SEARCH · Engineering Papers

Results for “1D”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 361 records · Page 20

All sources NASA NTRS DOE OSTI

NASA NTRS1992

Voyager 2 ultraviolet spectrometer solar occultations at Neptune - Constraints on the abundance of methane in the stratosphere

The study compares Voyager 2 ultraviolet spectrometer (UVS) solar occultation lightcurves at wavelengths 125-138 nm acquired during the Neptune encounter with 1D methane photochemical transport models. For the p-T models under consideration, acceptable fits to the UVS lightcurves are obtained with eddy mixing coefficient values (K sub 1/2) near the half-light altitudes of 2-15 x 10 exp 6 sq cm/s (ingress) and 4-35 x 10 exp 6 sq cm/s (egress) and lower stratospheric methane mixing ratio values of 5-100 x 10 exp -5. For the nominal p-T models and a criterion based on replicating the spacing in altitude of the 125-138 nm UVS lightcurves, K sub 1/2 values of 10 exp 7 sq cm/s (ingress) and 1-2 x 10 exp 7 sq cm/s (egress) and methane mixing ratios of about 0.0004 (ingress and egress) are indicated.

Bishop, James↗

NASA NTRS1991

The negative ions emission in nitrogen

The contribution of negative atomic ions to continuum radiation in nitrogen plasma is discussed. It is shown that both unstable N(-)(3P) and metastable N(-)(1D) ions have a significant effect on the total production of the continuum radiation at electron temperatures below 12,000 K.

Soon, W. H.↗

NASA NTRS1991

Effect of InAlAs window layer on the efficiency of indium phosphide solar cells

Indium phosphide (InP) solar cell efficiencies are limited by surface recombination. The effect of a wide-bandgap lattice-matched indium aluminum arsenide (In0.52Al0.48As) window layer on the performance of InP solar cells was investigated using a numerical code PC-1D. The p(+)n InP solar cell performance improves significantly with the use of a window layer. No improvement is seen for n(+)p InP cells. Cell results are explained by the band diagram of the heterostructure and the conduction-band energy discontinuity. The calculated I-V and internal quantum efficiency results clearly demonstrate that In0.52Al0.48As is a promising candidate as a window layer material for p(+)n InP solar cells.

Jain, R. K.↗

NASA NTRS1992

Numerical study of low pressure nuclear thermal rockets

The flowfields and performance of low pressure nuclear thermal rockets, which use hydrogen as a propellant, are studied by solving the Navier-Stokes equations and the species equations. A finite-rate chemistry model is used in the species equations, and the turbulence is simulated by the Baldwin-Lomax turbulence model with a modified van Driest's damping constant. The calculated results for the chamber temperatures of 3200 K and 4000 K with a chamber pressure range of 0.1 atm to 6 atm are presented as contours, centerline variations, and exit profiles. The performance values from the present calculations, such as the vacuum specific impulse and thrust, are compared with those from the 1D, inviscid equilibrium and frozen flow code.

Kim, Suk C.↗

NASA NTRS1992

Analytical estimates of radial segregation in Bridgman growth from low-level steady and periodic accelerations

Approximate analytical solutions are developed that are mathematically tractable but provide the elements of CFD models for estimating convective flows subjected to low-level accelerations. The estimates are applicable to dilute systems that have horizontal temperature gradients in the vertical Bridgman configuration. The Navier-Stokes momentum equation is solved in 1D and subsequently in 2D by the first-order perturbation method. The analysis used is the case of plane-front solidification of a dilute system in the vertical thermally stable configuration. The model is found to predict the degree of radial segregation within a factor of two for a range of material and processing parameters. The method provides detailed information on the effects of processing on solute distribution in the grown crystal which are of interest in the orbital experiments emphasizing the control of radial segregation.

Naumann, Robert J.↗

NASA NTRS1992

Numerical simulation of unsteady flow in a hypersonic shock tunnel facility

This paper describes the computational work performed on the simulation of a 16-in shock-tunnel facility. The numerical problems encountered during the computation of these flows are discussed along with the validity of some approximations used, notably concerning the reduction of the problem into problems of smaller dimensionality. Quasi-1D simulations can be used to help design experiments, or to better understanding the characteristics of the facility. An application to the design of a nonintrusive diagnostic is shown. The multidimensional flow transients computed include the shock reflection at the end of the driven tube, the shock propagation down the nozzle, and the breaking of the main diaphragm.

