Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “solar optical performance”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1981

Preliminary design study of solar probe heat shields

The requirements, constraints, design guidelines, and expected performances of heat-shield systems for a solar probe are analyzed. A multiple-stage, asymmetric, right-angle radiation cascade configuration is used as the basis for comparison. Output-to-input radiative flux ratios are first calculated for a system employing gray surfaces. Assuming that the temperature of the inner surface of the payload bus is allowed to reach 400 K, it is shown that four- and five-stage cascade systems employing graphite can approach, respectively, to within about 5.5 and 4 solar radii of the sun. The systems using slip-cast silica and tungsten are then analyzed accounting for the degradation of surface-optical performance caused by the solar wind. It is shown that two- and three-stage silica-tungsten systems can approach, respectively, to within 4 and 3 solar radii of the sun.

Park, C.↗
NASA NTRS1991

Performance of the Multi-Spectral Solar Telescope Array. III - Optical characteristics of the Ritchey-Chretien and Cassegrain telescopes

The Multi-Spectral Solar Telescope Array (MSSTA), which is a sounding-rocket-borne observatory for investigating the sun in the soft X-ray/EUV and FUV regimes of the electromagnetic spectrum, utilizes single reflection multilayer coated Herschelian telescopes for wavelengths below 100 A, and five doubly reflecting multilayer coated Ritchey-Chretien and two Cassegrain telescopes for selected wavelengths in the EUV region between 100 and 1000 A. The paper discusses the interferometric alignment, testing, focusing, visible light testing, and optical performance characteristics of the Ritchey-Chretien and Cassegrain telescopes of MSSTA. A schematic diagram of the MSSTA Ritchey-Chretien telescope is presented together with diagrams of the system autocollimation testing.

Hoover, Richard B.↗
NASA NTRS1972

Effects of electrostatic rocket material deposited on solar cells.

If solar arrays on solar-electric spacecraft protrude into the exhaust hemisphere of the electric thrusters, they will receive fluxes (usually small) of both propellant and accelerator grid atoms. Unlike propellants, grid materials have low vapor pressures and will not reevaporate. An analysis is presented of degradation in the optical, thermal, and electrical performance of solar cells resulting from thin deposits of grid material (aluminum and molybdenum) on various array surfaces. The classical optical theory of thin films, heat balance equations, and a typical relationship for solar cell efficiency vs temperature are used to compute curves showing optical properties, temperature, and power output as functions of film thickness. The results compare favorably with available experimental data. It is shown that a few monolayers of metal deposition on the illuminated surface will seriously degrade cell performance. A means of estimating the arrival rate of these materials is provided.

Kemp, R. F.↗
NASA NTRS2005

Protection of Conductive and Non-conductive Advanced Polymer-based Paints from Highly Aggressive Oxidative Environments

Research has been continued to further improve the space durability of conductive and non-conductive polymer-based paints and of conductive thermal control paints for space applications. Efforts have been made to enhance the space durability and stability of functional Characteristics in ground-based space environment imitating conditions, using specially developed surface modification treatment. The results of surface modification of new conductive paints, including the ground-based testing in aggressive oxidative environments, such as atomic oxygen/UV and oxygen plasma, and performance evaluation are presented. Functional properties and performance characteristics, such as thermal optical properties (differential solar absorptance and thermal emittance representing the thermal optical performance of thermal control paints) and surface resistivity characteristics of pristine, surface modified, and tested materials were verified. Extensive surface analysis studies have been performed using complementary surface analyses including SEM/EDS and XPS. Test results revealed that the successfully treated materials exhibit reduced mass loss and no surface morphology change, thus indicating good protection from the severe oxidative environment. It was demonstrated that the developed surface modification treatment could be applied successfully to charge dissipative and conductive paints.

Gudimenko, Y.↗
NASA NTRS1984

Preliminary concept of a 100-kilowatt miniaturized Cassegrainian concentrator solar array

A miniaturized Cassegrainian concentrator (MCC) solar array system is examined to assess the practicality of assembling the basic MCC element into a total array system capable of producing multi-hundred kilowatts of power for Space Platform/Space Station or other low Earth orbit long lifetime missions. Preliminary mechanical and electrical subsystems are developed in order to determine first order performance characteristics. Results of the study support the feasibility of a 100-kilowatt MCC array system with beginning-of-life (BOL) performance of 160 watts per square meter and 28 W/kg. The performance numbers are based on 20 percent efficient (at operating temperature) solar cells and 0.25-millimeter thick electroformed nickel optics. These performance numbers can be improved upon significantly with the development of higher efficiency solar cells and/or lighter weight optics.

