SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Scanning tunneling spectroscopy was performed at 4.2K on epitaxial thin-film heterostructures comprising YBa2Cu3O7 and La0.7Ca0.3MnO3, to study the microscopic effects of spin-polarized quasiparticle injection from the half-metallic ferromagnetic manganite on the high-Tc cuprate superconductor.
Photovoltaic effects in cadmium telluride-mercury telluride heterostructures
CdTe-HgTe heterostructures preparation with minimum energy gaps, showing photovoltaic effect caused by undesirable p-n junction due to Cd vacancy formation
Heterostructure avalanche photodiodes have been successfully fabricated in several III-V alloy systems: GaAlAs/GaAs, GaAlSb/GaAlSb, and InGaAsP/InP. These diodes cover optical wavelengths from 0.4 to 1.8 micron. Early stages of development show very encouraging results. High speed response of less than 35 ps and high quantum efficiency more than 95 percent have been obtained. The dark currents and the excess avalanche noise are also dicussed. A direct comparison of GaAlSb, GaAlAsSb, and In GaAsP avalanche photodiodes is given.
Experimental results are reported on the longitudinal mode characteristics of PbSnTe buried heterostructure laser diodes operating at 10 microns. It is found that both 'wide' (5 microns) and 'narrow' (2 microns) stripe lasers operate in a single longitudinal mode over a range up to two times the threshold, as expected on the basis of the homogeneous gain model. However, a systematic change to multimode operation is found above this pumping level, which this model cannot explain. The observed phenomenon is explained by spectral inhomogeneity with an intraband relaxation time of the order of 2 ps.
A GaAlAs buried-heterostructure laser has been monolithically integrated with a bipolar phototransistor. The heterojunction transistor was formed by the regrowth of the burying layers of the laser. Typical threshold current values for the lasers were 30 mA. Common-emitter current gains for the phototransistor of 100-400 and light responsitivity of 75 A/W (for wavelengths of 0.82 micron) at collector current levels of 15 mA were obtained.
The band gap of Ga(0.47)In(0.53)As corresponds to an emission wavelength of about 1.65 microns. Lasers have been produced with Al(0.48)In(0.52)As as cladding layers operating at room temperature. The peak emission of Ga(0.47)In(0.53)As can be continuously varied from 1.65 to 1.2 microns by the use of the multiquantum well structures. This range of wavelengths covers the minimum loss and dispersion in optical fibers and will be applicable to integrated optics. Double heterostructure broad area lasers have been fabricated using AlInAs as cladding layers to the GaInAs active layer. Room temperature threshold current densities of 4.3 kA/sq cm have been obtained for lasers with a 4500 A active region. The first data on GaInAs/AlInAs quantum well emitters will be presented. Photoluminescence of 4 K from quantum well layers of 100, 150, and 180 A with 150 A AlInAs barrier layers produced emission at 1.27, 1.35, and 1.41 microns, respectively. Ga(0.47)In(0.52)As quantum well LEDs have also been produced which emit at 1.34 microns.
Shallow-homojunction GaAs solar cells are fabricated with a back-surface field (BSF) produced by a GaAs/Al(0.2)Ga(0.8)As heterostructure. These cells exhibit higher open-circuit voltages and conversion efficiencies than control cells made with a p-GaAs/p(+)-GaAs BSF. Conversion efficiencies of over 22 percent (AM1, total area) have been obtained with this new structure. The use of a higher bandgap material below the active region not only provides an enhanced BSF but will also permit the implementation of two solar-cell designs: a GaAs cell with a back-surface reflector and an AlGaAs cell that can be used as the upper cell in tandem configurations.
Impact ionization across the band-edge discontinuity of quantum-well heterostructures is studied theoretically. A heterolayer structure of alternating Al(x)Ga(1-x)As and GaAs layers is considered where the GaAs layers are heavily doped with donors. Thus a large number of electrons is confined to the quantum-well region. Incident electrons are heated up by applied electric fields and collide with the electrons confined in the well regions. Both the ionization rate as a function of the incident energy, and average ionization rates are computed. Device applications of such multiple quantum-well structures and the possibility of a complete analog to the conventional photomultiplier are discussed.
In(x)Ga(1-x)As-GaAs heterostructures and strained-layer superlattices can be used as optical waveguides. For such applications it is important to know explicitly the refractive index variation with mismatch strain and with alloying in the ternary layer. Starting from the Kramers-Kronig integral dispersion relations, a model has been developed from which the refractive index change in the ternary layer of In(x)Ga(1-x)As-GaAs heterojunctions can be calculated. The results are presented and discussed. The expected changes in a superlattice have been qualitatively predicted.
