Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Homojunction”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1988

p/n InP homojunction solar cells with a modified contacting scheme by liquid phase epitaxy

p/n InP homojunction solar cells with a modified contacting scheme have been fabricated from wafers grown by liquid phase epitaxy. A p(+)-In(0.53)Ga(0.47)As contacting layer is incorporated in the cell structure to reduce contact resistance and to eliminaate surface spiking problems at the front surface. The highest conversion efficiency (total area) obtained under AM0 illumination is 15.0 percent. The corresponding open-circuit voltage, short-circuit current density, and fill factor for the best cell are 0.866 V, 29.3 mA/sq cm, and 81.0 percent, respectively.

Choi, K. Y.↗
NASA NTRS1988

InP homojunction solar cell performance on the LIPS 3 flight experiment

Performance data for the NASA Lewis Research Center indium phosphide n+p homojunction solar cell module on the LIPS 3 Flight Experiment is presented. The objective of the experiment is to measure the performance of InP cells in the natural radiation environment of the 1100 km altitude, 60+ deg inclination orbit. Analysis of flight data indicates that the performance of the four cells throughout the first year is near expected values. No degradation in short-circuit current was seen, as was expected from radiation tolerance studies of similar cells. Details of the cell structure and flight module design are discussed. The results of the temperature dependency and radiation tolerance studies necessary for normalization and analysis of the data are included.

Brinker, David J.↗
NASA NTRS1989

InP shallow-homojunction solar cells

Indium phosphide solar cells with very thin n-type emitters have been made by both ion implantation and metalorganic chemical vapor deposition. Air mass zero efficiencies as high as 18.8 percent (NASA measurement) have been achieved. Although calculations show that, as is the case with GaAs, a heterostructure is expected to be required for the highest efficiencies attainable, the material properties of InP give the shallow-homojunction structure a greater potential than in the case of GaAs. The best cells, which were those made by ion implantation, show open-circuit voltage (V sub oc) of 873 mV, short-circuit current of 357 A/sq m (35.7 mA/sq cm), and fill factor of 0.829. Improvements are anticipated in all three of these parameters. Internal quantum efficiency peaks at over 90 percent in the red end of the spectrum, but drops to 54 percent in the blue end. Other cells have achieved 74 percent in the blue end. Detailed modeling of the data indicates that a high front surface recombination velocity is responsible for the low blue response, that the carrier lifetime is high enough to allow good carrier collection from both the base and the emitter, and that the voltage is base-limited.

Keavney, Christopher↗
NASA NTRS1989

An empirical study of the performance of APMOVPE AM0 InP homojunction solar cells as a function of emitter thickness and doping, and base doping

Their excellent radiation resistance and conversion efficiencies greater than 20 percent, measured under global conditions, make InP shallow-homojunction solar cells very attractive for space or terrestrial application. In addition, modeling studies show that, for optimized design, efficiencies of these devices should exceed 20 percent even under AM0 conditions. However, a systematic experimental investigation of the influence of the various cell design parameters on cell performance has not as yet been made. For the n+/p/p+ structures investigated in the previous modeling study, the design parameters include the impurity concentrations and thicknesses of the emitter and base layers. In the work reported here, researchers discuss an experimental investigation of the effects on cell performance of varying the impurity concentrations of the emitter and base and thickness of the emitter.

Wanlass, M. W.↗
NASA NTRS1989

N/P InP homojunction solar cells with an In0.53Ga0.47As contacting layer grown by liquid phase epitaxy

N/P InP homojunction solar cells with an In sub 0.53 Ga sub 0.47 As contacting layer were fabricated by liquid phase epitaxy (LPE). Electron-Beam-Induced-Current (EBIC) measurements were performed on several selected samples. It was found that the background doping level in the base region sometimes results in a deep junction, which greatly affects the cell performance.

Shen, C. C.↗
NASA NTRS1989

On-orbit results of the LIPS 3/InP homojunction solar cell experiment

The flight performance of NASA Lewis Research Center's indium phosphide homojunction solar cell module on the LIPS 3 satellite is presented. A module of four n+p cells was fabricated and has been on-orbit on the LIPS 3 spacecraft since 1987. The experimental objective is the measurement of InP cell performance in the natural radiation environment of the 1100 kilometer altitude, 60 deg inclination, circular orbit. Flight data from the first year is near expected values, with no degradation in short-circuit current. The temperature dependence of current-voltage parameters is included along with the laboratory radiation tolerance studies necessary for normalization and analysis of the data. Details of the cell structure and flight module design are also discussed.

Brinker, David J.↗
NASA NTRS1989

On-orbit results of the LIPS 3/InP homojunction solar cell experiment

The flight performance of the NASA indium phosphide homojunction cell module on the LIPS 3 satellite is presented. The experimental objectivewas to measure the InP cell performance in the natural radiation environment in a circular 1100 km altitude orbit inclined 60 degrees. Flight data for the first year is close to expected values. No degradation in the short-circuit current is seen. Details of cell structure and flight module design are discussed.

Brinker, David J.↗
NASA NTRS1988

An empirical investigation of the InP shallow-homojunction solar cell

An experimental study of the performance of epitaxially grown InP shallow-homojunction solar cells as a function of the thickness and carrier concentration in the base and emitter layers is presented. Identification of improvements to cell design leading to higher performance is emphasized. As a result, using a near-optimum set of design parameters, cells with conversion efficiencies of 20.3 percent (global) and 17.6 percent (AM0) have been achieved. For such cells, it is shown that the internal response of the base layer is essentially perfect, whereas the emitter-layer properties can be improved substantially and warrant further investigation. Discrepancies between the results of the present study and those of earlier modeling efforts are discussed.

