SEARCH · Engineering Papers

Results for “numeric profiling”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 307 records · Page 17

All sources NASA NTRS DOE OSTI

NASA NTRS1994

Numerical study of boundary layer interaction with shocks: Method and code validation

A major problem in modeling of turbulent supersonic flows is the correct assessment of viscous-inviscid interaction problems. Of particular interest is the interaction of boundary layers with shocks. Present turbulence models give in most cases unsatisfactory results in the region of rapid distortion and in the separation region (if one is present) in particular with regard to mean flow profiles and turbulence quantities. The objective of the present work is the direct numerical simulation of shock boundary layer interaction. This report summarizes the first phase during which a numerical method suitable for this problem has been developed and a computer code has been written and tested.

Adams, Nikolaus A.↗

NASA NTRS1979

A prediction method for velocity and temperature profiles in a two-dimensional nominally steady turbulent boundary layer

This paper describes a recently developed boundary-layer prediction method for a variable property compressible flow, in which heat transfer takes place primarily by forced convection and for which the mainstream Mach number is small. The leading order terms, in asymptotic expansions for large Reynolds numbers, are obtained for the mean velocity and temperature distribution in both the inner and outer layer of the turbulent boundary layer. Closure in the inner layer is achieved using an analytical model for the mean profiles which is based on the observed coherent structure of the time-dependent inner layer flow. For the outer layer, simple eddy viscosity and conductivity models are developed without recourse to the Reynolds analogy. In the prediction method a numerical solution of the outer layer equations is matched to the analytical inner layer profiles as the computation procedes downstream. Calculations are presented for a range of adverse and favorable pressure gradient flows and the predicted results compare well with existing data.

Weigand, G. G.↗

NASA NTRS1990

A numerical and experimental analysis of reactor performance and deposition rates for CVD on monofilaments

The computational fluid dynamics (CFD) code FLUENT is adopted to simulate a cylindrical upflow reactor designed for chemical vapor deposition (CVD) on monofilaments. Equilibrium temperature profiles along the fiber and quartz reactor wall are experimentally measured and used as boundary conditions in numerical simulations. Two-dimensional axisymmetric flow and temperature fields are calculated for hydrogen and argon; the effect of free convection is assessed. The gas and surface chemistry is included for predicting silicon deposition from silane. The model predictions are compared with experimentally measured silicon CVD rates. Inferences are made for optimum conditions to obtain uniformity.

Gokoglu, S. A.↗

NASA NTRS1980

Observations of neutral wind profiles between 115- and 175-km altitude in the dayside auroral oval

Lithium trail neutral wind measurements have been made in the morning dayside auroral oval as a function of altitude. During all four experiments the winds displayed a large altitude shear. In the most extreme case the wind at 135-km altitude was toward the south at 210 m/s, and at 185-km altitude toward the northwest at 170 m/s. A one-dimensional numerical solution to the Navier Stokes equation including an initial steady-state wind profile, viscosity, pressure gradient, Lorenz force and the Coriolis force was made in order to study the effect of auroral processes on the neutral atmosphere. Since electric fields and plasma density were measured, the Lorenz force could be modeled with reasonable accuracy. The pressure gradient was determined in an iterative way as a best fit to the observations. Within the limitations of a one-dimensional model the numerical solution is in reasonable agreement with one of the observations, which is applicable to such a modeling, and indicates that both Lorenz forces and pressure gradients due to auroral processes are required to explain the observation.

Pereira, E.↗

NASA NTRS1991

Optimal design of solidification processes

An optimal design algorithm is presented for the analysis of general solidification processes, and is demonstrated for the growth of GaAs crystals in a Bridgman furnace. The system is optimal in the sense that the prespecified temperature distribution in the solidifying materials is obtained to maximize product quality. The optimization uses traditional numerical programming techniques which require the evaluation of cost and constraint functions and their sensitivities. The finite element method is incorporated to analyze the crystal solidification problem, evaluate the cost and constraint functions, and compute the sensitivities. These techniques are demonstrated in the crystal growth application by determining an optimal furnace wall temperature distribution to obtain the desired temperature profile in the crystal, and hence to maximize the crystal's quality. Several numerical optimization algorithms are studied to determine the proper convergence criteria, effective 1-D search strategies, appropriate forms of the cost and constraint functions, etc. In particular, we incorporate the conjugate gradient and quasi-Newton methods for unconstrained problems. The efficiency and effectiveness of each algorithm is presented in the example problem.

