Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Dendritic growth”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
DOE OSTI2020

Dynamic Observation of Dendritic Quasicrystal Growth upon Laser-Induced Solid-State Transformation

In this paper, we report the laser-induced solid-state transformation between a periodic “approximant” and quasicrystal in the Al-Cr system during rapid quenching. Dynamic transmission electron microscopy allows us to capture in situ the dendritic growth of the metastable quasicrystals. The formation of dendrites during solid-state transformation is a rare phenomenon, which we attribute to the structural similarity between the two intermetallics. Through ab initio molecular dynamics simulations, we identify the dominant structural motif to be a 13-atom icosahedral cluster transcending the phases of matter.

36 MATERIALS SCIENCE↗
DOE OSTI2022

High-performance all-solid-state Li–S batteries enabled by an all-electrochem-active prelithiated Si anode

The development of all-solid-state Li–S batteries has been greatly impeded by dendrite growth and dendrite penetration, which are both related to the Li metal anode. As a compromised alternative, we report lithium silicide (Li x Si) as a dendrite-free and high-capacity anode with Li source. Here, the as-synthesized Li x Si is relatively soft, highly electronically conductive, and with a high Li diffusivity. These distinctive properties make Li x Si anode viable as an “all-electrochem-active” electrode (consisted of 100 wt.% Li x Si). Compared with the typical composite electrode, the all-electrochem-active electrode not merely maximizes the electrode-level energy density but also minimizes the electrolyte-related interfacial degradation. Li x Si symmetric cell demonstrates a reversible cycling at 4 mA cm –2 for over 320 h. Stress change and morphological evolution of the Li x Si electrode are investigated upon dealloying/alloying. When paired with a S cathode (active mass loading of 3 mg cm –2 ), Li x Si–S full cell shows a good cycling behavior over 500 cycles and rate performance (69% capacity retained at 1.2C) even at 25 °C.

25 ENERGY STORAGE↗
DOE OSTI2024

Lithium Dendrite-Free Li 7 N 2 I-LiOH Solid Electrolytes for High Energy Lithium Batteries

All-solid-state lithium batteries (ASSLBs) hold great potential to improve the safety and energy density of today’s lithium-ion batteries by using non-flammable inorganic solid electrolytes. Solid electrolytes (SEs) are believed to prevent Li dendrite growth because of high mechanical strength and high Li+ transference numbers. Significant advances in SE have been achieved, among which, Li7La3Zr2O12 (LLZO) and Li2S–P2S5 (LPS) are the most promising SEs for bulk-type solid-state lithium batteries because of high ionic conductivities (>10-4 S/cm2). However, in contrast to our expectations, the growth of lithium dendrites is not suppressed but is facilitated in LLZOs and LPSs regardless of dopants, porosity, and crystallinity of the electrolytes. Despite the unity Li transference number and over two-times of shear modulus than that of Li metal, the critical current densities for Li plating and stripping in these SEs are less than 1.0 mA cm-2, which is one-fourth to one-tenth of that in liquid electrolytes at room temperature. The incompatibility between LLZO and LPS with Li metal seriously limits the energy density of all-solid-state batteries. The mechanism for lithium dendrite formation and growth in SEs are still disputable. Lack of understanding of the Li dendrite formation mechanism seriously impeded the development of solid-state lithium batteries. The development of the criterion for Li dendrite suppression is essential for the success of solid electrolyte lithium batteries. In this project, a criterion for Li dendrite suppression will be developed through thermodynamics and kinetics analysis of lithium dendrite nucleation/growth, which will guide the solid-state electrolyte design. Li7N2I-LiOH, Li5NI2-LiOH and Li3YCl6 solid electrolyte with high ionic conductivity and low electronic conductivity were used to validate the criterion for lithium dendrite suppression. Different surface modifications were also explored to enhance the dendrite suppression capability of SSEs.

25 ENERGY STORAGE↗
DOE OSTI2020

Electrolyte design for Li metal-free Li batteries

Li metal, with the lowest thermodynamically achievable negative electrochemical potential and the highest specific capacity (3860 mAh g -1 ), is the ultimate anode choice for Li batteries. However, the highest reported Li plating/stripping Coulombic efficiency (CE) of 99.5% after extensive efforts is still too low for the Li metal-free (all the Li metal in cycling comes from cathode, without anode pre-lithiation) Li metal batteries. The low CE is attributed to both non-uniform Li plating/stripping on the lithiophobic Cu current collector and Li dendrite growth through lithiophilic organic–inorganic solid electrolyte interphase (SEI) formed in carbonate electrolytes. Here, we use a lithiophilic Bismuth graphite blend (Bi–Gr) substrate to replace lithiophobic Cu current collector to seed a uniform Li nucleation, and form a lithiophobic LiF-rich SEI rather than lithiophilic organic-rich SEI to suppress Li dendrite growth. Molecular dynamics simulations reveal the preferential reduction of anions in 2.0 M LiPF 6 in tetrahydrofuran/2-methyl tetrahydrofuran (2.0 M LiPF 6 –mixTHF) electrolyte to generate LiF-rich SEI on plated Li. Bi–Gr substrate and 2.0 M LiPF 6 –mixTHF electrolyte enable the Li anodes to achieve a record high CE of 99.83% at a high capacity of 1.0 mAh cm -2 and current of 0.5 mA cm -2 . The Bi particles serve as dispersed nucleation centers that promote uniform Li deposition with strong adhesion to the substrate to avoid dead Li, while the lithiophobic LiF-rich SEI promotes lateral Li growth and suppresses the vertical Li dendrite growth even at a high current density of 3.0 mA cm -2 and high areal capacities of 3.0 mAh cm -2 . The regulation of Li nucleation and growth enables the Li metal-free LiFePO 4 full cells to achieve 100 cycles at a practical areal capacity of >2.0 mAh cm -2 . This article highlights the benefits of simultaneous substrate design to improve Li nucleation and electrolyte design to promote lithiophobic SEI growth, enabling a promising and practical route Li metal-free Li metal batteries.

