Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “electronics analysis”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 379 records · Page 21

Toward a tunable fabrication of multifunctional iron-aluminum spinels via solution combustion synthesis: The effects of fuel, heating mode, and Fe:Al precursor ratio

The solid solutions of iron and aluminum spinels (hercynite, maghemite, magnetite, and γ-alumina) are promising materials for emerging technologies such as solar thermochemical fuel production and clean dehydrogenation of fossil fuels. Solution combustion synthesis (SCS) is an attractive technique for the fabrication of these materials as it has been used for synthesis of many nanoscale oxides. However, the design space of SCS is large with many synthesis parameters affecting the properties of the combustion products. To optimize the SCS of these materials, it is important to determine which parameters yield the best properties. In the present work, FeAlO x nanocomposites were obtained by SCS using iron nitrate and aluminum nitrate as precursors and oxidizers. Two fuels (citric acid and glycine), three Fe:Al molar ratios (1:2, 1:1, and 2:1) in the precursors, and three heating modes (hotplate, muffle furnace, and microwave oven) were compared. The products were characterized by X-ray diffraction analysis, scanning electron microscopy, Brunauer-Emmett-Teller surface area analysis, and laser diffraction particle size analysis. The fuel used had the largest impact on the combustion behavior and hence the material properties. The high combustion temperature of glycine allowed for the formation of an FeAl 2 O 4 /Fe 3 O 4 solid solution, while the lower-temperature combustion of citric acid yielded Al-substituted γ-Fe 2 O 3 with high amorphous content. With citric acid, the specific surface area as high as 200 m 2 /g was achieved. The effect of Fe:Al precursor ratio was clearly seen in variations of the lattice parameter, which demonstrated the ability to tune the phase composition. The heating mode had minor effects on material properties, but some differences were observed. As a result, all products obtained by SCS in a microwave oven had low specific surface areas compared to those obtained with a hotplate and a muffle furnace.

Alumina↗

Analysis of the structural, electronic, elastic and thermodynamic properties of CuAl2X4 (X = O, S) spinel structure

Highlights: • Fundamental properties of CuAl{sub 2}X{sub 4} (X = O, S) aluminate spinels have been investigated. • The pressure dependence of the elastic constants C{sub ij} can be successfully fit by a straight line. • CuAl{sub 2}X{sub 4} (X = O, S) compounds are mechanically stable at ambient conditions. • Temperature and pressure dependences of some macroscopic parameters are achieved. - Abstract: The structural, electronic, elastic and thermodynamic properties of oxo- and thio-spinels have been predicted based on the ultrasoft pseudo-potential scheme as implemented in the CASTEP code. The exchange-correlation potential was treated within the generalized gradient approximation (GGA-PBE). The calculated structural parameters such as lattice constants and internal parameters are in good agreement with the available experimental data. The ground state electronic band structure revealed that CuAl{sub 2}X{sub 4} (XO, S) spinels are direct band gap semiconductors with a transition along Γ-Γ symmetry points. The calculated values of elastic constants satisfy the Born criteria at ambient conditions and confirm that the spinel structures of CuAl{sub 2}O{sub 4} and CuAl{sub 2}S{sub 4} are mechanically stable. The thiospinel structure may have a phase transition under pressure, due to the negative value of C{sub 44}. The influence of temperature and pressure on macroscopic characteristics of CuAl{sub 2}O{sub 4} and CuAl{sub 2}S{sub 4} compounds was estimated using the quasi-harmonic Debye model.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Three-dimensional nonlinear efficiency enhancement analysis in free-electron laser amplifier with prebunched electron beam and ion-channel guiding

Efficiency enhancement in free-electron laser is studied by three-dimensional and nonlinear simulation using tapered helical wiggler magnetic field or tapered ion-channel density. In order to reduce the saturation length, prebunched electron beam is used. A set of nonlinear and coupled differential equations are derived that provides the self-consistent description of the evolution of both an ensemble of electrons and the electromagnetic radiation. These equations are solved numerically to show that the combined effect of tapering and prebunching results in significant enhancement of power and considerable reduction of the saturation length. To have a deeper insight into the problem, an analytical treatment is also presented that uses the small signal theory to derive a modified pendulum equation.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Non-perturbative analysis of space charge limited electron flow in critical regimes

