Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “smoothing”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 379 records · Page 21
All sourcesNASA NTRSDOE OSTI
NASA NTRS1982

Linear force and moment equations for an annular smooth shaft seal perturbed both angularly and laterally

Coefficients are derived for equations expressing the lateral force and pitching moments associated with both planar translation and angular perturbations from a nominally centered rotating shaft with respect to a stationary seal. The coefficients for the lowest order and first derivative terms emerge as being significant and are of approximately the same order of magnitude as the fundamental coefficients derived by means of Black's equations. Second derivative, shear perturbation, and entrance coefficient variation effects are adjudged to be small.

Fenwick, J.↗
NASA NTRS1982

The study of X-ray scattering to determine surface topography of smooth surfaces

The scattering of X-rays from state-of-the-art polished mirrors is discussed with reference to the requirements of the Advanced X-ray Astrophysics Facility telescope. An experimental set-up is described which allows information to be obtained with subarcsecond resolution. A sample of the data obtained is presented along with a possible theoretical model for its interpretation.

Williams, A. C.↗
NASA NTRS1984

On the effect of using the Shapiro filter to smooth winds on a sphere

Spatial differencing schemes which are not enstrophy conserving nor implicitly damping require global filtering of short waves to eliminate the build-up of energy in the shortest wavelengths due to aliasing. Takacs and Balgovind (1983) have shown that filtering on a sphere with a latitude dependent damping function will cause spurious vorticity and divergence source terms to occur if care is not taken to ensure the irrotationality of the gradients of the stream function and velocity potential. Using a shallow water model with fourth-order energy-conserving spatial differencing, it is found that using a 16th-order Shapiro (1979) filter on the winds and heights to control nonlinear instability also creates spurious source terms when the winds are filtered in the meridional direction.

Takacs, L. L.↗
NASA NTRS1983

Elastohydrodynamic lubrication of smooth surfaces

Fully flooded, elastohydrodynamically lubricated contacts are considered. Elastohydrodynamic lubrication (EHL) analysis requires the simultaneous solution of the elastically, viscosity, density, and Reynolds equations. The most important practical aspect of elastohydrodynamic lubrication theory is the determination of the minimum film thickness within the conjunction. The maintenance of a fluid film of adequate magnitude is an essential feature of the correct operation of lubricated machine elements. The results show the influence of contact geometry on minimum film thickness as expressed by the ellipticity parameter and the dimensionless speed, load, and materials parameters. Film thickness equations are developed for materials of high elastic modulus, such as metal, and for materials of low elastic modulus, such as rubber.

Hamrock, B. J.↗
NASA NTRS1986

Smoothly Adjustable dc Load

Load circuit for testing dc power supplies adjusted without momentary interruptions typical of rheostat loads. Load current passes through power transistor and fixed resistor instead of wire-wound rheostat. In new circuit potentiometer used to adjust bias of power transistor and thereby adjust load. Components are standard, commercially available parts, mounted on transistor heat sink, forming compact package.

Patocka, C. G.↗
NASA NTRS1986

Smoothed Two-Dimensional Edges for Laminar Flow

New concept allows passive method for installing flaps, slats, iceprotection equipment, and other leading-edge devices on natural-laminar-flow (NLF) wings without causing loss of laminar flow. Two-dimensional roughness elements in laminar boundary layers strategically shaped to increase critical (allowable) height of roughness. Facilitates installation of leading-edge devices by practical manufacturing methods.

Holmes, B. J.↗
NASA NTRS1984

SASS wind ambiguity removal by direct minimization. II - Use of smoothness and dynamical constraints

A variational analysis method (VAM) is used to remove the ambiguity of the Seasat-A Satellite Scatterometer (SASS) winds. The VAM yields the best fit to the data by minimizing an objective function S which is a measure of the lack of fit. The SASS data are described and the function S and the analysis procedure are defined. Analyses of a single ship report which are analogous to Green's functions are presented. The analysis procedure is tuned and its sensitivity is described using the QE II storm. The procedure is then applied to a case study of September 6, 1978, south of Japan.

