An empirical method for calculating radial pressure distribution on rotating disks.
Radial pressure distribution on enclosed rotating disk with or without blades and with radial outward or inward throughflow
RADIAL FLOW↗
SEARCH · Engineering Papers
Results for “PRESSURE DISTRIBUTION”
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
An empirical method for calculating radial pressure distribution on rotating disks.
Radial pressure distribution on enclosed rotating disk with or without blades and with radial outward or inward throughflow
ROTATING DISK↗
Simulation of real-gas effects on pressure distributions for a proposed Aeroassist Flight Experiment vehicle and comparison to prediction
Pressure distributions measured on a 60-deg elliptic cone, raked off at a 73-deg angle and having an ellipsoid nose (ellipticity equal to 2.0), are presented for a range of angle of attack from -10 to 15 deg. The high normal shock density ratio aspect of a real gas was simulated by testing in Mach-6 air (normal shock density ratio equal to 5.25) and Mach 6 CF4 (normal shock density ratio equal to 12.0). The effects of Reynolds number, angle of attack, and normal shock density ratio on these measurements are examined, and comparisons are made to an inviscid flowfield computer code known as HALIS. A significant effect of density ratio on pressure distributions on the cone section of the configuration was observed; the magnitude of this effect decreased with increased angle of attack. The effect of Reynolds number on pressures was negligible for forebody pressure distributions, but a measurable effect was noted on base pressures. In general, the HALIS code accurately predicted the measured pressure distributions in air and CF4.
Micol, John R.↗
Afterbody/nozzle pressure distributions of a twin-tail twin-engine fighter with axisymmetric nozzles at Mach numbers from 0.6 to 1.2
Distributions of static pressure coefficient over the afterbody and axisymmetric nozzles of a generic, twin-tail twin-engine fighter were obtained in the Langley 16-Foot Transonic Tunnel. The longitudinal positions of the vertical and horizontal tails were varied for a total of six aft-end configurations. Static pressure coefficients were obtained at Mach numbers between 0.6 and 1.2, angles of attack between 0 deg and 8 deg, and nozzle pressure ratios ranging from jet-off to 8. The results of this investigation indicate that the influence of the vertical and horizontal tails extends beyond the vicinity of the tail-afterbody juncture. The pressure distribution affecting the aft-end drag is influenced more by the position of the vertical tails than by the position of the horizontal tails. Transonic tail-interference effects are seen at lower free-stream Mach numbers at positive angles of attack than at an angle of attack of 0 deg.
Wing, David J.↗
Analysis of measured airfoil pressure distributions
A method for evaluating the Glauert coefficients from airfoil pressure distributions is investigated. The linear operating range of the airfoils in steady-state and periodic operating conditions are considered. A rational method for quantitatively characterizing airfoil pressure distributions relative to their geometry and aerodynamic operating environment is developed. The characteristics of the airfoil operating environment is determined from its measured pressure distribution.
Piziali, R. A.↗
Pressure-Distribution Measurements on O-2H Airplane in Flight
Results are given of pressure-distribution measurements made over two different horizontal tail surfaces and the right wing cellule, including the slipstream area, of an observation-type biplane. Measurements were also taken of air speed, control-surface positions, control-stick forces, angular velocities, and accelerations during various abrupt maneuvers. These maneuvers consisted of push-downs and pull-ups from level flight, dive pull-outs, and aileron rolls with various thrust conditions. The results from the pressure-distribution measurements over the wing cellule are given on charts showing the variation of individual rib coefficients with wing coefficients; the data from the tail-surface pressure-distribution measurements are given mainly as total loads and moments. These data are supplemented by time histories of the measured quantities and isometric views of the rib pressure distributions occurring in abrupt maneuvers.
Pearson, H A↗
Large scale advanced propeller blade pressure distributions - Prediction and data
Two Euler analysis techniques, finite difference and finite volume, are employed to predict the blade surface pressure distributions of a large scale advanced propeller. The predicted pressure distributions are compared with wind tunnel data. Both techniques produced blade pressure distributions which are in fairly good agreement with the data over the range of test Mach numbers of 0.2 to 0.78. However, the numerical simulations fail to predict correctly the measured pressure distributions for the low Mach number, high power case which seem to have a leading edge vortex. A discussion of the compressibility effects is also presented.