The combined Eulerian-Lagrangian formalism, developed in our previous work for studying the turn on regime of a one-dimensional diode, is extended for wider versatility and better precision in the study of the time dependent space charge limited electron flow with fixed injected current. An analytical analysis is supplemented with an approximate numerical scheme which appears to be sufficiently accurate to calculate the flow evolution until the process approaches stabilization or becomes unstable. This can be compared with properties of stationary flows and showed to be in a good agreement with them. When the stabilization is impossible, the ratio of anode to cathode currents is decreasing and thus the space charge is accumulated in the diode. We discuss the limitations of our approach and give some qualitative estimates for the flow parameters when stabilization is impossible.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Quasi-linear analysis of the extraordinary electron wave destabilized by runaway electrons

Runaway electrons with strongly anisotropic distributions present in post-disruption tokamak plasmas can destabilize the extraordinary electron (EXEL) wave. The present work investigates the dynamics of the quasi-linear evolution of the EXEL instability for a range of different plasma parameters using a model runaway distribution function valid for highly relativistic runaway electron beams produced primarily by the avalanche process. Simulations show a rapid pitch-angle scattering of the runaway electrons in the high energy tail on the 100–1000 μs time scale. Due to the wave-particle interaction, a modification to the synchrotron radiation spectrum emitted by the runaway electron population is foreseen, exposing a possible experimental detection method for such an interaction.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Depth-resolved ultra-violet spectroscopic photo current-voltage measurements for the analysis of AlGaN/GaN high electron mobility transistor epilayer deposited on Si

We have demonstrated that the depth-dependent defect distribution of the deep level traps in the AlGaN/GaN high electron mobility transistor (HEMT) epi-structures can be analyzed by using the depth-resolved ultra-violet (UV) spectroscopic photo current-voltage (IV) (DR-UV-SPIV). It is of great importance to analyze deep level defects in the AlGaN/GaN HEMT structure, since it is recognized that deep level defects are the main source for causing current collapse phenomena leading to reduced device reliability. The AlGaN/GaN HEMT epi-layers were grown on a 6 in. Si wafer by metal-organic chemical vapor deposition. The DR-UV-SPIV measurement was performed using a monochromatized UV light illumination from a Xe lamp. The key strength of the DR-UV-SPIV is its ability to provide information on the depth-dependent electrically active defect distribution along the epi-layer growth direction. The DR-UV-SPIV data showed variations in the depth-dependent defect distribution across the wafer. As a result, rapid feedback on the depth-dependent electrical homogeneity of the electrically active defect distribution in the AlGaN/GaN HEMT epi-structure grown on a Si wafer with minimal sample preparation can be elucidated from the DR-UV-SPIV in combination with our previously demonstrated spectroscopic photo-IV measurement with the sub-bandgap excitation.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Design, fabrication, and performance analysis of GaN vertical electron transistors with a buried p/n junction

The Current Aperture Vertical Electron Transistor (CAVET) combines the high conductivity of the two dimensional electron gas channel at the AlGaN/GaN heterojunction with better field distribution offered by a vertical design. In this work, CAVETs with buried, conductive p-GaN layers as the current blocking layer are reported. The p-GaN layer was regrown by metalorganic chemical vapor deposition and the subsequent channel regrowth was done by ammonia molecular beam epitaxy to maintain the p-GaN conductivity. Transistors with high ON current (10.9 kA/cm{sup 2}) and low ON-resistance (0.4 mΩ cm{sup 2}) are demonstrated. Non-planar selective area regrowth is identified as the limiting factor to transistor breakdown, using planar and non-planar n/p/n structures. Planar n/p/n structures recorded an estimated electric field of 3.1 MV/cm, while non-planar structures showed a much lower breakdown voltage. Lowering the p-GaN regrowth temperature improved breakdown in the non-planar n/p/n structure. Combining high breakdown voltage with high current will enable GaN vertical transistors with high power densities.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Band-to-band tunneling distance analysis in the heterogate electron–hole bilayer tunnel field-effect transistor