Hoffman, R. N.↗
NASA NTRS1984

Objective scatterometer wind ambiguity removal using smoothness and dynamical constraints

In the present investigation, a variational analysis method (VAM) is used to remove the ambiguity of the Seasat-A Satellite Scatterometer (SASS) winds. At each SASS data point, two, three, or four wind vectors (termed ambiguities) are retrieved. It is pointed out that the VAM is basically a least squares method for fitting data. The problem may be nonlinear. The best fit to the data and constraints is obtained on the basis of a minimization of the objective function. The VAM was tested and tuned at 12 h GMT Sept. 10, 1978. Attention is given to a case study involving an intense cyclone centered south of Japan at 138 deg E.

Hoffman, R. N.↗
NASA NTRS1988

Tool Extracts Smooth, Fragile Tubes

When laterally compressible tube too slippery to pull, simple tool does job. Consists of three linked sections of steel tube with sticky rubber on inside and handles on outside. Hinged sections encircle tube to be pulled. User pulls on handles to extract tube.

Sanders, Fred G.↗
NASA NTRS1987

Diffraction of sound by a smooth ridge

The propagation of sound over uneven terrain and irregular topography is considered. Laboratory scale experiments were conducted on a 4.88 x 2.44 m plywood bench top with a cylindrical ridge whose radius of curvature is about 2.5 m. Experimental results include the insertion loss on the diffracting surface, and in the penumbra region, at several distances from the apex of the ridge.

Berthelot, Yves H.↗
NASA NTRS1989

Effect of wall suction on the stability of compressible subsonic flows over smooth two-dimensional backward-facing steps

The effect of suction on the stability of compressible flows over backward-facing steps is investigated. Mach numbers up to 0.8 are considered. The results show that continuous suction stabilizes the flow outside the separation bubble, but it destabilizes the flow inside it. Nevertheless, the overall N factor decreases as the suction level increases due to the considerable reduction of the separation bubble. For the same suction flow rate, properly distributed suction strips stabilize the flow more than continuous suction. The size of the separation bubble, and hence its effect on the instability can be considerably reduced by placing strips with high suction velocities in the separation region.

Al-Maaitah, Ayman A.↗
NASA NTRS1990

Source region of the smooth high-frequency nightside Uranus kilometric radiation - A ray-tracing study

This paper presents a plasma density model for the Uranus nightside at r less than 4.2 r(u), developed on the basis of radio wave observations of the Planetary Radio Astronomy instrument on board the Voyager 2 spacecraft and on cyclotron maser instability. The results provide an accurate description of the Uranus kilometric radiation (UKR) source region dependent on a minimum of assumptions, and indicate that the UKR source region is more extended in longitude than previosly determined.

Menietti, J. D.↗
NASA NTRS1989

Application of super smooth optics to extra-solar planet detection

The observational constraints on direct detection of extrasolar planets around nearby stars are defined. The design of an instrument capable of meeting these goals requires the efficient reduction of diffracted and scattered light by about three orders of magnitude below the airy wings of the unapodized aperture. The diffraction reduction is achieved through the high-efficiency coronagraph, which uses Gaussian occulting masks in the first focus to concentrate better diffracted light in the pupil plane. Laboratory experiments confirm this high efficiency to the limits set by the experimental setup. Scattering due to midspatial scale figure error in the mirrors must also be reduced to a comparable level.

Terrile, Richard J.↗
NASA NTRS1991

High frequency scattering by a smooth coated cylinder simulated with generalized impedance boundary conditions

Rigorous uniform geometrical theory of diffraction (UGTD) diffraction coefficients are presented for a coated convex cylinder simulated with generalized impedance boundary conditions. In particular, ray solutions are obtained which remain valid in the transition region and reduce uniformly to those in the deep lit and shadow regions. These involve new transition functions in place of the usual Fock-type integrals, characteristic to the impedance cylinder. A uniform asymptotic solution is also presented for observations in the close vicinity of the cylinder. As usual, the diffraction coefficients for the convex cylinder are obtained via a generalization of the corresponding ones for the circular cylinder.

Syed, Hasnain H.↗