Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Agreements”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 361 records · Page 20

Investigation of the Statistics of Pure Tone Sound Power Injection from Low Frequency, Finite Sized Sources in a Reverberant Room

The effect of finite source size on the power statistics in a reverberant room for pure tone excitation was investigated. Theoretical results indicate that the standard deviation of low frequency, pure tone finite sources is always less than that predicted by point source theory and considerably less when the source dimension approaches one-half an acoustic wavelength or greater. A supporting experimental study was conducted utilizing an eight inch loudspeaker and a 30 inch loudspeaker at eleven source positions. The resulting standard deviation of sound power output of the smaller speaker is in excellent agreement with both the derived finite source theory and existing point source theory, if the theoretical data is adjusted to account for experimental incomplete spatial averaging. However, the standard deviation of sound power output of the larger speaker is measurably lower than point source theory indicates, but is in good agreement with the finite source theory.

Smith, Wayne Farrior↗

Uranium dioxide fuel cladding strain investigation with the use of CYGRO-2 computer program

Previously irradiated UO2 thermionic fuel pins in which gross fuel-cladding strain occurred were modeled with the use of a computer program to define controlling parameters which may contribute to cladding strain. The computed strain was compared with measured strain, and the computer input data were studied in an attempt to get agreement with measured strain. Because of the limitations of the program and uncertainties in input data, good agreement with measured cladding strain was not attained. A discussion of these limitations is presented.

Smith, J. R.↗

A mathematical model for jet engine combustor pollutant emissions

Mathematical modeling for the description of the origin and disposition of combustion-generated pollutants in gas turbines is presented. A unified model in modular form is proposed which includes kinetics, recirculation, turbulent mixing, multiphase flow effects, swirl and secondary air injection. Subelements of the overall model were applied to data relevant to laboratory reactors and practical combustor configurations. Comparisons between the theory and available data show excellent agreement for basic CO/H2/Air chemical systems. For hydrocarbons the trends are predicted well including higher-than-equilibrium NO levels within the fuel rich regime. Although the need for improved accuracy in fuel rich combustion is indicated, comparisons with actual jet engine data in terms of the effect of combustor-inlet temperature is excellent. In addition, excellent agreement with data is obtained regarding reduced NO emissions with water droplet and steam injection.

Boccio, J. L.↗

Evaluate the application of ERTS-A data for detecting and mapping snow cover

The author has identified the following significant results. It is concluded from data analysis that the amount of information in ERTS-1 imagery with practical application to snow mapping is substantial. For the Arizona and California test sites, it appears that the extent of the mountain snowpacks can be mapped from ERTS-1 data in more detail than is depicted in aerial survey snow charts. In the Salt-Verde watershed, the agreement between the percentage of the area snow covered as measured from the ERTS-1 data and from aerial survey charts is generally well within 10%. In nearly all of the areas in which greater discrepancies occur, the differences can be explained by changes in snow cover during the interval between the two observations. In the southern Sierra Nevada, the agreement between ERTS-1 data and aerial survey charts is of the order of 5% in all cases, except for the Kaweah Basin on one date. In addition to comparative analysis with aerial snow charts, the ERTS-1 data have also been compared with high altitude aircraft photography. The ERAP data have provided an excellent source of correlative information. The results of the comparative analysis indicate that although small details in the snow line that cannot be detected in the ERTS-1 data can be mapped from higher resolution aircraft data, the boundaries of snow cover can be mapped just as accurately from ERTS-1 data.

Barnes, J. C.↗

Backscattering from a two-scale rough surface with application to radar sea return

A two-scale composite surface scattering theory was developed without using the noncoherent assumption. The surface is assumed electrically homogeneous and finitely conducting; the surface roughness may be nonuniform geometrically. The special forms of the terms for excluding the non-coherent assumption and the meanings of these terms are discussed. To gain insight into the mechanisms of backscattering, the results are compared with those obtained by previous theories. The comparison with NRL data shows satisfactory agreement for both horizontal and vertical polarization, especially for incident angles larger than 30 deg. For smaller incident angles, NASA/JSC data have been chosen for comparison and close agreement is again observed.

Chan, H. L.↗

Calculated distributions of hydrogen and helium ions in the low-latitude ionosphere.

The simultaneous time-dependent continuity equations for O(+), H(+) and He(+) in the low latitude F-region are solved. Account is taken of E x B drift, a meridional neutral wind, and ion-ion and ion-neutral drag. The calculated profiles of O(+) and H(+) concentrations at 1630 LT are in fair agreement with the observations of Hanson et al. The He(+) field-aligned velocity is almost matched to the O(+) field-aligned velocity and, above the chemical equilibrium region and around the He(+) peak, the He(+) concentration is determined largely by production and transport. There is disagreement between the theoretical vertical He(+) profile and the profile observed by Hanson et al. Satisfactory agreement is obtained with Taylor's satellite results at fixed height for O(+) and H(+). It is found that the He(+) concentration is greater in the winter hemisphere than in the summer hemisphere, even if the neutral helium distribution is symmetrical about the Equator. The He(+) results are consistent with Taylor's results.