Cambier, Jean-Luc↗

NASA NTRS1992

An integrated analytical aeropropulsive/aeroelastic model for the dynamic analysis of hypersonic vehicles

The development of an approach to the determination of the dynamic characteristics of hypersonic vehicles which is intentionally generic and basic is given. The approach involves a 2D hypersonic aerodynamic analysis utilizing Newtonian theory, coupled with a 1D aero/thermoanalysis of the flow in a scramjet-type propulsion system. In addition, the airframe is considered to be elastic, and the structural dynamics are characterized in terms of a simple lumped-mass model of the invacuo vibration modes. The vibration modes are coupled to the rigid-body modes through the aero/propulsive forces acting on the structure. The control effectors considered on a generic study configuration include aerodynamic pitch-control surfaces, as well as engine fuel flow and diffuser area ratio. The study configuration is shown to be highly statically unstable in pitch, and to exhibit strong airframe/engine/elastic coupling in the aeroelastic and attitude dynamics, as well as the engine responses.

Chavez, Frank R.↗

NASA NTRS1992

Electromagnetic ion/ion cyclotron instability - Theory and simulations

Linear theory and 1D and 2D hybrid simulations are employed to study electromagnetic ion/ion cyclotron (EMIIC) instability driven by the relative streaming of two field-aligned ion beams. The characteristics of the instability are studied as a function of beam density, propagation angle, electron-ion temperature ratios, and ion beta. When the propagation angle is near 90 deg the EMIIC instability has the characteristics of an electrostatic instability, while at smaller angles electromagnetic effects play a significant role as does strong beam coupling. The 2D simulations point to a narrowing of the wave spectrum and accompanying coherent effects during the linear growth stage of development. The EMIIC instability is an important effect where ion beta is low such as in the plasma-sheet boundary layer and upstream of slow shocks in the magnetotail.

Winske, D.↗

NASA NTRS1992

Non-LTE radiating acoustic shocks and Ca II K2V bright points

We present, for the first time, a self-consistent solution of the time-dependent 1D equations of non-LTE radiation hydrodynamics in solar chromospheric conditions. The vertical propagation of sinusoidal acoustic waves with periods of 30, 180, and 300 s is calculated. We find that departures from LTE and ionization recombination determine the temperature profiles of the shocks that develop. In LTE almost all the thermal energy goes into ionization, so the temperature rise is very small. In non-LTE, the finite transition rates delay the ionization to behind the shock front. The compression thus goes into thermal energy at the shock front leading to a high temperature amplitude. Further behind the shock front, the delayed ionization removes energy from the thermal pool, which reduces the temperature, producing a temperature spike. The 180 s waves reproduce the observed temporal changes in the calcium K line profiles quite well. The observed wing brightening pattern, the violet/red peak asymmetry and the observed line center behavior are all well reproduced. The short-period waves and the 5 minute period waves fail especially in reproducing the observed behavior of the wings.

Carlsson, Mats↗

NASA NTRS1992

The Colorado IUE active galaxy survey. I - Blazars

This paper presents consistently reduced UV continuum flux densities amd spectra indices derived from all 499 usable archived IUE observations of blazars made through mid-1991. The extraction of 1D spectra and the measurement of spectral parameters are discussed. A detailed error analysis is presented, including a discussion of the difference in the calibration between the IUE long- and short-wavelength cameras. The resulting data are presented in tabular and graphical form and are available by electronic mail as well. These results will be most useful for variability studies, but can also be used to characterize the broad-band energy distributions and to compare blazar properties with those of other AGN. This is the first in a series of papers, in which extracted spectral parameters will be published for the over 4500 spectra of AGN in the IUE archives.

Edelson, Rick↗

NASA NTRS1992

Resistivity due to weak double layers - A model for auroral arc thickness

We have calculated the resistivity due to a sequence of fluctuating weak double layers aligned parallel to the ambient magnetic field line. The average response of an electron drifting through a 1D randomly oriented array of WDLs is studied using a test particle approach. The average is taken over the randomly fluctuating values of the electric field associated with the double layers. Based on our calculations, we estimate that a 350 eV electron energy the thickness of the visual auroral arc is about 2.5 km and that of the auroral fine structure as about 250 m when mapped down to the ionosphere. The significance of our calculations is discussed in the context of magnetosphere-ionosphere coupling.

Prakash, Manju↗

NASA NTRS1991

Piezoresistive sensors for measurement of thermally-induced stresses in microelectronics

The general theory of conduction in a piezoresistive material subjected to temperature change is derived and the basic equations needed to design and apply test chips for thermal stress measurement are established. A general expression is obtained for the resistance changes which occur in an arbitrarily oriented 1D filamentary conductor subjected to general 3D stress states and arbitrary temperature changes. The derived formula is valid for crystals such as silicon which have cubic symmetry and diamond lattice structures. Basic equations are presented for the resistance changes experienced by stressed in-plane resistors fabricated on (100) silicon wafers. The established theory is applied to a simple two-element sensor rosette. A test chip containing this rosette configuration is designed and fabricated, and a suitable calibration system is constructed.