In this work, we analyze the behavior of the band-to-band tunneling distance between electron and hole subbands resulting from field-induced quantum confinement in the heterogate electron–hole bilayer tunnel field-effect transistor. We show that, analogously to the explicit formula for the tunneling distance that can be easily obtained in the semiclassical framework where the conduction and valence band edges are allowed states, an equivalent analytical expression can be derived in the presence of field-induced quantum confinement for describing the dependence of the tunneling distance on the body thickness and material properties of the channel. This explicit expression accounting for quantum confinement holds valid provided that the potential wells for electrons and holes at the top and bottom of the channel can be approximated by triangular profiles. Analytical predictions are compared to simulation results showing very accurate agreement.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Analysis of the structural, electronic and optic properties of Ni doped MgSiP{sub 2} semiconductor chalcopyrite compound

The structural, electronic band structure and optic properties of the Ni doped MgSiP{sub 2} chalcopyrite compound have been performed by using first-principles method in the density functional theory (DFT) as implemented in Vienna Ab-initio Simulation Package (VASP). The generalized gradient approximation (GGA) in the scheme of Perdew, Burke and Ernzerhof (PBE) is used for the exchange and correlation functional. The present lattice constant (a) follows generally the Vegard’s law. The electronic band structure, total and partial density of states (DOS and PDOS) are calculated. We present data for the frequency dependence of imaginary and real parts of dielectric functions of Ni doped MgSiP{sub 2}. For further investigation of the optical properties the reflectivity, refractive index, extinction coefficient and electron energy loss function are also predicted. Our obtained results indicate that the lattice constants, electronic band structure and optical properties of this compound are dependent on the substitution concentration of Ni.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Analysis of the fast electron scaling theory for the heating of a solid target

Simple scaling laws for laser-generated fast electron heating of solids that employ a Spitzer-like resistivity are unlikely to be universally adequate as this model does not produce an adequate description of a material's behaviour at low temperatures. This is demonstrated in this paper by using both numerical simulations and by comparing existing analytical scaling laws for low temperature resistivity. Generally, we find that, in the low temperature regime, the scaling for the heating of the background material has a much stronger dependence on the key empirical parameters (laser intensity, pulse duration, etc.).

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Analysis of magnetically immersed electron guns with non-adiabatic fields

Electron diode guns, which have strongly varying magnetic or electric fields in a cathode-anode gap, were investigated in order to generate laminar electron beams with high current density using magnetically immersed guns. By creating a strongly varying radial electric field in a cathode-anode gap of the electron gun, it was demonstrated that the optical properties of the gun can be significantly altered, which allows the generation of a laminar, high-current electron beam with relatively low magnetic field on the cathode. The relatively high magnetic compression of the electron beam achieved by this method is important for producing electron beams with high current density. A similar result can be obtained by inducing a strong variation of the magnetic field in a cathode-anode gap. It was observed that creating a dip in the axial magnetic field in the cathode-anode gap of an adiabatic electron gun has an optical effect similar to guns with strong variation of radial electric field. By analyzing the electron trajectories angles and presenting the results in a gun performance map different geometries of magnetically immersed electron guns with non-adiabatic fields are compared with each other and with a more traditional adiabatic electron gun. Some advantages and limitations of guns with non-adiabatic fields are outlined. In conclusion, the tests results of non-adiabatic electron gun with modified magnetic field are presented.

43 PARTICLE ACCELERATORS↗

Colour-producing [beta]-keratin nanofibres in blue penguin (Eudyptula minor) feathers

The colours of living organisms are produced by the differential absorption of light by pigments (e.g. carotenoids, melanins) and/or by the physical interactions of light with biological nanostructures, referred to as structural colours. Only two fundamental morphologies of non-iridescent nanostructures are known in feathers, and recent work has proposed that they self-assemble by intracellular phase separation processes. Here, we report a new biophotonic nanostructure in the non-iridescent blue feather barbs of blue penguins (Eudyptula minor) composed of parallel {beta}-keratin nanofibres organized into densely packed bundles. Synchrotron small angle X-ray scattering and two-dimensional Fourier analysis of electron micrographs of the barb nanostructure revealed short-range order in the organization of fibres at the appropriate size scale needed to produce the observed colour by coherent scattering. These two-dimensional quasi-ordered penguin nanostructures are convergent with similar arrays of parallel collagen fibres in avian and mammalian skin, but constitute a novel morphology for feathers. The identification of a new class of {beta}-keratin nanostructures adds significantly to the known mechanisms of colour production in birds and suggests additional complexity in their self-assembly.

77 NANOSCIENCE AND NANOTECHNOLOGY↗