Demodulation of digital signals using an FM DISCRIMINATOR.
Frequency shift keyed /FSK/ digital signal detection using FM discriminators, predicting error rates for several sequences
SIGNAL DISCRIMINATOR↗
SEARCH · Engineering Papers
Results for “error rate”
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
High-Data-Rate Quadrax Cable Microwave Characterization at the NASA Glenn Structural Dynamics Laboratory
An experiment was performed to determine the degradation in the bit-error-rate (BER) in the high-data-rate cables chosen for the Orion Service Module due to extreme launch conditions of vibrations with a magnitude of 60g. The cable type chosen for the Orion Service Module was no. 8 quadrax cable. The increase in electrical noise induced on these no. 8 quadrax cables was measured at the NASA Glenn vibration facility in the Structural Dynamics Laboratory. The intensity of the vibrations was set at 32g, which was the maximum available level at the facility. The cable lengths used during measurements were 1, 4, and 8 m. The noise measurements were done in an analog fashion using a performance network analyzer (PNA) by recording the standard deviation of the transmission scattering parameter S(sub 21) over the frequency range of 100 to 900 MHz. The standard deviation of S(sub 210 was measured before, during, and after the vibration of the cables at the vibration facility. We observed an increase in noise by a factor of 2 to 6. From these measurements we estimated the increase expected in the BER for a cable length of 25 m and concluded that these findings are large enough that the noise increase due to vibration must be taken in to account for the design of the communication system for a BER of 10(exp -8).
Theofylaktos, Onoufrios↗
Serial concatenated trellis coded modulation with rate-1 inner code
We develop new, low complexity turbo codes suitable for bandwidth and power limited systems, for very low bit and word error rate requirements.
code↗
A cascaded coding scheme for error control
A cascaded coding scheme for error control was investigated. The scheme employs a combination of hard and soft decisions in decoding. Error performance is analyzed. If the inner and outer codes are chosen properly, extremely high reliability can be attained even for a high channel bit-error-rate. Some example schemes are studied which seem to be quite suitable for satellite down-link error control.
Kasami, T.↗
A cascaded coding scheme for error control
A cascade coding scheme for error control is investigated. The scheme employs a combination of hard and soft decisions in decoding. Error performance is analyzed. If the inner and outer codes are chosen properly, extremely high reliability can be attained even for a high channel bit-error-rate. Some example schemes are evaluated. They seem to be quite suitable for satellite down-link error control.
Shu, L.↗
BonVoision: Leveraging Spatial Data Smoothness For Recovery From Memory Soft Errors
The increasing soft error rates in memory systems raise an emerging concern for modern computing systems. As a result, detectable but uncorrectable errors (DUEs) become potentially more frequent and affect HPC applications. Today, upon encountering a DUE, HPC applications crash, incurring significant performance, storage, and energy overheads. In this paper, we propose a technique to continue application execution past a DUE through the repair of the corrupted memory data by leveraging spatial data smoothness. We present BonVoision, a run-time system that intercepts DUE events, analyzes the binary to identify data elements in the structural neighborhood of the event, and fixes the corrupted data elements by interpolating from the values in their neighborhood. Our evaluation demonstrates that BonVoision incurs negligible overhead and outperforms other recovery strategies by a factor of 2×, on average. We demonstrate that BonVoision also improves the efficiency of existing checkpointing/restart schemes by approximately increasing the optimal checkpoint interval by 23%.
Fang, Bo↗
Analysis of synchronous digital-modulation schemes for satellite communication
The multipath communication channel for space communications is modeled as a multiplicative channel. This paper discusses the effects of multiplicative channel processes on the symbol error rate for quadrature modulation (QM) digital modulation schemes. An expression for the upper bound on the probability of error is derived and numerically evaluated. The results are compared with those obtained for additive channels.
Takhar, G. S.↗
Performance of convolutionally coded unbalanced QPSK systems
An evaluation is presented of the performance of three representative convolutionally coded unbalanced quadri-phase-shift-keying (UQPSK) systems in the presence of noisy carrier reference and crosstalk. The use of a coded UQPSK system for transmitting two telemetry data streams with different rates and different powers has been proposed for the Venus Orbiting Imaging Radar mission. Analytical expressions for bit error rates in the presence of a noisy carrier phase reference are derived for three representative cases: (1) I and Q channels are coded independently; (2) I channel is coded, Q channel is uncoded; and (3) I and Q channels are coded by a common 1/2 code. For rate 1/2 convolutional codes, QPSK modulation can be used to reduce the bandwidth requirement.
