Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “INSURANCE”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 361 records · Page 20
All sourcesNASA NTRSDOE OSTI
NASA NTRS1979

Non-flammable polyimide materials for aircraft and spacecraft applications

Recent developments in polyimide chemistry show promise for producing materials with very low flammability and a wide range of mechanical properties. Polyimide foams can be synthesized to provide fire safety without detectable formation of smoke or toxic byproducts below 204 C (400 F), thus avoiding an environment which is lethal to human habitation. This work has been and is currently being performed under development programs, the objective of which is to provide cost effective processes for producing thermally stable, polyimide flexible resilient foams, thermal-acoustical insulating materials, rigid low density foam panels, and high strength foam structures. The chemical and physical properties demonstrated by these materials represent a technological advancement in the art of thermally stable polyimide polymers which are expected to insure fire protection of structures and components used in air transportation and space exploration. Data compiled to date on thermal, physical and functional properties of these materials are presented.

Gagliani, J.↗
NASA NTRS1980

Jig for assembling large composite panels

Layup of composite panels as large as 15 by 60 ft is greatly facilitated by simple mechanism. Jig consists of flat, detachable table, and curved laminating-plate joined by rack and pinion to insure accurate registration. Vacuum holds thin plastic film to laminating-plate. Preimpregnated composite sheet is applied to plate, which is then lowered face down onto table. Release of vacuum leaves layer and film and table. Film is peeled off, and steps are repeated for next layer of laminate.

Watts, J. T.↗
NASA NTRS1981

Motel solar hot-water installation--Atlanta, Georgia

Analysis of hardness of local water, average insolation for site, and daily hot water requirements insures suitability of solar-energy system design. Report describes two units which are designed to supply 81 percent of motel's annual hot water demand based on hypothetical 85 percent occupancy. Report includes drawings, operating and maintenance instructions, and test results for 1 day of operation.

Source record↗
NASA NTRS1979

Evaluation criteria for commercially oriented materials processing in space proposals

An approach and criteria for evaluating NASA funded experiments and demonstrations which have commercial potential were developed. Methods for insuring quick initial screening of commercial proposals are presented. Recommendations are given for modifying the current evaluation approach. New criteria for evaluating commercially orientated materials processing in space (MPS) proposals are introduced. The process for selection of qualified individuals to evaluate the phases of this approach and criteria is considered and guidelines are set for its implementation.

Moore, W. F.↗
NASA NTRS1979

Experimental setup for decomposition of UF6

The rate at which UF6 decomposes into UF5 and UF4 was determined as a function of neutron fluence. To study UF6 decomposition rate, an absorption cell for VUV and the associated VUV spectroscopy system was used to measure UF6 while under irradiation. The cell contains 50 torr of UF6 at room temperature to insure that the UF6 is in a gaseous state. It is shown that by determining the absorption coefficient below 2100A for UF6, above 2100A for F2, and at 4100A for cell degradation, UF6 decomposition can be measured at a neutron flux of 10 to the 12th power/sq cm for 72 continuous hours.

Rowe, M.↗
NASA NTRS1979

Residential photovoltaic module and array requirements study, appendices

Regional building code variations, federal and city codes, and the national electric code are reviewed for their possible effects on the design of photovoltaic modules. Problems that photovoltaic arrays may impose on the insurability of residences are also discussed. Mounting configurations are developed for the modules, and grounding, wiring, terminal, and voltage requirements are established. Installation and materials costs are presented along with performance criteria.

Nearhoof, S. L.↗
NASA NTRS1979

On the Performance of the Martin Digital Filter for High- and Low-pass Applications

A nonrecursive numerical filter is described in which the weighting sequence is optimized by minimizing the excursion from the ideal rectangular filter in a least squares sense over the entire domain of normalized frequency. Additional corrections to the weights in order to reduce overshoot oscillations (Gibbs phenomenon) and to insure unity gain at zero frequency for the low pass filter are incorporated. The filter is characterized by a zero phase shift for all frequencies (due to a symmetric weighting sequence), a finite memory and stability, and it may readily be transformed to a high pass filter. Equations for the filter weights and the frequency response function are presented, and applications to high and low pass filtering are examined. A discussion of optimization of high pass filter parameters for a rather stringent response requirement is given in an application to the removal of aircraft low frequency oscillations superimposed on remotely sensed ocean surface profiles. Several frequency response functions are displayed, both in normalized frequency space and in period space. A comparison of the performance of the Martin filter with some other commonly used low pass digital filters is provided in an application to oceanographic data.

Mcclain, C. R.↗
NASA NTRS1980

Validation Methods Research for Fault-Tolerant Avionics and Control Systems: Working Group Meeting, 2

The validation process comprises the activities required to insure the agreement of system realization with system specification. A preliminary validation methodology for fault tolerant systems documented. A general framework for a validation methodology is presented along with a set of specific tasks intended for the validation of two specimen system, SIFT and FTMP. Two major areas of research are identified. First, are those activities required to support the ongoing development of the validation process itself, and second, are those activities required to support the design, development, and understanding of fault tolerant systems.

Gault, J. W.↗
NASA NTRS1980

Wireless microphone communication system telephonics P/N 484D000-1

The wireless microphone is a lightweight, portable, wireless voice communications device for use by the crew of the space shuttle orbiter. The wireless microphone allows the crew to have normal hands-free voice communication while they are performing various mission activities. The unit is designed to transmit at 455 or 500 kilohertz and employs narrow band FM modulation. Two orthogonally placed antennas are used to insure good reception at the receiver.

