Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Frequency control”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 361 records · Page 20
All sourcesNASA NTRSDOE OSTI
NASA NTRS1985

ISAAC (integrated Structural Analysis and Control) via Continuum Modeling and Distributed Frequency Domain Design Techniques

A methodology is proposed for the integrated design of structures and their controls. The integration of design is accomplished through simultaneous selection, via optimization, of designer-specified parameters governing the structure and its controller. The cost function is chosen to address the primary structural and control goals. Inequality constraints are added to insure that additional design requirements are met. The methodology is illustrated through development of an example involving a cantilever beam. A distributed transfer function is derived from the Bernoulli-Euler beam equation. A controller parameterization is then chosen, and performance requirements specified. A controller is then obtained via optimization, which is shown to give good performance.

Gustafson, C. L.↗
NASA NTRS1990

Intensity noise in diode-pumped single-frequency Nd:YAG lasers and its control by electronic feedback

The power spectrum of the relative intensity noise (RIN) of single-frequency diode-pumped Nd:YAG lasers is observed to be shot-noise limited at frequencies above 20 MHz for a photocurrent of up to 4.4 mA. Relaxation oscillations result in noise 60-70 dB above shot noise at a few hundred kHz. These relaxation oscillations have been suppressed using electronic feedback.

Kane, Thomas J.↗
NASA NTRS1967

Temperature-stabilized, triggerable microelectronic astable multivibrator starts reliably

Multiple chip custom block, MIC construction is used to fabricate an ultracompact, low-power astable multivibrator. The design provides a multivibrator that free runs, eliminating lockup, is triggerable, pulling into synchronization with an external signal source, and permits design flexibility for controlling the frequency variations with temperature.

Stebbins, W. J.↗
NASA NTRS1970

Portable vibration exciter

Gas-driven vibration exciter produces a sinusoidal excitation function controllable in frequency and in amplitude. It allows direct vibration testing of components under normal loads, removing the possibility of component damage due to high static pressure.

Beecher, L. C.↗
NASA NTRS1974

Data-matched filter

After amplification and normalization, incoming data bits are fed, alternately, to pair of integrators. While one integrator is operating, content of other is on hold, sample, and dump. Clock derived in bit-timing extractor times and controls integrators. Frequency of clock is one-half data rate.

Scheinberg, N. R.↗
NASA NTRS1973

Analysis of helicopter maneuver-loads and rotor-loads flight test data

A study was conducted in which available airload and blade response data for the NH-3A and CH-53A rotors were analyzed in an attempt to provide greater insight into the sources of rotor vibratory loads in both level and maneuvering flight. Primary emphasis in the study was placed on examining and understanding causes of high-frequency rotor control loads. Secondary objectives were: (1) to examine the effect of number of rotor blades on hub vibratory shear forces and (2) to assess which of the many terms appearing in the hub vibratory shear force expression were of most significance.

Beno, E. A.↗
NASA NTRS1975

Acoustical modeling study of the open test section of the NASA Langley V/STOL wind tunnel

An acoustic model study was carried out to identify effective sound absorbing treatment of strategically located surfaces in an open wind tunnel test section. Also an aerodynamic study done concurrently, sought to find measures to control low frequency jet pulsations which occur when the tunnel is operated in its open test section configuration. The acoustical modeling study indicated that lining of the raised ceiling and the test section floor immediately below it, results in a substantial improvement. The aerodynamic model study indicated that: (1) the low frequency jet pulsations are most likely caused or maintained by coupling of aerodynamic and aeroacoustic phenomena in the closed tunnel circuit, (2) replacing the hard collector cowl with a geometrically identical but porous fiber metal surface of 100 mks rayls flow resistance does not result in any noticable reduction of the test section noise caused by the impingement of the turbulent flow on the cowl.

Ver, I. L.↗
NASA NTRS1976

Active control technology and the use of multiple control surfaces

Needed criteria for active control technology applications in commercial transports are lacking. Criteria for redundancy requirements, believed to be consistent with certification philosophy, are postulated to afford a discussion of the relative value of multiple control surfaces. The control power and frequency bandpass requirements of various active control technology applications are shown to be such that multiple control surfaces offer advantages in minimizing the hydraulic or auxiliary power for the control surface actuators.

Hart, J. E.↗
NASA NTRS1976

Modeling laser velocimeter signals as triply stochastic Poisson processes

Previous models of laser Doppler velocimeter (LDV) systems have not adequately described dual-scatter signals in a manner useful for analysis and simulation of low-level photon-limited signals. At low photon rates, an LDV signal at the output of a photomultiplier tube is a compound nonhomogeneous filtered Poisson process, whose intensity function is another (slower) Poisson process with the nonstationary rate and frequency parameters controlled by a random flow (slowest) process. In the present paper, generalized Poisson shot noise models are developed for low-level LDV signals. Theoretical results useful in detection error analysis and simulation are presented, along with measurements of burst amplitude statistics. Computer generated simulations illustrate the difference between Gaussian and Poisson models of low-level signals.

