Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “agglomeration”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1988

Reducing adhesion and agglomeration within a cloud of combustible particles

The study of combustible particle clouds inside flame tubes is of fundamental scientific interest as well as a practical concern. Only the suspended concentration is important to the combustion process, so that assurances must be provided that a minimum of particles adheres to the tube wall. This paper demonstrates experimentally the ability to minimize adhesion and agglomeration of acoustically-mixed lycopodium particles within a 5-cm diameter lexan flame tube. The area density of particles (ADP) adhering to the wall of bare lexan tubes was measured at greater than 100 particles/sq mm. The nature of adhesion was found to be clearly electrostatic, with the ADP level aggravated by increased mixing time, vigor, and the concentration of particles. Increases in the conductivity of the air and the tube wall did not affect ADP levels substantially. However, the observed adhesion was reduced to less than 10 p/sq mm when the air was ionized by use of an alpha emitter mounted on the inner walls of the flame tube.

Ross, Howard D.↗
NASA NTRS1991

Saltation threshold reduction due to the electrostatic agglomeration of fine particles

Particles between 80 and 110 microns in diameter are the most easily moved by the wind. As the particle size decreases below 60 microns, they are increasingly more difficult to move by surface winds, and a number of experiments were performed in an attempt to reduce the required wind velocity. These include: (1) the bombardment of a bed of fine particles by particles near the optimum size, the larger particles kicking the fine particles into the windstream where they are entrained; and (2) the electrostatic agglomeration of fine particles into sizes more easily saltated. The results of these experiments are discussed.

Leach, Rodman N.↗
NASA NTRS1990

Steric stabilization of nonaqueous silicon slips. I - Control of particle agglomeration and packing. II - Pressure casting of powder compacts

The application of steric stabilization to control particle agglomeration and packing of silicon powder in benzene and trichloroethylene is reported. The results provide useful guidelines for controlling unfavorable particle-particle interactions during nonaqueous processing of silicon-based ceramic materials. The application of steric stabilization to the control and improvement of green processing of nonaqueous silicon slips in pressure consolidation is also demonstrated.

Kerkar, Awdhoot V.↗
NASA NTRS1993

Soot agglomeration in isolated, free droplet combustion

Under the conditions of an isolated, free droplet experiment, hollow, carbonaceous structures, called soot spheres, were observed to form during the atmospheric pressure, low Reynolds number combustion of 1-methylnaphthalene. These structures which are agglomerates composed of smaller spheroidal units result from both thermophoretic effects induced by the envelope flame surrounding each drop and aerodynamic effects caused by changes in the relative gas/drop velocities. A chemically reacting flow model was used to analyze the process of sootshell formation during microgravity droplet combustion. The time-dependent temperature and gas property field surrounding the droplet was determined, and the soot cloud location for microgravity combustion of n-heptane droplets was predicted. Experiments showed that the sooting propensity of n-alkane fuel droplets can be varied through diluent substitution, oxygen-index variations, and ambient pressure reductions.

Choi, M. Y.↗
NASA NTRS1994

Agglomeration multigrid for viscous turbulent flows

Agglomeration multigrid, which has been demonstrated as an efficient and automatic technique for the solution of the Euler equations on unstructured meshes, is extended to viscous turbulent flows. For diffusion terms, coarse grid discretizations are not possible, and more accurate grid transfer operators are required as well. A Galerkin coarse grid operator construction and an implicit prolongation operator are proposed. Their suitability is evaluated by examining their effect on the solution of Laplace's equation. The resulting strategy is employed to solve the Reynolds-averaged Navier-Stokes equations for aerodynamic flows. Convergence rates comparable to those obtained by a previously developed non-nested mesh multigrid approach are demonstrated, and suggestions for further improvements are given.

Mavriplis, D. J.↗
NASA NTRS1994

Constraints on chondrule agglomeration from fine-grained chondrule rims

Fine-grained rims around chondrules, Ca,Al-rich inclusions, and other coarse-grained components occur in most types of unequilibrated chondrites, most prominently in carbonaceous chondrites of the CM group. Based on mineralogical and petrographic investigations, it was suggested that rim structures in unequilibrated ordinary chondrites could have formed in the solar nebula by accretion of dust on the surfaces of the chondrules. Dust mantles in CM chondrites seem to have formed by accretion of dust on the surfaces of chondrules and other components during their passage through dust-rich regions in the solar nebula. Concentric mantles with compositionally different layers prove the existence of various distinct dust reservoirs in the vicinity of the accreting parent body. Despite mineralogical and chemical differences, fine-grained rims from other chondrite groups principally show striking similarities to dust mantle textures in CM chondrite. This implies that the formation of dust mantles was a cosmically significant event like the chondrule formation itself. Dust mantles seem to have formed chronologically between chondrule-producing transient heating events and the agglomeration of chondritic parent bodies. For this reason the investigation of dust mantle structures may help to answer the question of how a dusty solar nebula was transformed into a planetary system.

