Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “hot wire”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 361 records · Page 20
All sourcesNASA NTRSDOE OSTI
NASA NTRS1972

Aeroacoustic characteristics of jet flap type exhausts.

This work which is intended to shed more light on the acoustic and fluid dynamic characteristics of jet flap type exhaust flows, reports and discusses some typical experimental results obtained with cold model air jets in a reverberation chamber. Acoustic data on the total sound power output and the overall noise spectrum of various jet flap configurations are given and compared with data from conventional circular jets. In addition various flow data for the same jets resulting from hot wire measurements are reported and general conclusions are obtained regarding the expected noise source distribution. The results indicate the dependence of the acoustic and flow characteristics on the major nozzle parameters. For the jet flaps the total radiated sound power is found to follow a 3 to 6 power of the exhaust velocity while for the circular jets the 8 power law is confirmed. The noise produced in the secondary mixing region downstream of the flap trailing edge tends to exceed the noise issuing from the primary mixing region.

Gruschka, H. D.↗
NASA NTRS1972

Temperature and velocity field of the two-dimensional transverse hot-air jet in a freestream flow.

Experimental investigation of the low subsonic, two-dimensional transverse hot-air jet. In the study jet-to-freestream angles of 90, 120, 135, and 150 deg and jet-to-freestream velocity ratios of 5, 10, and 20 were investigated. In the tests the jet velocity and temperature fields were measured using a temperature-compensated hot-wire anemometer. Photographs of the flowfield were also made. The tests results are compared with the available data and analysis. Results indicate a relatively minor deflection of the freestream by the jet and the presence of a large separated flow region behind the jet.

Tatom, J. W.↗
NASA NTRS1972

Hypersonic transitional boundary layers.

Surface thin-film gages have been used to determine the extent of the transition region, intermittency distribution, and disturbance convection velocities in the boundary layer on a sharp 5-deg half angle cone at Mach 7.4 in the Ames 3.5-ft Hypersonic Wind Tunnel. In addition, extensive hot wire space-time correlation measurements have been obtained in the wind-tunnel freestream and in the transitional hypersonic boundary layer on a cone-ogive-cylinder in the same facility. Disturbance convection velocities have been obtained from the longitudinal cross correlation measurements as a function of fluctuation scale and distance from the wall. The results of normal cross correlation measurements are also discussed.

Owen, F. K.↗
NASA NTRS1972

Wind tunnel simulation of full scale vortices.

An experimental investigation has been conducted to determine the important scaling parameters for the flow in the core region of a vortex generated by a rectangular wing tip. The effect of an unconventional planform, the ogee tip, on the tip vortex is also determined. Data were measured for wing pitch angles of 6 and 9 deg at Mach numbers of 0.2, 0.5, and 0.6 for Reynolds numbers ranging from 440,000 to 7,000,000 using a triaxial hot wire probe. The probe was located at 2 and 5 chordlengths downstream from the trailing edge of the 4.25 inch and 26.0 inch chord wings. For rectangular planform wings, the measured vortex core diameter to chord ratios, peak tangential velocity ratios, and axial velocity ratios are shown to be functions only of wing lift coefficient and elapsed time from vortex formation, and appear to be independent of both Mach number and Reynolds number.

Rorke, J. B.↗
NASA NTRS1972

Recirculation patterns in the initial region of coaxial jets.

This experimental study is concerned with the mixing in the initial region of turbulent coaxial streams. The investigation is limited to the low-speed incompressible case with the inner stream of lower velocity than the outer stream. Velocity ratios ranged from infinity to one. The inner to outer stream density ratio was either 4 or 1. Experimental measurements were made with a hot-wire anemometer system, static pressure probes, and shadowgraphy. The data show that a backflow region is formed in this particular apparatus at outer to inner stream velocity ratio of 13 for the homogeneous case and at outer to inner stream velocity ratio of 26 for the heterogeneous case. For higher velocity ratio, a circulating toroidal vortex is established which enhances mixing between the inner and outer streams. This vortex pattern exhibits similarity of velocity with velocity ratio variations.

Rozenman, T.↗
NASA NTRS1972

On the structure of hypersonic turbulent boundary layers.