Mayo, W. T., Jr.↗
NASA NTRS1979

GEOS 3 STDN S band Doppler tracking investigation

GEOS 3S Doppler band and laser ranging data, acquired from August 1975 to March 1976 in the spacecraft altimeter calibration area, are examined. An evaluation of two-way and three-way Doppler data, for the positioning of Spaceflight Tracking and Data Network S band stations is presented, as well as the Goddard Space Flight Center laser system that is used to reference the exact position of the Doppler stations. The two-way and three-way Doppler tracking devices, situated at Rosman and Bermuda, have yielded data for the recovery of GEOS 3 arc height with an uncertainty of only 1 m. Attention is given to the effects of beacon signal frequency instability, controlled by a temperature sensitive auxiliary crystal oscillator on board the spacecraft, and to the one-way range rate tracking noise that was found to be within a range of 2 to 10 cm/s. 1- and 2-way passes and their different arc meters are graphed, showing the Doppler tracking interval. It was concluded that other accurate computations and recovery of station coordinates could be performed employing tracking data from S band stations.

Rosenbaum, B.↗
NASA NTRS1980

The dynamics and control of large flexible space structures, 3. Part A: Shape and orientation control of a platform in orbit using point actuators

The dynamics, attitude, and shape control of a large thin flexible square platform in orbit are studied. Attitude and shape control are assumed to result from actuators placed perpendicular to the main surface and one edge and their effect on the rigid body and elastic modes is modelled to first order. The equations of motion are linearized about three different nominal orientations: (1) the platform following the local vertical with its major surface perpendicular to the orbital plane; (2) the platform following the local horizontal with its major surface normal to the local vertical; and (3) the platform following the local vertical with its major surface perpendicular to the orbit normal. The stability of the uncontrolled system is investigated analytically. Once controllability is established for a set of actuator locations, control law development is based on decoupling, pole placement, and linear optimal control theory. Frequencies and elastic modal shape functions are obtained using a finite element computer algorithm, two different approximate analytical methods, and the results of the three methods compared.

Bainum, P. M.↗
NASA NTRS1980

Development and performance of a laser heterodyne spectrometer using tunable semiconductor lasers as local oscillators

A diode laser based IR heterodyne spectrometer for laboratory and field use was developed for high efficiency operation between 7.5 and 8.5 microns. The local oscillator is a PbSSe tunable diode laser kept continuously at operating temperatures of 12-60 K using a closed cycle cooler. The laser output frequency is controlled and stabilized using a high precision diode current supply, constant temperature controller, and a shock isolator mounted between the refrigerator cold tip and the diode mount. Single laser modes are selected by a grating placed in the local oscillator beam. The system employs reflecting optics throughout to minimize losses from internal reflection and absorption, and to eliminate chromatic effects. Spectral analysis of the diode laser output between 0 and 1 GHz reveals excess noise at many diode current settings, which limits the infrared spectral regions over which useful heterodyne operation can be achieved. System performance has been studied by making heterodyne measurements of etalon fringes and several Freon 13 (CF3Cl) absorption lines against a laboratory blackbody source. Preliminary field tests have also been performed using the Sun as a source.

Glenar, D.↗
NASA NTRS1980

Input signal conditioner for the multimegasymbol telemetry system feasibility model

The input signal conditioner portion of the multimegasymbol telemetry demodulator and detector feasibility model is described. The input signal conditioner accepts the 55 MHz wideband IF signal of a Block 4 Deep Space Network receiver and provides selectable bandpass filtering, total power automatic gain control, and frequency translation providing inphase and quadrature outputs at baseband.

Stevens, G. L.↗
NASA NTRS1979

On the design of a postprocessor for a search for extraterrestrial intelligence /SETI/ system

The design of an on-line postprocessor for a search for extraterrestrial intelligence (SETI) system is described. Signal processing tasks of the postprocessor include: (1) analysis of power level, phase coherence, and state of polarization of single-channel signals in a search for significant signals; (2) grouping or aggregation of adjacent channel data, time averaging of data; and (3) the detection of drifting and modulated signals. Control functions include multichannel spectrum analyzer frequency and clock control, system calibration and selfdiagnostic, control of data flow to and from short-term and long-term (archival) memories, and operation of detection subsystems, such as a visual display and a tunable receiver.

Healy, T. J.↗