SEARCH · Engineering Papers

Results for “rockets”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 379 records · Page 21

All sources NASA NTRS DOE OSTI

NASA NTRS1949

Experimental Study of Gas-Flow Separation in Overexpanded Exhaust Nozzles for Rocket Motors

In a rocket motor having a de Laval nozzle with a fixed expansion ratio, there is only one pressure ratio (p(sub c)/p(sub o)) for which this expansion ratio is correct. At any other pressure ratio the gases will be either underexpanded or overexpanded, depending on whether the pressure ratio is higher or lower than the correct value. Rocket motor flame patterns illustrating the four possible regimes are shown in Figures 1 to 4, inclusive. In Figure 1, the pressure ratio is higher than the correct one for the fixed expansion ratio of the nozzle, resulting in underexpansion of the gases. in Figure 2, the pressure ratio is the correct one. In Figure 3, the pressure ratio is only slightly lower than the correct one, resulting in overexpansion without separation of the gases from the wall. In Figure 4, the pressure ratio is considerably below the correct one, resulting in overexpansion with separation of the gases from the nozzle wall. The present report is concerned primarily with this fourth type of flow, that is, overexpansion of the gases with separation of the flow from the wall. Such a situation exists in a rocket motor operating at a considerably lower altitude than that for which its exhaust nozzle was designed.

Cowles, Frederick B.↗

NASA NTRS1968

Description and Flight Performance Results of the WASP Sounding Rocket

A general description of the design and construction of the WASP sounding rocket and of the performance of its first flight are presented. The purpose of the flight test was to place the 862-pound (391-kg) spacecraft above 250 000 feet (76.25 km) on free-fall trajectory for at least 6 minutes in order to study the effect of "weightlessness" on a slosh dynamics experiment. The WASP sounding rocket fulfilled its intended mission requirements. The sounding rocket approximately followed a nominal trajectory. The payload was in free fall above 250 000 feet (76.25 km) for 6.5 minutes and reached an apogee altitude of 134 nautical miles (248 km). Flight data including velocity, altitude, acceleration, roll rate, and angle of attack are discussed and compared to nominal performance calculations. The effect of residual burning of the second stage motor is analyzed. The flight vibration environment is presented and analyzed, including root mean square (RMS) and power spectral density analysis.

De Pauw, J. F.↗

NASA NTRS1971

The United States sounding rocket program

The United States sounding rocket program is discussed. The program is concerned with the fields of solar physics, galactic astronomy, fields and particles, ionospheric physics, aeronomy, and meteorology. Sounding rockets are described with respect to propulsion systems, gross weight, and capabilities. Instruments used to conduct ionospheric probing missions are examined. Results of previously conducted sounding rocket missions are included.

Source record↗

NASA NTRS1972

Pulse performance analysis for small hypergolic-propellant rocket engines

Small rocket engine tests were conducted for the purpose of obtaining pulse performance data to aid in preliminary design and evaluation of attitude control systems. Both monopropellant and hypergolic bipropellant engines of thrust levels from 1 to 100 lbs were tested. The performance data for the hypergolic propellant rockets are compared with theoretical performance calculated from idealized chamber filling and evacuation characteristics. Electromechanical delays in valve response and heat transfer characteristics were found to cause substantial deviation between theoretical and test performance. The theoretical analysis is modified to obtain a semi-empirical model for hypergolic propellant rockets which is demonstrated to be reasonably accurate for two different engine configurations over a considerable range of duty cycles.

Smith, G. W.↗

NASA NTRS1972

The geometry and physical properties of exhaust clouds generated during the static firing of S-1C and S-2 rocket engines

An experimental program was conducted during the static firing of the S-1C stage 13, 14, and 15 rocket engines and the S-2 stage 13, 14, and 15 rocket engines. The data compiled during the experimental program consisted of photographic recordings of the time-dependent growth and diffusion of the exhaust clouds, the collection of meteorological data in the ambient atmosphere, and the acquisition of data on the physical structure of the exhaust clouds which were obtained by flying instrumented aircraft through the clouds. A new technique was developed to verify the previous measurements of evaporation and entrainment of blast deflector cooling water into the cloud. The results of the experimental program indicate that at the lower altitudes the rocket exhaust cloud or plume closely resembles a free-jet type of flow. At the upper altitudes, where the cloud is approaching an equilibrium condition, structure is very similar to a natural cumulus cloud.

