SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Improvements in the open circuit voltage of 0.1 ohm-cm silicon solar cells were achieved using a multistep diffusion technique. Experimental details are given along with the results of an analysis that indicate that anomalous behavior of the electron mobility in the cell base limits attainment of higher voltages.
The dynamics of grain motion through gas are examined in terms of the injection of isotopically anomalous (compared to solar abundances) material into the early solar nebula. Calculations indicate that the injected grains cannot penetrate to the center of any of a range of reasonable configurations, suggesting the formation of an edge region enriched in injected material. Furthermore, the dynamical behavior of grains in turbulent flows indicates that pockets of grains can have some resistance to turbulent diffusion. The constraints developed here are used to delineate a set of consistent, injected-grain models for the origin of the isotopic anomalies in meteorite inclusions.
Improvements in the open-circuit voltage of 0.1 ohm-cm silicon solar cells have been achieved using a multistep diffusion technique. Experimental details are given along with the results of an analysis that indicate that anomalous behaviors of the electron mobility in the cell base limits attainment of higher voltages.
The kinetic and morphological behavior of systems solidifying at small undercooling were investigated with emphasis on the role of convective and diffusive transport and the influence of gravity. A data base was established for pure succinonitrile which permits a comprehensive check on diffusional dendrite growth theory and the development of scaling laws to extend the theory to other material systems. A departure from diffusional-controlled growth was observed which becomes more significant at smaller undercoolings. A shuttle experiment is prepared to test the theory at the low undercoolings where convective effects begin to dominate.
The pattern of erosion of a plateau along an escarpment may be modeled usng cluster growth techniques, recently popularized in models of drainage network evolution. If erosion on the scarp takes place in discrete events at rates subject to local substrate strength, the whole range of behavior is described by a combination of three cluster growth mechanisms: invasion percolation, Eden growth and diffusion-limited aggregation (DLA). These model the relative importance of preexisting substrate strength, background weathering, and seepage weathering and erosion respectively. The rate of seepage processes is determined by the efflux of groundwater at the plateau margin, which in turn is determined by the pressure field in the plateau aquifer. If this process acted alone, it would produce erosion patterns in the form of Laplacian fractals, with groundwater recharge from a distant source, or Poissionian fractals, with groundwater recharge uniform over the plateau. DLA is used to mimic the Laplacian or Poissonian potential field and the corresponding seepage growth process. The scaling structure of clusters grown by pure DLA, invasion percolation, or Eden growth is well known; this study presents a model which combines all three growth mechanisms for the first time. Mixed growth processes create clusters with different scaling properties and morphologies over distinct length scale ranges, and this is demonstrable in natural examples of plateau erosion.
To understand the diffusion of aerospace knowledge, it is necessary to understand the communications practices and the information-seeking behaviors of those involved in the production, transfer, and use of aerospace knowledge at the individual, organizational, national, and international levels. In this paper, we report selected results from a survey of Japanese and U.S. aerospace engineers and scientists that focused on communications practices and information-seeking behaviors in the workplace. Data are presented for the following topics: importance of and time spent communicating information, collaborative writing, need for an undergraduate course in technical communications, use of libraries, the use and importance of electronic (computer) networks, and the use and importance of foreign and domestically produced technical reports. The responses of the survey respondents are placed within the context of the Japanese culture. We assume that differences in Japanese and U.S. cultures influence the communications practices and information-seeking behaviors of Japanese and U.S. aerospace engineers and scientists.
To understand the diffusion of aerospace knowledge, it is necessary to understand the communications practices and the information-seeking behaviors of those involved in the production, transfer, and use of aerospace knowledge at the individual, organizational, national, and international levels. In this paper, we report selected results from a survey of Japanese and U.S. aerospace engineers and scientists that focused on communications practices and information-seeking behaviors in the workplace. Data are presented for the following topics: importance of and time spent communicating information, collaborative writing, need for an undergraduate course in technical communications, use of libraries, the use and importance of electronic (computer) networks, and the use and importance of foreign and domestically produced technical reports. The responses of the survey respondents are placed within the context of the Japanese culture. We assume that differences in Japanese and U.S. cultures influence the communications practices and information-seeking behaviors of Japanese and U.S. aerospace engineers and scientists.