Patterson, R. E.↗
NASA NTRS1987

Acquisition, tracking, and pointing; Proceedings of the Meeting, Orlando, FL, Apr. 3, 4, 1986

The present conference discusses the effect of target signatures on active tracking, the high resolution obtainable with a two-degrees-of-freedom angle sensor having a high update rate, solar object tracking for the Hubble Space Telescope, scaled experiments for the assessment of precise active tracking, and large aperture high-accuracy satellite laser tracking. Also discussed are laboratory test results for the Spaceborne Geodynamic Ranging System's high speed optical tracking system, jitter stabilization for precise optical pointing, scan stabilization and jitter control for an airborne telescope, a simulation of the Solar Optical Telescope's pointing performance, a microprocessor-based dual-speed angle converter, and image localization for alignment by means of adaptive preprocessing.

Auelmann, Richard R.↗
NASA NTRS2004

The COR1 Inner Coronagraph for STEREO-SECCHI

The Solar Terrestrial Relations Observatory (STEREO) is a pair of identical satellites that will orbit the Sun so as to drift ahead of and behind Earth respectively, to give a stereo view of the Sun. STEREO is currently scheduled for launch in November 2005. One of the instrument packages that will be own on each of the STEREO spacecrafts is the Sun Earth Connection Coronal and Heliospheric Investigation (SECCHI), which consists of an extreme ultraviolet imager, two coronagraphs, and two side-viewing heliospheric imagers to observe solar coronal mass ejections all the way from the Sun to Earth. We report here on the inner coronagraph, labeled COR1. COR1 is a classic Lyot internally occulting refractive coronagraph, adapted for the first time to be used in space. The field of view is from 1.3 to 4 solar radii. A linear polarizer is used to suppress scattered light, and to extract the polarized brightness signal from the solar corona. The optical scattering performance of the coronagraph was first modeled using both the ASAP and APART numerical modeling codes, and then tested at the Vacuum Tunnel Facility at the National Center for Atmospheric Research in Boulder, Colorado. In this report, we will focus on the COR1 optical design, the predicted optical performance, and the observed performance in the lab. We will also discuss the mechanical and thermal design, and the cleanliness requirements needed to achieve the optical performance.

Thompson, William T.↗
NASA NTRS1978

Thermal optical surface properties and high-temperature solar energy conversion

The effects of thermal surface properties on the performance of representative point focusing solar power plants are assessed in this paper. The tradeoff relationships are presented in terms of normalized system performance as a function of thermal optical design parameters. Crucial surface properties include solar reflectance, specular spreading due to microscopic roughness, surface error due to manufacturing slope tolerance or waviness and concentrator pointing accuracy. Two representative power conversion systems, a Rankine steam cycle and an open air Brayton cycle, are considered.

Wen, L.↗
NASA NTRS2013

"Kicking Up Some Dust": An Experimental Investigation Relating Lunar Dust Erosive Wear to Solar Power Loss

The exhaust from retrograde rockets fired by spacecraft landing on the Moon can accelerate lunar dust particles to high velocities. Information obtained from NASA's Apollo 12 mission confirmed that these high-speed dust particles can erode nearby structures. This erosive wear damage can affect the performance of optical components such as solar concentrators. Solar concentrators are objects which collect sunlight over large areas and focus the light into smaller areas for purposes such as heating and energy production. In this work, laboratory-scale solar concentrators were constructed and subjected to erosive wear by the JSC-1AF lunar dust simulant. The concentrators were focused on a photovoltaic cell and the degradation in electrical power due to the erosive wear was measured. It was observed that even moderate exposure to erosive wear from lunar dust simulant resulted in a 40 percent reduction in power production from the solar concentrators.

Mpagazehe, Jeremiah N.↗
NASA NTRS1975

Optical design of the SBUV/TOMS experiment on Nimbus G

The paper examines the tradeoffs performed in optimizing the optical design of the solar backscatter ultraviolet/total ozone mapping spectrometer (SBUV/TOMS) experiment on Nimbus G to stringent performance requirements within the limitations of the spacecraft interface. The SBUV portion of the experiment incorporates a double monochromator optimized for better than 1.0 A spectral resolution over the wavelength range 1600-4000 A. The TOMS portion of the experiment is a stepped line scanning system with a 105-deg total field of view. Special techniques are used to reduce the polarization sensitivity of the instrument to less than 5% for 100% linearly polarized incident radiation and to keep the spectral stray light to less than 0.000001 of the incident solar spectrum. Optical material selection is imperative in order to minimize the effects of fluorescence and phosphorescence arising from the bombardment of particulate radiation in space.