Forbes, R. E.↗

NASA NTRS1972

Liquid rocket performance computer model with distributed energy release

Development of a computer program for analyzing the effects of bipropellant spray combustion processes on liquid rocket performance is described and discussed. The distributed energy release (DER) computer program was designed to become part of the JANNAF liquid rocket performance evaluation methodology and to account for performance losses associated with the propellant combustion processes, e.g., incomplete spray gasification, imperfect mixing between sprays and their reacting vapors, residual mixture ratio striations in the flow, and two-phase flow effects. The DER computer program begins by initializing the combustion field at the injection end of a conventional liquid rocket engine, based on injector and chamber design detail, and on propellant and combustion gas properties. It analyzes bipropellant combustion, proceeding stepwise down the chamber from those initial conditions through the nozzle throat.

Combs, L. P.↗

NASA NTRS1972

Results of a rocket-Nimbus sounder comparison experiment

Stratospheric temperature data obtained from instrumentation on board Nimbus 3 and 4 are compared with conventional rocket soundings to determine the compatibility of measurements. The Arcasonde 1A and Datasonde were the primary rocketsondes used, but acoustic grenade and pitot probe soundings were also involved. Observed temperature profiles and computed radiances obtained from rocket soundings are compared with 15-microns data provided by the satellite infrared spectrometers, the infrared interferometer spectrometer, and the selective chopper radiometer onboard the satellites. A reasonable agreement between the rocket and satellite data is indicated, but variations are noted which are related to the sounding techniques.

Miller, A. J.↗

NASA NTRS1971

Nozzle and cavity wall cooling limitations on specific impulse of a gas-core nuclear rocket.

Experimental and theoretical study of the performance of a gas-core nuclear rocket, showing that in a uranium plasma nuclear rocket with an 8-ft cavity diameter the cavity wall can be cooled up to a power level of 7400 MW when the rocket operates at a pressure of 1000 atm and the propellant mass flow rate is 10 lbm/sec. A maximum cavity specific impulse of 5800 sec was obtained under such operating conditions. The fact that the wall heat flux was much lower for reactor powers below this level is linked to the presence of a relatively cool, opaque insulating layer of seeded propellant between the hot plasma and the solid wall. The additional coolant required for nozzle protection reduced the maximum cavity specific impulse to 5200 sec.

Kascak, A. F.↗

NASA NTRS1971

Technology for low cost solid rocket boosters.

A review of low cost large solid rocket motors developed at the Lewis Research Center is given. An estimate is made of the total cost reduction obtainable by incorporating this new technology package into the rocket motor design. The propellant, case material, insulation, nozzle ablatives, and thrust vector control are discussed. The effect of the new technology on motor cost is calculated for a typical expandable 260-in. booster application. Included in the cost analysis is the influence of motor performance variations due to specific impulse and weight changes. It is found for this application that motor costs may be reduced by up to 30% and that the economic attractiveness of future large solid rocket motors will be improved when the new technology is implemented.

Ciepluch, C.↗

NASA NTRS1972

Development of boron epoxy rocket motor chambers.

A 71 cm diameter 74 cm length boron/epoxy composite rocket motor chamber was designed based on the geometric configuration of the JPL Applications Technology Satellite titanium alloy apogee motor chamber. Because analyses showed large stress concentrations in the domes, the configuration was modified using the same basic constraints for openings and attachments. The rocket motor chamber was then fabricated by filament winding with boron/epoxy tape and hydrostatically tested to failure at 264 N/sq cm, 57.2 N/sq cm above the design value. Two more rocket motor chambers were fabricated with the same basic constraints, but shortened to 57.6 cm for a smaller propellant load. The first of these short chambers failed in proof because of filament winding fabrication difficulties. The second chamber was successfully fabricated and passed the hydrostatic proof test.

Jensen, W. M.↗

NASA NTRS1972

Pulse performance analysis for small hypergolic propellant rocket engines

Small rocket engine tests were conducted for the purpose of obtaining pulse performance data to aid in preliminary design and evaluation of attitude control systems. Both monopropellant and hypergolic bipropellant engines of thrust levels from 5 to 445 N (1 to 100 lb) were tested. The performance data for the hypergolic propellant rockets are compared with theoretical performance calculated from idealized chamber filling and evacuation characteristics. Electromechanical delays in valve response and heat transfer characteristics were found to cause substantial deviation between theoretical performance and test performance. The theoretical analysis is modified to obtain a semiempirical model for hypergolic propellant rockets.

