SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
There are no author-identified significant results in this report.
There are no author-identified significant in this report.
There are no author-identified significant results in this report.
There are no author-identified significant results in this report.
There are no author-identified significant results in this report.
There are no author-identified significant results in this report.
There are no author-identified significant results in this report.
There are no author-identified significant results in this report.
The Forest Analysis Team of the Lyndon B. Johnson Space Center Earth Observations Division conducted a year's investigation of LANDSAT 1 multispectral data to determine the size of forest features that could be detected and to determine the suitability for making forest classification maps. The Sam Houston National Forest of Texas was used as the test site. Using conventional interpretation and computer aided techniques, the team was able to differentiate up to 14 classes of forest features to an accuracy ranging between 55 and 84 percent.
The Range Analysis Team conducted an investigation to determine the utility of using LANDSAT 1 data for mapping vegetation-type information on range and related grazing lands. Two study areas within the Houston Area Test Site (HATS) were mapped to the highest classification level possible using manual image interpretation and computer aided classification techniques. Rangeland was distinguished from nonrangeland (water, urban area, and cropland) and was further classified as woodland versus nonwoodland. Finer classification of coastal features was attempted with some success in differentiating the lowland zone from the drier upland zone. Computer aided temporal analysis techniques enhanced discrimination among nearly all the vegetation types found in this investigation.
Abstract Bentonite clay is widely used in engineered barrier systems for the permanent disposal of high‐level radioactive waste due to its low permeability, high swelling capacity, and thermal stability. However, the complex thermal‐hydrological‐mechanical (THM) processes induced by heating from decaying radioactive waste and hydration from surrounding rock can lead to heterogeneous changes that are difficult to measure and predict. This study develops an Electrical Resistivity Tomography (ERT)‐based framework for monitoring THM processes, progressing from sample‐scale to bench‐scale tests, to inform field‐scale applications. Sample‐scale tests analyzed small bentonite samples under controlled variations in water content, temperature, and porosity to establish fundamental resistivity relationships. Bench‐scale tests involved larger bentonite columns subjected to heating (up to 200°C) and hydration under controlled pressure, simulating repository conditions. ERT measurements, complemented by X‐ray CT imaging, temperature monitoring, and tracing sensors, revealed coupled THM processes, such as hydration‐induced compression, swelling, and thermal gradients, leading to complex resistivity patterns. The results demonstrate the potential of ERT for capturing THM‐induced resistivity changes, though challenges remain in upscaling and quantitative analysis. This study evaluates laboratory test capabilities and proposes future improvements for understanding THM‐induced resistivity responses. A conceptual framework for ERT implementation in field‐scale monitoring is presented, synthesizing findings from both scales and exploring how ERT data can inform long‐term modeling and reduce prediction uncertainties. Overall, this ERT‐based framework offers a robust method for monitoring bentonite buffers, aiding in early issue detection and supporting the safe long‐term disposal of radioactive waste in geological repositories, while highlighting the need for future development. Plain Language Summary Bentonite clay is crucial in engineered barrier systems (EBS) for containing high‐level radioactive waste due to its ability to absorb water, swell, seal and remain stable under high temperatures. When bentonite absorbs water and heats up from radioactive decay, it experiences complex changes in its physical and mechanical properties. Understanding these changes is important for ensuring the long‐term safety and effectiveness of EBS. This study used Electrical Resistivity Tomography (ERT), a non‐invasive method that measures electrical conductivity to monitor these changes during laboratory experiments. The ERT data revealed significant variations in resistivity corresponding to changes in water content, temperature, and density, providing detailed spatial and temporal insights into the behavior of bentonite. These findings enhance our ability to predict the long‐term performance of bentonite barriers, ensuring the safe containment of radioactive waste. By improving our understanding of bentonite's behavior, this research supports the development of more reliable and effective barrier systems for radioactive waste disposal, protecting the environment and public health. Key Points ERT monitoring was employed to capture resistivity changes in bentonite during controlled heating and hydration experiments, providing insights into THM processes ERT data reveal significant resistivity changes correlated with water content, temperature, and mechanical effects, enhancing the understanding of THM dynamics in bentonite This study explores the potential of the framework for application in field‐scale EBS monitoring, emphasizing the need for integrating additional geophysical methods for comprehensive subsurface imaging
The author has identified the following significant results. It is concluded from data analysis that the amount of information in ERTS-1 imagery with practical application to snow mapping is substantial. For the Arizona and California test sites, it appears that the extent of the mountain snowpacks can be mapped from ERTS-1 data in more detail than is depicted in aerial survey snow charts. In the Salt-Verde watershed, the agreement between the percentage of the area snow covered as measured from the ERTS-1 data and from aerial survey charts is generally well within 10%. In nearly all of the areas in which greater discrepancies occur, the differences can be explained by changes in snow cover during the interval between the two observations. In the southern Sierra Nevada, the agreement between ERTS-1 data and aerial survey charts is of the order of 5% in all cases, except for the Kaweah Basin on one date. In addition to comparative analysis with aerial snow charts, the ERTS-1 data have also been compared with high altitude aircraft photography. The ERAP data have provided an excellent source of correlative information. The results of the comparative analysis indicate that although small details in the snow line that cannot be detected in the ERTS-1 data can be mapped from higher resolution aircraft data, the boundaries of snow cover can be mapped just as accurately from ERTS-1 data.
