Results for “backscattered cosmic rays” — Page 2

NASA NTRS1984

Path-integrated growth of auroral kilometric radiation

Using Poeverlein's graphical method, three dimensional ray path calculations are performed to evaluate the path-integrated growth of auroral kilometric radiation (AKR). The ray tracing results indicate that waves whose initial wave vector lie in the local meridian plane continue to propagate in that plane and that among these waves, those with frequencies near the cutoff frequency (f sub R = 0) refract substantially, where as those with frequencies well above the cutoff frequency suffer little refraction. It is also shown that waves whose initial wave vector lie outside of the local meridian plane propagate in the longitudinal as well as the radial and the latitudinal directions. The refraction of these waves is also highly dependent upon the wave frequency, i.e., waves with frequencies near f sub R = 0 refract substantially, whereas waves with frequencies much above f sub R = 0 undergo little refraction. In order to test the electron cyclotron maser mechanisms as a method for generation of AKR, a typical electron distribution function measured in the auroral zone by the S3-3 satellite, is used to calculate path-integrated growths of representative rays. The results of this study indicate that electron distribution functions like those measured by the S3-3 satellite are not capable of amplifying cosmic noise background to the observed intensities of auroral kilometric radiation, and that much steeper slopes at the edges of the loss cone are required. The presence of such distribution functions in the auroral zone is plausible if one assumes that backscattered electrons in this region have energies less than a few hundred eV.

Omidi, N.↗

NASA NTRS1995

Image analysis used to count and measure etched tracks from ionizing radiation

We have developed techniques to use digitized scanning electron micrographs and computer image analysis programs to measure track densities in lunar soil grains and plastic dosimeters. Tracks in lunar samples are formed by highly ionizing solar energetic particles and cosmic rays during near surface exposure on the Moon. The track densities are related to the exposure conditions (depth and time). Distributions of the number of grains as a function of their track densities can reveal the modality of soil maturation. We worked on two samples identified for a consortium study of lunar weathering effects, 61221 and 67701. They were prepared by the lunar curator's staff as polished grain mounts that were etched in boiling 1 N NaOH for 6 h to reveal tracks. We determined that backscattered electron images taken at 10 percent contrast and approximately 50 percent brightness produced suitable high contrast images for analysis. We used the NIH Image program to cut out areas that were unsuitable for measurement such as edges, cracks, etc. We ascertained a gray-scale threshold of 25 to separate tracks from background. We used the computer to count everything that was two pixels or greater in size and to measure the area to obtain track densities. We found an excellent correlation with manual measurements for track densities below 1 x 10(exp 8) cm(exp -2). For track densities between 1 x 10(exp 8) cm(exp -2) to 1 x 10(exp 9) cm(exp -2) we found that a regression formula using the percentage area covered by tracks gave good agreement with manual measurements. We determined the track density distributions for 61221 and 67701. Sample 61221 is an immature sample, but not pristine. Sample 67701 is a submature sample that is very close to being fully mature. Because only 10 percent of the grains have track densities less than 10(exp 9) cm(exp -2), it is difficulty to determine whether the sample matured in situ or is a mixture of a mature and a submature soil. Although our analysis of plastic dosimeters is at an early stage of development, results are encouraging. The dosimeter was etched in 6.25 N NaOH at 70 deg C for 16 h. We took 200x secondary electron images of the sample and used the NIH Image software to count and measure major and minor diameters of the etched tracks. We calculated the relative track etch rate from a formula that relates it to the major and minor diameters. We made a histogram of the number of tracks versus their relative etch rate. The relative track etching rate is proportional to the linear energy transfer of the particle. With appropriate calibration experiments, the histogram could be used to calculate the radiation dose.

Blanford, George E.↗