SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Ho:Tm:LuAG has been grown, examined spectroscopically, and lased at 2.1 microns. Ho:Tm:LuAG was selected for this experimental investigation when quantum-mechanical modeling predicted that it would be a good laser material for Ho laser operation on one of the 5I7 to 5I8 transitions. Lasing was achieved at 2.100 microns, one of the three wavelengths predicted to be most probable for laser action.
In the measurement of tropospheric HO we have employed three low-pressure laser-excited fluorescence (LEF) experimental systems. These instruments operate by expanding the ambient air flow via a nozzle, followed by transit down a flowtube through a detection region traversed by the excitation laser beam. This sampling method we named FAGE (fluorescence assay with gas expansion). The instruments employed a hydrocarbon reagent, added below the nozzle, to remove HO for background measurement. In the second and third instruments, air sampling via parallel nozzles and tubes, with reagent addition alternating between two channels, permitted continuous signal measurement with simultaneous measurement of background. The first two instruments (FAGE1 and FAGE2) used 282 nm HO excitation by frequency-doubled tunable dye lasers, pumped by pulsed Nd:YAG lasers at 10-30 Hz repetition rate. The third instrument (FAGE3) uses 308 nm excitation in which the dye laser is pumped by a copper vapor laser, pulsed at 5600 Hz.
A review of Tm and Ho materials is presented, covering some fundamental aspects on the spectroscopy and laser dynamics in both single and co-doped systems. Following an introduction to 2- m lasers, applications and historical development, the physics of quasi-four level lasers, energy transfer and modeling are discussed in some detail. Recent developments in using Tm lasers to pump Ho lasers are discussed, and seen to offer some advantages over conventional Tm:Ho lasers. This article is not intended as a complete review, but as a primer for introducing concepts and a resource for further study.
A room temperature, directly diode pumped Ho:LuAG laser oscillated for the first time. Direct pumping of the Ho upper laser manifold maximizes efficiency, minimizes heating, and eliminates Ho:Tm energy sharing. Design and performance are presented.
The measurement of calorimetric spectra following atomic weak decays, beta (b) and electron capture (EC), of nuclides having a very low Q-value, can provide an impressively high sensitivity to a non-vanishing neutrino mass. The achievable sensitivity in this kind of experiments is directly connected to the performance of the used detectors. In particular an energy resolution of a few eV and a pulse formation time well below 1 microsecond are required. Low temperature Metallic Magnetic Calorimeters (MMCs) for soft X-rays have already shown an energy resolution of 2.0 eV FWHM and a pulse rise-time of about 90 ns for fully micro-fabricated detectors. We present the use of MMCs for high precision measurements of calorimetric spectra following the beta-decay of Re-187 and the EC of Ho-163. We show results obtained with detectors optimized for Re-187 and for Ho-163 experiments respectively. While the detectors equipped with superconducting Re absorbers have not yet reached the aimed performance, a first detector prototype with a Au absorber having implanted Ho-163 ions already shows excellent results. An energy resolution of 12 eV FWHM and a rise time of 90 ns were measured.
The reaction of O(3P) with 1-C4H8 was examined in the presence of CO which scavenges HO radicals to produce CO2. From the CO2 quantum yield, an upper limit to the efficiency of HO production in the reaction of O(3P) with 1-C4H8 was found to be 0.020 at both 298 and 473 K.
The parameters for a chemical technique can be outlined from the following set of desirable goals: (1) sufficient conversion of tracer species A to product B that B can be measured quantitatively in the presence of A and a great excess of air; (2) specificity of reaction such that A is converted to B only by reaction with HO; and (3) sufficient sensitivity for detection that the ambient concentration of HO is not seriously perturbed by the presence of A and B. This proposed study involves finding a chemical reaction specific enough for OH, and a measurement of the product formed. What one wants is a rate constant of about 10 to the -10th power cu cm/s, so that 0.1 percent of the OH will be converted in 100 s. Laboratory studies are needed to find a reaction which will fill this bill, yielding a product in quantity sufficient for precise measurement. This is an extremely fast constant and the search may be difficult. Again there is a question of perturbing the local environment, while still providing a sensitive measurement. Also the temperature and pressure dependence of the reaction rate is a complicated function for many of these species (that is, one must use a RRKM or Troe-based picture), and must be taken into account.
The carbon kinetic isotope effect in the CH4 + HO reaction is measured experimentally and the use of carbon isotope ratios to diagnose atmospheric methane is examined. The chemical, photolysis, and analytical experimental conditions and procedures are described. It is determined that the CH4 + HO reaction has a carbon kinetic isotope effect of 1.010 + or 0.007 for k(12)k(13) (rate constants ratio) at 297 + or - 3 K. This value is compared with the data of Rust and Stevens (1980). Causes for the poor correlation between the data at high methane conversions are discussed. It is supposed that the difference between the k(12) and k(13) values is due to a difference in the activation energy of the two reactions.
Longitudinal pumping by laser diodes increases efficiency. Improved holmium:yttrium lithium fluoride laser radiates as much as 56 mW of power at wavelength of 2.1 micrometer. New Ho:YLF laser more compact and efficient than older, more powerful devices of this type. Compact, efficient Ho:YLF laser based on recent successes in use of diode lasers to pump other types of solid-state lasers.
