Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “K”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 361 records · Page 20
All sourcesNASA NTRSDOE OSTI
NASA NTRS2010

UV Absorption Cross Sections of Nitrous Oxide (N2O) and Carbon Tetrachloride (CCl4) Between 210 and 350 K and the Atmospheric Implications

Absorption cross sections of nitrous oxide (N2O) and carbon tetrachloride (CCl4) are reported at five atomic UV lines (184.95, 202.548, 206.200, 213.857, and 228.8 nm) at 27 temperatures in the range 210-350 K. In addition, UV absorption spectra of CCl4 are reported between 200-235 nm as a function of temperature (225-350 K). The results from this work are critically compared with results from earlier studies. For N2O, the present results are in good agreement with the current JPL recommendation enabling a reduction in the estimated uncertainty in the N2O atmospheric photolysis rate. For CCl4, the present cross section results are systematically greater than the current recommendation at the reduced temperatures most relevant to stratospheric photolysis. The new cross sections result in a 5-7% increase in the modeled CCl4 photolysis loss, and a slight decrease in the stratospheric lifetime, from 51 to 50 years, for present day conditions. The corresponding changes in modeled inorganic chlorine and ozone in the stratosphere are quite small. A CCl4 cross section parameterization for use in 37 atmospheric model calculations is presented.

Carlon, Nabilah Rontu↗
NASA NTRS2013

Reducing Earth Topography Resolution for SMAP Mission Ground Tracks Using K-Means Clustering

The K-means clustering algorithm is used to reduce Earth topography resolution for the SMAP mission ground tracks. As SMAP propagates in orbit, knowledge of the radar antenna footprints on Earth is required for the antenna misalignment calibration. Each antenna footprint contains a latitude and longitude location pair on the Earth surface. There are 400 pairs in one data set for the calibration model. It is computationally expensive to calculate corresponding Earth elevation for these data pairs. Thus, the antenna footprint resolution is reduced. Similar topographical data pairs are grouped together with the K-means clustering algorithm. The resolution is reduced to the mean of each topographical cluster called the cluster centroid. The corresponding Earth elevation for each cluster centroid is assigned to the entire group. Results show that 400 data points are reduced to 60 while still maintaining algorithm performance and computational efficiency. In this work, sensitivity analysis is also performed to show a trade-off between algorithm performance versus computational efficiency as the number of cluster centroids and algorithm iterations are increased.

ground tracks↗
NASA NTRS2016

Vanadium K Xanes Studies of EET79001 Impact-Melt Glasses Revisited

Some impact-melt glasses in shergottites are rich in Martian atmospheric noble gases and sulfur suggesting a possible association with regolith-derived secondary mineral assemblages in the shocked samples. Previously, we studied two glasses, # 506 (Lith C in Lith A) and # 507 (Lith C in Lith B) from EET79001 [1,2] and suggested that sulfur initially existed as sulfate in the glass precursor materials and, on shock-melting of the precursors, the sulfate was reduced to sulfides in the shock glasses. To examine the validity of this hypothesis, we used V K microXANES techniques to measure the valence states of vanadium in the Lith C glasses from Lith A and Lith B in EET79001 [3] to complement and com-pare with previous analogous measurements on,78 glass (Lith C in Lith A) [4,5]. We reported the preliminary results in [3]. Vanadium is ideal for addressing the redox issue because it has multiple valence states and is a well-studied element. Vanadium in basalts exists mostly as V(sup 3+), V(sup 4+) and V(sup 5+) in terrestrial samples, mainly as V(sup 3+) with minor V(sup 2+) and minor V(sup 4+) in lunar samples and as roughly equal mixtures of V(sup 3+) and V(sup 4+) in Martian meteorites. In this report, we discuss the application of the V K XANES results to decipher the nature of shock reduction occurring in the silicate glasses during the impact process.

Sutton, S. R.↗
NASA NTRS1969

Calibration of a resistance thermometer down to 0.04 degrees K

Method for calibrating germanium-resistance thermometers in cryostats between 0.4 degrees K and 4 degrees K involves extrapolating the specific heat of a simple metal to low temperatures. This method is used when a magnetic thermometer is not available.

Culbert, H. V.↗
NASA NTRS1969

Rotational relaxation in parahydrogen and its mixtures with helium, neon, and argon at 300 deg K.

