Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “RADIO RECEIVER”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1978

Intruder Detector

The shadowy prowler is attempting a break-in, unaware that his presence has already been detected and reported by the device in the lower left corner of the photo. It is part of a three-element ntruder Detecti on System developed by NASA's Ames Research Center from technology acquired in the Apollo lunar exploration program. Apollo astronauts left behind on the moon small portable seismic (shock) detectors to record subsurface vibrations and transmit to Earth data on the moon's density and thickness. A similar seismic detector is the key component of the lntruder Detection System. Encased in a stainless steel tube, the detector is implanted in the ground outside the facility being protected-home, bank, industrial or other facilities. The vibration-sensing detector picks up the footstep of anyone within a preset range. The detector is connected by cable to the transmitter, which relays the warning to a portable radio receiver. The radio alerts plant guards or home occupants by emitting an audible tone burst for each footstep.

Source record↗
NASA NTRS1980

Microprocessor-controlled receiver

Microprocessor and radio receiver are combined in low-cost, high performance, data communications receiver. Hybrid receiver automatically acquires and tracks UHF channels despite low signal-to-noise ratios, fading signal strengths, and high Doppler offset. It also performs digital bit synchronization, which has traditionally required separate unit.

Grant, T. L.↗
NASA NTRS2022

Simons Observatory: Characterizing the Large Aperture Telescope Receiver with Radio Holography

We present near-field radio holography measurements of the Simons Observatory Large Aperture Telescope Receiver optics. These measurements demonstrate that radio holography of complex millimeter-wave optical systems comprising cryogenic lenses, filters, and feed horns can provide detailed characterization of wave propagation before deployment. We used the measured amplitude and phase, at 4 K, of the receiver near-field beam pattern to predict two key performance parameters: 1) the amount of scattered light that will spill past the telescope to 300 K and 2) the beam pattern expected from the receiver when fielded on the telescope. These cryogenic measurements informed the removal of a filter, which led to improved optical efficiency and reduced sidelobes at the exit of the receiver. Holography measurements of this system suggest that the spilled power past the telescope mirrors will be less than 1%, and the main beam with its near sidelobes are consistent with the nominal telescope design. This is the first time such parameters have been confirmed in the lab prior to deployment of a new receiver. This approach is broadly applicable to millimeter and submillimeter instruments.

Grace. E. Chesmore↗
NASA NTRS2006

Digital Front End for Wide-Band VLBI Science Receiver

An upgrade to the very-long-baseline-interferometry (VLBI) science receiver (VSR) a radio receiver used in NASA's Deep Space Network (DSN) is currently being implemented. The current VSR samples standard DSN intermediate- frequency (IF) signals at 256 MHz and after digital down-conversion records data from up to four 16-MHz baseband channels. Currently, IF signals are limited to the 265-to-375-MHz range, and recording rates are limited to less than 80 Mbps. The new digital front end, denoted the Wideband VSR, provides improvements to enable the receiver to process wider bandwidth signals and accommodate more data channels for recording. The Wideband VSR utilizes state-of-the-art commercial analog-to-digital converter and field-programmable gate array (FPGA) integrated circuits, and fiber-optic connections in a custom architecture. It accepts IF signals from 100 to 600 MHz, sampling the signal at 1.28 GHz. The sample data are sent to a digital processing module, using a fiber-optic link for isolation. The digital processing module includes boards designed around an Advanced Telecom Computing Architecture (ATCA) industry-standard backplane. Digital signal processing implemented in FPGAs down-convert the data signals in up to 16 baseband channels with programmable bandwidths from 1 kHz to 16 MHz. Baseband samples are transmitted to a computer via multiple Ethernet connections allowing recording to disk at rates of up to 1 Gbps.

Jongeling, Andre↗
NASA NTRS1965

FM receiver dynamic response

Dynamic response of frequency modulation radio receiver employing amplitude sensitive discriminator

FREQUENCY MODULATION↗
NASA NTRS1990

Satellite sound broadcasting system, portable reception

Studies are underway at JPL in the emerging area of Satellite Sound Broadcast Service (SSBS) for direct reception by low cost portable, semi portable, mobile and fixed radio receivers. This paper addresses the portable reception of digital broadcasting of monophonic audio with source material band limited to 5 KHz (source audio comparable to commercial AM broadcasting). The proposed system provides transmission robustness, uniformity of performance over the coverage area and excellent frequency reuse. Propagation problems associated with indoor portable reception are considered in detail and innovative antenna concepts are suggested to mitigate these problems. It is shown that, with the marriage of proper technologies a single medium power satellite can provide substantial direct satellite audio broadcast capability to CONUS in UHF or L Bands, for high quality portable indoor reception by low cost radio receivers.

Golshan, Nasser↗
NASA NTRS1975

Observations of a low-frequency cutoff in magnetospheric radio noise received on Imp 6

The quasi-continuous component of the magnetospheric noise observed by Imp 6, lying between 30 and 110 kHz, often exhibits a low-frequency cutoff when the spacecraft is in the interplanetary medium or the magnetosheath. A hypothesis is considered in which this low-frequency cutoff, f-co, is caused by overdense plasma situated somewhere along the noise-source-to-satellite path. The plasma is assumed to have a plasma frequency approximately equal to f-co, thus cutting off propagation below f-co.