Broad area graded-index separate-confinement heterostructure single quantum well lasers grown by molecular-beam epitaxy (MBE) with threshold current density as low as 93 A/sq cm (520 microns long) have been fabricated. Buried lasers formed from similarly structured MBE material with liquid phase epitaxy regrowth had threshold currents at submilliampere levels when high reflectivity coatings were applied to the end facets. A CW threshold current of 0.55 mA was obtained for a laser with facet reflectivities of about 80 percent, a cavity length of 120 micron, and an active region stripe width of 1 micron. These devices driven directly with logic level signals have switch-on delays less than 50 ps without any current prebias. Such lasers permit fully on-off switching while at the same time obviating the need for bias monitoring and feedback control.
GaAS/AlGaAs heterostructures have been grown by molecular-beam epitaxy on GaAs substrates intentionally oriented (tilted) a few degrees (0-6.5) off the (001) plane towards either (111)A, (111)B, or (011). It was observed that the 4-K photoluminescence and low-field electron transport properties of these structures may be functions of the substrate tilt angle and tilt direction, depending on the concentration of impurities incorporated during growth. A substrate tilt during molecular-beam epitaxy is observed to have the largest effect on these properties when the background impurity concentration in the molecular-beam epitaxial machine is high. This supports the contention that the observed changes in material characteristics are due to differences in the incorporation of defects and impurities. The incorporation of defects and impurities are reduced by using substrates tilted toward (111)A, in comparison to nominally flat (001) substrates or substrates tilted toward (111)B.
Multiple-layer GaAlAs optical waveguide heterostructures have been grown by MBE. These samples were designed to operate at 840 nm with negligible coupling of guided light to the absorbing GaAs substrate. The Al concentration was 13 percent for the guiding layer and was 16 percent for the cladding layers. The process for growing waveguide layers was calibrated primarily by high-energy electron diffraction, with the optical quality confirmed by photoluminescence measurements. Channel waveguide structures having widths of 5 microns were etched in a low-pressure magnetically confined multipolar plasma reactor. The resulting waveguide structures were characterized by Raman spectroscopy, ellipsometry, AES, and optical-waveguide loss measurements.
A set of formulas for a generalized axial stress in diamond and zinc-blende semiconductors under axial stress is derived to calculate stress-related Raman shifts. By analyzing known Raman data on cubic SiC under hydrostatic pressures, one of the Raman-stress coefficients was obtained, and the existing elastic stiffness constants of cubic SiC were optimized. A method for calculating the stress and strain in SiC films on (100) Si is proposed. It is suggested that the stress and strain expressions and the method of the stress and strain determinations in heterostructures are quite general and may be used for other systems.
The Si/CoSi2/Si heterostructures prepared by codeposition and solid-phase epitaxy on Si(111) substrates were characterized using Auger plasmon data as a measure of Si overlayer thickness. The method of calibration is described, and the results of two studies, including a study of islanding in Si/CoSi2/Si and a study of diffusion in CoSi2/Si are presented, illustrating the utility of the Auger plasmon loss technique. It is shown that, most likely, the diffusion proceeds through residual defects in the CoSi2.
A high-power low-threshold graded-index separate confinement heterostructure AlGaAs single quantum well laser on Si substrates has been demonstrated for the first time by a hybrid growth of migration-enhanced molecular beam epitaxy followed by metalorganic vapor phase epitaxy. The quantum well laser showed an output power of more than 400 mW per facet under pulsed conditions. A room-temperature threshold current of 300 mA was obtained with a differential quantum efficiency of 40 percent without facet coating. The threshold current density was 550 A/sq cm for a cavity length of 500 microns. These results show the highest peak power reported to date for low-threshold lasers on Si substrates. The full width at half maximum of the far-field pattern parallel to the junction was 6 deg. Threshold current densities as low as 250 A/sq cm were obtained for lasers on GaAs substrates.
AlGaAs/InGaAs/GaAs-type heterostructure with one or two doped channels have been used to fabricate both discrete devices and monolithic amplifiers for millimeter-wave operation. Maximum current densities of 1 A/mm and maximum transconductances of 530 mS/mm were obtained. 0.25 x 50 micron discrete devices delivered a power density of 1 W/mm with 2.9-dB gain and 25 percent efficiency at 60 GHz. A 100-micron monolithic one-stage amplifier demonstrated 93 mW (0.93-W/mm power density) at 31.5 GHz with 4.2-dB gain and 29 percent efficiency. A record 34 percent efficiency was achieved with a 53.7-mW output power and 4.8-dB gain.
A precise and effective numerical procedure to model the band diagram of modulation doped multiquantum well heterostructures is presented. This method is based on a self-consistent iterative solution of the Schroedinger equation and the Poisson equation. It can be used rather easily in any arbitrary modulation-doped structure. In addition to confined energy subbands, the unconfined states can be calculated as well. Examples on realistic device structures are given to demonstrate capabilities of this procedure. The numerical results are in good agreement with experiments. With the aid of this method the transitions involving both the confined and unconfined conduction subbands in a modulation doped AlGaAs/GaAs superlattice, and in a strained layer InGaAs/GaAs superlattice are identified. These results represent the first observation of unconfined transitions in modulation doped multiquantum well structures.