Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “hot wire”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 379 records · Page 21
All sourcesNASA NTRSDOE OSTI
NASA NTRS1976

Measurements in the near-wall region of a relaxing three-dimensional low speed turbulent air boundary layer

An experimental investigation was conducted at selected locations of the near-wall region of a three dimensional turbulent air boundary layer relaxing in a nominally zero external pressure gradient behind a transverse hump (in the form of a 30 deg swept, 5-foot chord wing-type model) faired into the side wall of a low speed wind tunnel. Wall shear stresses measured with a flush-mounted hot-film gage and a sublayer fence were in very good agreement with experimental data obtained with two Preston probes. With the upstream unit Reynolds number held constant at 325,000/ft. approximately one-fourth of the boundary layer thickness adjacent to the wall was surveyed with a single rotated hot-wire probe mounted on a specially designed minimum interference traverse mechanism. The boundary layer (approximately 3.5 in thick near the first survey station where the length Reynolds number was 5.5 million) had a maximum crossflow velocity ratio of 0.145 and a maximum crossflow angle of 21.875 deg close to the wall.

Hebbar, K. S.↗
NASA NTRS1976

Turbulence measurements in hypersonic shock-wave boundary-layer interaction flows

Turbulent intensity and Reynolds shear stress measurements are presented for two nonadiabatic hypersonic shock-wave boundary-layer interaction flows, one with and one without separation. These measurements were obtained using a new hot-wire probe specially designed for heated flows. Comparison of the separated and attached flows shows a significant increase above equilibrium values in the turbulent intensity and shear stress downstream of the interaction region for the attached case, while for the separated case, the turbulent fluxes remain close to equilibrium values. This effect results in substantial differences in turbulence lifetimes for the two flows. It is proposed that these differences are due to a coupling between the turbulent energy and separation bubble unsteadiness, a hypothesis supported by the statistical properties of the turbulent fluctuations.

Mikulla, V.↗
NASA NTRS1976

Experimental investigation of oscillations in flows over shallow cavities

Wind tunnel experiments were carried out with three axisymmetric models to study laminar axisymmetric flows over shallow cavities at low subsonic speeds. The first model had a hemispherical nose, the second an ogive-shape nose, and the third an elliptic nose. Constant-temperature hot-wire anemometry was used in measuring both mean and fluctuating quantities. Flow around the cavity was visualized by heating the first model. To study the effect of mass injection on cavity oscillations, air was injected circumferentially all along the base of the cavity. Major results are that the cavity depth has little effect on oscillations in shallow cavities except when the depth is of the order of the thickness of the cavity shear flow, that downstream corner is the key factor in inducing self-sustained oscillations in the cavity shear layer, and that the presence of a back face results in an integral relation between wave length of the propagating disturbances and the cavity width in each mode of cavity operation.

Sarohia, V.↗
NASA NTRS1976

Wake-related sound generation from isolated airfoils

A model for the prediction of wake-related sound generation by a single airfoil is presented which assumes that the net force fluctuation on an airfoil can be expressed in terms of the net momentum fluctuation in the near wake of the airfoil. The model predicts a forcing function for sound generation which is related to the spectra of the two-point velocity correlations in the turbulent region near the airfoil trailing edge. Cross spectra were obtained from correlations of the longitudinal and transverse components of turbulence in the wake of a 36-in. chord airfoil in a wind tunnel using x-probe hot-wire sensors. Additional data were obtained from a 10-in. chord airfoil in a free-jet facility. Based on results from these tests, a scaling model was developed using the turbulent boundary-layer thickness as the primary length measure. The model was used to predict the sound radiated from a 2-in. chord airfoil for which acoustical data was available; good agreement was obtained both in level and spectral shape. The single-airfoil result is extended to a rotor geometry, and comparisons are studied for various aerodynamic parameters.

Clark, L. T.↗
NASA NTRS1975

Sound and fluctuating disturbance measurements in the settling chamber and test section of a small, Mach 5 wind tunnel

Disturbance measurements were made using a hot-wire anemometer and piezoelectric pressure transducers in the settling chamber and free stream of a small Mach 5 wind tunnel. Results from the two instruments are compared and acoustical disturbances in the settling chamber are discussed. The source of the test-section noise is identified as nozzle-wall waviness at low Reynolds numbers and as eddy-Mach-wave radiation from the turbulent boundary layer on the nozzle wall at high Reynolds numbers.

