SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Tester enables direct measurement of the resonant frequency of an yttrium iron garnet disk. The disk is tested while mounted on the isolator strip with less regard for dimensional flaws.
The resonance frequency shift of an acoustic rectangular chamber due to the presence of a rigid sphere has been measured for l = 1,2 modes as a function of sphere size and position. The frequency shift is the results of volume exclusion and wave scattering. An analytical Green's function calculation was used to explain the data, providing excellent agreement between the measured and the calculated values. Also reported are similar measurements for a thin disk and the ratio of second harmonic to fundamental pressure as a function of sphere position. The measurement shows that the sphere reduces the first harmonic content, with sharply peaked suppression minima at specific sphere positions.
The calculation of currents induced by a transverse electric plane wave normally incident upon an infinite strip embedded in a grounded dielectric slab is used to infer a lower bound on the resonant frequency (or resonant-E-plane dimension) for rectangular microstrip antennas. An upper bound is provided by the frequency for which the E-plane dimension is a half-wavelength.
Analysis of test facility for measuring resonant frequencies of fluid feed lines
This study showcases the electromechanical impedance (EMI) technique for extracting and promoting zero-group velocity (ZGV) and cutoff frequency resonances in a waveguide structure. Here, we identify the mechanisms of multiple resonances in the EMI spectra via a wave propagation perspective. Both simulation and experiments reveal the fact that sharp resonances in the conductance spectra are associated with either ZGV or cutoff frequency points. Consequently, we design four test configurations to enhance local resonances by aligning induced motions with considered mode shapes. Reasonable agreement between simulation and experiment results is observed. We evaluate the performance of considered configurations in terms of mode enhancement, and configurations that can selectively promote certain mode families are summarized. This study also shines the light on the EMI technique for quantitative non-destructive evaluation (NDE) by potentially supporting the inverse characterization of mechanical properties of host structures.
Vibration mount allows adjustment of its resonant frequency and is insensitive to wide temperature variation. The concept is essentially a multidirectional, frictionally damped spring with an adjustable cap. The mount provides vibration isolation in both compression and shear and may be applicable to space use.
With standing wave ultrasonic techniques, small changes in phase velocity which result from changes in some external parameter (e.g., temperature or magnetic field) have traditionally been determined by observing shifts in the mechanical resonance frequency of a composite resonator. Some previous investigators have assumed that the fractional change in velocity is equal to the fractional change in frequency. Substantially improved formulas for determining the dispersion are presented and one of these is shown to be much more accurate than all previous approximations. The results of simulated and actual experiments over wide ranges of dispersion, transducer loading parameter, and frequency are analyzed in order to compare the errors inherent in the various approximations.
With standing wave ultrasonic techniques, small changes in phase velocity which result from changes in some external parameter (e.g., temperature or magnetic field) have traditionally been determined by observing shifts in the mechanical resonance frequency of a composite resonator. Some previous investigators have assumed that the fractional change in velocity is equal to the fractional change in frequency. We discuss quantitatively the errors involved in such an approach, showing that it leads to substantial inaccuracies when the loading effect of the transducer(s) cannot be neglected. Substantially improved formulas for determining the dispersion are presented and one of these is shown to be much more accurate than all previous approximations. The results of simulated and actual experiments over wide ranges of dispersion, transducer loading parameter, and frequency are analyzed in order to compare the errors inherent in the various approximations.
Programmable catalysts exhibiting forced oscillation in the free energy of reacting surface species were simulated to understand the general mechanisms leading to efficient use of the input energy. Catalytic ratchets with either positive or negative adsorbate scaling exhibited oscillation conditions of both high and low turnover efficiency, yielding catalytic turnover frequencies either close to or significantly lower than the applied catalyst oscillation frequency, respectively. The “effective rate”, defined as the product of the catalytic turnover frequency and the turnover efficiency (ηTOE), was limited via two catalytic mechanisms: a leaky catalytic ratchet existed when molecules repeatedly traversed backward through the catalytic transition state upon catalyst oscillation, while a catalytic ratchet with low surface participation exhibited reduced formation of a gas-phase final product due to low surface product coverage. Furthermore, a single applied frequency yielding a maximum effective catalytic rate defined as the “resonance frequency” provided maximum combined benefit for catalytic rate and efficiency.
The West Virginia State College Community College Division NASA Magnetic Earth Ionosphere Resonant Frequencies (MEIRF) study is described. During this contract period, the two most significant and professionally rewarding events were the presentation of the research activity at the Sir Isaac Newton Conference in St. Petersburg, Russia, and the second Day of Discovery Conference, focusing on economic recovery in West Virginia. An active antenna concept utilizing a signal feedback principle similar to regenerative receivers used in early radio was studied. The device has potential for ELF research and other commercial applications for improved signal reception. Finally, work continues to progress on the development of a prototype monitoring station. Signal monitoring, data display, and data storage are major areas of activity. In addition, we plan to continue our dissemination of research activity through presentations at seminars and other universities.
