SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Temperature gradients for analyzing surface distortions of magnesium solar collector in ecliptic earth orbit determined by analog computer simulation
Large temperature gradient effect on convective heat transfer in turbulent downstream region of heated tube
Compatibility of tantalum and niobium with hydrogen in presence of temperature gradient
Experimental flow regime diagrams are determined for a new rotating cylindrical annulus configuration which permits a measure of control over the internal vertical temperature gradient. The new annulus has radial temperature gradients imposed on plane horizontal thermally conducting endwalls (with the cylindrical sidewalls as insulators) and is considered to be more relevant to atmospheric dynamics studies than the classical cylindrical annulus. Observations have revealed that, in addition to the axisymmetric flow and nonaxisymmetric baroclinic wave flow which occur in the classical annulus, two additional nonaxisymmetric flow types occur in the new annulus: boundary-layer thermal convection and deep thermal convection. Flow regime diagrams for three different values of the imposed vertical temperature difference are presented, and explanations for the flow transitions are offered. The new annulus provides scientific backup for the proposed Atmospheric General Circulation Experiment for Spacelab. The apparatus diagram is included.
Single crystals of mercurous chloride were grown at temperature gradients of 8, 11 and 17 K/cm by the physical vapor transport method. The optical quality of these crystals was evaluated by measuring bulk scattering and inhomogeneity of refractive index by birefringence interferometry. It was observed that a high temperature gradient at the solid-vapor interface induced thermal stresses and crystals showed higher scattering and irregular fringes.
A method is described for studying the influence of a temperature gradient on the crystallization of quiescent polymer melts. The apparatus used consists of two brass plates with embedded electrical resistance heaters and cooling coils. The crystallizations experiments were conducted by placing polymer specimens between the paltes, and manually adjusting heaters and cooling fluids for temperature control. Linear polyethylene, isotactic polyprophylene, and a high density polyethylene were used. It is concluded that the role of a temperature gradient in producing oriented crystallization is in producing conditions which lead the spherulitic growth pattern to proceed primarily in one direction. Steep gradients diminish the penetration of supercooling and favors oriented growth.
This paper develops a dynamic model for pressure sensors in continuum and rarefied flows with longitudinal temperature gradients. The model was developed from the unsteady Navier-Stokes momentum, energy, and continuity equations and was linearized using small perturbations. The energy equation was decoupled from momentum and continuity assuming a polytropic flow process. Rarefied flow conditions were accounted for using a slip flow boundary condition at the tubing wall. The equations were radially averaged and solved assuming gas properties remain constant along a small tubing element. This fundamental solution was used as a building block for arbitrary geometries where fluid properties may also vary longitudinally in the tube. The problem was solved recursively starting at the transducer and working upstream in the tube. Dynamic frequency response tests were performed for continuum flow conditions in the presence of temperature gradients. These tests validated the recursive formulation of the model. Model steady-state behavior was analyzed using the final value theorem. Tests were performed for rarefied flow conditions and compared to the model steady-state response to evaluate the regime of applicability. Model comparisons were excellent for Knudsen numbers up to 0.6. Beyond this point, molecular affects caused model analyses to become inaccurate.
Average solar wind properties at 1 AU either alone or together with the electron density distribution are used to obtain or review some results that relate coronal temperatures, temperature gradients, and compositions. Measured values of the temperature (T) and the temperature gradient parameter are used to find compositions that satisfy the equations used to obtain the results. The total energy equation may be satisfied if the thermal conductivity is reduced by considerable depletions of H(+) in the corona. The hydrostatic approximation (momentum equation) for the electron density distribution appears to require considerable depletions of H(+) in the corona.
The purposes of this investigation were to evaluate the influence of temperature gradients and to test the validity of a recently developed method of calculating plastic flow in disks by comparing the calculated results with experimental observations. Short-time spin tests on parallel-sided, 10-inch-diameter disks were conducted under conditions that subject the disks to a range of temperatures from 70 to 1440 F. The agreement between the theoretical and experimental results was good over the range of temperature conditions investigated. Temperature gradients produced little reduction in the burst speed of the disks which had a high ductility..
Traveling-wave bulk electroconvection induced in slightly conducting liquid with temperature gradient, giving velocity profile equations for plane flow
An investigation is described of the effect of transverse mean-velocity and temperature gradients on sound attenuation in acoustically treated two-dimensional ducts. The results show that cooling the duct walls leads to channeling the sound toward the walls for both downstream and upstream propagation. The effect of mean-temperature gradients on the attenuation rates of the lowest three modes can be as important as the effect of mean-velocity gradients.