Extensive hot-wire auto- and cross-correlation measurements obtained in a fully developed compressible turbulent boundary layer are presented. A tentative mechanism of turbulence production and growth in hypersonic flow suggested by these measurements is developed. This flow model is consistent with previous observations in incompressible flows. Detailed measurements of the mean properties of the hypersonic turbulent boundary layer are also presented and compared with results from various transformation and finite-difference prediction methods. It is shown that none of the theories predict all the properties of the hypersonic turbulent boundary layer and that additional measurements are needed to provide more adequate physics of turbulent processes for use in the various theories.

Owen, F. K.↗
NASA NTRS1973

The behavior of a compressible turbulent boundary layer in a shock-wave-induced adverse pressure gradient

The results of an experimental investigation of the mean- and fluctuating-flow properties of a compressible turbulent boundary layer in a shock-wave-induced adverse pressure gradient are presented. The turbulent boundary layer developed on the wall of an axially symmetric nozzle and test section whose nominal free-stream Mach number and boundary-layer thickness Reynolds number were 4 and 100,000, respectively. The adverse pressure gradient was induced by an externally generated conical shock wave. Mean and time-averaged fluctuating-flow data, including the complete experimental Reynolds stress tensor and experimental turbulent mass- and heat-transfer rates are presented for the boundary layer and external flow, upstream, within and downstream of the pressure gradient. The mean-flow data include distributions of total temperature throughout the region of interest. The turbulent mixing properties of the flow were determined experimentally with a hot-wire anemometer. The calibration of the wires and the interpretation of the data are discussed. From the results of the investigation, it is concluded that the shock-wave - boundary-layer interaction significantly alters the turbulent mixing characteristics of the boundary layer.

Rose, W. C.↗
NASA NTRS1973

An evlauation of the three-dimensional split-film anemometer for measurements of atmospheric turbulence

A three-dimensional split-film anemometer was tested in turbulent, as well as in nonturbulent flow downstream from a wind tunnel turbulence grid. The data obtained with this probe in the turbulence behind the grid, indicated that the measured turbulence intensities were somewhat lower than the intensity measured with the conventional hot-wire anemometry; a result of the finite dimensions of the sensor arrays. The probe yaw angle was determined to be accurate within three degrees. Statistical averages, determined by mean-wind direction and vertical and lateral directions were computed on the basis of the probe yaw angle.

Tieleman, H. W.↗
NASA NTRS1973

A comparison of a coaxial focused laser Doppler system in atmospheric measurements

Measurements of atmospheric velocities and turbulence with the laser Doppler system were obtained, and the results compared with cup anemometer and hot-wire measurements in the same wind field. The laser Doppler velocimeter (LDV) is described along with the test procedures. It was found that mean values determined from the LDV data are within 5% of other anemometer data for long time periods, and the LDV measures higher velocities.

Karaki, S.↗
NASA NTRS1973

Investigations of three dimensional flow characteristics in a three bladed rocket pump inducer

Because of the long and narrow passages between the blades of a rocket pump inducer, major effects from turbulence and viscosity make the flow through such a device truly three-dimensional and therefore difficult to measure or predict. To investigate the flow characteristics, conventional and three-dimensional hot-wire probe measurements were conducted in a model inducer 3 ft in diameter. Blade-to-blade variation of the three components of velocity at the exit and the corresponding turbulence intensities were obtained by means of hotwire probes aligned in the three coordinate directions. Analysis of the three-dimensional inviscid flow field led to qualitative prediction of the flow characteristics. Extensive measurements and theoretical analyses of the flow field showed that blade blockage, viscosity, and blade boundary layer interactions are the dominant influences on flow in this type of turbomachinery.

Poncet, A.↗
NASA NTRS1972

Properties of cirrus generating cells.

Particle size spectra were measured during 20 hr of sampling in cirrus generating cells (uncinus, stratus, spissatus, thunderstorm anvil) and the particle concentration, mean crystal length, ice water content, reflectivity factor, and precipitation rate were calculated from these spectra. Average values of the physical properties in the generating cells were obtained. Growth was found to be downward, reaching a maximum ice water content just below the base of the generating cell. The maximum ice water contents (not including the thunderstorm anvil) were found in cirrus uncinus. Liquid water was not found throughout the cirrus sampling by measurement with the Johnson-Williams hot-wire liquid-water meter; however, it is believed that liquid water is present as a transient phase.

Heymsfield, A. J.↗
NASA NTRS1973

Turbulence measurements in a compressible boundary layer subjected to a shock-wave-induced adverse pressure gradient.

