Silver oxide-zinc storage battery power supply, design and fabrication Final progress report
Design and tests of prototype silver zinc-oxide storage battery power supply
SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Design and tests of prototype silver zinc-oxide storage battery power supply
Magnesium zinc oxide (MZO, Mg x Zn 1-x O) is a leading emitter for CdTe-based solar cells due to its transparency and the ability to tune its conduction band offset with the absorber. Devices employing alloyed cadmium selenide telluride (CST, CdSe y Te 1-y ) absorbers achieved high efficiency (>19%) using MZO deposited by reactive sputtering over a broad composition range (3.68–3.92 eV, x: 0.20–0.35). Minimal differences in implied and measured open circuit voltage indicate that the contacts are well passivated and highly selective across the spectrum of MZO employed. Device performance insensitivity to MZO composition, which is not observed in CdTe devices, is attributed to the formation of an oxygenated interface layer. Se volatility creates a group VI deficiency at the interface that drives O migration from the MZO into the absorber. This introduces conductivity in the emitter not present in its as-deposited state, contributing to the exceptional performance observed. It is shown that the quality of device passivation depends on the oxidation state of the as-deposited MZO such that intelligent control and management of the reactive sputtering process is required.
The study of modifications in structural, optical and electrical properties of vacuum evaporated zinc oxide thin films on doping with III group oxides namely aluminum oxide, gallium oxide and indium oxide are reported. It was observed that all the films have transmittance ranging from 85 to 95%. The variation in optical properties with dopants is discussed. On doping the film with III group oxides, the conductivity of the films showed an excellent improvement of the order of 10{sup 3} {Omega}{sup -1} cm{sup -1}. The measurements of activation energy showed that all three oxide doped films have 2 donor levels below the conduction band.
Separators for silver oxide-zinc and silver oxide- cadmium cells for spacecraft application
The solubility of metal oxides is one of the key descriptors for the evaluation of their potential toxic effects, both in the bulk form and in nanoparticulated aggregates. Current work presents a new methodology for the in silico assessment of the solubility of metal oxides, which is demonstrated using a well-studied system, ZnO. The calculation of the solubility is based on statistical thermodynamics tools combined with Density Functional Tight Binding theory for the evaluation of the free energy exchange during the dissolution process. Models of small ZnO clusters are used for describing the final dissolved material, since the complete ionic dissolution of ZnO is hindered by the formation of O2- anions in solution, which are highly unstable. Results show very good agreement between the computed solubility values and experimental data for ZnO bulk, up to 0.5 mg·L-1 and equivalents of 50 g·L-1 for the free Zn2+ cation in solution. However, the reference model for solid nanoparticles formed by free space nanoparticles can only give a limited quantitative solubility evaluation for ZnO nanoparticles.
Barrier properties of membrane separators for silver oxide-zinc and silver oxide-cadmium spacecraft batteries
Improved separators for silver oxide-zinc and silver oxide-cadmium cells for spacecraft application
Improved separators for silver oxide-zinc and silver oxide-cadmium cells - flexibility and electrolytic conductivity in modified methyl cellulose polyacid films
We investigate the complex impedance (CI) spectra of chromium-doped indium zinc oxide (CIZO) films with different rapid thermal annealing (RTA) temperatures. The CI spectra drawn from the impedance contributions of Zn-O and In-O bondings in CIZO films were analyzed by two sets of parallel resistance and capacitance components in series. The result demonstrates that zinc interstitials controls electron concentration and transition of electrical transport from semiconducting to metallic. At higher RTA temperature, high-density zinc interstitial promotes Zn atom diffusion from the surface, modifying surface morphology.
We report on the fabrication and performance of polymer-based inverted solar cells utilizing amorphous indium zinc oxide (a-IZO) as the electron-collecting electrode. Amorphous IZO films of 200 nm thickness were deposited by room temperature sputtering in a high-purity argon atmosphere. The films possessed a high optical transmittance in the visible region (≥ 80%), a low resistivity (3.3 × 10 -4 Ωcm), a low surface roughness (root mean square = 0.68 nm), and a low work function (4.46 ± 0.02 eV). Inverted solar cells with the structure a-IZO/P3HT: PCBM/PEDOT:PSS/Ag exhibited a power conversion efficiency of 3% estimated for AM 1.5G, 100 mW/cm 2 illumination.
Versatile and intriguing solution‐based processes are utilized to synthesize nanostructured materials for device applications to reduce material production and device fabrication costs. This study presents results on the fabrication and characterization of copper oxide (CuO) coated cobalt‐doped zinc oxide nanowires (Co‐doped ZnO NW s)‐based heterojunction diodes prepared by a two‐step synthesis route through combined hydrothermal growth and sol–gel spin coating. Highly dense, well‐ordered, undoped, and Co‐doped ZnO NW s were successfully grown by hydrothermal method. Complementary CuO thin films were synthesized by sol–gel method and subsequently coated onto both undoped and Co‐doped ZnO NW s through spin‐coating technique. Enhanced diode properties with a rectification ratio of 10 3 at ±2 V and an ideality factor of n = 2.4 (in dark) were obtained for Co‐doped ZnO NW s‐based heterojunction diodes. The obtained results demonstrated that the investigated heterojunction diode structure fabricated by facile and cost‐effective solution‐based processes can be a promising candidate for the next generation optoelectronic devices.
