Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “beam refraction”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 37 records · Page 2

Impact of increased smoothing by spectral dispersion bandwidth on stimulated Brillouin scattering in laser driven Hohlraums

Experiments were conducted at the National Ignition Facility (NIF) to investigate the impact of increased smoothing by spectral dispersion (SSD) bandwidth on the production of stimulated Brillouin scattering (SBS) within an indirect-drive inertial confinement fusion (ICF) Hohlraum. This was done in a subscale gold Hohlraum driven by 192 laser beams depositing 1.1 MJ of energy. The laser bandwidth was increased from 45 to 118 GHz (before frequency tripling) on the 30° and 50° cones, where backscatter could be measured using the Full Aperture Backscatter Station (FABS). It was expected that this 2.6-fold increase in bandwidth would suppress SBS generated within the Hohlraum plasma and lower the backscattered SBS energy on the 50° cones by over a factor of four. Experimental results, however, show that this SSD change only reduced the 50° cone SBS during the main capsule drive by -18±31% and -4.5±7.8% over the entire pulse. This is small compared to expected shot-to-shot SBS reproducibility (∼30%), such that the result can be considered within normal performance fluctuations. New 3D parallel paraxial code (pF3D) simulations, accounting for beam refractive intensification reproduce this result, suggesting that closer to 300 GHz of bandwidth would have been required to mitigate SBS to the expected level. Delivering such a high bandwidth is not feasible at NIF when operating at high peak power and would potentially prevent NIF’s ability to use cross-beam energy transfer (CBET) for implosion symmetry tuning.

Physics↗

Generalized Rashba-Dresselhaus spin-orbit coupling for cold atoms

We study the possibility for generating a new type of spin-orbit coupling for the center-of-mass motion of cold atoms, using laser beams that resonantly couple N atomic internal ground states to an extra state. After a general analysis of the scheme, we concentrate on the tetrapod setup (N=4) where the atomic state can be described by a three-component spinor, evolving under the action of a Rashba-Dresselhaus-type spin-orbit coupling for a spin 1 particle. We illustrate a consequence of this coupling by studying the negative refraction of atoms at a potential step and show that the amplitude of the refracted beam is significantly increased in comparison to the known case of spin 1/2 Rashba-Dresselhaus coupling. Finally, we explore a possible implementation of this tetrapod setup, using stimulated Raman couplings between Zeeman sublevels of the ground state of alkali-metal atoms.

74 ATOMIC AND MOLECULAR PHYSICS↗

Automation, Operation, and Data Analysis in the Cryogenic, High Accuracy, Refraction Measuring System (CHARMS)

The Cryogenic High Accuracy Refraction Measuring System (CHARMS) at NASA s Goddard Space Flight Center has been enhanced in a number of ways in the last year to allow the system to accurately collect refracted beam deviation readings automatically over a range of temperatures from 15 K to well beyond room temperature with high sampling density in both wavelength and temperature. The engineering details which make this possible are presented. The methods by which the most accurate angular measurements are made and the corresponding data reduction methods used to reduce thousands of observed angles to a handful of refractive index values are also discussed.

Frey, Bradley↗

Automation, Operation, and Data Analysis in the Cryogenic, High Accuracy, Refraction Measuring System (CHARMS)

The Cryogenic High Accuracy Refraction Measuring System (CHARMS) at NASA's Goddard Space Flight Center has been enhanced in a number of ways in the last year to allow the system to accurately collect refracted beam deviation readings automatically over a range of temperatures from 15 K to well beyond room temperature with high sampling density in both wavelength and temperature. The engineering details which make this possible are presented. The methods by which the most accurate angular measurements are made and the corresponding data reduction methods used to reduce thousands of observed angles to a handful of refractive index values are also discussed.

Frey, Bradley J.↗

Upgrade of the JET far infrared interferometer diagnostic

In recent years there has been a major upgrade of the JET far infrared diagnostic system consisting of a new laser system with the wavelength at 118.8 {mu}m at and more advanced processing electronics for phase counting. This provides a second colour measurement of the electron plasma density on the vertical system. Due to the shorter wavelength, the plasma induced laser beam refraction is reduced by a factor of three alleviating density errors caused by loss of signal (so-called 'fringe jumps'[A. Murari et al., Rev. Sci. Instrum. 77, 073505 (2006)]), in particular during high performance plasmas experiments in JET.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Welding for testability: An approach aimed at improving the ultrasonic testing of thick-walled austenitic and dissimilar metal welds

Austenitic and dissimilar welds in thick walled components show a coarse grained, dendritic microstructure. Therefore, ultrasonic testing has to deal with beam refraction, scattering and mode conversion effects. As a result, the testing techniques typically applied for isotropic materials yield dissatisfying results. Most approaches for improvement of ultrasonic testing have been based on modeling and improved knowledge of the complex wave propagation phenomena. In this paper, we discuss an alternative approach: is it possible to use a modified welding technology which eliminates the cause of the UT complications, i.e. the large-grained structure of the weld seams? Various modification parameters were tested, including: TIG current pulsing, additional DC and AC magnetic fields, and also additional external vibrations during welding. For all welds produced under different conditions, the grain structure of the weld seam was characterized by optical and GIUM microstructure visualizations on cross sections, wave field propagation measurements, and ultrasonic tests of correct detectability of flaws. The mechanical properties of the welds were also tested.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Negative Refraction in Time-Varying Strongly Coupled Plasmonic-Antenna–Epsilon-Near-Zero Systems