The author has identified the following significant results. The standard error of measurement of snow covered areas in major drainage basins in the Cascade Range, Washington, using single measurements of ERTS-1 images, was found to range from 11% to 7% during a typical melt season, but was as high as 32% in midwinter. Many dangerous glacier situations in Alaska, Yukon, and British Columbia were observed on ERTS-1 imagery. Glacier dammed lakes in Alaska are being monitored by ERTS-1. Embayments in tidal glaciers show changes detectable by ERTS-1. Surges of Russell and Tweedsmuir Glaciers, now in progress, are clearly visible. The Tweedsmuir surge is likely to dam the large Alsek River by mid-November, producing major floods down-river next summer. An ERTS-1 image of the Pamir Mountains, Tadjik S.S.R., shows the surging Medvezhii (Bear) Glacier just after its surge of early summer which dammed the Abdukagor Valley creating a huge lake and later a flood in the populous Vanch River Valley. A map was compiled from an ERTS-1 image of the Lowell Glacier after its recent surge, compared with an earlier map compiled from pain-stakingly compiled from a mosaic of many aerial photographs, in a total elapsed time of 1.5 hours. This demonstrates the value of ERTS-1 for rapid mapping of large features.
Five snow extent maps of the 5,601 sq km American River Basin were prepared using a Zoom Transfer Scope from ERTS-1 MSS band 4 imagery. The maps were generally completed within one hour. A snowmelt curve based on ERTS-1 imagery was used as a calibration standard or comparison for maps prepared from NOAA-2 VHRR imagery in the same manner. Cost comparisons with U-2 derived imagery indicate that ERTS-1 snow mapping of the basins is six times faster. Conservative estimates of comparable aircraft snow survey flights yields a cost figure 200 times that of the ERTS-1 snow map. Snow mapping attempts in the Lake Ontario Basin demonstrated that ERTS-1 is not well suited to large basins. Optimum size of basins for ERTS studies is believed to range from about 250 sq km to 30,000 sq km. The value of the ERTS-1 MSS for Great Lake ice evaluation was proved during the past winter on Lake Erie. Not only were ice features and types of ice identified, but melting ice was detected through the combined use of band 5 and band 7. Ice movement (direction and speed) was mapped by examining imagery from two successive days.