Amorphous InZnO's (a-IZO) basic PV applicability has now been demonstrated in prototype CIGS, Si Heterojunction (SiHJ) and organic photovoltaics (OPV). However, to move beyond initial demonstration devices, improved TCO properties and processibility of the a-IZO films are needed. Here, RF-superimposed DC sputtering was used to improve the reliable deposition of a-IZO with conductivity > 3000 S/cm.
Silver oxide diffusion tests on separator membranes for use in silver oxide-cadmium and silver oxide-zinc electrochemical cells
The fixed node diffusion Monte Carlo (DMC) method has attracted interest in recent years as a way to calculate properties of solid materials with high accuracy. However, the framework for the calculation of properties such as total energies, atomization energies, and excited state energies is not yet fully established. Several outstanding questions remain as to the effect of pseudopotentials, the magnitude of the fixed node error, and the size of supercell finite size effects. Here, we consider in detail the semiconductors ZnSe and ZnO and carry out systematic studies to assess the magnitude of the energy differences arising from controlled and uncontrolled approximations in DMC. The former include time step errors and supercell finite size effects for ground and optically excited states, and the latter include pseudopotentials, the pseudopotential localization approximation, and the fixed node approximation. We find that for these compounds, the errors can be controlled to good precision using modern computational resources and that quantum Monte Carlo calculations using Dirac-Fock pseudopotentials can offer good estimates of both cohesive energy and the gap of these systems. We do however observe differences in calculated optical gaps that arise when different pseudopotentials are used.
The effects of humic acid (HA) on interactions between ZnO nanoparticles (ZnO NPs) and Pseudomonas putida KT2440 biofilms at different maturity stages were investigated. Three stages of biofilm development were identified according to bacterial adenosine triphosphate (ATP) activity associated with biofilm development process. In the initial biofilm stage 1, the ATP content of bacteria was reduced by more than 90% when biofilms were exposed to ZnO NPs. However, in the mature biofilm stages 2 and 3, the ATP content was only slightly decreased. Biofilms at stage 3 exhibited less susceptibility to ZnO NPs than biofilms at stage 2. These results suggest that more mature biofilms have a significantly higher tolerance to ZnO NPs compared to young biofilms. In addition, biofilms with intact extracellular poly-meric substances (EPS) showed higher tolerance to ZnO NPs than those without EPS, indicating that EPS play a key role in alleviating the toxic effects of ZnO NPs. In both pure ZnO NPs and ZnO-HA mixtures, dissolved Zn 2+ originating from the NPs significantly contributed to the overall toxicity. The presence of HA dramatically decreased the toxicity of ZnO NPs due to the binding of Zn 2+ on HA. The combined results from this work suggest that the biofilm maturity stages and environmental constituents (such as humic acid) are important factors to consider when evaluating potential risks of NPs to ecological systems.
Highlights: • Zinc oxide nanoparticles (ZnO-NPs) synthesized by a green strategy using lemon juice and ethylene glycol. • Physicochemical studies confess the formation of hexagonal wurtzite ZnO nanaogranules with some honed faces. • Direct band gap energy obtained for ZnO nano granules was 3.15 eV. • ZnO nano granules act as good catalyst for the photo degradation of methylene blue, congo red, and rhodamine B under UV-light irradiation. - Abstract: Zinc oxide nanoparticles (ZnO-NPs) obtained by a green synthetic strategy using lemon juice and ethylene glycol. The material was characterized using the techniques UV–vis spectroscopy, FTIR spectroscopy, X-ray diffraction analysis, FESEM, EDAX and HRTEM. Diffraction patterns and TEM micrographs confess the formation of hexagonal wurtzite ZnO nanaogranules with some honed faces and having an average size of 49.16 nm. The developed ZnO-NPs was tested for the photocatalytic degradation of Methylene Blue, Congo Red and Rhodamine B target dyes under UV irradiation and found to have remarkable activity.
ZnO thin films with significantly reduced bandgaps were synthesized by doping N and co-doping Al and N at 100oC. All the films were synthesized by radio-frequency magnetron sputtering on F-doped tin-oxide-coated glass. We found that co-doped ZnO:(Al,N) thin films exhibited significantly enhanced crystallinity as compared to ZnO doped solely with N, ZnO:N, at the same growth conditions. Furthermore, annealed ZnO:(Al,N) thin films exhibited enhanced N incorporation over ZnO:N films. As a result, ZnO:(Al,N) films exhibited improved photocurrents than ZnO:N films grown with pure N doping, suggesting that charge-compensated donor-acceptor co-doping could be a potential method for bandgap reduction of wide-bandgap oxide materials to improve their photoelectrochemical performance.