Henderson, B. D.↗
NASA NTRS1975

Application of solar energy; Proceedings of the First Southeastern Conference, Huntsville, Ala., March 24-26, 1975

Topics related to architectural and institutional considerations are discussed along with studies of components and subsystems. Subjects in the area of system design and analysis are also explored. Residential and commercial applications are considered, taking into account hot-water usage in a typical single-family residence, solar heating and cooling of mobile homes, aspects of design and performance in the case of a solar heating system using a reflective pyramid optical condenser, solar heating in a Boston school, a performance analysis of solar service hot water systems, comparative performance analyses of three solar heated and cooled buildings, and the use of solar energy in a soybeam processing operation. Applications related to power generation are also examined, giving attention to solar thermal electric power systems and photovoltaic research. Individual items are announced in this issue.

Wu, S. T.↗
NASA NTRS1974

The NASA program for standardizing silicon solar cells

The present work describes briefly the goals of the recently organized Standardized Space Power Systems Office and its program for developing low-cost, standard power system components for spacecraft. The first step is the development of standard specifications for solar cells and covers. These include: (1) physical dimensions, materials of construction, appearance and integrity of solar cell and coverglass; (2) electrical performance characteristics of solar cell and optical characteristics of coverglass; and (3) sampling, inspection, and electrical and environmental tests needed to demonstrate compliance with the above specifications.

Bifano, W.J.↗
NASA NTRS1979

To the solar foci

Earlier authors showed that the sun is likely to act as a lens for gravitational radiation, with focui in the outer solar system. They suggested that missions to these foci have the potential of directly measuring the density structure of the sun. Other applications include gravitational wave astronomy and tests of general relativity. This idea is reexamined, concentrating on the engineering aspects of focal missions; primarily spacecraft design and performance. Other topics studied include solar optics, gravitational wave detectors, navigation, and the design of missions for different purposes. Specifically, it is shown that shuttle launched chemical rockets have a substantial capability for reaching some foci; and that all can be reached with large payloads using nuclear isotope-electric propulsion.

Sonnabend, D.↗
NASA NTRS1989

Polarization aberrations in the solar activity measurements experiments (SAMEX) solar vector magnetograph

An optical design and polarization analysis of the Air Force/NASA Solar Activity Measurements Experiments solar vector magnetograph optical system is performed. Polarization aberration theory demonstrates that conventional telescope coating designs introduce unacceptably high levels of polarization aberrations into the optical system. Several ultralow polarization mirror and lens coatings designs for this instrument are discussed. Balancing of polarization aberrations at different surfaces is demonstrated.

Mcguire, James P., Jr.↗
NASA NTRS1976

Conceptual design of a parabolic dish solar collector using simulation techniques

The development of solar concentrators in recent years have produced a wide variety of collectors for the utilization of solar energy. This paper presents the simulation techniques used to predict the optical and thermal performance of a paraboloid of revolution type solar collector. Conceptual design of a dish concentrator with a fixed receiver size is obtained by parametrically examining the significant variables.

Gupta, B. P.↗
NASA NTRS1986

A technique for the optical analysis of deformed telescope mirrors

The NASTRAN-ACCOS V programs' interface merges structural and optical analysis capabilities in order to characterize the performance of the NASA Goddard Space Flight Center's Solar Optical Telescope primary mirror, which has a large diameter/thickness ratio. The first step in the optical analysis is to use NASTRAN's FEM to model the primary mirror, simulating any distortions due to gravitation, thermal gradients, and coefficient of thermal expansion nonuniformities. NASTRAN outputs are then converted into an ACCOS V-acceptable form; ACCOS V generates the deformed optical surface on the basis of these inputs, and imaging qualities can be determined.

Bolton, John F.↗
NASA NTRS2002

NiH2 Reliability Impact Upon Hubble Space Telescope Battery Replacement

The NASA Hubble Space Telescope (HST) was designed to be deployed and later serviced for maintenance and upgrades, as required, by the space shuttle fleet, with a Goodyear mission life for the batteries. HST was deployed 380 miles above the Earth, from Space Shuttle Discovery, on April 25, 1990. Four servicing missions, (SM1, SM2, SM3A, AND SM3B) have been performed. Astronauts have replaced or modified optics, solar arrays, a power control unit, and various science packages. A fifth Servicing Mission, SM4 scheduled for early 2004, is planned to replace the batteries for the first time. The HST is powered by solar array wings and nickel hydrogen (NiH2) Duracell batteries, which are grouped into two parallel battery modules of three parallel batteries each. With a design life of 7 years at launch, these batteries have surpassed 12 years in orbit, which gives HST the highest number of charge/discharge cycles of any NiH2 battery currently in low earth orbit (LEO) application. Being in a LEO orbit, HST has a 45-minute umbra period, during which spacecraft power requirements normally force the batteries into discharge, and a 60-minute sun period, which is available for battery recharge. The intent of this paper is to address the issue of NiH2 battery reliability and how battery capacity degradation can impact scheduling of a Servicing Mission to bring replacement batteries to HST, and extend mission life till deployment of Next Generation Space Telescope (NGST), planned for 2008 at the earliest.

Rao, Gopalakrishna M.↗