Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Denver”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1993

Case Study of a Low-Reflectivity Pulsating Microburst: Numerical Simulation of the Denver, 8 July 1989, Storm

On 8 July 1989, a very strong microburst was detected by the Low-Level Windshear Alert System (LLWAS), within the approach corridor just north of Denver Stapleton Airport. The microburst was encountered by a Boeing 737-200 in a "go-around" configuration which was reported to have lost considerable air speed and altitude during penetration. Data from LLWAS revealed a pulsating microburst with an estimated peak velocity change of 48 m/s. Wilson et al. (1991) reported that the microburst was accompanied by no apparent visible clues such as rain or virga, although blowing dust was present. Weather service hourly reports indicated virga in all quadrants near the time of the event. A National Center for Atmospheric Research (NCAR) research Doppler radar was operating; but according to Wilson et al., meaningful velocity could not be measured within the microburst due to low radar-reflectivity factor and poor siting for windshear detection at Stapleton.

Proctor, F. H.↗
NASA NTRS2004

Passive Wake Acoustics Measurements at Denver International Airport

From August to September 2003, NASA conducted an extensive measurement campaign to characterize the acoustic signal of wake vortices. A large, both spatially as well as in number of elements, phased microphone array was deployed at Denver International Airport for this effort. This paper will briefly describe the program background, the microphone array, as well as the supporting ground-truth and meteorological sensor suite. Sample results to date are then presented and discussed. It is seen that, in the frequency range processed so far, wake noise is generated predominantly from a very confined area around the cores.

Wang, Frank Y.↗
NASA NTRS2015

Evaluation of Fast-Time Wake Models Using Denver 2006 Field Experiment Data

The National Aeronautics and Space Administration conducted a series of wake vortex field experiments at Denver in 2003, 2005, and 2006. This paper describes the lidar wake vortex measurements and associated meteorological data collected during the 2006 deployment, and includes results of recent reprocessing of the lidar data using a new wake vortex algorithm and estimates of the atmospheric turbulence using a new algorithm to estimate eddy dissipation rate from the lidar data. The configuration and set-up of the 2006 field experiment allowed out-of-ground effect vortices to be tracked in lateral transport further than any previous campaign and thereby provides an opportunity to study long-lived wake vortices in moderate to low crosswinds. An evaluation of NASA's fast-time wake vortex transport and decay models using the dataset shows similar performance as previous studies using other field data.

Ahmad, Nash’at N.↗
NASA NTRS2014

Trajectory Prediction Accuracy and Error Sources for Regional Jet Descents: Results of a 2010 Flight Trial at Denver International Airport using a Global 5000 Test Aircraft - Part I

The Efficient Descent Advisor (EDA) controller automation tool generates trajectory-based speed, path, and altitude-profile advisories to facilitate efficient, continuous descents into congested terminal airspace. While prior field trials have assessed the trajectory-prediction accuracy for large jet (i.e., Boeing and Airbus) types, smaller (i.e., regional and business) jet types present unique challenges involving different descent procedures and Flight Management System (FMS) capabilities. A small-jet field trial was conducted at Denver in the fall of 2010 with the objective of measuring trajectory prediction accuracy and quantifying the primary sources of error. This paper uses data collected onboard a Bombardier Global 5000 test aircraft to quantify the size and sources of trajectory prediction error. Error sources were quantified for the 44 runs by incrementally replacing predicted data with data collected onboard the aircraft and measuring the effect on time error. Results for en-route descents, from prior to top of descent to the meter fix 60-120 nmi downstream, indicate that the aircraft arrived an average 15 seconds earlier than predicted, with a standard deviation of 10 seconds. Target Mach and CAS deceleration were found to be the two largest error sources. If CAS deceleration error was reduced using a typical, more predictable level flight deceleration then the arrival time prediction error in 2010 would be on par with a 2009 flight trial of Airbus and Boeing revenue flights. Four of the error sources, tracker jumps, CAS deceleration, target Mach, and path distance, lend themselves to significant reductions with modest to no changes to ATC automation andor procedures. Wind error and its impact on arrival time error was significantly reduced in 2010 compared to a 1994 flight test using NASAs Boeing 737 test aircraft.