Dantzig, Jonathan A.↗

NASA NTRS2002

Moisture Advection and Fresh Water Flux over Oceans

Moisture transport in the atmosphere is one of the most significant components in the hydrological cycle. Under stationary condition, ocean surface fresh water flux, which is the difference between precipitation (P) and evaporation (E), is balanced by the divergence of column-integrated moisture transport (IMT) in the atmosphere. Characterizing accurately a global picture of IMT from observation is a difficult task. It requires measurements of vertical profiles for wind vector and humidity. More specifically, IMT can be defined as the integration in pressure coordinates the product of specific humidity q and wind vector u, where g is the gravitational acceleration, and p, is the atmospheric pressure at ocean surface.In this study, a statistical relationship is derived between u, and u(sub)s using data from numerical weather prediction model. The relationship is then validated using surface and vertical profile from radiosonde data, before applied to spacebased measurements.

scatterometers↗

NASA NTRS1991

Experiment and numerical simulation of RF heating in the Tandem Mirror plasma propulsion device

Recent results of experimental and theoretical studies of ICRF heating of the plasma in the Tendem Mirror rocket are presented. The radial and axial profile of the magnetic field of the wave have been measured, and the data agree with the results from numerical simulation. One very important new finding is that the wave damped when it approached the resonance plane. This is a strong indication of beach heating effect and that RF power is absorbed by the ions in the plasma as expected. This power absorption phenomenon was also further confirmed by the refined analytical study of the wave propagation in a slab model. The electron density in the central cell has been measured by a microwave interferometer. The existence of two types of discharge similar to those of H-alpha emission have also been observed from the density measurements. A preliminary design of a flight system for a 100-day Mars transit has been undertaken. The specific weight for a 10 MW rocket is only 0.04 kg/kW.

Yang, T. F.↗

NASA NTRS1989

Investigation of the flow in the diffuser section of the NASA Lewis icing research tunnel

The flow in the diffuser section of the Icing Research Wind Tunnel at NASA Lewis Research Center is investigated using both tunnel calibration measurements and numerical simulation techniques. Local pressure and temperature measurements are made to establish velocity and temperature profiles in the diffuser of the tunnel. These profiles are compared with similar measurements made prior to renovating the equipment which generates the tunnel's icing cloud. This comparison indicates the manner in which this change affected the flow. The measured data were also compared with a numerical simulation of the flow to help understand how such changes may favorably alter the tunnel flow.

Addy, Harold E., Jr.↗

NASA NTRS1989

Investigation of the flow in the diffuser section of the NASA Lewis Icing Research Tunnel

Addy, Harold E., Jr.↗

NASA NTRS1980

A model of CO-CH4 global transport/chemistry. II - Preliminary calculation by 1 dimensional model

Calculations of the one-dimensional CO-CH4 transport/chemistry model were performed to investigate the sensitivity of the OH vertical profile to various factors. The boundary conditions at the earth's surface and the tropopause are discussed. The results show that the liquid-phase or soil-phase resistance dominates the mass transfer of both CO and CH4 between the atmosphere and the earth's surface. At the tropopause, the CO and CH4 fluxes are set approximately equal to the value at the previous time step in the numerical calculation. Photolysis rate coefficients that increase with altitude modified the OH vertical profile so that the maximum value was at midtroposphere altitudes. Increasing the CO concentration caused a decrease of the OH concentration, and the OH profile was very sensitive to the NO(x) profiles. The calculated OH profiles are compared with those from other investigations and also with some available measurements. Although the available measurements of the OH profiles are limited, the calculated OH profiles agree fairly well with them.

Kitada, T.↗

NASA NTRS1984

Modeling degradation and failure of Ni-Cr-Al overlay coatings

Degradation of a Ni-16Cr-25Al-0.06Zr overlay coating on a Ni-22Cr substrate was examined after oxidation accompanied by thermal cycling. Concentration/distance profiles were measured in the coating and substrate after various one-hour cycles at 1150 C. A numerical model was developed to simulate coating degradation by simultaneous oxidation and coating/substrate interdiffusion. The validity of the model was confirmed by comparison of predicted and measured concentration/distance profiles. The ability of the model to identify critical system parameters was demonstrated for the case of the initial Al and Cr content of the coating and substrate.

Nesbitt, J. A.↗

NASA NTRS1984

Modeling degradation and failure of Ni-Cr-Al overlay coatings

Degradation of a Ni-16Cr-25Al-0.06Zr overlay coating on a Ni-22Cr substrate was examined after oxidation accompanied by thermal cycling. Concentration/distance profiles were measured in the coating and substrate after various one-hour cycles at 1150 C. A numerical model was developed to simulate coating degradation by simultaneous oxidation and coating/substrate interdiffusion. The validity of the model was confirmed by comparison of predicted and measured concentration/distance profiles. The ability of the model to identify critical system parameters was demonstrated for the case of initial Al and Cr content of the coating and substrate.