The rms intensities of fluctuating mass flux and total temperature and their correlation coefficients are given for the case of an adiabatic, Mach 4, axisymmetric shock-wave boundary-layer interaction. Data were obtained upstream, within, and downstream of the interaction by the use of constant temperature hot-wire anemometer. Turbulence spectra and quantitative behavior from oscilloscope traces are shown at selected locations. The measurements indicate that certain frequencies of the turbulence are increased as a result of the interaction and that the mass flux and total temperature fluctuations remain highly correlated over most of the boundary layer throughout the interaction. The present data are also transformed to rms intensities of fluctuating static temperature and velocity and compared with existing data obtained in adiabatic flows.

Rose, W. C.↗
NASA NTRS1973

Mean flow and turbulence measurements in a Mach 5 shear layer.

Hot-wire study of turbulent mixing in the near field of a Mach 5 jet with extension of the results into the hypersonic range. Mean and fluctuating measurement data are given for the free shear layer of the 10.6-cm diameter jet which was contained in a 61-by-61 cm vacuum chamber and exhausted into a diffuser 44 cm downstream of the jet exit. An auxiliary air supply was used to equalize the static pressures in the chamber and the nozzle. The nozzle wall boundary layer was turbulent at the jet exit, providing measurement data at higher Reynolds numbers, which are also included.

Morrisette, E. L.↗
NASA NTRS1973

Turbulent correlation measurements in a two-stream mixing layer.

Two point space-time measurements of the axial component of fluctuating velocity were made using linearized hot-wire anemometry. Space scales, convected frame correlations and time scales, and convection velocities in the shear layer were evaluated. Both filtered narrow and broad band convected frame autocorrelations were determined. Differences between axial broad band convection velocities and both mean turbulence and mean entrained fluid velocities were observed. Scaled broad band convection velocities for the mixing layer and simple round jets were found to collapse to a common curve. Axial narrow band convection velocities showed strong frequency and transverse position dependence.

Jones, B. G.↗
NASA NTRS1973

Concepts for a theoretical and experimental study of lifting rotor random loads and vibrations (further experiments with progressing/regressing rotor flapping modes), Phase 7-C

The experiments with progressing/regressing forced rotor flapping modes have been extended in several directions and the data processing method has been considerably refined. The 16 inch hingeless 2-bladed rotor model was equipped with a new set of high precision blades which removed previously encountered tracking difficulties at high advance ratio, so that tests up to .8 rotor advance ratio could be conducted. In addition to data with 1.20 blade natural flapping frequency data at 1.10 flapping frequency were obtained. Outside the wind tunnel, tests with a ground plate located at different distances below the rotor were conducted while recording the dynamic downflow at a station .2R below the rotor plane with a hot wire anemometer.

Hohenemser, K. H.↗
NASA NTRS1973

Three dimensional laser Doppler velocimeter turbulence measurements in a pipe flow

The mean and turbulent u, v, and w components of a gaseous fully developed turbulent pipe flow were measured with a laser Doppler velocimeter system. Measurements of important system parameters are presented and discussed in relation to the measurement accuracy. Simultaneous comparisons of the laser Doppler and hot wire anemometer measurements in the turbulent flow provided evidence that the two systems were responding to the same flow phenomena.

Fuller, C. E., III↗
NASA NTRS1974

Noise characteristics of jet flap type exhaust flows

An experimental investigation of the aerodynamic noise and flow field characteristics of internal-flow jet-augmented flap configurations (abbreviated by the term jet flap throughout the study) is presented. The first part is a parametric study of the influence of the Mach number (subsonic range only), the slot nozzle aspect ratio and the flap length on the overall radiated sound power and the spectral composition of the jet noise, as measured in a reverberation chamber. In the second part, mean and fluctuating velocity profiles, spectra of the fluctuating velocity and space correlograms were measured in the flow field of jet flaps by means of hot-wire anemometry. Using an expression derived by Lilley, an attempt was made to estimate the overall sound power radiated by the free mixing region that originates at the orifice of the slot nozzle (primary mixing region) relative to the overall sound power generated by the free mixing region that originates at the trailing edge of the flap (secondary mixing region). It is concluded that at least as much noise is generated in the secondary mixing region as in the primary mixing region. Furthermore, the noise generation of the primary mixing region appears to be unaffected by the presence of a flap.

Schrecker, G. O.↗