Trajectory Prediction Error↗
NASA NTRS2014

Trajectory Prediction Accuracy and Error Sources for Regional Jet Descents: Results of a 2010 Flight Trial at Denver International Airport using SkyWest Revenue Flights - Part II

The Efficient Descent Advisor (EDA) controller automation tool generates trajectory-based speed, path, and altitude-profile advisories to facilitate efficient, continuous descents into congested terminal airspace. While prior field trials have assessed the trajectory prediction accuracy for large jet (i.e., Boeing and Airbus) types, smaller (i.e., regional and business) jet types present unique challenges involving different descent procedures and Flight Management System (FMS) capabilities. This paper quantifies the trajectory prediction accuracy for small jet revenue flight descents based on SkyWest Canadair Regional Jet 200, 700, and 900 aircraft arrivals to Denver in the fall of 2010. Post flight test data analysis and SkyWest pilot interviews uncovered unexpected variation between flight crews due to different interpretations of (1) which fixed flight path angle (FPA) to fly based on the flight trial procedure and (2) how to fly the descent to achieve the target FPA. Pilot reports were used to select a subset of flights where pilots indicated an FPA according to the flight trial procedure to remove the unexpected variation due to (1) to focus on (2). Results for the subset for en-route descents, from prior to top of descent to the meter fix 30 to 130 nmi downstream, indicate that aircraft arrived to the meter fix six seconds early with about a twelve second standard deviation. Large FPA errors up to one degree relative to the EDA flight trial procedure were detected after the flight trial as a characteristic of the unexpected variation. It is recommended that quantitative validation be performed during future flight trials so that experimental procedures can be adjusted if unexpected results are detected.

Field Test Results↗
NASA NTRS1974

Management and design of long-life systems; Proceedings of the Symposium, Denver, Colo., April 24-26, 1973

The long life of Pioneer interplanetary spacecraft is considered along with a general accelerated methodology for long-life mechanical components, dependable long-lived household appliances, and the design and development philosophy to achieve reliability and long life in large turbine generators. Other topics discussed include an integrated management approach to long life in space, artificial heart reliability factors, and architectural concepts and redundancy techniques in fault-tolerant computers. Individual items are announced in this issue.

Schurmeier, H. M.↗
NASA NTRS1991

Airborne radar simulation studies of the Denver July 11, 1988 microburst

In the simulation program, a wind shear detection Doppler radar was placed in UAL 395 and 236 aircraft and flown along their landing flight paths. The microburst was placed at the appropriate location and intensity corresponding to each aircraft's landing approach time. A baseline set of radar design parameters were used in the simulation. Output display information and wind shear detection processing was produced as the aircraft approached the microburst. Information on the results of the simulation study are given in graphical form.

Britt, Charles L.↗
NASA NTRS1992

Ground clutter measurements using the NASA airborne doppler radar: Description of clutter at the Denver and Philadelphia airports

Detection of hazardous wind shears from an airborne platform, using commercial sized radar hardware, has been debated and researched for several years. The primary concern has been the requirement for 'look-down' capability in a Doppler radar during the approach and landing phases of flight. During 'look-down' operation, the received signal (weather signature) will be corrupted by ground clutter returns. Ground clutter at and around urban airports can have large values of Normalized Radar Cross Section (NRCS) producing clutter returns which could saturate the radar's receiver, thus disabling the radar entirely, or at least from its intended function. The purpose of this research was to investigate the NRCS levels in an airport environment (scene), and to characterize the NRCS distribution across a variety of radar parameters. These results are also compared to results of a similar study using Synthetic Aperture Radar (SAR) images of the same scenes. This was necessary in order to quantify and characterize the differences and similarities between results derived from the real-aperature system flown on the NASA 737 aircraft and parametric studies which have previously been performed using the NASA airborne radar simulation program.

Harrah, Steven D.↗
NASA NTRS1992

Spectrum characteristics of Denver and Philadelphia ground clutter and the problem of distinguishing wind shear targets from moving clutter

Spectral analysis of 1991 wind shear flight data has provided information about the power spectral density, spectral width, and velocity of ground clutter detected by the wind shear radar at several major airports. Ground clutter must be recognized and separated from weather targets before wind shear can be computed. Information will be presented characterizing and comparing ground clutter and weather target spectra. The information includes (1) spectral widths of stationary ground clutter seen at various scan and tilt angles, (2) power spectral density and velocity of moving ground clutter relative to the stationary ground clutter, and (3) spectral widths and velocities of weather targets. A summary of numerical results in the form of histograms and example numerical results in the form of spectral plots are presented.

Mackenzie, Anne I.↗
NASA NTRS1991

Thematic Conference on Geologic Remote Sensing, 8th, Denver, CO, Apr. 29-May 2, 1991, Proceedings. Vols. 1 & 2

The proceedings contain papers discussing the state-of-the-art exploration, engineering, and environmental applications of geologic remote sensing, along with the research and development activities aimed at increasing the future capabilities of this technology. The following topics are addressed: spectral geology, U.S. and international hydrocarbon exporation, radar and thermal infrared remote sensing, engineering geology and hydrogeology, mineral exploration, remote sensing for marine and environmental applications, image processing and analysis, geobotanical remote sensing, and data integration and geographic information systems. Particular attention is given to spectral alteration mapping with imaging spectrometers, mapping the coastal plain of the Congo with airborne digital radar, applications of remote sensing techniques to the assessment of dam safety, remote sensing of ferric iron minerals as guides for gold exploration, principal component analysis for alteration mappping, and the application of remote sensing techniques for gold prospecting in the north Fujian province.