After deriving a general expression for the acoustic radiation force on a small spherical particle of radius R in a standing wave field in a temperature gradient, attention is given to the case of a particle in a long tube chamber having a temperature gradient along the axis of symmetry. A simplification of the analysis is obtained through the introduction of the mass flux density potential. A general expression is presented for the time-averaged acoustic force; results of the new sample positions and restoring forces for a plane-wave mode are compared to the homogeneous case.
Oxygen density profiles inferred from Ogo 6 green nightglow emission vary too sharply between 100 and 120 km to be consistent with temperature gradients in standard model atmospheres, and the eddy diffusion coefficient K determined from these observations reaches its maximum below 115 km. For three atomic oxygen profiles obtained at geographic latitudes of -27.69, +48.89, and +59.10 the temperature profiles required to create a downward flux that varies with altitude as the integrated photolytic production rate above that altitude are calculated, assuming K to be invariant with altitude and latitude. The oxygen distribution can be reconciled with a constant eddy coefficient above 100 km if the temperature gradient reaches a value between 10 and 20 deg K/km for low values of the eddy coefficient (about 500,000 sq cm/sec) or between 30 and 50 deg K/km for a higher eddy coefficient (about 1.6 million sq cm/sec). The maximum gradient for the Jacchia (1971) model is about 10 deg K/km. These temperature profiles predict Ar/N ratios consistent with those measured by sounding rockets. The low K profiles are large enough to remove a large part of the solar energy deposited below 120 km by thermal conduction.
Ion temperature gradient along magnetic field lines in outer plasmasphere by thermal diffusion equations compared with electron temperature observations
A numerical model of heat transfer using combined conduction, radiation and convection in AADSF was used to evaluate temperature gradients in the vicinity of the crystal/melt interface for variety of hot and cold zone set point temperatures specifically for the growth of mercury cadmium telluride (MCT). Reverse usage of hot and cold zones was simulated to aid the choice of proper orientation of crystal/melt interface regarding residual acceleration vector without actual change of furnace location on board the orbiter. It appears that an additional booster heater will be extremely helpful to ensure desired temperature gradient when hot and cold zones are reversed. Further efforts are required to investigate advantages/disadvantages of symmetrical furnace design (i.e. with similar length of hot and cold zones).
The results of a detailed study of the nonlinear response of curved sandwich panels with composite face sheets and subjected to a temperature gradient through-the-thickness combined with mechanical loadings are presented. The analysis is based on a first-order shear-deformation Sanders-Budiansky type theory with the effects of large displacements, moderate rotations, transverse shear deformation and laminated anisotropic material behavior included. A mixed formulation is used with the fundamental unknowns consisting of the generalized displacements and the stress resultants of the panel. The nonlinear displacements, strain energy, principal strains, transverse shear stresses, transverse shear strain energy density, and their hierarchical sensitivity coefficients are evaluated. The hierarchical sensitivity coefficients measure the sensitivity of the nonlinear response to variations in the panel parameters, the effective properties of the face sheet layers and the core, and the micromechanical parameters. Numerical results are presented for cylindrical panels subjected to combined pressure loading, edge shortening or extension, edge shear and a temperature gradient through the thickness. The results show the effects of variations in the loading and the panel aspect ratio, on the nonlinear response and its sensitivity to changes in the various panel, effective layer and micromechanical parameters.
Interrupted growth experiments on Hg(0.8)Cd(0.2)Se alloys were performed in an attempt to estimate the actual internal temperature gradient in the melt during directional solidification. The results have been analyzed in terms of a theoretical model which assumes an axial composition profile characteristic of diffusion controlled solute redistribution during growth. A comparison of the calculated and measured values suggests a reduction in the applied (empty furnace) temperature gradient by about a factor of three. Values of the interface segregation coefficient (k) determined from the phase diagram, predict values of solute concentration build up in the solid during growth interruptions which are inconsistent with measured results. It appears that the k values used tend to underestimate the actual k values for higher alloy compositions and overestimate k for the lower alloy compositions.
Plane stress analysis of edge stiffened rectangular plate subjected to boundary loads, boundary displacements, and temperature gradients