Metzler, K.↗
NASA NTRS1995

A 3D agglomeration multigrid solver for the Reynolds-averaged Navier-Stokes equations on unstructured meshes

An agglomeration multigrid strategy is developed and implemented for the solution of three-dimensional steady viscous flows. The method enables convergence acceleration with minimal additional memory overheads, and is completely automated, in that it can deal with grids of arbitrary construction. The multigrid technique is validated by comparing the delivered convergence rates with those obtained by a previously developed overset-mesh multigrid approach, and by demonstrating grid independent convergence rates for aerodynamic problems on very large grids. Prospects for further increases in multigrid efficiency for high-Reynolds number viscous flows on highly stretched meshes are discussed.

Marvriplis, D. J.↗
NASA NTRS1994

Oscillatory Dynamics of Single Bubbles and Agglomeration in a Sound Field in Microgravity

A dual-frequency acoustic levitator containing water was developed for studying bubble and drop dynamics in low gravity. It was flown on USML-1 where it was used in the Glovebox facility. High frequency (21 or 63 kHz) ultrasonic waves were modulated by low frequencies to excite shape oscillations on bubbles and oil drops ultrasonically trapped in the water. Bubble diameters were typically close to 1 cm or larger. When such large bubbles are acoustically trapped on the Earth, the acoustic radiation pressure needed to overcome buoyancy tends to shift the natural frequency for quadrupole (n = 2) oscillations above the prediction of Lamb's equation. In low gravity, a much weaker trapping force was used and measurements of n = 2 and 3 mode frequencies were closer to the ideal case. Other video observations in low gravity include: (i) the transient reappearance of a bulge where a small bubble has coalesced with a large one, (ii) observations of the dynamics of bubbles coated by oil indicating that shape oscillations can shift a coated bubble away from the oil-water interface of the coating giving a centering of the core, and (iii) the agglomeration of bubbles induced by the sound field.

Marston, Philip L.↗
NASA NTRS2004

Agglomeration Multigrid for an Unstructured-Grid Flow Solver

An agglomeration multigrid scheme has been implemented into the sequential version of the NASA code USM3Dns, tetrahedral cell-centered finite volume Euler/Navier-Stokes flow solver. Efficiency and robustness of the multigrid-enhanced flow solver have been assessed for three configurations assuming an inviscid flow and one configuration assuming a viscous fully turbulent flow. The inviscid studies include a transonic flow over the ONERA M6 wing and a generic business jet with flow-through nacelles and a low subsonic flow over a high-lift trapezoidal wing. The viscous case includes a fully turbulent flow over the RAE 2822 rectangular wing. The multigrid solutions converged with 12%-33% of the Central Processing Unit (CPU) time required by the solutions obtained without multigrid. For all of the inviscid cases, multigrid in conjunction with an explicit time-stepping scheme performed the best with regard to the run time memory and CPU time requirements. However, for the viscous case multigrid had to be used with an implicit backward Euler time-stepping scheme that increased the run time memory requirement by 22% as compared to the run made without multigrid.

Frink, Neal↗
NASA NTRS1979

SPAR 5 experiment no. 74-30 agglomeration in immiscible liquids

The influence of gravity, cooling rate, and composition on the macro-and microstructure of liquid phase immiscible alloys were researched. Aluminum indium alloys of compositions 30, 40, 70, and 90 weight percent indium were processed aboard two sounding rocket flights, SPAR 2 and SPAR 5. Radiographic and metallographic examination of the SPAR 2 flight and ground base samples showed the expected separation at lg of the ground base alloys into indium rich and aluminum rich layers. The flight alloys produced an aluminum rich core surrounding by indium rich metal. The results obtained from the SPAR 5 40 and 70 weight percent indium alloys were essentially identical to those from SPAR 2. The 30 and 90 weight percent indium alloys also showed massive separation into configuration similar to the 40 and 70 weight percent indium alloys. The 90 weight percent indium alloy showed additional evidence that surface tension induced droplet migration had occurred in this alloy which could at least in part account for the observed structures.