Abstract The long‐term containment of high‐level radioactive waste in geological disposal repositories relies on Engineered Barrier Systems (EBS), with bentonite clay emerging as a candidate material due to its unique properties. Understanding moisture dynamics within bentonite buffers is crucial for EBS performance, as it directly influences the material's swelling capacity, thermal and hydraulic conductivity, mechanical properties, and long‐term evolution under complex thermal‐hydrological‐mechanical (THM) processes. This study develops an advanced Electrical Resistivity Tomography (ERT)‐based framework to quantitatively monitor moisture dynamics under THM conditions. Our framework extends the Waxman‐Smits model to incorporate the coupled effects of temperature, water content, fluid chemistry, and mechanical changes on bentonite's electrical properties. Utilizing HotBENT‐Lab data from our companion paper, which includes electrical conductivity, CT density, and thermocouple measurements, this study offers a novel methodological framework bridging different scales of the model. Our results show that the extended model can estimate water content from ERT data, capturing spatial and temporal variations in moisture distribution within bentonite columns. However, the model tends to overestimate water content compared to CT density‐derived measurements. We address this discrepancy by incorporating a simplified swelling effect model, which improves agreement between ERT and CT density‐based water content estimates. We also discuss model limitations, including simplified treatment of swelling and micropore effects, and propose a conceptual framework for transitioning from laboratory to field applications, addressing challenges such as parameter scalability, field validation methods, and integration of diverse data sources. This ERT‐based framework can potentially advance real‐world moisture monitoring of bentonite‐based EBS in nuclear waste repositories. Plain Language Summary Safely containing high‐level radioactive waste depends on barriers made from materials like bentonite clay, which is effective because it swells and seals in the waste. To ensure these barriers work well over time, it's important to understand how moisture moves through the clay. Our study developed a new method using ERT to monitor moisture levels in bentonite under conditions that mimic those in actual storage sites, including changes in temperature, water content, and mechanical stress. This study improved an existing model to better account for how these factors affect the clay, allowing us to create more accurate moisture maps. Initially, the proposed model overestimated the amount of water in the clay, but its accuracy was improved by factoring in how the clay swells when wet. This study also identified some limitations of the model and suggested ways to adapt it for use in real‐world waste storage sites. This new approach could lead to better monitoring and safety checks for nuclear waste storage systems, helping to ensure long‐term containment. Key Points This work develops an ERT‐based framework extending the Waxman‐Smits model to monitor bentonite moisture dynamics during coupled THM processes The extended model accurately estimates water content from Electrical Resistivity Tomography data, incorporating swelling effects to improve precision This work proposes a conceptual framework for transitioning from laboratory to field applications, advancing EBS monitoring in nuclear waste repositories
The author has identified the following significant results. Analysis of all available (Gemini, Apollo, Nimbus, NASA aircraft) small scale snow covered imagery has been conducted to develop and refine snow enhancement techniques. A detailed photographic interpretation of ERTS-simulation imagery covering the Feather River/Lake Tahoe area was completed and the 580-680nm. band was determined to be the optimum band for fracture detection. ERTS-1 MSS bands 5 and 7 are best suited for detailed fracture mapping. The two bands should provide more complete fracture detail when utilized in combination. Analysis of early ERTS-1 data along with U-2 ERTS simulation imagery indicates that snow enhancement is a viable technique for geological fracture mapping. A wealth of fracture detail on snow-free terrain was noted during preliminary analysis of ERTS-1 images 1077-15005-6 and 7, 1077-15011-5 and 7, and 1079-15124-5 and 7. A direct comparison of data yield on snow-free versus snow-covered terrain will be conducted within these areas following receipt of snow-covered ERTS-1 imagery.
The author has identified the following significant results. Preliminary results of a spectral ratioing technique are shown for a region at the southern end of the Wind River Range, Wyoming. Digital ratio graymaps and analog ratio images have been produced for the test site, but ground truth is not yet available for thorough interpretation of these products. ERTS-1 analog ratio images were found generally better than either ERTS-1 single channel images or high altitude aerial photos for the discrimination of vegetation from non-vegetation in the test site region. Some linear geological features smaller than the ERTS-1 spatial resolution are seen as well in ERTS-1 ratio and single channel images as in high altitude aerial photography. Geochemical information appears to be extractable from ERTS-1 data. Good preliminary quantitative agreement between ERTS-1 derived ratios and laboratory derived reflectance ratios of rocks and minerals encourage plans to use lab data as training sets for a simple ratio gating logic approach to automatic recognition maps. Empirical atmospheric corrections indicate that atmospheric corrections are needed to make the ratio method, and possibly other types of data processing, consistent over large geographical and temporal displacements.
The author has identified the following significant results. Geologic interpretation of ERTS-1 imagery is dependent on recognition of the distribution, continuity, trend, and geometry of key surface features. In the examination of ERTS-1 imagery, lithology must be interpreted largely from the geomorphic expression of the terrain. ERTS-1 imagery is extremely useful in detecting local structures. Most mapped structures are topographically-expressed. Consequently, ERTS-1 imagery acquired during mid-winter, when the solar illumination angle is low, provides the largest amount of structural information. Stereoscopic analyses of ERTS-1 images significantly aid geologic interpretation. Positive transparencies of ERTS-1 images (1:1,000,000) commonly contain more geologic information than can be adequately annotated during geologic interpretation.