Wanlass, M. W.↗
NASA NTRS1988

Modeling and simulation of InP homojunction solar cells

Modeling and simulation of single-crystal InP homojunction solar cells has been performed using the PC-1D code. Cell design and performance have been optimized using the best available estimates of the various materials parameters. A comparison has been made of the predictions of the PC-1D model to those of other models. The optimum performance is predicted to give an efficiency approaching 21 percent at AM0. It is shown that in order to describe the performance of actual cells it is necessary to use larger values of the intrinsic carrier concentration and the surface recombination velocity (SRV) than have been reported in the literature. However, even with a near-maximum value of SRV (e.g., 10 to the 7th cm/s) it is necessary to reduce the minority carrier diffusion length in the emitter to only 0.01 micron in order to account for the relatively low quantum efficiency in the blue part of the spectrum. This indicates that improvement in the emitter bulk properties could be much more important than the SRV. Other loss mechanisms are also discussed; in particular, it is shown that recombination in the base, for good quality material, is relatively insignificant.

Yahia, A. H.↗
NASA NTRS1988

InP homojunction solar cell performance on the LIPS III flight experiment

Performance data for the NASA Lewis Research Center indium phosphide n+p homojunction solar cell module on the LIPS 3 flight experiment is presented. The objective of the experiment is to measure the performance of InP cells in the natural radiation environment of the 1100 km altitude, 60+ deg inclination orbit. Analysis of flight data indicates that the performance of the four cells throughout the first year is near expected values. No degradation in short-circuit current was seen, as was expected from radiation tolerance studies of similar cells. Details of the cell structure and flight module design are discussed. The results of the temperature dependency and radiation tolerance studies necessary for normalization and analysis of the data are included.

Brinker, David J.↗
NASA NTRS1990

Investigation of buried homojunctions in p-InP formed during sputter deposition of both indium tin oxide and indium oxide

While dc magnetron sputter deposition of indium tin oxide leads to the formation of a buried homojunction in single crystal p-type InP, the mechanism of type conversion of the InP surface is not apparent. In view of the recent achievement of nearly 17-percent global efficiencies for cells fabricated solely by sputter deposition of In2O3, it is presently surmised that tin may not be an essential element in type conversion. A variety of electrical and optical techniques are presently used to evaluate the changes at both indium tin oxide/InP and indium oxide/InP interfaces. Such mechanisms as the passivation of acceptors by hydrogen, and sputter damage, are found to occur simultaneously.

Gessert, T. A.↗
NASA NTRS1991

A theoretical comparison of the near-optimum design and predicted performance of n/p and p/n indium phosphide homojunction solar cells

Using a detailed simulation model of p(+)nn(+) and n(+)pp(+) indium phosphide (InP) homojunction solar cells, extensive parametric variation computer simulation runs were performed to aid in making near-optimum designs for these two solar cell configurations. The values of all the geometrical and material parameters corresponding to the near-optimal designs of both these configurations are presented. The results of parametric variation runs are presented for each configuration showing how the performance parameters J(sub sc), V(sub oc), and eta vary with each of the cell design parameters for the near-optimally designed cell. Finally, the theoretically obtained results are discussed, and the relative merits and drawbacks of the two configurations are compared.

Goradia, Chandra↗
NASA NTRS1990

Recent results from the InP homojunction cell module on the LIPS III spacecraft

The flight performance of the NASA Lewis Research Center's indium phosphide homojunction cell module on the LIPs III spacecraft is presented. Four n+-p diffused junction cells, an early product of an InP development program, were flown. The voltage range of the data prohibits determination of the open-circuit voltage or the maximum power point. However, analysis of the 32 months of short-circuit current data reveals a slight increase, not the 4 percent decrease expected from radiation tolerance studies. This increase may be due to continual cleaning of possible prelaunch dust contamination or changes in data acquisition system calibration. For all cells, the average short-circuit current remains below prelaunch values.

Brinker, David J.↗
NASA NTRS1991

Theoretical modeling, near-optimum design and predicted performance of n(+)pp(+) and p(+)nn(+) indium phosphide homojunction solar cells

Using a detailed simulation model of p(+)nn(+) and n(+)pp(+) indium phosphide (InP) homojunction solar cells, extensive parametric variation computer simulation runs are conducted to help arrive at near-optimum designs of these two solar cell configurations. Values of all the geometrical and material parameters corresponding to the near-optimal designs of both these configurations are presented. For each configuration, results are given for parametric variation runs showing how the performance parameters JSC, VOC, and eta vary with each of the cell parameters for the near-optimally designed cell.

Goradia, Chandra↗
NASA NTRS1994

Annealing of irradiated n+p InP buried homojunctions

At the last SPRAT conference, the Naval Research Laboratory (NRL) presented results from two experiments. One studied n+p diffused junction (DJ) InP solar cells, and the other studied n+p shallow homojunction (SHJ) InP mesa diodes grown by metalorganic chemical vapor deposition (MOCVD). The former work showed that a DJ solar cell in which the maximum power P(sub max) had been degraded by nearly 80 percent under irradiation recovered completely under short circuit illumination at 450K. The recovery was accompanied by the removal of all but one of the radiation-induced defect levels. The latter work, on the other hand, showed that the radiation-induced defects in the SHJ diodes did not anneal until the temperature reached 650K. These results suggest that an irradiated DJ solar cell, under illumination, will anneal at a temperature 200K lower than an irradiated SHJ cell. This is an unexpected result considering the similarity of the devices. The goal of the present research is to explain this different behavior. This paper investigates two points which arose from the previous studies. The first point is that the DJ cells were annealed under illumination while the SHJ diodes were annealed without bias. The second point investigated here is that the emitters of the DJ and SHJ devices were significantly different.

Walters, Robert J.↗