Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “V/STOL AIRCRAFT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1977

Applications of advanced V/STOL aircraft concepts to civil utility missions, volume 1

The suitability of advanced V/STOL aircraft to civil utility applications was assessed for offshore oil support, forest fire support, transport, and humanitarian missions. The aircraft concepts considered were a lift fan aircraft, a tilt rotor aircraft, and an advanced helicopter. All the aircraft had a design payload of 2,268 kg. (5,000 lb.) with the maximum range varying from 2,224 km. (1,800 nm) for the lift fan STOL to 1,482 km (800 nm) for the advanced helicopter. The analysis of these missions considered such factors as aircraft performance, annual utilization, initial cost, and operating cost. It is concluded that all the advanced V/STOL aircraft concepts generally performed these missions better than contemporary aircraft. The lift fan aircraft and the tilt rotor aircraft were found to be effective for the offshore oil and the forest fire support missions. The lift fan aircraft in the VTOL mode was also found to be very attractive for the executive transport mission where the passenger time value was $30/hr. or more.

Source record↗
NASA NTRS1963

THE FUTURE OF V/STOL AIRCRAFT

Discussion of the performance of v/stol aircraft and their future in view of some of their general deficiencies

VTOL AIRCRAFT↗
NASA NTRS1975

Digital simulation of V/STOL aircraft for autopilot research

Simulations of V/STOL aircraft for autopilot research were introduced as examples of large scale systems. A hierarchy of simulations was assembled, and a modular organization was given to the simulations. The dynamics of the system were subdivided into translational and rotational degrees of freedom, based on the different frequencies at which significant variations in motion variables, control forces and moments occur in two subsystems. This is the basis of the autopilot partitioning into two smaller control problems.

Cicolani, L. S.↗
NASA NTRS1978

V/STOL aircraft simulation - Requirements and capabilities at Ames Research Center

Ground-based flight simulation contributes greatly to the development of new aircraft and flight management systems and will be especially important in improving the performance, safety, and environmental characteristics of future civil and military V/STOL aircraft. This paper describes existing simulation facilities at Ames Research Center and discusses their capabilities and limitations for V/STOL aircraft investigations. Simulation requirements for NASA research and support of DOD programs are also discussed, including technology development for advanced rotorcraft and civil and military V/STOL aircraft. Current efforts and future plans are described for the upgrading of Ames simulation facilities to meet those requirements. Recent advances in equipment technology and operational methodology are shown to provide significantly improved simulation fidelity through better motion and visual cues and faster system response to pilot inputs.

Wilcox, D. E.↗
NASA NTRS1990

Jet-powered V/STOL aircraft - Lessons learned

Over the years a variety of jet-powered V/STOL aircraft were studied in test facilities and flight. The tests disclosed several fundamental limitations: (1) lack of design features conducive to good STOL performance, (2) inadequate performance margins and poor handling qualities, (3) performance and handling qualities degradation due to propulsion system induced flow and ground effect, and (4) inadequate integration of flight control and propulsion systems. The purpose of this paper is to review the lessons learned from tests of jet V/STOL aircraft in key technology areas including: (1) aerodynamic/performance tradeoffs, (2) unique propulsion requirements and induced flow effects, (3) handling qualities, and (4) operating procedures. The sensitivity of current ASTOVL designs to meet requirements in these critical technology area is examined.

Anderson, Seth B.↗
NASA NTRS1974

Application of a Kalman filter identification technique to flight data from the X-22A variable stability V/STOL aircraft

A digital identification technique based on Kalman filter theory was developed for the estimation of V/STOL aircraft stability and control parameters from flight data. The application of this technique to flight data from flying qualities experiments using the variable stability X-22A V/STOL aircraft is discussed. The estimation algorithm is briefly reviewed, experimental and data acquisition procedures used in the X-22A flight programs are outlined, and specific problem areas such as the determination of noise statistics and selection of pilot inputs to enhance identifiability are discussed. Results are presented for a wide range of simulated dynamic configurations.