We investigated the natural resonance properties and damping characteristics of rat macrovibrissae (whiskers). Isolated whiskers rigidly fixed at the base showed first-mode resonance peaks between 27 and 260 Hz, principally depending on whisker length. These experimentally measured resonant frequencies were matched using a theoretical model of the whisker as a conical cantilever beam, with Young's modulus as the only free parameter. The best estimate for Young's modulus was approximately 3-4 GPa. Results of both vibration and impulse experiments showed that the whiskers are strongly damped, with damping ratios between 0.11 and 0.17. In the behaving animal, whiskers that deflected past an object were observed to resonate but were damped significantly more than isolated whiskers. The time course of damping varied depending on the individual whisker and the phase of the whisking cycle, which suggests that the rat may modulate biomechanical parameters that affect damping. No resonances were observed for whiskers that did not contact the object or during free whisking in air. Finally, whiskers on the same side of the face were sometimes observed to move in opposite directions over the full duration of a whisk. We discuss the potential roles of resonance during natural exploratory behavior and specifically suggest that resonant oscillations may be important in the rat's tactile detection of object boundaries.
VLF noise phenomena observed with satellite electric dipole antennas compared with lower hybrid resonance frequency of ionospheric medium in vicinity
Young’s modulus is an important parameter for characterizing the strength of, and wave propagation through, a given material. This study improves the estimation of Young’s modulus using the impulse excitation technique based on an experimental analysis of 19 borosilicate glass bars. Analysis of the frequency equations relating Young’s modulus to the out-of-plane and in-plane flexural resonant frequencies of rectangular prisms has been conducted for both the fundamental frequency and its overtones at higher orders of vibration. Furthermore, the Young’s moduli of three novaculite rocks with various porosities were then measured up to the seventh order of vibration to validate the optimum shear constant equation for estimating Young’s modulus. Young’s modulus was found to be nearly frequency independent for these rock samples.
A two-step hybrid perturbation Galerkin technique is applied to the problem of determining the resonant frequencies of one or several degree of freedom nonlinear systems involving a parameter. In one step, the Lindstedt-Poincare method is used to determine perturbation solutions which are formally valid about one or more special values of the parameter (e.g., for large or small values of the parameter). In step two, a subset of the perturbation coordinate functions determined in step one is used in Galerkin type approximation. The technique is illustrated for several one degree of freedom systems, including the Duffing and van der Pol oscillators, as well as for the compound pendulum. For all of the examples considered, it is shown that the frequencies obtained by the hybrid technique using only a few terms from the perturbation solutions are significantly more accurate than the perturbation results on which they are based, and they compare very well with frequencies obtained by purely numerical methods.
A two-step hybrid perturbation Galerkin technique is applied to the problem of determining the resonant frequencies of one or several degrees of freedom nonlinear systems involving a parameter. In one step, the Lindstedt-Poincare method is used to determine perturbation solutions which are formally valid about one or more special values of the parameter (e.g., for large or small values of the parameter). In step two, a subset of the perturbation coordinate functions determined in step one is used in Galerkin type approximation. The technique is illustrated for several one degree of freedom systems, including the Duffing and van der Pol oscillators, as well as for the compound pendulum. For all of the examples considered, it is shown that the frequencies obtained by the hybrid technique using only a few terms from the perturbation solutions are significantly more accurate than the perturbation results on which they are based, and they compare very well with frequencies obtained by purely numerical methods.
The natural vibration frequencies of a structure can be affected by inducing stress in the structure. The success of this kind of control of the resonant frequencies of a truss structure depends on the geometry of the structure. It is shown that in adaptive truss structures the method is effective for vibrations in less stiff directions, such as the normal direction of the plane containing all of the bars of a node, suggesting its applicability for cable, membrane, and thin plate and shell structures.
The accurate determination of the Field Line Resonance (FLR) frequency of a resonating geomagnetic field line is necessary to remotely monitor the plasmaspheric mass density during geomagnetic storms and quiet times alike. Under certain assumptions the plasmaspheric mass density at the equator is inversely proportional to the square of the FLR frequency. The most common techniques to determine the FLR frequency from ground magnetometer measurements are the amplitude ratio and phase difference techniques, both based on geomagnetic field observations at two latitudinally separated ground stations along the same magnetic meridian. Previously developed automated techniques have used statistical methods to pinpoint the FLR frequency using the amplitude ratio and phase difference calculations. We now introduce a physics-based automated technique, using non-linear least square fitting of the ground magnetometer data to the analytical resonant wave equations, that reproduces the wave characteristics on the ground, and from those determine the FLR frequency. One of the advantages of the new technique is the estimation of physics-based errors of the FLR frequency, and as a result of the equatorial plasmaspheric mass density. We present analytical results of the new technique, and test it using data from the Inner-Magnetospheric Array for Geospace Science (iMAGS) ground magnetometer chain along the coast of Chile and the east coast of the United States. We compare the results with the results of previously published statistical automated techniques.
The calculation of currents induced by a plane wave normally incident upon an infinite strip embedded in a grounded dielectric slab is used to infer the resonant width (or frequency) of rectangular microstrip antennas. By placing the strip inside the dielectric, the effect of a dielectric cover of the same material as the substrate can be included in the calculation of resonant frequency. A comparison with measured results indicated agreement of 1 percent or better for rectangular microstrip antennas constructed on Teflon-fiberglass substrate.