Source record↗
NASA NTRS1980

Orbiter electrical equipment utilization baseline

The baseline for utilization of Orbiter electrical equipment in both electrical and Environmental Control and Life Support System (ECLSS) thermal analyses is established. It is a composite catalog of Space Shuttle equipment, as defined in the Shuttle Operational Data Book. The major functions and expected usage of each component type are described. Functional descriptions are designed to provide a fundamental understanding of the Orbiter electrical equipment, to insure correlation of equipment usage within nominal analyses, and to aid analysts in the formulation of off-nominal, contingency analyses.

Source record↗
NASA NTRS1980

Experimental investigation of the radiation of sound from an unflanged duct and a bellmouth, including the flow effect

The radiation of sound from an inlet as a function of flow velocity, frequency, duct mode structure, and inlet geometry was examined by using a spinning mode synthesizer to insure a given space-time structure inside the duct. Measurements of the radiation pattern (amplitude and phase) and of the pressure reflection coefficient were obtained over an azimuthal wave number range of 0 to 6 and a frequency range up to 5000 Hz for an unflanged duct and a bellmouth. The measured radiated field and pressure reflection coefficient without flow for the unflanged duct agree reasonably well with theory. The influence of the inlet contour appears to be very drastic near the cut-on frequency of a mode and reasonable agreement is found between the bellmouth pressure reflection coefficient and a infinite hyperboloidal inlet theory. It is also shown that the flow has a weak effect on the amplitude of the directivity factor but significantly shifts the directivity factor phase. The influence of the flow on the modulus of the pressure reflection coefficient is found to be well described by a theoretical prediction.

Ville, J. M.↗
NASA NTRS1979

Managing tort liability risks in the era of the Space Shuttle

A new section, named section 308 on 'Insurance and Indemnification', that was added to the National Aeronautics and Space Act of 1958, is discussed. The reasons behind the NASA proposed section are examined, and its various provisions mentioned, as well as outlining the steps needed to implement these provisions. Attention is given to the tort liability risks and to the various costs that NASA would need to cover in case of liability for death, bodily harm, or damage to property resulting from activities carried on in connection with the landing, operations or recovery of the Space Shuttle. The entire section and its six subsections are presented in two appendices.

Mossinghoff, G. J.↗
NASA NTRS1980

The impact of fuels on aircraft technology through the year 2000

In the future, it may be necessary to use jet fuels with a broader range of properties in order to insure a more flexible and reliable supply and to minimize energy consumption and processing costs at the refinery. This paper describes research being conducted to (1) determine the potential range of properties for future jet fuels, (2) establish a data base of fuel property effects on propulsion system components, (3) evolve and evaluate advanced component technology that would permit the use of broader property fuels and (4) identify technical and economic trade-offs within the overall fuel production-air transportation system associated with variations in fuel properties.

Grobman, J.↗
NASA NTRS1980

Flexible body stability analysis of Space Shuttle ascent flight control system by using lambda matrix solution techniques

A lambda matrix solution technique is being developed to perform an open loop frequency analysis of a high order dynamic system. The procedure evaluates the right and left latent vectors corresponding to the respective latent roots. The latent vectors are used to evaluate the partial fraction expansion formulation required to compute the flexible body open loop feedback gains for the Space Shuttle Digital Ascent Flight Control System. The algorithm is in the final stages of development and will be used to insure that the feedback gains meet the design specification.

Bown, R. L.↗
NASA NTRS1980

Observation of the plasma boundary layer at lunar distances - Direct injection of plasma into the plasma sheet

The paper presents observational evidence from the Apollo suprathermal ion detector experiments that the injection of magnetosheath particles at the low-latitude magnetopause operates at lunar distances as well. An interface between the magnetosheath and the plasma sheet, termed the plasma sheet boundary layer (PSBL), is identified and believed to be the extension of the magnetospheric boundary layer (also called the plasma boundary layer) observed on the dayside. Using measurements of the PSBL's thickness, magnetic field, and plasma velocity the average electric potential drop across the PSBL is estimated at 4.2 kV and compared with the potential drop which is needed to insure that the magnetopause is an equipotential for a closed magnetosphere. It was concluded though that the magnetosphere is open since this drop is much larger than 4.2 kV.

Sanders, G. D.↗
NASA NTRS1982

Cam-Design Torque Wrench

New Torque wrench for electrical connnectors automatically tightens its grip with increasing torque to insure against slippage. Tool requires only minimal clearance between connector and adjacent structures or components. Wrench is operated with one hand and can be used on connectors of various shapes.

Schick, P. H. J.↗
NASA NTRS1982

User Documentation for Multiple Software Releases

In proposed solution to problems of frequent software releases and updates, documentation would be divided into smaller packages, each of which contains data relating to only one of several software components. Changes would not affect entire document. Concept would improve dissemination of information regarding changes and would improve quality of data supporting packages. Would help to insure both timeliness and more thorough scrutiny of changes.

Humphrey, R.↗
NASA NTRS1980

An analytical technique for approximating unsteady aerodynamics in the time domain

An analytical technique is presented for approximating unsteady aerodynamic forces in the time domain. The order of elements of a matrix Pade approximation was postulated, and the resulting polynomial coefficients were determined through a combination of least squares estimates for the numerator coefficients and a constrained gradient search for the denominator coefficients which insures stable approximating functions. The number of differential equations required to represent the aerodynamic forces to a given accuracy tends to be smaller than that employed in certain existing techniques where the denominator coefficients are chosen a priori. Results are shown for an aeroelastic, cantilevered, semispan wing which indicate a good fit to the aerodynamic forces for oscillatory motion can be achieved with a matrix Pade approximation having fourth order numerator and second order denominator polynomials.

Dunn, H. J.↗