Nesbitt, J. A.↗

NASA NTRS1979

An elastic-plastic analysis of fatigue crack closure in modes I and II

In this paper, an efficient elastic-plastic finite element procedure to analyze crack-closure and, its effects on fatigue crack growth under general spectrum loading, is presented. A hybrid-displacement finite element procedure is used to properly treat the stress and strain singularities near the crack-tip; and crack-growth under cyclic loading is simulated by the translation of certain 'core' elements, near the crack-tip, in which proper stress and strain singularities were embedded. Both pure mode I and mode II types of cyclic loading are considered. In the mode I case, four types of cyclic loading, viz., constant amplitude block loading, high-to-low block loading, low-to-high block, and a single overload in an otherwise constant amplitude block loading are considered; whereas in mode II, only a constant amplitude block loading is considered. Detailed results are presented for the crack-closure and opening-stresses, crack-surface deformation profiles, etc., in each case. Certain observations, based on the present numerical results, concerning various factors that cause crack growth acceleration or retardation under general spectrum loading, are presented and discussed.

Nakagaki, M.↗

NASA NTRS1982

The baroclinic instability of highly structured one-dimensional basic states

A frictionless, adiabatic, quasi-geostrophic model on a beta-plane was employed to examine the baroclinic instability of highly structured one-dimensional basic states. Definitions of the model eigenvalue equation, the boundary conditions, and the fluxes and energetics are provided, and highly structured average wind speed and temperature profiles were selected to represent a wide range of latitudes. Attention was given to the instability source, wavelength, growth rate, phase velocity, steering levels, and the vertical structure of their amplitude, phase, meridional entropy transport, and conversion of potential-to-kinetic energy. Green modes, Charney-Eady modes, and the modes defined in the paper are examined in connection with the highly structured profiles. The eigenvalue approach is shown to be superior to the numerical time integration approach and necessary conditions for instabilities are defined.

Fullmer, J. W. A.↗

NASA NTRS1984

Comments on the ultraviolet spectrum of gamma(2) Velorum

A table of spectral features, including narrow, very broad, and 'photospheric' lines, in the ultraviolet spectrum of the Wolf-Rayet binary gamma(2) Velorum is given together with radial velocities at phase 0.99. The very broad lines display P Cygni profiles. Ten weak absorption features are tentatively assigned to blends of numerous lines of Fe IV, and three other similar features are possibly due to Fe V blends. These iron lines appear to be associated with the Wolf-Rayet component. The narrow features are present with a wide range of ionization. The Si IV, and probably C IV, features are circumstellar, while the other narrow absorptions are either interstellar or possibly a combination of interstellar and circumstellar. A model is proposed for the outer layers of the extended envelope of the Wolf-Rayet star.

Sahade, J.↗

NASA NTRS1988

Forty-eight-inch lidar aerosol measurements taken at the Langley Research Center, May 1974 to December 1987

A ground based lidar system located at NASA Langley Research Center in Hampton, Va., was used to obtain high resolution vertical profiles of the stratospheric and upper tropospheric aerosol since 1974. More than 200 measurements obtained at a wavelength of 0.6943 microns during 1974 to 1987 are summarized. Plots of peak backscatter mixing ratio and integrated backscatter vs time are presented for the entire measurement sequence. The plots highlight the influence of several major volcanic eruptions on the long term stratospheric aerosol layer. In particular, the eruptions of El Chichon in late Mar. to early Apr. 1982, produced a massive aerosol layer. Aerosol enhancement from El Chichon reached Hampton, Va. by May 1982, with a scattering ratio of approx. 50 detected on Jul. 1, 1982. In addition, scattering ratio profiles for June 1982 to December 1987, along with tables containing numerical values of the backscatter ratio and backscattering function versus altitude, are included to further describe the upper tropospheric and stratospheric aerosol layer. A 14 year summary is presented, in a ready to use format, of lidar observations at a fixed midlatitude location to be used for further study.

Fuller, W. H., Jr.↗

NASA NTRS1988

Laser Atmospheric Wind Sounder (LAWS)

A development status report is presented for the Laser Atmospheric Wind Sounder (LAWS) instrument that is to be carried by both an Earth Observing System polar-orbit satellite and the NASA manned Space Station. The wind Doppler lidar profiles thus obtained by LAWS will furnish essential information for future numerical weather prediction, large-scale atmospheric circulation and climate dynamics, and the global biogeochemical and hydrologic cycles; it will then be possible to approach the atmosphere, oceans, cryosphere, and biota as a single, coupled system.

Fitzjarrald, D.↗

NASA NTRS1990

A two-dimensional kinematic dynamo model of the ionospheric magnetic field at Venus

The results of a high-resolution, two-dimensional, time dependent, kinematic dynamo model of the ionospheric magnetic field of Venus are presented. Various one-dimensional models are considered and the two-dimensional model is then detailed. In this model, the two-dimensional magnetic induction equation, the magnetic diffusion-convection equation, is numerically solved using specified plasma velocities. Origins of the vertical velocity profile and of the horizontal velocities are discussed. It is argued that the basic features of the vertical magnetic field profile remain unaltered by horizontal flow effects and also that horizontal plasma flow can strongly affect the magnetic field for altitudes above 300 km.

Cravens, T. E.↗