Time-varying metasurfaces are emerging as a powerful instrument for the dynamical control of the electromagnetic properties of a propagating wave. Here we demonstrate an efficient time-varying metasurface based on plasmonic nano-antennas strongly coupled to an epsilon-near-zero (ENZ) deeply subwavelength film. The plasmonic resonance of the metal resonators strongly interacts with the optical ENZ modes, providing a Rabi level spitting of ~30%. Optical pumping at frequency ω induces a nonlinear polarization oscillating at 2ω responsible for an efficient generation of a phase conjugate and a negative refracted beam with a conversion efficiency that is more than 4 orders of magnitude greater compared to the bare ENZ film. In this work, the introduction of a strongly coupled plasmonic system therefore provides a simple and effective route towards the implementation of ENZ physics at the nanoscale.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Crystals with an Open Wave-Vector Surface: Peculiarities of Reflection and Possibilities of Designing Flat Lenses

The frequency dependence of the reflection coefficient of MgF{sub 2} crystal in the frequency range of 200-800 cm{sup -1} at different orientations of the optical axis has been investigated. The experimental data are compared with the calculation results. This comparison confirms that the wave vectors for the extraordinary wave have an open surface. This makes it possible to focus a divergent beam refracted at a flat boundary ori- ented perpendicularly to the optical crystal axis. The focusing effect of a plane-parallel MgF{sub 2} crystal plate is calculated.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Peculiarities of Laue Diffraction of Neutrons in Strongly Absorbing Crystals

Well-known Kato’s theory of the Laue diffraction of spherical X-ray waves is generalized to the case of the neutron diffraction in strongly absorbing crystals, taking into consideration both the potential and the resonant scattering of neutrons by nuclei as well as a realistic angular dispersion of incident neutrons. The saddle-point method is applied for estimation of the angular integrals, being more adequate in the case of strongly absorbing crystals than the commonly used stationary-phase approximation. It is found that the intensity distribution of the diffracted and refracted beams along the basis of the Borrmann triangle significantly depends on the deviation of the neutron energy from the nuclear resonant level. When comparing our calculations with the Shull’s experimental data on neutron diffraction in silicon, we also regard the role of finite width of the collimating and scanning slits.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

A survey of laser display

Laser display systems, discussing mechanical, diffractive and refractive beam deflection techniques, electro-optical polarization devices, holographic displays, etc

Devaney, A. J.↗

Optical tip clearance sensor for aircraft engine controls

Aircraft gas turbine performance and efficiency are related to airfoil tip clearance. The possibility has been considered to obtain optimum performance and efficiency by reducing clearance to a safe minimum with the aid of a closed-loop tip clearance control system, which utilizes a tip clearance sensor. The use of optical sensing methods appears to represent a potential solution to the tip clearance measurement problem. Principles of sensor operation are discussed along with dimensional considerations and diffraction limitations. A description is presented of the study of the feasibility of a certain sensor, taking into account the test rig system, the optical components, and the mounting tube. Attention is also given to the operation of the feasibility-study sensor, performance estimations, the optical fiber bundle, light beam refraction, and aspects of aircraft engine implementation.

Poppel, G. L.↗

B.Gregory Lecture

Third series of "Gregory lectures" on the memory of B. Gregory (1919-1977), DG from 1965 to 1970. The first conference B. Gregory is presented by Professor V. Weisskopf, his predecessor. Chriss Greeg from Berkeley also speaks.

beam↗

What is the temporal analog of reflection and refraction of optical beams?

It is shown numerically and analytically that when an optical pulse approaches a moving temporal boundary across which the refractive index changes, it undergoes a temporal equivalent of reflection and refraction of optical beams at a spatial boundary. The main difference is that the role of angles is played by changes in the frequency. The frequency dependence of the dispersion of the material in which the pulse is propagating plays a fundamental role in determining the frequency shifts experienced by the reflected and refracted pulses. As a result, our analytic expressions for these frequency shifts allow us to find the condition under which an analog of total internal reflection may occur at the temporal boundary.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Experimental study of the spatial distributions of relativistic electron beams reflected and refracted by a thin foil

Photographs of cross sections of an electron beam scattered from thin foils have been obtained on a dosimetric film. The procession of images makes it possible to obtain the spatial distribution of particles both reflected from a foil and passed through it. The spatial distribution of electrons incident on aluminum, copper, and lead foils, as well as on bimetallic foils composed of aluminum and lead layers and of aluminum and copper layers, has been measured. The effect of the material and thickness of the foil, as well as of the angle between the initial beam trajectory and the target plane, on the spatial distribution of electrons has been studied. The effect of the sequence of the metal layers in bimetallic foils on the distribution of beams has been analyzed. A 7.4-MeV microtron has been used as a source of electrons.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Microfocused X-rays Beams Using Compound Refractive Lenses: Possibilities for Indus-2

For the generation of micro focused hard x-ray beams on Indus-2, with large depth of focus and large focal lengths, simulation studies have been performed using parabolic Be compound refractive lenses (CRLs). The use of these lenses is expected to open many new experimental possibilities widely used at other synchrotron sources.

43 PARTICLE ACCELERATORS↗

Monte Carlo simulation applied in total reflection x-ray fluorescence: Preliminary results

The X-ray Fluorescence (XRF) analysis is a technique for the qualitative and quantitative determination of chemical constituents in a sample. This method is based on detection of the characteristic radiation intensities emitted by the elements of the sample, when properly excited. A variant of this technique is the Total Reflection X-ray Fluorescence (TXRF) that utilizes electromagnetic radiation as excitation source. In total reflection of X-ray, the angle of refraction of the incident beam tends to zero and the refracted beam is tangent to the sample support interface. Thus, there is a minimum angle of incidence at which no refracted beam exists and all incident radiation undergoes total reflection. In this study, we evaluated the influence of the energy variation of the beam of incident x-rays, using the MCNPX code (Monte Carlo NParticle) based on Monte Carlo method.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