36 MATERIALS SCIENCE↗
DOE OSTI2020

Development of lithium ion conducting interface between lithium metal and a lithium ion conducting ceramic using block polymers

The lithium-air (Li-air) technology developed by EDF uses an air electrode which works with an aqueous electrolyte, which prevent the use of unprotected lithium metal electrode. A Li+ ionic conductor glass ceramic is used to separate the aqueous electrolyte compartment from the negative lithium electrode. However, this glass-ceramic is not stable in contact with lithium, it is thus necessary to add a protective buffer layer. In another hand, this protection should ideally resist to lithium dendritic growth. It is in this context that this research project which has as goal the development of a protective buffer layer based on block copolymer electrolytes (BCE) between the lithium metal and the lithium ionic conductor ceramic, for lithium-air battery. In a first part, the BCE is studied in lithium-lithium symmetric cells, in order to determine their electrochemical properties such as ionic conductivity, steady state transference number, and finally their resistance to dendritic growth during cycling. Several characterization techniques were employed and especially hard X-ray micro-tomography to analyze the lithium morphology before and after cycling. For single-ion BCE, we expect to suppress dendritic growth, however, we report here for the first time, the visualization of a homogeneous growth of lithium but the formation of dense lithium objects. In another part, the composite BCE-ceramic is studied by electrochemical impedance spectroscopy (EIS). The cycling of lithium-composite-lithium symmetric cells and the analysis of the EIS measurement after each cycle permit to determine if the dendrites have cross the protective layer and are in contact with the ceramic. Besides, the quantification of the polarization loss at the interface polymer-ceramic is evaluated by polarization experiments. This contribution is found to be small.

36 MATERIALS SCIENCE↗
DOE OSTI2021

Polarimetric Signatures in Landfalling Tropical Cyclones

Polarimetric radar observations from the NEXRAD WSR-88D operational radar network in the contiguous United States, routinely available since 2013, are used to reveal three prominent microphysical signatures in landfalling tropical cyclones: 1) hydrometeor size sorting within the eyewall convection, 2) vertical displacement of the melting layer within the inner core, and 3) dendritic growth layers within stratiform regions of the inner core. Size sorting signatures within eyewall convection are observed with greater frequency and prominence in more intense hurricanes, and are observed predominantly within the deep-layer environmental wind shear vector-relative quadrants that harbor the greatest frequency of deep convection (i.e., downshear and left-of-shear). Melting-layer displacements are shown that exceed 1 km in altitude compared to melting-layer altitudes in outer rainbands and are complemented by analyses of archived dropsonde data. Dendritic growth and attendant snow aggregation signatures in the inner core are found to occur more often when echo-top altitudes are low (≤10 km MSL), nearer the -15°C isotherm commonly associated with dendritic growth. These signatures, uniquely observed by polarimetric radar, provide greater insight into the physical structure and thermodynamic characteristics of tropical cyclones, which are important for improving rainfall estimation and the representation of tropical cyclones in numerical models.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2023

Harnessing Electrochemical‐Mechanical Couplings to Improve the Reliability of Solid‐State Batteries

Abstract One key barrier to using lithium‐metal anode batteries is that metal dendrites can penetrate solid electrolytes, causing short‐circuits and battery failures. It is established that this failure is likely caused by crack propagation due to electrodeposition‐induced stresses from lithium metal. This study explores ways to harness these electrochemical‐mechanical couplings to control dendrite growth and improve battery reliability using a phase‐field model and targeted fracture experiments. The results show that dendrite growth can be effectively mitigated by applying mechanical stresses or tailoring the material's fracture toughness. This study also outlines the requirements for compressive stress to halt or deflect dendrites as a function of the overpotential and discusses the role of microstructure in this process.

Monismith, Scott↗
DOE OSTI2023

Scaling laws for two-dimensional dendritic crystal growth in a narrow channel

Here, we investigate analytically and computationally the dynamics of two-dimensional needle crystal growth from the melt in a narrow channel. Our analytical theory predicts that, in the low supersaturation limit, the growth velocity $\textit{V}$ decreases in time $\textit{t}$ as a power law $V ~t^{–2/3}$, which we validate by phase-field and dendritic-needle-network simulations. Simulations further reveal that, above a critical channel width $Λ ≈ 5l_D$, where $l_D$ is the diffusion length, needle crystals grow with a constant $V < V_s$, where $V_s$ is the free-growth needle crystal velocity, and approaches $V_s$ in the limit $Λ \gg l_D$.

36 MATERIALS SCIENCE↗