Divsalar, D.↗
Compact disk error measurements
The objectives of this project are as follows: provide hardware and software that will perform simple, real-time, high resolution (single-byte) measurement of the error burst and good data gap statistics seen by a photoCD player read channel when recorded CD write-once discs of variable quality (i.e., condition) are being read; extend the above system to enable measurement of the hard decision (i.e., 1-bit error flags) and soft decision (i.e., 2-bit error flags) decoding information that is produced/used by the Cross Interleaved - Reed - Solomon - Code (CIRC) block decoder employed in the photoCD player read channel; construct a model that uses data obtained via the systems described above to produce meaningful estimates of output error rates (due to both uncorrected ECC words and misdecoded ECC words) when a CD disc having specific (measured) error statistics is read (completion date to be determined); and check the hypothesis that current adaptive CIRC block decoders are optimized for pressed (DAD/ROM) CD discs. If warranted, do a conceptual design of an adaptive CIRC decoder that is optimized for write-once CD discs.
Howe, D.↗
Reconfigurable Antennas for High Data Rate Multi-beam Communication Systems
High-speed (2-100 Mb/sec) wireless data communication - whether land- or satellite-based - faces a major challenge: high error rates caused by interference and unpredictable environments. A planar antenna system that can be reconfigured to respond to changing conditions has the potential to dramatically improve data throughput and system reliability. Moreover, new planar antenna designs that reduce array size, weight, and cost can have a significant impact on terrestrial and satellite communication system performance. This research developed new individually-reconfigurable planar antenna array elements that can be adjusted to provide multiple beams while providing increased scan angles and higher aperture efficiency than traditional diffraction-limited arrays. These new elements are microstrip spiral antennas with specialized tuning mechanisms that provide adjustable radiation patterns. We anticipate that these new elements can be used in both large and small arrays for inter-satellite communication as well as tracking of multiple mobile surface-based units. Our work has developed both theoretical descriptions as well as experimental prototypes of the antennas in both single element and array embodiments. The technical summary of the results of this work is divided into six sections: A. Cavity model for analysis and design of pattern reconfigurable antennas; B. Performance of antenna in array configurations for broadside and endfire operation; C. Performance of antenna in array configurations for beam scanning operation; D. Simulation of antennas in infinite phased arrays; E. Demonstration of antenna with commercially-available RF MEMS switches; F. Design of antenna MEMS switch combinations for direct simultaneous fabrication.
Bernhard, Jennifer T.↗
Digital simulation of a communication link for Pioneer Saturn Uranus atmospheric entry probe, part 1
A digital simulation study is presented for a candidate modulator/demodulator design in an atmospheric scintillation environment with Doppler, Doppler rate, and signal attenuation typical of the conditions of an outer planet atmospheric probe. The simulation results indicate that the mean channel error rate with and without scintillation are similar to theoretical characterizations of the link. The simulation gives information for calculating other channel statistics and generates a quantized symbol stream on magnetic tape from which error correction decoding is analyzed. Results from the magnetic tape data analyses are also included. The receiver and bit synchronizer are modeled in the simulation at the level of hardware component parameters rather than at the loop equation level and individual hardware parameters are identified. The atmospheric scintillation amplitude and phase are modeled independently. Normal and log normal amplitude processes are studied. In each case the scintillations are low pass filtered. The receiver performance is given for a range of signal to noise ratios with and without the effects of scintillation. The performance is reviewed for critical reciever parameter variations.
Hinrichs, C. A.↗
Active readout-error mitigation
Mitigating errors is a significant challenge for near-term quantum computers. One of the most important sources of errors is related to the readout of the quantum state into a classical bit stream. A variety of techniques have been proposed to mitigate these errors with post-hoc corrections. Here, we propose a complementary scheme to actively reduce readout errors on a shot-by-shot basis by encoding single qubits, immediately prior to readout, into multiqubit states. The computational resources of our technique are independent of the circuit depth and are compatible with the error rates and connectivity of many current devices. We analyze the potential of our approach using two types of error-correcting codes, and, as a proof of principle, we demonstrate an 80% improvement in readout error on the IBMQ Mumbai quantum computer.
97 MATHEMATICS AND COMPUTING↗
The CO2 laser frequency stability measurements
Carbon dioxide laser frequency stability data are considered for a receiver design that relates to maximum Doppler frequency and its rate of change. Results show that an adequate margin exists in terms of data acquisition, Doppler tracking, and bit error rate as they relate to laser stability and transmitter power.