Nallasamy, M.↗
Large-scale advanced propeller blade pressure distributions: Prediction and data
Two Euler analyses techniques, finite difference and finite volume, were employed to predict the blade surface pressure distributions of a large scale advanced propeller. The predicted pressure distributions were compared with wind tunnel data. Both techniques produced blade pressure distributions that are in fairly good agreement with the data over the range of test Mach numbers of 0.2 to 0.78. However, the numerical simulations fail to predict correctly the measured pressure distributions for the low Mach number, high power case. The data indicate the presence of a leading edge vortex for this case. A discussion of the compressibility effects is also presented.
Nallasamy, M.↗
Pressure distribution on wings in reversed flow
The series of pressure distribution measurements at three test sections on NACA airfoils 2212 and M6 within 170 to 210 angles of attack in reversed flow proved to be largely independent of the profile form. In contradiction to the pressure distribution in normal flow considerable negative pressure from the upper surface spills over onto the lower surface, and vice versa, even in the zone of sound flow. The results are presented as chord-wise pressure and load distribution. The spanwise lift distribution and the total lift coefficients of the wing obtained by integration manifest approximate agreement with the behavior of a diagonally disposed flat plate. By consideration of the ground effect (represented by a flat wall) the lower surface of the wing shows an increase in the low pressure.
Naumann, A↗
An experimental study of pressure distribution curves applicable to pneumatic tires
Pressure distribution curves applicable to pneumatic tires
PRESSURE DISTRIBUTION↗
KC-135 wing and winglet flight pressure distributions, loads, and wing deflection results with some wind tunnel comparisons
A full-scale winglet flight test on a KC-135 airplane with an upper winglet was conducted. Data were taken at Mach numbers from 0.70 to 0.82 at altitudes from 34,000 feet to 39,000 feet at stabilized flight conditions for wing/winglet configurations of basic wing tip, 15/-4 deg, 15/-2 deg, and 0/-4 deg winglet cant/incidence. An analysis of selected pressure distribution and data showed that with the basic wing tip, the flight and wind tunnel wing pressure distribution data showed good agreement. With winglets installed, the effects on the wing pressure distribution were mainly near the tip. Also, the flight and wind tunnel winglet pressure distributions had some significant differences primarily due to the oilcanning in flight. However, in general, the agreement was good. For the winglet cant and incidence configuration presented, the incidence had the largest effect on the winglet pressure distributions. The incremental flight wing deflection data showed that the semispan wind tunnel model did a reasonable job of simulating the aeroelastic effects at the wing tip. The flight loads data showed good agreement with predictions at the design point and also substantiated the predicted structural penalty (load increase) of the 15 deg cant/-2 deg incidence winglet configuration.
Montoya, L. C.↗
Pressure Distribution on Joukowski Wings and Graphic Construction of Joukowski Wings
In the first article, in connection with a lecture on the hydrodynamic basis of flight and the potential flow about a Joukowski wing, the pressure distribution on several wings is computed and plotted. The diagrams of the pressure distributions are presented accompanied with a qualitative discussion of the pressure distribution. In the second article, the the cross-sectional outline (or profile) a Joukowski wing are plotted.
PRESSURE DISTRIBUTION - AIRFOILS - JOUKOWSKI↗
Circumferential pressure distributions in a model labyrinth seal
A research program to isolate and study leakage flow through labyrinth glands was initiated. Circumferential pressure distributions were measured in the labyrinth glands with geometry appropriate to the high pressure labyrinths in large steam turbines. Knowledge of this pressure distribution is essential as it is this unequal pressure field that results in the destabilizing force. Parameters that are likely to affect the pressure distributions are incorporated into the test rig. Some preliminary pressure profiles are presented.