Solid-state lasers pumped by continuous-wave diode lasers can be Q-switched to obtain high peak power output pulses. The dependence of laser-pulse energy, average output power, peak power, and pulse width on pulse-repetition frequency in Q-switched Nd:YAG and Ho:YLF lasers is determined and compared. At low pulse repetition rates, the much longer upper-stage lifetime in Ho:YLF gives a distinct advantage. At higher pulse rates, the overall laser efficiency and the stimulated emission cross section are more important parameters, leading to an advantage for Nd:YAG. The results are of significance for designing lasers for use in space optical communications and remote sensing systems.
The energy transfer processes in Tm,Ho:YAG lasers were investigated in spectral studies and measurements of the temporal response to pulsed excitation. These processes include the population of the 3H4 pump band of Tm, cross-relaxation in Tm, the transfer of energy from Tm to Ho, and various loss mechanisms. It was found that the Tm cross-relaxation is due to a dipole-dipole interaction between Tm ions and that the rate of this process is a function of temperature and ion concentration.
The development of eye-safe, solid-state Lidar systems is discussed, with an emphasis on Coherent Doppler Lidar for Atmospheric Wind Measurements. The following subject areas are covered: tunable Ho DIAL (Differential Absorption Lidar)/lidar atmospheric measurements; atmospheric turbulence measurements and detector arrays; diurnal measurements of C(sub n)(sup 2) for KSC lidar measurements; and development of single-frequency Ho laser/lidar.
In recent advanced lasers, 2 micron solid-state lasers such as Tm:YAG and Ho:YAG lasers are very attractive for laser radar remote sensing technologies because of eye safety, realizations of all solid-state laser pumped by diode laser and smaller dimension, tunability of lasing wavelength, possibility of coherent detection, etc. Featuring these advantages, 2 micron lasers have been candidated as laser transmitters for use in water vapor Differential Absorption Lidar (DIAL), laser altimeter, Doppler wind sensor, Mie lidar, etc. Characterization of a tunable Cr, Tm, Ho:YAG laser and its applications to spectroscopy concerning absorption and reflectance are reported.
Unique features include high efficiency and tunability at wavelengths near 2.067 micrometers. Continuous-wave, diode-pumped Tm,Ho:YLF laser tuned by tilting Fabry-Perot etalon and/or adjusting temperature of Tm,Ho:YLF crystal. Proposed for use in remote sensing of winds and in remote sensing of CO2 and H2O, of which many strong absorption lines over-lap laser tuning range. Range extended by tuning to wave-length between CO2 and H2O absorption peaks.
We present the emitter efficiency results for the thin film 25 percent Ho YAG (Yttrium Aluminum Garnet, Y3Al5O12) selective emitter from 1000 to 1700 K with a platinum substrate. Spectral emittance and emissive power measurements were made (1.2 less than lambda less than 3.2 microns) and used to calculate the radiative efficiency. The radiative efficiency and power density of rare earth doped selective emitters are strongly dependent on temperature and experimental results indicate an optimum temperature (1650 K for Ho YAG) for thermophotovoltaic (TPV) applications.
Tuning of both the pump laser, a Ho:Tm:YLF laser operating on the 5 I 7 - 5 I 8 transition, and an AgGaSe2 parametric oscillator has been demonstrated. Tuning of the Ho:Tm:YLF laser is complicated but not frustrated by the existence of both CO2 and H2O lines in the vicinity of the laser transition. Tuning of the parametric oscillator was achieved by tuning of the pump laser. Injection seeding of the parametric oscillator on the nonresonant signal was also demonstrated. In addition, the measured efficiencies of the parametric oscillator were compared by two different methods, measuring the parametric-oscillator output energy and measuring the energy depleted from the pump. By comparison of these measurements, the intrinsic efficiency of the parametric oscillator cab be determined
An optical efficiency of 0.052 under normal mode operation for diode-pumped Ho:Tm:YLiF4 at a pulse repetition frequency of 10 Hz has been achieved. Laser output energy of 30 mJ in single Q-switched pulses with 600-ns pulse length were obtained for an input energy of 3 J. A diffusion-bonded birefringent laser rod consisting of Ho:Tm-doped and undoped pieces of YLF was utilized for 10-Hz operation.
SONEX, which was delayed by aircraft inspection problems, began the second week of October and concluded in mid-November with 16 flights. These flights covered the Pacific Ocean off the western United States, transits across the United States, the western coast of Europe, and the North and Central Atlantic Ocean. Particular attention was paid to the North Atlantic Flight Corridor. ATHOS collected high-quality HO(x) data on 15 flights. Observations taken at 5 Hz were typically averaged into 20-second measurements. Each 20-second measurement has precision 1(sigma) of less than 0.01 pptv. OH measurements were generally made from the surface to flight altitudes. HO2 measurements, which require reagent NO flow, were made from flight altitudes to near the top of the planetary boundary layer. Measured OH and HO2 during SONEX was generally lower than the measured OH and HO2 during SUCCESS (April-May, 1996, central United States). Whereas during SUCCESS midday OH was 0.1-0.5 pptv and HO2 was 3-15 pptv, during SONEX midday OH was 0.02-0.2 pptv and HO2 was 0.5-8 pptv. Part of this difference results from the midday solar zenith angles, which were larger during SONEX than during SUCCESS due to both the season and the generally higher latitudes sampled during SONEX. However, some of the difference may be due to differences in HOx sources, since less air influenced by convection was sampled during SONEX. These possibilities await post-flight calibrations of ATHOS and analysis of observations of HO(x) and simultaneously measured meteorology and trace species.