The Direct Simulation Monte Carlo method is used to study the positional history of the individual molecules in a gas that is homogeneous at the macroscopic level and is in Maxwellian equilibrium at the microscopic level. The behavior at small times is characterized by 'persistence of velocity' effects, and a 'random walk' type of dispersal occurs over a longer timescale. It is shown that the rate of dispersal can be directly related to the self-diffusion coefficient. In addition, the diffusion coefficients are obtained directly from one-dimensional calculations, and the local Knudsen number at which the Chapman-Enskog theory breaks down is determined. Results are presented for both simple gases and gas mixtures.
Longitudinally averaged observations of the photospheric field during 1976-1986 are analyzed using a flux transport model. The way in which source eruptions, supergranular diffusion, and meridional flow collaborate to produce strong, highly concentrated polar fields near sunspot minimum is clarified as follows: (1) widespread eruptions of individual bipolar magnetic regions, with their leading polarity flux equatorward of their trailing polarity flux, collectively establish a large-scale separation of polarities in latitude; (2) the low-latitude, leading polarity flux diffuses across the equator and merges with its opposite hemisphere counterpart; and (3) meridional flow carries the resulting surplus of trailing polarity flux to the poles, and concentrates it there against the spreading effect of diffusion. Episodic 'surges' of flux to the poles are induced by fluctuations in the source eruption rate. Simulations indicate that relatively weak, trailing polarity surges may occur even in a steady flow field. However, in order to account for the giant surges of alternating polarity and the resulting oscillations in the polar field strength observed during 1980-1982, both accelerated flow and enhanced eruption rates are required.
The simulation of radiation transport in the optically thick flux-limited diffusion regime has been identified as one of the most time-consuming tasks within large simulation codes. Due to multimaterial complex geometry, the radiation transport system must often be solved on unstructured grids. In this paper, we investigate the behavior and the benefits of the unstructured P(sub 1) nonconforming finite element method, which has proven to be flexible and effective on related transport problems, in solving unsteady implicit nonlinear radiation diffusion problems using Newton and Picard linearization methods. Key words. nonconforrning finite elements, radiation transport, inexact Newton linearization, multigrid preconditioning
The integrity of the metal-poly oxide and the gate oxide was evaluated for several 5-micron CMOS-bulk process. The pinhole array capacitor consists of diffused and poly fingers that form a network of MOS transistors (elements), which are capped by a deposited oxide and metal layer. The smallest structure used contained about 15,000 elements and the largest structure contained about 68,000 elements. Each structure was divided into several subarrays. The structures are placed a number of times on each wafer. From a yield analysis of the subarrays, the elements per defect were found to be typically in excess of 50,000 elements/defect for the metal-poly oxide and 100,000 elements/defect for the gate oxide. From the switching behavior of the transistors, the gate oxide defects were tentatively identified as gate-to-body shorts rather than gate-to-diffusion shorts.
Transport conditions were evaluated during the vapor phase growth of mercurous chloride crystals in a closed tube. Experimentally observed growth rates were much smaller than those calculated by the Hertz-Knudsen (H-K) equation. The Arrhenius behavior of growth rate with the temperature was used to derive the sticking coefficient. A one-dimensional diffusion model was used to calculate the total mass flux and was compared with the condensing flux. It was predicted that growth occurred in the convecto-diffusive range.
The equations governing the behavior of perturbations of a mixture of nearly homogeneous and isotropic matter and radiation are derived, using a diffusion approximation where spatial perturbations in the radiation spectrum are allowed to vary with frequency. A simple model of line opacity leads to dispersion relations which display a new bulk instability. The model is used to derive an approximate dispersion relation for radiation interacting via resonance scattering opacity in atomic hydrogen at low density and low temperature. Possible applications to cosmology are briefly discussed.
The interaction of molten salts of different Na2O activities and mullite is examined with furnace and burner tests. The more-acidic molten salts form small amounts of Al2O3; the more-basic molten salts form various Na2O-Al2O3-SiO2 compounds. The results are interpreted using the Na2O-Al203-SiO2 ternary phase diagram, and some possible diffusion paths are discussed. The generally higher melting points of Na2O-Al2O3-SiO2 compounds lead to better behavior of mullite in molten salts, as compared to SiO2-protected ceramics such as SiC. Mullite-coated SiC is discussed, and the corrosion behavior is evaluated.