Anders, J. B.↗
NASA NTRS1975

Turbulence stress measurements in a nonadiabatic hypersonic boundary layer

Turbulent shear stress and direct turbulent total heat-flux measurements have been made across a nonadiabatic, zero pressure gradient, hypersonic boundary layer by using specially designed hot-wire probes free of strain-gauging and wire oscillation. Heat-flux measurements were in reasonably good agreement with values obtained by integrating the energy equation using measured profiles of velocity and temperature. The shear-stress values deduced from the measurements, by assuming zero correlation of velocity and pressure fluctuations, were lower than the values obtained by integrating the momentum equation. Statistical properties of the cross-correlations are similar to corresponding incompressible measurements at approximately the same momentum-thickness Reynolds number.

Mikulla, V.↗
NASA NTRS1976

A laser velocimeter system for small radial turbomachinery

The paper describes the design and test of a laser Doppler velocimeter (LDV) to map the velocity fields in small high-speed turbomachinery. This instrument is presently being used as a diagnostic tool for the study of the basic fluid dynamics of the inducer, impeller and the diffuser regions of high-pressure-ratio small centrifugal compressors. The LDV instrumentation has been optimized to permit measurement of instantaneous velocities up to approximately 500 m/s within a rotating impeller. It is shown that LDV can make nondisturbing gas velocity measurements and surmount the difficulties found in applying other types of aerodynamic instrumentation, e.g., hot-wire anemometers, to this measurement problem.

Runstadler, P. W., Jr.↗
NASA NTRS1976

Turbulence measurements in hypersonic shock-wave boundary-layer interaction flows

Turbulent intensity and Reynolds shear stress measurements are presented for two nonadiabatic hypersonic shock-wave boundary-layer interaction flows, one with and one without separation. These measurements were obtained using a new hot-wire probe specially designed for heated flows. Comparison of the separated and attached flows shows a significant increase above equilibrium values in the turbulent intensity and shear stress downstream of the interaction region for the attached case, while for the separated case, the turbulent fluxes remain close to equilibrium values. This effect results in substantial differences in turbulence lifetime for the two flows. We propose that these differences are due to a coupling between the turbulent energy and separation bubble unsteadiness, a hypothesis supported by the statistical properties of the turbulent fluctuations.

Mikulla, V.↗
NASA NTRS1976

Fluctuating disturbances in a Mach 5 wind tunnel

An experimental investigation has been conducted to determine the source and nature of disturbances in the settling chamber and test section of a Mach 5 wind tunnel. Various changes in the air supply piping to the wind tunnel are shown to influence the disturbance levels in the settling chamber. These levels were reduced by the use of an acoustic muffler section in the settling chamber. Three nozzles were tested with the same settling chamber and hot-wire measurements indicated that the test section disturbances were entirely acoustic. Significant reductions in the test section noise levels were obtained with an electroplated nozzle utilizing boundary-layer removal upstream of the throat. The source of test section noise is shown to be different for laminar and turbulent nozzle-wall boundary layers.

Anders, J. B.↗
NASA NTRS1976

Turbulence measurement in transonic flow

The paper examines the response of a hot-wire anemometer in transonic flow in a variable-density closed-circuit wind tunnel and presents measurements obtained in a transonic turbulent boundary layer. Typical calibration curves are shown which indicate that, in contrast to previous work, the wire can be operated in a condition that will allow a single sensitivity to the velocity-density product rather than to density and velocity independently. Using these calibrations, measurements of fluctuating density and velocity obtained in a 0.8 M turbulent boundary layer are obtained. Agreement with independently obtained velocity fluctuations justifies both the calibration and data reduction procedures.

Rose, W. C.↗
NASA NTRS1976

Sound generated in the vicinity of the trailing edge of an upper surface blown flap

Far-field noise data indicated that for practical upper surface blown flap configurations, the noise radiated below the flap is dominated by the noise generated in the vicinity of the trailing edge. Sound field by turbulent mixing in the trailing edge wake is investigated experimentally and theoretically. Hot-wire measurements were made downstream of the trailing edge to determine the gross turbulence mixing characteristics of the flow. This information is used as input to a theoretical analysis of the sound field. Favorable agreement is found between predicted and measured far-field noise directivities at various frequencies and noise power spectra at various directions.

Tam, C. K. W.↗
NASA NTRS1976

An experimental and computational investigation of the flow field about a transonic airfoil in supercritical flow with turbulent boundary-layer separation

A combined experimental and computational research program for testing and guiding turbulence modeling within regions of separation induced by shock waves incident on turbulent boundary layers is described. Specifically, studies are made of the separated flow over the rear portion of an 18%-thick circular-arc airfoil at zero angle of attack in high Reynolds number supercritical flow. The measurements include distributions of surface static pressure and local skin friction. The instruments employed include high-frequency response pressure cells and a large array of surface hot-wire skin-friction gages. Computations at the experimental flow conditions are made using time-dependent solutions of ensemble-averaged Navier-Stokes equations, plus additional equations for the turbulence modeling.