Leong, Y. M. M. S.↗
A Method for Calculating the Induced Pressure Distribution Associated with a Jet in a Crossflow
A model is presented which can be used to study the loss of lift during hovering and horizontal flight of the VTOL aircraft. The model numerically predicts the pressure distribution induced by a round, turbulent, unheated, subsonic jet exhausting normally through a flat plate into a subsonic crossflow. The complete model assumes that the predominant features of the flow are jet entrainment and a pair of contrarotating vortices which form downstream of the jet. Experimentally determined vortex properties and a reasonable assumption concerning jet entrainment were used. Potential flow considerations were used except in the wake region, where a simple method for approximating the pressure distribution was suggested. The calculated pressure distribution, lift, and pitching moments on the flat plate are presented for a jet to crossflow velocity ratio of 8 and were compared with experimental results. A computer program is given which was used to calculate the pressure distribution across the flat plate.
Dietz, W. E., Jr.↗
Measured pressure distributions of large-angle cones in hypersonic flows of tetrafluoromethane, air, and helium
An experimental study of surface pressure distributions on a family of blunt and sharp large angle cones was made in hypersonic flows of helium, air, and tetrafluoromethane. The effective isentropic exponents of these flows were 1.67, 1.40, and 1.12. Thus, the effect of large shock density ratios such as might be encountered during planetary entry because of real-gas effects could be studied by comparing results in tetrafluoromethane with those in air and helium. It was found that shock density ratio had a large effect on both shock shape and pressure distribution. The differences in pressure distribution indicate that for atmospheric flight at high speed where real-gas effects produce large shock density ratios, large-angle cone vehicles can be expected to experience different trim angles of attack, drag coefficient, and lift-drag ratios than those for ground tests in air wind tunnels.
Jones, R. A.↗
Surface-pressure Distributions on a Systematic Group of NACA 1-series Cowlings with and Without Spinners
A method for calculating the flow fields of axially symmetric bodies from their pressure distributions is reported in NACA RM No. L8I17. In order to facilitate application of this method to the important case of the cowling-spinner combination, for use in the design of propellers, the present paper presents static-pressure distributions on the tops of 79 high-critical-speed NACA 1-series cowling-spinner combinations over wide ranges of inlet-velocity ratio at angles of attack of 0 degrees, 2 degrees, 4 degrees, and 6 degrees. Static-pressure distributions around the nose sections of several cowlings are given in greater detail to aid in estimating the pressures near the stagnation points and to show the effect of changes in the internal lip shape. The effects of the operation of a typical propeller on the surface pressures on the cowling are shown for one configuration. The pressure distributions over the nine NACA 1-series nose inlets used as the basic components of these combinations are also presented ro supplement the existing open-nose-cowling data of NACA ACR No. L5F30a which are applicable to the case of the rotating cowling.
Boswinkle, Robert W JR↗
A Systematic Investigation of Pressure Distributions at High Speeds over Five Representative NACA Low-Drag and Conventional Airfoil Sections
Pressure distributions determined from high-speed wind-tunnel tests are presented for five NACA airfoil sections representative of both low-drag and conventional types. Section characteristics of lift, drag, and quarter-chord pitching moment are presented along with the measured pressure distributions for the NACA 65sub2-215 (a=0.5), 66sub2-215 (a=0.6), 0015, 23015, and 4415 airfoils for Mach numbers up to approximately 0.85. A critical study is made of the airfoil pressure distributions in an attempt to formulate a set of general criteria for defining the character of high speed flows over typical airfoil shapes. Comparisons are made of the relative characteristics of the low-drag and conventional airfoils investigated insofar as they would influence the high-speed performance and the high-speed stability and control characteristics of airplanes employing these wing sections.
Graham, Donald J↗
Remarks on the Pressure Distribution over the Surface of an Ellipsoid, Moving Translationally Through a Perfect Fluid
This note, prepared for the National Advisory Committee for Aeronautics, contains a discussion of the pressure distribution over ellipsoids when in translatory motion through a perfect fluid. An easy and convenient way to determine the magnitude of the velocity and of the pressure at each point of the surface of an ellipsoid of rotation is described. The knowledge of such pressure distribution is of great practical value for the airship designer. The pressure distribution over the nose of an airship hull is known to be in such good agreement with the theoretical distribution as to permit basing the computation of the nose stiffening structure on the theoretical distribution of pressure.
Munk, Max M↗