Ultrasonic‐velocity dispersion measurements have been performed in parahydrogen and its mixtures with helium, neon, and argon, all at 300°K. In each case the experimental dispersion curves can be matched successfully to those calculated under the assumption that the 0–2 rotational transition relaxes separately from the 2–4 and higher‐order terms. For pure pH 2 we find a relaxation time 𝜏 20 of 1.30 × 10 −8 sec for the 2 → 0 transition and a 𝜏 42 of 3.90 × 10 −8 sec for the 4 → 2 transition. Comparison with the quantum‐mechanical theories of Roberts and of Davison for H 2 –H 2 collisions using Morse potentials shows good agreement for 𝜏 20 over the temperature range of 75°–300°K. The Morse‐potential asymmetry parameter yielding the best fit is β = 0.113 for Roberts' calculation and 0.108 for Davison's. It is found that He–pH 2 collisions are more effective than pH 2 –pH 2 in producing the J = 0 to J = 2 transition, but less effective for higher‐order transitions. Collisions of neon with pH 2 are found to be more effective at room temperature for inducing the 0 → 2 and 2 → 4 transitions than either helium or argon.

Leonard M Valley↗
NASA NTRS1971

Strain gage performance above 1033 K

Study provides compendium of test methods and results which may be used in evaluating high temperature environment gage behavior. Tests include resistance to ground and drift rate and gage factor variation as temperature function. Variation ranged from zero at room temperature (297 K) to 14.5 percent at 1053 K.

Nichols, D. W.↗
NASA NTRS1971

Thermodynamic properties and theoretical rocket performance of hydrogen to 100,000 K and 1.01325 x 10 to the 8th power N/sq m

The composition and thermodynamic properties were calculated for 100 to 110,000 K and 1.01325 x 10 to the 2nd power to 1.01325 x 10 to the 8th power N/sq m for chemical equilibrium in the Debye-Huckel and ideal-gas approximations. Quantities obtained were the concentrations of hydrogen atoms, protons, free electrons, hydrogen molecules, negative hydrogen ions, hydrogen diatomic molecular ions, and hydrogen triatomic molecular ions, and the enthalpy, entropy, average molecular weight, specific heat at constant pressure, density, and isentropic exponent. Electronically excited states of H and H2 were included. Choked, isentropic, one-dimensional nozzle flow with shifting chemical equilibrium was calculated to the Debye-Huckel and ideal-gas approximations for stagnation temperatures from 2500 to 100,000 K. The mass flow per unit throat area and the sonic flow factor were obtained. The pressure ratio, temperature, velocity, and ideal and vacuum specific impulses at the throat and for pressure ratios as low as 0.000001 downstream were found. For high temperatures at pressures approaching 1.01325 x 10 to the 8th power N/sq m, the ideal-gas approximation was found to be inadequate for calculations of composition, precise thermodynamic properties, and precise nozzle flow. The greatest discrepancy in nozzle flow occurred in the exit temperature, which was as much as 21 percent higher when the Debye-Huckel approximation was used.

Patch, R. W.↗
NASA NTRS1972

Testing superalloys at 2000 (1367) and 2200 F (1478 K) in a Mach 4.6 airstream

Seven superalloy models were tested in a plasma arc tunnel facility. The test models were 3 in. (7.62cm) square flat surfaces (nominally 0.01 to 0.02 in. (0.0254 to 0.0508 cm) thick) held in a water-cooled wedge holder at a 60 deg (1.05 rad) angle of attack. The models were cycled 25 times (two were cycled 50 times) for 10 min each cycle in a Mach 4.6 test stream with the model leading edge temperature maintained at 2200 F (1478 K) (one at 2000 F (1367 K)). Backface temperatures were measured with four platinum-platinum 10% rhodium thermocouples and the front surface temperatures with an optical pyrometer. Four different nickel base alloy materials and one cobalt material were evaluated.

Land, D. W.↗
NASA NTRS1972

The thermodynamic properties of nitrogen from 65 to 2000 K with pressures to 10,000 atmospheres

An equation of state is presented for liquid and gaseous nitrogen for temperatures from 65 degrees K to 2000 degrees K and pressures to 10,000 atmospheres. All the pressure-density-temperature data available from published literature have been corrected and applied to bring experimental temperatures into accord with the International Practical Temperature Scale of 1968. The coefficients of the equation of state were determined by a weighted least squares fit to selected published pressure-density-temperature data. The methods of weighting the various data for simultaneous fitting are presented and discussed.

