Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “backscattered cosmic rays”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

23 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1977

On the high energy proton spectrum measurements

Reasons are considered for the steepening of the cosmic-ray proton spectrum above 1000 GeV and the 20% increase in inelastic cross sections of protons on carbon and polyethylene nuclei between 20 and 600 GeV observed in the Pronton 1, 2, and 3 satellite experiments. It is shown that these unexpected observations can arise as consequences of energy-dependent albedo (backscatter) from the calorimeter used in the experiments. The experimental apparatus employed is described along with an experimental setup for studying the albedo from the calorimeter, and experimental results are presented concerning the magnitude and energy variation of the albedo. The effects this albedo could have on the proton spectrum and cross-section measurements of the Proton experiments are estimated. The origin and nature of the albedo particles are briefly investigated.

Ellsworth, R. W.↗
NASA NTRS1984

Path-integrated growth of auroral kilometric radiation

Using Poeverlein's graphical method, three dimensional ray path calculations are performed to evaluate the path-integrated growth of auroral kilometric radiation (AKR). The ray tracing results indicate that waves whose initial wave vector lie in the local meridian plane continue to propagate in that plane and that among these waves, those with frequencies near the cutoff frequency (f sub R = 0) refract substantially, where as those with frequencies well above the cutoff frequency suffer little refraction. It is also shown that waves whose initial wave vector lie outside of the local meridian plane propagate in the longitudinal as well as the radial and the latitudinal directions. The refraction of these waves is also highly dependent upon the wave frequency, i.e., waves with frequencies near f sub R = 0 refract substantially, whereas waves with frequencies much above f sub R = 0 undergo little refraction. In order to test the electron cyclotron maser mechanisms as a method for generation of AKR, a typical electron distribution function measured in the auroral zone by the S3-3 satellite, is used to calculate path-integrated growths of representative rays. The results of this study indicate that electron distribution functions like those measured by the S3-3 satellite are not capable of amplifying cosmic noise background to the observed intensities of auroral kilometric radiation, and that much steeper slopes at the edges of the loss cone are required. The presence of such distribution functions in the auroral zone is plausible if one assumes that backscattered electrons in this region have energies less than a few hundred eV.

Omidi, N.↗
NASA NTRS1995

Image analysis used to count and measure etched tracks from ionizing radiation

We have developed techniques to use digitized scanning electron micrographs and computer image analysis programs to measure track densities in lunar soil grains and plastic dosimeters. Tracks in lunar samples are formed by highly ionizing solar energetic particles and cosmic rays during near surface exposure on the Moon. The track densities are related to the exposure conditions (depth and time). Distributions of the number of grains as a function of their track densities can reveal the modality of soil maturation. We worked on two samples identified for a consortium study of lunar weathering effects, 61221 and 67701. They were prepared by the lunar curator's staff as polished grain mounts that were etched in boiling 1 N NaOH for 6 h to reveal tracks. We determined that backscattered electron images taken at 10 percent contrast and approximately 50 percent brightness produced suitable high contrast images for analysis. We used the NIH Image program to cut out areas that were unsuitable for measurement such as edges, cracks, etc. We ascertained a gray-scale threshold of 25 to separate tracks from background. We used the computer to count everything that was two pixels or greater in size and to measure the area to obtain track densities. We found an excellent correlation with manual measurements for track densities below 1 x 10(exp 8) cm(exp -2). For track densities between 1 x 10(exp 8) cm(exp -2) to 1 x 10(exp 9) cm(exp -2) we found that a regression formula using the percentage area covered by tracks gave good agreement with manual measurements. We determined the track density distributions for 61221 and 67701. Sample 61221 is an immature sample, but not pristine. Sample 67701 is a submature sample that is very close to being fully mature. Because only 10 percent of the grains have track densities less than 10(exp 9) cm(exp -2), it is difficulty to determine whether the sample matured in situ or is a mixture of a mature and a submature soil. Although our analysis of plastic dosimeters is at an early stage of development, results are encouraging. The dosimeter was etched in 6.25 N NaOH at 70 deg C for 16 h. We took 200x secondary electron images of the sample and used the NIH Image software to count and measure major and minor diameters of the etched tracks. We calculated the relative track etch rate from a formula that relates it to the major and minor diameters. We made a histogram of the number of tracks versus their relative etch rate. The relative track etching rate is proportional to the linear energy transfer of the particle. With appropriate calibration experiments, the histogram could be used to calculate the radiation dose.

Blanford, George E.↗
DOE OSTI2024

Ground observations of a space laser for the assessment of its in-orbit performance

The wind mission Aeolus of the European Space Agency was a groundbreaking achievement for Earth observation. Between 2018 and 2023, the space-borne lidar instrument ALADIN onboard the Aeolus satellite measured atmospheric wind profiles with global coverage, which contributed to improving the accuracy of numerical weather prediction. The precision of the wind observations, however, declined over the course of the mission due to a progressive loss of the atmospheric backscatter signal. The analysis of the root cause was supported by the Pierre Auger Observatory in Argentina whose fluorescence detector registered the ultraviolet laser pulses emitted from the instrument in space, thereby offering an estimation of the laser energy at the exit of the instrument for several days in 2019, 2020, and 2021. The reconstruction of the laser beam not only allowed for an independent assessment of the Aeolus performance, but also helped to improve the accuracy in the determination of the laser beam’s ground track on single pulse level. The results presented in this paper set a precedent for the monitoring of space lasers by ground-based telescopes and open new possibilities for the calibration of cosmic-ray observatories.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗
DOE OSTI2021

Synthesis of magnesiowüstite nanocrystallites embedded in an amorphous silicate matrix via low energy multiple ion implantations

The synthesis process is presented for experimentally simulating modifications in cosmic dust grains using sequential ion implantations or irradiations followed by thermal annealing. Cosmic silicate dust analogues were prepared via implantation of 20–80 keV Fe - , Mg - , and O - ions into commercially available p-type silicon (100)wafers. The as-implanted analogues are amorphous with a Mg/(Fe+Mg) ratio of 0.5 tailored to match theoretical abundances in circumstellar dusts. Before the ion implantations were performed, Monte-Carlo-based ion-solid interaction codes were used to model the dynamic redistribution of the implanted atoms in the silicon substrate. 600 keV helium ion irradiation was performed on one of the samples before thermal annealing. Two samples were thermally annealed at a temperature appropriate for an M-class stellar wind, 1000 K, for 8.3 h in a vacuum chamber with a pressure of 1 x 10 -7 torr. The elemental depth profiles were extracted utilizing Rutherford Backscattering Spectrometry (RBS) in the samples before and after thermal annealing. X-ray diffraction (XRD)analysis was employed for the identification of various phases in crystalline minerals in the annealed analogues. Transmission electron microscopy (TEM) analysis was utilized to identify specific crystal structures. RBS analysis shows redistribution of the implanted Fe, Mg, and O after thermal annealing due to incorporation into the crystal structures for each sample type. XRD patterns along with TEM analysis showed nanocrystalline Mg and Fe oxides with possible incorporation of additional silicate minerals.

79 ASTRONOMY AND ASTROPHYSICS↗