Moffett, R. J.↗

Gravity field of Mars from Mariner 9 tracking data.

Further reduction of Doppler tracking data from Mariner 9 confirms our earlier conclusion that the gravity field of Mars is considerably rougher than the fields of either the earth or the moon. The largest positive gravity anomaly uncovered is in the Tharsis region which is also topographically high and geologically unusual. The value obtained for the inverse mass of Mars is in good agreement with prior determinations from Mariner fly by trajectories. The direction found for the rotational pole of Mars is in excellent agreement with Sinclair's recent value, determined from earth-based observations of Mars' satellites. Other important physical constants that have either been refined or confirmed by the Mariner 9 data include: (1) the dynamical flattening, (2) the maximum principal moment of inertia, and (3) the period of precession of Mars' pole.

Lorell, J.↗

Antenna admittance determination of electron density.

A circular-aperture flush-mounted antenna for which a theoretical description of the antenna-plasma interaction has been developed was used to obtain a comparison between theoretical and experimental antenna admittance in the presence of ionized boundary layers of low-collision frequency. The antenna was located in a flat-plate model which was in turn located in the expanding-flow environment of a reflected-shock tunnel. The electron-temperature and electron-density distributions in the plate boundary layer at the antenna location were independently measured using voltage-swept thin-wire Langmuir probes for one of the test conditions. The antenna admittance was measured using a four-probe microwave reflectometer and these measured values were found to be in good agreement with those predicted from the theory. Measurements were also performed with another type of circular-aperture antenna which did not satisfy all of the constraints of the theoretical model, although good agreement was obtained between the calculations and the experimental results.

Dunn, M. G.↗

Providing satellite systems for the national weather satellite services.

Discussion of cooperative arrangements and agreements among NASA, the Department of Commerce, and other governmental agencies in developing and operating meteorological satellite systems. The development of present interagency agreements and their conditions are discussed along with differences from the usual NASA program introduced by the supplier-client relationship between NASA and NOAA (National Oceanic and Atmospheric Administration).

Stroud, W. G.↗

Helium in the topside Venus ionosphere.

The amount of helium in the Venus atmosphere can be estimated from an examination of the measured ionization profiles and from the recent discovery of radioactive materials in the Venus crust. The amount necessary to give agreement between computed and experimental results is approximately 400,000,000 per cu cm at 140 km. When a nominal value of the eddy diffusion coefficient of 1,000,000 sq cm per sec is used, the atmospheric helium mixing ratio is found to be 0.00006, nearly ten times that for the earth. If agreement is required between the helium mixing ratio estimated from an earth-like distribution of crustal radioactive materials and from the measured ionization profile, the required eddy diffusion coefficient would be 5,000,000 sq cm per sec.

Herman, J. R.↗

A new method for calculating correction factors for near-field gain measurements.

A new method is demonstrated with which near-field antenna gain correction factors can be calculated directly from measured far-field pattern data by using a spherical wave expansion of the pattern. This eliminates the need for any assumptions regarding antenna aperture field distributions. For illustration, the method is applied to the case of a horn antenna. A comparison of the calculation results with direct measurement data shows an agreement within 0.03 dB. The method, when compared to the method used by Chu and Semplak (1965), is found to show similar agreement.

Ludwig, A. C.↗

Theory and performance of plated thermocouples.

A theory has been developed to describe the performance of thermocouples which have been formed by electroplating portions of one thermoelectric material with another. The electroplated leg of the thermocouple was modeled as a collection of infinitesimally small homogeneous thermocouples connected in series. Experiments were performed using several combinations of Constantan wire sizes and copper plating thicknesses. A transient method was used to develop the thermoelectric calibrations, and the theory was found to be in quite good agreement with the experiments. In addition, data gathered in a Soviet experiment were also found to be in close agreement with the theory.

Pesko, R. N.↗

Fuel droplet burning rates at high pressures.

Combustion of methanol, ethanol, propanol-1, n-pentane, n-heptane, and n-decane was observed in air under natural convection conditions, at pressures up to 100 atm. The droplets were simulated by porous spheres, with diameters in the range from 0.63 to 1.90 cm. The pressure levels of the tests were high enough so that near-critical combustion was observed for methanol and ethanol. Due to the high pressures, the phase-equilibrium models of the analysis included both the conventional low-pressure approach as well as high-pressure versions, allowing for real gas effects and the solubility of combustion-product gases in the liquid phase. The burning-rate predictions of the various theories were similar, and in fair agreement with the data. The high-pressure theory gave the best prediction for the liquid-surface temperatures of ethanol and propanol-1 at high pressure. The experiments indicated the approach of critical burning conditions for methanol and ethanol at pressures on the order of 80 to 100 atm, which was in good agreement with the predictions of both the low- and high-pressure analysis.