Jacobsen, R. T.↗
NASA NTRS1972

The k-space formulation of the n-dimensional scattering problem

The n-dimensional scattering problem is solved by means of a k-space formulation of the field equations, thereby replacing the conventional integral equation formulation by a set of two algebraic equations in two unknowns in two spaces (the constitutive equation being an algebraic equation in x-space). These equations are solved by an iterative method with the aid of the fast Fourier transform (FFT) algorithm connecting the two spaces, requiring very simple initial approximations. Since algebraic and FFT equations are used, the number of arithmetic multiple-add operations and storage allocations required for a numerical solution are reduced from the order of N sq (for solving the matrix equations resulting from the conventional integral equations) to the order of N(log base 2 of N) and N, respectively (where N is the number of data points required for the specification of the problem). The advantage gained in speed and storage is thus of the order of N/log base 2 of N and N, respectively. This method is thus considerably more efficient than the conventional matrix method, and permits exact numerical solutions for much larger problems. Arguments are presented toward the view that the field equations are more fundamental in k-space. The details and some numerical results of the application of this method to the three-dimensional electromagnetic scattering problems are presented as an example.

Bojarski, N. N.↗
NASA NTRS1973

Unrestrained swelling of uranium-nitride fuel irradiated at temperatures ranging from 1100 to 1400 K (1980 to 2520 R)

Six fuel pins were assembled, encapsulated, and irradiated in the Plum Brook Reactor. The fuel pins employed uranium mononitride (UN) in a stainless steel (type 304L) clad. The pins were irradiated for approximately 4000 hours to burnups of about 2.0 atom percent uranium. The average clad surface temperature during irradiation was about 1100 K (1980 deg R). Since stainless steel has a very low creep strength relative to that of UN at this temperature, these tests simulated unrestrained swelling of UN. The tests indicated that at 1 percent uranium atom burnup the unrestrained diametrical swelling of UN is about 0.5, 0.8, and 1.0 percent at 1223, 1264, and 1306 K (2200, deg 2273 deg, and 2350 deg R), respectively. The tests also indicated that the irradiation induced swelling of unrestrained UN fuel pellets appears to be isotropic.

Rohal, R. G.↗
NASA NTRS1973

Microwave properties of n-type InSb in a magnetic field between 4 and 300 K.

A two-band conduction model is used to determine the properties of shallow-type impurity semiconductors in the presence of microwave and dc magnetic fields as a function of temperature. Measurements using cavity perturbation techniques are employed to determine the properties of n-type InSb and theoretical and experimental results between 4 and 300 K are compared. The hot-electron effect was found to be insignificant between 77 and 300 K, and the scattering mechanisms are dominated by acoustic and polar modes over the same temperature range.-

Eldumiati, I. I.↗
NASA NTRS1972

K-Ar dating of lunar fines - Apollo 12, Apollo 14, and Luna 16.

K-Ar ages were determined on a 6-in. double-focus mass spectrometer in fines of less than 1 mm from Apollo 14 and 16, and Luna 16 lunar soil samples. Age estimates of about 2.8 AE and about 4.0 AE are suggested for the two low-K components whose presence in the samples must be assumed to accommodate the age data. An average value of 0.1849 plus or minus 0.0008 was obtained for the Ar-18/Ar-36 ratio in the solar wind from ordinate intercept correlations for the Apollo 14 and Luna 16 samples. Cosmic ray exposure ages were close to 440 m.y. for both Apollo 14 samples and close to 840 m.y. for both Luna 16 samples.

Pepin, R. O.↗
NASA NTRS1974

New nickel-base wrought superalloy with applications up to 1253 K (1800 F)

Alloy possesses combination of high tensile strength at low and intermediate temperatures to 1033 K with good rupture strength at high temperatures to 1255 K. Alloy has promise for turbine disk application in future gas turbine engines and for wrought integrally bladed turbine wheel; thickness and weight of disk portion of wheel could be reduced.

Kent, W. B.↗
NASA NTRS1974

Experimental transient vane temperatures in a cascade for gas stream temperature cycling between 922 and 1644 K (1200 and 2500 F)

Experimental transient turbine vane metal temperatures were obtained from tests conducted on air-cooled vanes installed in a four-vane cascade for a gas temperature cycled between 922 and 1644 K (1200 and 2500 F). Transient data were recorded by a high-speed data acquisition system. Temperatures at the same phase of each transient cycle were repeatable between cycles to within 11 kelvins (20 F), simulated cruise and idle steady-state readings were repeated by the cruise and idle readings taken from the ends of a transient half-cycle at low pressure to within 17 kelvins (30 F). The tests were conducted at pressure levels of 31 and 83 N-sq cm (45 and 120 psia) with coolant temperatures of 811 and 589 K (1000 and 600 F), respectively.

Gauntner, D. J.↗