Johnson, E. H., Jr.↗
Satellite inventory of Minnesota forest resources
The methods and results of using Landsat Thematic Mapper (TM) data to classify and estimate the acreage of forest covertypes in northeastern Minnesota are described. Portions of six TM scenes covering five counties with a total area of 14,679 square miles were classified into six forest and five nonforest classes. The approach involved the integration of cluster sampling, image processing, and estimation. Using cluster sampling, 343 plots, each 88 acres in size, were photo interpreted and field mapped as a source of reference data for classifier training and calibration of the TM data classifications. Classification accuracies of up to 75 percent were achieved; most misclassification was between similar or related classes. An inverse method of calibration, based on the error rates obtained from the classifications of the cluster plots, was used to adjust the classification class proportions for classification errors. The resulting area estimates for total forest land in the five-county area were within 3 percent of the estimate made independently by the USDA Forest Service. Area estimates for conifer and hardwood forest types were within 0.8 and 6.0 percent respectively, of the Forest Service estimates. A trial of a second method of estimating the same classes as the Forest Service resulted in standard errors of 0.002 to 0.015. A study of the use of multidate TM data for change detection showed that forest canopy depletion, canopy increment, and no change could be identified with greater than 90 percent accuracy. The project results have been the basis for the Minnesota Department of Natural Resources and the Forest Service to define and begin to implement an annual system of forest inventory which utilizes Landsat TM data to detect changes in forest cover.
Bauer, Marvin E.↗
NEMA NU 2-2012 performance studies for the SiPM-based ToF-PET component of the GE SIGNA PET/MR system
Purpose: The GE SIGNA PET/MR is a new whole body integrated time-of-flight (ToF)-PET/MR scanner from GE Healthcare. The system is capable of simultaneous PET and MR image acquisition with sub-400 ps coincidence time resolution. Simultaneous PET/MR holds great potential as a method of interrogating molecular, functional, and anatomical parameters in clinical disease in one study. Despite the complementary imaging capabilities of PET and MRI, their respective hardware tends to be incompatible due to mutual interference. In this work, the GE SIGNA PET/MR is evaluated in terms of PET performance and the potential effects of interference from MRI operation. Methods: The NEMA NU 2-2012 protocol was followed to measure PET performance parameters including spatial resolution, noise equivalent count rate, sensitivity, accuracy, and image quality. Each of these tests was performed both with the MR subsystem idle and with continuous MR pulsing for the duration of the PET data acquisition. Most measurements were repeated at three separate test sites where the system is installed. Results: The scanner has achieved an average of 4.4, 4.1, and 5.3 mm full width at half maximum radial, tangential, and axial spatial resolutions, respectively, at 1 cm from the transaxial FOV center. The peak noise equivalent count rate (NECR) of 218 kcps and a scatter fraction of 43.6% are reached at an activity concentration of 17.8 kBq/ml. Sensitivity at the center position is 23.3 cps/kBq. The maximum relative slice count rate error below peak NECR was 3.3%, and the residual error from attenuation and scatter corrections was 3.6%. Continuous MR pulsing had either no effect or a minor effect on each measurement. Conclusions: Performance measurements of the ToF-PET whole body GE SIGNA PET/MR system indicate that it is a promising new simultaneous imaging platform.
60 APPLIED LIFE SCIENCES↗
Equalization of data transmission cable
The paper describes an equalization approach utilizing a simple RLC network which can obtain a maximum slope of -12dB/octave for reshaping the frequency characteristics of a data transmission cable, so that data may be generated and detected at the receiver. An experimental procedure for determining equalizer design specifications using distortion analysis is presented. It was found that for lengths of 16 PEV-L cable of up to 5 miles and data transmission rates of up to 1 Mbs, the equalization scheme proposed here is sufficient for generation of the data with acceptable error rates.
Zobrist, G. W.↗
Error control techniques for satellite and space communications
The performance anlaysis of NASA's telecommand systems was summarized. It is assumed that the decoded frames are scrambled prior to decoding by the outer code. The average decoded bit error rate are examined which allows the possibility of evaluating many different frame coding options. The capacity and cutoff rate of the outer channel formed by the combination of the actual physical channel and the inner encoder and decoder in a concatenated coding system were analyzed. The best combination of inner and outer codes to use in a concatenated coding system were determined. It was established that in general: (1) it is better not to interleave between the inner and outer codes; and (2) for a fixed overall code rate, it is better to use higher rate inner codes and lower rate outer codes. Inner convolutional codes are considered. The analysis is more difficult in this case because the inner decoder error events do not appear in blocks of fixed length but can be of many different lengths.
Costello, D. J., Jr.↗
A cascaded error control coding scheme for space and satellite communication
An error control coding scheme for space and satellite communications is presented. The scheme is attained by cascading two codes, the inner and outer codes. Error performance of the scheme is analyzed. It is shown that, if the inner and outer codes are chosen properly, extremely high reliability can be achieved even for a high channel bit-error-rate. Several exmple schemes are studied. One of the example schemes is proposed to NASA for satellite or spacecraft downlink error control.
Lin, Shu↗