Vesecky, J. F.↗
NASA NTRS1925

The drift of an aircraft guided towards it's destination by directional receiving of radio signals transmitted from the ground

Following a curved path increases the distance to be flown, and a type of radio navigation that forces the adoption of such a path is therefore less efficient than one that marks out a definite straight line between the point of departure and the intended destination, and holds the airplane to that line. To determine the loss of efficiency resulting from curvature of the path, calculations were made for two particular cases by the method of step-by-step integration. The calculations were based on the assumption that the pilot makes straightforward use of his radio for navigation and makes no allowance for drift. Results are given in tabular form for two airplanes flying 200 miles at 100 mph, one with a cross wind of 50 mph wind across course, and the other with a 20 mph wind across course. It is shown that the following of the curved path increases the time of flight and the air distance flown by 17 percent and 2.5 percent in the two cases.

Source record↗
NASA NTRS2009

Aligning a Receiving Antenna Array to Reduce Interference

A digital signal-processing algorithm has been devised as a means of aligning (as defined below) the outputs of multiple receiving radio antennas in a large array for the purpose of receiving a desired weak signal transmitted by a single distant source in the presence of an interfering signal that (1) originates at another source lying within the antenna beam and (2) occupies a frequency band significantly wider than that of the desired signal. In the original intended application of the algorithm, the desired weak signal is a spacecraft telemetry signal, the antennas are spacecraft-tracking antennas in NASA s Deep Space Network, and the source of the wide-band interfering signal is typically a radio galaxy or a planet that lies along or near the line of sight to the spacecraft. The algorithm could also afford the ability to discriminate between desired narrow-band and nearby undesired wide-band sources in related applications that include satellite and terrestrial radio communications and radio astronomy. The development of the present algorithm involved modification of a prior algorithm called SUMPLE and a predecessor called SIMPLE. SUMPLE was described in Algorithm for Aligning an Array of Receiving Radio Antennas (NPO-40574), NASA Tech Briefs Vol. 30, No. 4 (April 2006), page 54. To recapitulate: As used here, aligning signifies adjusting the delays and phases of the outputs from the various antennas so that their relatively weak replicas of the desired signal can be added coherently to increase the signal-to-noise ratio (SNR) for improved reception, as though one had a single larger antenna. Prior to the development of SUMPLE, it was common practice to effect alignment by means of a process that involves correlation of signals in pairs. SIMPLE is an example of an algorithm that effects such a process. SUMPLE also involves correlations, but the correlations are not performed in pairs. Instead, in a partly iterative process, each signal is appropriately weighted and then correlated with a composite signal equal to the sum of the other signals.

Jongeling, Andre P.↗
NASA NTRS1995

Ulysses radio observations of the heliospheric activity in early June 1991

The radio receiver of the URAP (Unified Radio and Plasma Wave) experiment on Ulysses has recorded a heliospheric activity particularly intense between late May and early June 1991. Many solar radio emissions of types III and II were observed together with interplanetary (IP) shocks. In the same time, the radio spectrograph ARTEMIS at Nancay (France) observed several intense type II bursts. We investigate the association and/or interaction of these radio emissions, which are remotely observed, with some IP shocks detected in situ, in the context of a Coronal Mass Ejection (CME) induced scenario.

Hoang, S.↗
NASA NTRS1982

An electric noise component with density 1/f identified on ISEE 3

The properties of the 1/f noise detected at the terminals of ISEE 3 antennas are described and related to the solar wind parameters. The 1/f noise was observed with the radio receivers of the three-dimensional radio mapping experiment using the S and Z dipole antennas. The noise spectra contained a negative spectral index component at frequencies lower than 0.7 of the plasma frequency, and 5-10 times the predicted thermal noise for the Z antenna. S-antenna measurements of the 1/f component revealed it to be deeply spin modulated with a minimum electric field in the direction of the solar wind. Modulation increases with increasing frequency, becomes negligible when the 1/f intensity is negligible with respect to the thermal noise, and increases with solar wind velocity. The possibilities that the noise is due either to waves or currents are discussed.

Hoang, S.↗
NASA NTRS1989

Measuring Tension In A Tether

Proposed instrument measures tension in tether and transmits data on tension so tension monitored or adjusted as necessary. Positioned along length of tether, which measures tension only at ends. Device includes strain gauge to sense tension. Output of strain gauge controls modulation of battery- or solar-powered radio transmitter. In another version, transmitter receives radio signal on one frequency and returns signal on another frequency with modulation signifying tension. Yet another version, data on tension carried on beam of light. Laser-diode transmitter powered by battery, radio beam, beam of light, or solar energy.

Hinman, E. M.↗
NASA NTRS1993

Telemetry Tests Of The Advanced Receiver II

Report describes telemetry tests of Advanced Receiver II (ARX-II): digital radio receiving subsystem operating on intermediate-frequency output of another receiving subsystem called "multimission receiver" (MMR), detecting carrier, subcarrier, and data-symbol signals transmitted by spacecraft, and extracts Doppler information from signals. Analysis of data shows performance of MMR/ARX-II system comparable and sometimes superior to performances of Blk-III/BPA and Blk-III/SDA/SSA systems.

Hinedi, Sami M.↗