second period is required for updating the S-band quad antenna switch state based on a maximum roll rate of 2 deg per second. The possibility of a variable update period is suggested since the 2 deg per second attitude rate is seldom encountered and would, for example, dictate approximately 248,000 on-board computer calculations during Reference Mission 2. The average number of antenna switch state changes was found to be in the range of 1,300 for Reference Mission 2.

Lindsey, J. F.↗
NASA NTRS1976

Analysis of aircraft wing-mounted antenna patterns

High frequency radiation patterns of aircraft wing mounted antennas are analyzed. Basic antenna types using ray optical techniques are studied. The aircraft is modelled in its most basic form so that this study is applicable to general type aircraft. The fuselage is modelled as a perfectly conducting finite elliptic cylinder. The wings and horizontal and vertical stabilizers are modelled as perfectly conducting "n" sided flat plates that can be arbitrarily attached to the fuselage or to themselves. The antenna locations are assumed to be on the surfaces of the wings at locations removed from engines and stores such that these effects are negligible. Volumetric patterns are calculated for several aircraft. The validity of the solution is shown by comparing the results against scale model measurements. The application of this solution to practical airborne antenna problems has shown its versatility in designing antennas and predicting their radiation patterns in an accurate and efficient manner.

Marhefka, R. J.↗
NASA NTRS1977

Theoretical aspects of sounder antenna operation

The fundamental problem of calculating the radiation from an electric dipole immersed in a magnetoplasma is one of solving Maxwell's equations coupled to the self-consistent field-particle equations describing the plasma. For very small applied antenna voltages, the plasma dynamics may be linearized, and the plasma reaction currents computed self-consistently in terms of the voltage on the antenna. Thus, the short dipole can be idealized as a point dipole of moment P sub o = C sub a, V sub o el, where C sub a is the antenna element-to-plasma capacitance for a sheath of dimensions roughly several plasma Debye lengths and el is the dipole element's length. In actual practice, it is at this point that the first difficulty with the antenna theory arises. Even for small signals, the sheath around such an antenna will exhibit a complex impedance. For larger signals, nonlinear effects appear. Attemps are made to solve this problem.

Fredricks, R. W.↗
NASA NTRS1977

Measurements of AAFE RADSCAT antenna characteristics

Antenna characteristics (active and passive) for a modified AAFE-RADSCAT parabolic dish antenna are documented for a variety of antenna configurations. The modified antenna was a replacement for the original unit which was damaged in January 1975. Pattern measurements made at Langley Research Center and Johnson Space Center are presented, with an analysis of the results. Antenna loss measurements are also presented and summarized.

Cross, A. E.↗
NASA NTRS1976

Antenna radiation patterns in the whistler wave regime measured in a large laboratory plasma

Antenna radiation patterns of balanced electric dipoles and shielded magnetic loop antennas are obtained by measuring the relative wave amplitude with a small receiver antenna scanned around the exciter in a large uniform collisionless magnetized laboratory plasma in the whistler wave regime. The boundary effects are assumed to be negligible even for many farfield patterns. Characteristic differences are observed between electrically short and long antennas, the former exhibiting resonance cones and the latter showing dipole-like antenna patterns along the magnetic field. Resonance cones due to small electric dipoles and magnetic loops are observed in both the near zone and the far zone. A self-focusing process is revealed which produces a pencil-shaped field-aligned radiation pattern.

Stenzel, R. L.↗
NASA NTRS1976

Advanced microwave radiometer antenna system study

The practicability of a multi-frequency antenna for spaceborne microwave radiometers was considered in detail. The program consisted of a comparative study of various antenna systems, both mechanically and electronically scanned, in relation to specified design goals and desired system performance. The study involved several distinct tasks: definition of candidate antennas that are lightweight and that, at the specified frequencies of 5, 10, 18, 22, and 36 GHz, can provide conical scanning, dual linear polarization, and simultaneous multiple frequency operation; examination of various feed systems and phase-shifting techniques; detailed analysis of several key performance parameters such as beam efficiency, sidelobe level, and antenna beam footprint size; and conception of an antenna/feed system that could meet the design goals. Candidate antennas examined include phased arrays, lenses, and optical reflector systems. Mechanical, electrical, and performance characteristics of the various systems were tabulated for ease of comparison.

Kummer, W. H.↗
NASA NTRS1978

JPL Large Advanced Antenna Station Array Study

In accordance with study requirements, two antennas are described: a 30 meter standard antenna and a 34 meter modified antenna, along with a candidate array configuration for each. Modified antenna trade analyses are summarized, risks analyzed, costs presented, and a final antenna array configuration recommendation made.

Source record↗
NASA NTRS1978

Nodding feed antenna for communications with satellites in synchronous orbit

The design, fabrication, and performance of a parabolic, ground receiving antenna system with a feed that nods in one axis producing a maximum beam deviation 1.1 deg from boresight is described. The antenna design was: (1)to lower the weight (and the subsequent cost) of the supporting structure and the actuator motors for a tracking antenna by moving just the feed; (2) to use a manual tracking system eliminating the need for expensive electronic controls or computers; (3) to provide for several hours of unattended operation; and (4)to permit operation of the antenna by unskilled personnel. Also described are some physical and orbital phenomenon that effect the operation or design of the antenna. One is the motion of a nearly geostationary satellite due to gravitational forces from the sun, the moon, and other stellar bodies. Others are the rotation of the nodding axis and the feed polarization as a function of the location of the station on the earth. A comparison of per unit cost was made for one unit and a quantity of 100.

Smetana, J.↗
NASA NTRS1977

An entree for large space antennas

Some of the possible areas of application for large antennas placed in space are discussed, and some initial design concepts for various antenna proposals are described. Applications include rural mobile communications, an orbiting deep space relay station, submillimeter radio astronomy, and multispectral radiometry of earth surface features. As a first step in developing the needed technology, a deployable 30-m antenna with 1-mm surface accuracy is proposed. Flight experience with such an antenna system would enable validation of performance prediction models. The 30-m-diam mesh deployable-defurlable antenna experiment would be carried out with the shuttle.

Powell, R. V.↗