Rubesin, M. W.↗
NASA NTRS1976

Evaluation of mean and turbulent velocity measurements in subsonic accelerated boundary layers

Exploratory measurements of the mean and turbulent flow in the wall boundary layer of a 15.2- by 10.2-cm channel were obtained as part of an instrumentation development program for measurements in compressible flow. Mean surface and flow field surveys were obtained at channel Mach numbers ranging from 0.2 to 0.9. The mean velocity distributions were obtained with total pressure probes and a laser velocimeter. At a channel Mach number of 0.2, several types of hot-wire probes were used to obtain both velocity fluctuations and Reynolds shear-stress results.

Sandborn, V. A.↗
NASA NTRS1976

An experimental study of a self-confined flow with ring-vorticity distribution

A new form of self-confined flow was investigated in which a recirculation zone forms away from any solid boundary. An inviscid flow analysis indicated that in a purely meridional axisymmetric flow a stationary, spherical, self-confined region should occur in the center of a streamlined divergent-convergent enlargement zone. The spherical confinement region would be at rest and at constant pressure. Experimental investigations were carried out in a specially built test apparatus to establish the desired confined flow. The streamlined divergent-convergent interior shape of the test section was fabricated according to the theoretical calculation for a particular streamline. The required inlet vorticity distribution was generated by producing a velocity profile with a shaped gauze screen in the straight pipe upstream of the test section. Fluid speed and turbulence intensity were measured with a constant-temperature hot-wire anemometer system. The measured results indicated a very orderly and stable flow field.

Lin, K. M.↗
NASA NTRS1976

Measurements in the mixing region of a turbulent jet in a coflowing airstream

The mixing region of a turbulent jet is an important example of an intermittent turbulent shear flow. There are a great deal of interest in this region because of interest in jet noise and STOL aircraft which use upper surface blowing or externally blown flap configurations to increase lift. A detailed study of the one point statistical properties of a smoke laden jet was made using a combination of a laser velocimeter and a light scattering system. The jet, with a 14 to 1 contraction, was placed inside a wind tunnel where the ratio of the jet exit velocity to free stream was 5.1 to 1. All measurements are made for a jet Reynolds number of 22,600. Among the quantities measured are mean axial and radial velocities, axial and radial intensities, power spectra, mean smoke concentration, concentration intensities, concentration spectra, intermittencies and velocity-concentration correlations. The results are compared with hot-wire data where available.

Morton, J. B.↗
NASA NTRS1977

Merging of aircraft trailing vortices

A merging-distance criterion for equal-strength corotational vortices is derived from low-turbulence wind-tunnel flow-visualization data. The vortex separation distance is normalized by defining a vortex core diameter based on circulation defect and angular-momentum defect. Merging may take place for larger separation distances than predicted from earlier two-dimensional inviscid calculations, which indicates that viscosity and possibly three-dimensional effects are important factors in the merging phenomenon. Hot-wire velocity distributions and rolling-moment measurements show that attenuation of the vortex hazard is associated with vortex merging.

Brandt, S. A.↗
NASA NTRS1977

Turbulence measurements in axisymmetric supersonic boundary layer flow in adverse pressure gradients

Mean flow and turbulence measurements are presented for adiabatic compressible turbulent boundary layer flow in adverse pressure gradients. The gradients were induced on the wall of an axially symmetric wind tunnel by contoured centerbodies mounted on the wind tunnel centerline. The boundary layer turbulence downstream of a boundary layer bleed section in a zero pressure gradient was also examined. The measurements were obtained using a constant temperature hot-wire anemometer. The adverse pressure gradients were found to significantly alter the turbulence properties of the boundary layer. With flow through the bleed holes there was a measureable decrease in the rms longitudinal velocity fluctuations near the wall and the turbulent shear stress in the boundary layer was reduced.

Gootzait, E.↗
NASA NTRS1977

Jet noise source modification due to forward flight

The effects of forward flight on the turbulence characteristics of a jet in a co-flowing stream have been determined for a 2.22 inch circular jet in a 36 inch free jet wind tunnel. The nozzle exit velocity was 400 ft/sec, and the tunnel velocity was set at 0, 40, 120 and 200 ft/sec. Measurements of flow properties including mean velocity, turbulence intensity and spectra, convection velocity, integral length scale, and convected integral time scale were carried out using two linearized hot wires. Results were used to predict changes due to flight in the jet acoustic sources. The noise reductions for a cold jet with a velocity of 1000 ft/sec, due to the change in acoustic sources in flight, agreed well at all angles with measured noise reductions.

Larson, R. S.↗