Source record↗
NASA NTRS1992

Engineering, construction, and operations in space - III: Space '92; Proceedings of the 3rd International Conference, Denver, CO, May 31-June 4, 1992. Vols. 1 & 2

The present volume on engineering, construction, and operations in space discusses surface structures on the moon and Mars, surface equipment, construction, and transportation on the moon and Mars, in situ materials use and processing, and space energy. Attention is given to such orbital structures as LEO and the space station, space mining and excavation, space materials, space automation and robotics, and space life support systems. Topics addressed include lunar-based astronomy, space systems integration, terrestrial support for space functions, and space education. Also discussed are space plans, policy, and history, space science and engineering, geoengineering and space exploration, and the construction and development of a human habitat on Mars.

Space life support systems↗
NASA NTRS1993

Case study of a low-reflectivity pulsating microburst - Numerical simulation of the Denver, 8 July 1989, storm

Results from a 3D simulation of a very strong microburst, detected by the Low-Level Windshear Alert System, are presented. The simulation was performed using the Terminal Area Simulation System (TASS) model (Proctor, 1987) which is a 3D nonhydrostatic cloud model that includes parameterizations for both liquid and ice-phase microphysics. Emphasis is placed om the pulsating characteristic and the very-low radar reflectivity of the event. The simulation revealed that the dissipating cloud induces a type-1 pulsating microburst event, with at least three distinct microburst pulses over a period of 20 min.

Proctor, Fred H.↗
NASA NTRS1994

Characteristics of a dry, pulsating microburst at Denver Stapleton Airport

This study examines the influence of ambient vertical wind shear on microburst intensity, asymmetry, and translation. Results show that microburst asymmetry is influenced by the magnitude of the low-level ambient vertical shear. The microburst outflow elongates in the direction of the shear vector (which is not necessarily in the direction of translation), and generates the greatest hazard (for commercial jet transports) along paths orthogonal to the shear vector. The model results also show that the asymmetry increases with increasing shear magnitude. One implication of these results concerns the detection of a microburst by a ground-based doppler systems. These systems may underestimate the hazard for landing and departing aircraft that are on trajectories orthogonal to both the sensor beam and shear vector, especially if the magnitude of the shear is large. Another implication is that microburst are more likely to be asymmetrical in regions (seasons) where there is climatologically a significant low-level shear. The model results also show that the rotor microbursts and severe wind damage can be a product of the microburst interaction with strong ambient wind shear.

Proctor, Fred H.↗
NASA NTRS1995

Averting Denver Airports on a Chip

As a result of recent advances in software engineering capabilities, we are now in a more stable environment. De-facto hardware and software standards are emerging. Work on software architecture and design patterns signals a consensus on the importance of early system-level design decisions, and agreements on the uses of certain paradigmatic software structures. We now routinely build systems that would have been risky or infeasible a few years ago. Unfortunately, technological developments threaten to destabilize software design again. Systems designed around novel computing and peripheral devices will spark ambitious new projects that will stress current software design and engineering capabilities. Micro-electro-mechanical systems (MEMS) and related technologies provide the physical basis for new systems with the potential to produce this kind of destabilizing effect. One important response to anticipated software engineering and design difficulties is carefully directed engineering-scientific research. Two specific problems meriting substantial research attention are: A lack of sufficient means to build software systems by generating, extending, specializing, and integrating large-scale reusable components; and a lack of adequate computational and analytic tools to extend and aid engineers in maintaining intellectual control over complex software designs.

Sullivan, Kevin J.↗
NASA NTRS1999

Collaborative Study of Analysis of High Resolution Infrared Atmospheric Spectra Between NASA Langley Research Center and the University of Denver

The Langley-D.U. collaboration on the analysis of high resolution infrared atmospheric spectra covered a number of important studies of trace gases identification and quantification from field spectra, and spectral line parameters analysis. The collaborative work included: Quantification and monitoring of trace gases from ground-based spectra available from various locations and seasons and from balloon flights. Studies toward identification and quantification of isotopic species, mostly oxygen and Sulfur isotopes. Search for new species on the available spectra. Update of spectroscopic line parameters, by combining laboratory and atmospheric spectra with theoretical spectroscopy methods. Study of trends of atmosphere trace constituents. Algorithms developments, retrievals intercomparisons and automatization of the analysis of NDSC spectra, for both column amounts and vertical profiles.

Goldman, Aaron↗