Smith, G. W.↗

NASA NTRS1972

A program of high resolution X-ray astronomy using sounding rockets

Two Aerobee 170 sounding rocket payloads were flown at the White Sands Missile Range: (1) a focusing X-ray collector on 31 March 1972; and (2) a high resolution telescope on 4 August 1972. Data has been reduced from each of these flights. In the first flight both the rocket and the experiment instrumentation performed adequately, and it is clear that at least the minimum scientific objectives were attained. In the second flight the attitude control system failed to point the telescope at the target for a sufficient length of time. However examination of final preflight checkout data and some flight data indicate that the instrumentation for this rocket payload was functioning according to expectations.

Source record↗

NASA NTRS1972

Study of solid rocket motor for space shuttle booster, volume 2, book 2

A technical analysis of the solid propellant rocket engines for use with the space shuttle is presented. The subjects discussed are: (1) solid rocket motor stage recovery, (2) environmental effects, (3) man rating of the solid propellant rocket engines, (4) system safety analysis, (5) ground support equipment, and (6) transportation, assembly, and checkout.

Source record↗

NASA NTRS1972

Liquid propellant rockets.

A brief overview of the state of knowledge in liquid rocket technology is presented and examples are provided of instances where some fundamental principles of chemistry, fluid mechanics, and mathematics can be applied. A liquid propellant rocket classification is discussed together with rocket system performance, applications for liquid propellants, the effective exhaust velocity, aspects of simplified nozzle expansion, questions about theoretical propellant performance, the effect of chamber pressure on equilibrium performance, and the kinetic recombination in nozzles. Details of propellant combustion are examined, giving attention to propellant injection, evaporation-controlled combustion, combustion instability, and monopropellant decomposition.

Dipprey, D. F.↗

NASA NTRS1973

Comparison of particle results from a sounding rocket and a geosynchronous satellite

Auroral data from the ATS 5 geosynchronous satellite and an auroral rocket are compared with the purpose of illustrating some problems which will arise in comparison of data from the GEOS satellite and coordinated rocket experiments. It is recommended that all sky cameras be used in such studies and that since conjugacy between satellite and rocket cannot be guaranteed, the difference should be measured.

Johnstone, A. D.↗

NASA NTRS1973

The resolution of temporal and spatial variations in auroral particle measurements from sounding rockets

The problems involved in the resolution of the temporal/spatial ambiguity in sounding rocket observations are discussed with reference to an experiment involving a mother-daughter rocket combination, together with a flashing light beacon on the rocket and television cameras on the ground. The ambiguity was successfully removed, enabling a proper interpretation of the observations of precipitating low energy electrons to be made.

Johnstone, A. D.↗

NASA NTRS1974

Development of a miniature solid propellant rocket motor for use in plume simulation studies

A miniature solid propellant rocket motor has been developed to be used in a program to determine those parameters which must be duplicated in a cold gas flow to produce aerodynamic effects on an experimental model similar to those produced by hot, particle-laden exhaust plumes. Phenomena encountered during the testing of the miniature solid propellant motors included erosive propellant burning caused by high flow velocities parallel to the propellant surface, regressive propellant burning as a result of exposed propellant edges, the deposition of aluminum oxide on the nozzle surfaces sufficient to cause aerodynamic nozzle throat geometry changes, and thermal erosion of the nozzle throat at high chamber pressures. A series of tests was conducted to establish the stability of the rocket chamber pressure and the repeatibility of test conditions. Data are presented which define the tests selected to represent the final test matrix. Qualitative observations are also presented concerning the phenomena experienced based on the results of a large number or rocket tests not directly applicable to the final test matrix.

Baran, W. J.↗

NASA NTRS1974

Liquid rocket combustion computer model with distributed energy release. DER computer program documentation and user's guide, volume 1

A computer program for analyzing rocket engine performance was developed. The program is concerned with the formation, distribution, flow, and combustion of liquid sprays and combustion product gases in conventional rocket combustion chambers. The capabilities of the program to determine the combustion characteristics of the rocket engine are described. Sample data code sheets show the correct sequence and formats for variable values and include notes concerning options to bypass the input of certain data. A seperate list defines the variables and indicates their required dimensions.

Combs, L. P.↗