Lebacqz, J. V.↗
NASA NTRS1979

Effect of nozzle spacing on ground interference forces for a two jet V/STOL aircraft

The effect of nozzle spacing on ground interference forces was investigated for a two jet V/STOL aircraft design. The need for information on the effect of jet spacing arises because of the tradeoff between mechanical complexity, which calls for close spacing, and roll control moments, which call for wider spacing. The ground interference forces on a two jet V/STOL aircraft model were measured for a range of nozzle spacings. Interference forces showed a complicated behavior with nozzle spacing, fuselage geometry, and height above ground. For some conditions a slight change in nozzle spacing resulted in a fourfold change in the interference force from 3% to 12% of the basic jet thrust. An understanding of the observed aircraft force behavior was developed using detailed measurements of the upwash flow properties, along with force and pressure measurements on a series of two dimensional fuselage representations.

Hill, W. G., Jr.↗
NASA NTRS1986

Control of V/STOL aircraft

This paper deals with control of V/STOL aircraft in powered-lift flight. A review of representative operational mission tasks is presented for the take-off, transition, hover and landing flight phases. Characteristics inherent in the basic airframe and propulsion system and the behavior associated with control augmentation systems are considered. Demands for augmented stability and control response to meet certain mission operational requirements are discussed. Experience from ground-based simulation and flight experiments that illustrates the impact of augmented stability and control on aircraft design is related by example.

Franklin, J. A.↗
NASA NTRS1979

Investigation of a laser Doppler velocimeter system to measure the flow field around a large scale V/STOL aircraft in ground effect

The flow field measured around a hovering 70 percent scale vertical takeoff and landing (V/STOL) aircraft model is described. The velocity measurements were conducted with a ground based laser Doppler velocimeter. The remote sensing instrumentation and experimental tests of the velocity surveys are discussed. The distribution of vertical velocity in the fan jet and fountain; the radial velocity in the wall jet and the horizontal velocity along the aircraft underside are presented for different engine rpms and aircraft height above ground. Results show that it is feasible to use a mobile laser Doppler velocimeter to measure the flow field generated by a large scale V/STOL aircraft operating in ground effect.

Zalay, A. D.↗
NASA NTRS1979

Investigation of a laser Doppler velocimeter system to measure the flow field of a large scale V/STOL aircraft in ground effect

An experimental research program for measuring the flow field around a 70 percent scale V/STOL aircraft model in ground effect is described. The velocity measurements were conducted with a ground-based laser Doppler velocimeter at an outdoor test pad. The remote sensing instrumentation, experimental tests, and results of the velocity surveys are discussed. The distribution of vertical velocity in the fan jet and fountain, the radial velocity in the wall jet and the horizontal velocity along the aircraft underside are presented for different engine rpms and aircraft heights above ground. The study shows that it is feasible to use a mobile laser Doppler velocimeter to measure the flow field generated by a large scale V/STOL aircraft operating in ground effect.

Zalay, A. D.↗
NASA NTRS1992

Nonlinear control design for slightly nonminimum phase systems - Application to V/STOL aircraft

The paper describes the application of techniques of exact I/O linearization of nonlinear control systems to the flight control of V/STOL aircraft. It is seen that the application of the theory to this example is not straightforward; in particular, the direct application of the theory yielded an undesirable controller. The situation was remedied by neglecting the coupling between the rolling moment input to the aircraft dynamics and the dynamics along the y-axis. An approximate I/O linearization procedure developed for slightly nonminimum phase nonlinear systems is shown to be effective for V/STOL aircraft.

Hauser, John↗
NASA NTRS1986

The handling qualities and flight characteristics of the Grumman design 698 simulated twin-engine tilt Nacelle V/STOL aircraft

This paper describes three government-conducted, piloted flight simulations of the Grumman Design 698 vertical and short takeoff and landing (V/STOL) aircraft. Emphasis is placed on the aircraft's handling qualities as rated by various NASA, Navy, and Grumman Aerospace Corporating pilots with flight experience ranging from conventional takeoff and landing (CTOL) to V/STOL aircraft. Each successive simulation incorporated modifications to the aircraft in order to resolve the flight problems which were of most concern to the pilots in the previous simulation. The objective of the first simulation was to assess the basic handling qualities of the aircraft with the noncross-shafted propulsion system. The objective of the second simulation was to examine the effects of incorporating the cross-shafted propulsion system. The objective of the third simulation was to examine inoperative single-engine characteristics with and without cross-shafted engines.

Eskey, M. A.↗