Canada, G. S.↗

A comparison of the overall and broadband noise characteristics of full-scale and model helicopter rotors.

The broadband noise generated by full-scale and model rotors is compared in terms of spectral content and the dependence on tip speed and rotor thrust/pitch angle. Low frequency broadband noise and high frequency broadband noise are studied separately and blade 'scaling' effects are outlined. The degree of agreement between measurements and theoretical and semi-empirical prediction methods is reviewed together with the directionality patterns. The parameters relating to the overall noise are also discussed. It is shown that in general good agreement is obtained between the full-scale and model rotors when considering spectral content and the dependency of the noise levels on tip speed and thrust. The scaling factors usually considered applicable to the low frequency broadband noise do not, however, appear to apply to either the model or full scale rotors.

Leverton, J. W.↗

A study of methods which predict supersonic flow fields from body geometry, distance, and Mach number

A study of seven methods for predicting flow-field pressure signatures from the parameters Mach number, body geometry, and field-path distance has been made. The methods included the method of characteristics, which served as a standard of comparison; a shock-capturing method; three Whitham theory methods; a modified characteristics method; and a bicharacteristics method. Results from each method were also compared with recently obtained wind-tunnel data for a cone-cylinder model at Mach numbers of 2.96 and 4.63 with ratios of radial distance to cone length of 2 and 5. The comparisons at a Mach number of 2.96 showed that signatures from all the methods correlated well with wind-tunnel data and with the signatures predicted by the method of characteristics. At a Mach number of 4.63, however, the agreement between the signatures obtained in the wind tunnel and those predicted by theory varied from good to poor, as did the agreement between the signatures obtained by the method of characteristics and the other six methods. It should be noted that these results and comparisons indicate pressure prediction capabilities only for the near-field flow about bodies of revolution.

Mack, R. J.↗

Transport analysis of measured neutron leakage spectra from spheres as tests of evaluated high energy cross sections

Integral tests of evaluated ENDF/B high-energy cross sections have been made by comparing measured and calculated neutron leakage flux spectra from spheres of various materials. An Am-Be (alpha,n) source was used to provide fast neutrons at the center of the test spheres of Be, CH2, Pb, Nb, Mo, Ta, and W. The absolute leakage flux spectra were measured in the energy range 0.5 to 12 MeV using a calibrated NE213 liquid scintillator neutron spectrometer. Absolute calculations of the spectra were made using version 3 ENDF/B cross sections and an S sub n discrete ordinates multigroup transport code. Generally excellent agreement was obtained for Be, CH2, Pb, and Mo, and good agreement was observed for Nb although discrepancies were observed for some energy ranges. Poor comparative results, obtained for Ta and W, are attributed to unsatisfactory nonelastic cross sections. The experimental sphere leakage flux spectra are tabulated and serve as possible benchmarks for these elements against which reevaluated cross sections may be tested.

Bogart, D. D.↗

Analysis of stratified and closely spaced jets exhausting into a crossflow

Procedures have been developed for determining the flow field about jets with velocity stratification exhausting into a crossflow. Jets with three different types of exit velocity stratification have been considered: (1) jets with a relatively high velocity core; (2) jets with a relatively low velocity core; and (3) jets originating from a vaned nozzle. The procedure developed for a jet originating from a high velocity core nozzle is to construct an equivalent nozzle having the same mass flow and thrust but having a uniform exit velocity profile. Calculations of the jet centerline and induced surface static pressures have been shown to be in good agreement with test data for a high velocity core nozzle. The equivalent ideal nozzle has also been shown to be a good representation for jets with a relatively low velocity core and for jets originating from a vaned nozzle in evaluating jet-induced flow fields. For the singular case of a low velocity core nozzle, namely a nozzle with a dead air core, and for the vaned nozzle, an alternative procedure has been developed. The internal mixing which takes place in the jet core has been properly accounted for in the equations of motion governing the jet development. Calculations of jet centerlines and induced surface static pressures show good agreement with test data these nozzles.

Ziegler, H.↗

Acoustic radiation patterns for a source in a hard-walled unflanged circular duct

Acoustic radiation patterns are measured over a 320 deg arc for a point source in a finite length, hard walled, unflanged circular duct. The measured results are compared with computed results which are based on the Wiener-Hopf solution for radiation from a semi-infinite unflanged duct. Measurements and computations are presented for frequencies slightly below and slightly above each of the first four higher order radial mode cutoff frequencies. It is found that the computed and measured patterns show better agreement below the mode cut-off frequencies than above and that the agreement is better at lower frequencies that at higher frequencies. The computed radiation patterns do not show fine lobes which are caused by diffraction from the back end of the duct.

Holm, R. G.↗