Gelles, S.↗
NASA NTRS1980

On the dynamics of agglomerating ensembles of clouds

It is shown that for dynamical time scales longer than 10 million years the ensemble of interstellar cold diffuse clouds may be described by equations of mass and momentum conservation where the pressure has the form p/v-squared/ where /v-squared/ is the mass averaged square velocity dispersion. Equilibrium cloud spectra are derived and an equation of state obtained. The equation of state undergoes a phase transition at a critical density close to the local interstellar gas density. At higher densities, more massive clouds are formed and the cloud fluid softens. It is suggested that this mechanism may naturally regulate the interstellar gas density if star formation is very efficient in the cooler high-density systems.

Cowie, L. L.↗
NASA NTRS1986

Agglomeration-Free Distributor for Fluidized Beds

New gas distributor for fluidized beds prevents hot particles from reacting on it and forming hard crust. In reduction of iron ore in fluidized bed, ore particles do not sinter on distributor and perhaps clog it or otherwise interfere with gas flow. Distributor also relatively cool. In fluidized-bed production of silicon, inflowing silane does not decompose until within bed of hot silicon particles and deposits on them. Plates of spiral distributor arranged to direct incoming gas into spiral flow. Turbulence in flow reduces frequency of contact between fluidized-bed particles and distributor.

Ouyang, F.↗
NASA NTRS1992

Modeling of coalescence, agglomeration, and phase segregation in microgravity processing of bimetallic composite materials

The overall objective of this research is to develop models to predict drop-size-distribution evolutions due to droplet collisions and coalescence during processing within the miscibility gap of bimetallic liquid-phase-miscibility-gap materials. The individual and collective action of gravitational and nongravitational mechanisms on the relative motion and coalescence of drops are considered.

Davis, Robert H.↗
NASA NTRS1992

Stardust: Studies in microgravity of condensation and agglomeration of cosmic dust analogue

A short description of the program Stardust whose goal is to study the formation and properties of high temperature particles and gases, including silicate and carbonaceous materials, that are of interest in astrophysics and planetary science, is given. The international program was carried out in microgravity conditions in parabolic flight. A description of the laboratory equipment, conceived to perform experimental tests in reduced gravity conditions, and which is based on the gas evaporation technique, is given. The gas evaporation technique utilizes one or more heated crucible to vaporize solids materials (SiO, Mg) in a low pressure of inert or reactive gas inside of a vacuum bell jar. The vapor pressures of the materials are controlled by the temperature of the crucibles. The temperature and pressure of inert gas are also controlled. By varying the vapor pressure relative to the gas temperature and pressure, the conditions for substantial grain condensation can be controlled and grain formation measured using light scattering techniques. Thus the partial pressure for grain condensation, can be measured as a function of temperature. The gas evaporation technique has the advantage that complex chemical systems can be studied by using multiple crucibles each containing solid source material. Experimental results and future trends are addressed.

Ferguson, F.↗
NASA NTRS2003

Microgravity Superagglomerates Produced By Silane And Acetylene

The size of the agglomerates produced in the upper portion of a flame is important for a variety of applications. Soot particle size and density effect the amount of radiative heat transfer from a fire to its surroundings. Particle size determines the lifetime of smoke in a building or in the atmosphere, and exposure hazard for smoke inhaled and deposited in the lungs. The visibility through a smoke layer and dectectability of the smoke are also greatly affected by agglomerate size. Currently there is limited understanding of soot growth with an overall dimension of 10 m and larger. In the case of polystyrene, smoke agglomerates in excess of 1 mm have been observed raining out from large fires. Unlike hydrocarbon fuels, silane has the advantage that silica particles are the major combustion product resulting in a particle volume fraction a factor of ten greater than that for a carbonaceous smoke. There are two very desirable properties of silica aero-gels that are important for both space and earth based applications. The first important property is its inertness to most oxidizing and reducing atmospheres. Therefore, silica aero-gels make excellent fire ablatives and can be used in very demanding applications. The second important property is that silica aero-gels are expected to have very high porosity (greater than 0.999), making them lightweight and ideal for aerospace applications. The added benefit of the high porosity is that they can be used as extremely efficient filters for many earth based applications as well. Evidence of the formation of superagglomerates in a laminar acetylene/air diffusion flame was found by Sorensen et al. [1]. An interconnecting web of super-agglomerates was observed to span the width of the soot plume in the region just above the flame tip and described as a gel state. It was observed that this gel state immediately breaks up into agglomerates as larges as 100 m due to buoyancy induced turbulence. Large soot agglomerates were observed in microgravity butane jet diffusion flames by Ito et al.[2]. Several other works to date have studied the effect of flame structure on soot volume fraction and agglomeration size in a microgravity environment.[3-4]. In microgravity the absence of buoyant convective flows increases the residence time in the flame and causes a broadening of the high temperature region in the flame. Both of these factors play a significant role in gas phase radiation and soot formation

Gokoglu, Suleyman↗