Suhling, J. C.↗

NASA NTRS1992

Numerical analyses of a rocket engine turbine and comparison with air test data

The study presents cold air test data on the Space Shuttle Main Engine High Pressure Fuel Turbopump turbine recently collected at the NASA Marshall Space Flight Center. Overall performance data, static pressures on the first- and second-stage nozzles, and static pressures along with the gas path at the hub and tip are gathered and compared with various (1D, quasi-3D, and 3D viscous) analysis procedures. The results of each level of analysis are compared to test data to demonstrate the range of applicability for each step in the design process of a turbine. One-dimensional performance prediction, quasi-3D loading prediction, 3D wall pressure distribution prediction, and 3D viscous wall pressure distribution prediction are illustrated.

Tran, Ken↗

NASA NTRS1992

A comparative study of experimental and simulated ultrasonic pulse-echo signals from multilayered structures

The effect on the system acoustic response of variations in the adhesive thickness, coupling thickness, and paint thickness is considered. Both simulations and experimental measurements are used to characterize and classify A-scans from test regions, and to study the effects of various parameters such as paint thickness and epoxy thickness on the variations in the reflected signals. A 1D model of sound propagation in multilayered structures is used to verify the validity of the measured signals, and is also used to computationally generate signals for a class of test locations with gradually varying parameters. This approach exploits the ability of numerical simulations to provide a good understanding of the ultrasonic pulses reflected at disbonds.

Abedin, M. N.↗

NASA NTRS1992

Two-temperature models of old supernova remnants with ion and electron thermal conduction

To investigate the potential effects thermal conduction may have on the evolution of old supernova remnants, we present the results of 1D (spherically symmetric) numerical simulations of a remnant in a homogeneous interstellar medium for four different cases: (1) without thermal conduction; (2) with both electron and ion thermal conduction assuming equal temperatures; (3) with electron thermal conduction only, following electron and ion temperatures separately; and (4) with both electron and ion thermal conduction following separate temperatures. We followed the entire evolution until the completion of the remnant bubble collapse. Our most significant result is that in remnant evolution studies concerned principally with either the shell or bubble evolution at late times, reasonable results are obtained with single-temperature models. When the electron and ion temperatures are followed separately, however, ion thermal conduction cannot safely be ignored.

Cui, Wei↗

NASA NTRS1992

Time-dependent quasi-one-dimensional simulations of high enthalpy pulse facilities

A numerical methodology is presented for simulating the time-dependent reacting flow inside the entire length of high enthalpy pulse facilities. The methodology is based on a finite-volume TVD scheme for the quasi-1D Euler equations coupled with finite-rate chemistry. A moving mesh and tracking of gas interfaces are used to overcome certain numerical difficulties associated with these types of flows. Simulation results of a helium driven shock tube show that computations can be used to predict the off-tailored behavior of shock tubes and tunnels. Particular attention is given to computations of the flow through the NASA Ames 16-inch combustion driven shock tunnel which show the influence of nonuniformities in the driver section on the reservoir conditions; and the effect of finite secondary diaphragm opening times on the chemical composition of the test flow in the HYPULSE expansion tube.

Wilson, Gregory J.↗

NASA NTRS1993

Increase in stagnation pressure and enthalpy in shock tunnels

A new technique based on the insertion of a converging section in the driven tube is described which is capable of producing substantial increases in both reservoir pressure and enthalpy. A 1D inviscid full kinetics code is used to study a number of different locations and shapes for the converging driven tube section. For driven tube diameter reductions of factors of 2 and 3, the reservoir pressure is found to increase by factors of 2.1 and 3.2, respectively, and the enthalpy is found to simultaneously increase by factors of 1.5 and 2.1, respectively.

Bogdanoff, David W.↗

NASA NTRS1993

Shock turbulence interaction in the presence of mean shear - An application of rapid distortion theory

The present examination of the response of anisotropic turbulent flows to a shock wave uses incompressible, homogeneous rapid distortion theory and idealizes the shock-wave as 1D compression. Attention is given to the shock's effect on axisymmetric flow and both the normal and oblique cases for shear flow. The oblique angle between the directions of compression and shear significantly affects turbulence evolution. Compression amplifies all components of turbulence intensity.

Mahesh, Krishnan↗