Some years ago, Stephan proposed an approach to one dimensional (linear) phased array beam steering which requires only a single phase shifter. This involves the use of a linear array of voltage-controlled electronic oscillators coupled to nearest neighbors. The oscillators are mutually injection locked by controlling their coupling and tuning appropriately. Stephan's approach consists of deriving two signals from a master oscillator, one signal phase shifted with respect to the other by means of a single phase shifter. These two signals are injected into the end oscillators of the array. The result is a linear phase progression across the oscillator array. Thus, if radiating elements are connected to each oscillator and spaced uniformly along a line, they will radiate a beam at an angle to that line determined by the phase gradient which is, in turn, determined by the phase difference between the injection signals.The beam direction is therefore controlled by adjusting this phase difference. Recently, Pogorzelski and York presented a formulation which facilitates theoretical analysis of the above beam steering technique. This was subsequently applied by Pogorzelski in analysis of two dimensional beam steering using perimeter detuning of a coupled oscillator array. The formulation is based on a continuum model in which the oscillator phases are represented by a continuous function satisfying a partial differential equation of diffusion type. This equation can be solved via the Laplace transform and the resulting solution exhibits the dynamic behavior of the array as the beam is steered. Stephan's beam steering technique can be similarly generalized to two-dimensional arrays in which the beam control signals are applied to the oscillators on the perimeter of the array. In this paper the continuum model for this two-dimensional case is developed and the dynamic solution for the corresponding aperture phase function is obtained. The corresponding behavior of the resulting far-zone radiation pattern is displayed as well.
Ni and Co variations in primary martian magmas exhibit anomalous incompatible behavior, which has remained an unexplained conundrum. Because martian magmas are S-rich, and some trace metals are reported to have enhanced solubility in S-bearing magmas, we have carried out a series of experiments to evaluate the effect of high-S melts on the olivine/melt partitioning of Ni, Co, Mn, V, and Cr. Near-liquidus experiments on a synthetic primary martian mantle melt (Yamato-980459 [Y98]) were completed in a piston-cylinder apparatus at 0.75 GPa. Previous studies in S-free systems illustrate that the partition coefficients for these elements are dependent chiefly on D(Mg(Ol/melt)) (the partition coefficient defined as wt% Mg in olivine/wt% Mg in melt, a proxy for temperature), and were used to calibrate a predictive expression that includes the effects of temperature [i.e., D(Mg(Ol/melt))], melt composition, and oxygen fugacity. These predictive expressions are then used to isolate any effect in DM olivine/melt due to dissolved sulfur. The results show that S might have a small effect for Co, but not enough to change Co partitioning from compatible to incompatible in our experiments. The addition of a sulfur term to the D(Co) predictive expressions shows that nearly 8000 ppm of sulfur would be required in the melt (at liquidus temperature of Y98) for D(Co) to become <1. These S contents are two times higher than those of a sulfide-saturated melt at the P-T conditions of a martian mantle source region. Therefore, the anomalous incompatible behavior observed in these primary magma suites must be due to another mechanism. High temperature, oxygen fugacity, and diffusion are not viable mechanisms, but magma mixing, assimilation, or kinetic crystallization effects remain possibilities.
A computational study of turbulent evaporating sprays is reported. The major focus is to examine the sensitivity of the vaporization behavior of turbulent sprays to the transient liquid-phase processes. Three models considered to represent these processes are the thin skin, infinite diffusion, and diffusion limit models. Favre-averaged equations with k-epsilon-g turbulence model are employed for the gas phase. The Lagrangian approach with a stochastic separated flow method is used for the liquid phase where the effects of gas turbulence on droplet trajectories and interphase transport rates are considered using random-walk computations. Also the variable-property effects are considered in detail. Results indicate that, depending upon the boiling temperature and heat of vaporization of the fuel considered, the vaporization behavior of turbulent sprays may be quite sensitive to the modeling of transient liquid-phase processes. Thus, it is important that for most hydrocarbon fuels these processes be adequately represented in any comprehensive spray computations. The present results also provide further support to the conclusions of earlier studies which have been based on simplified spray configurations.
The integrity of the metal-poly oxide and the gate oxide was evaluated for several 5-micron CMOS-bulk processes. The pinhole array capacitor consists of diffused and poly fingers that form a network of MOS transistors (elements), which are capped by a deposited oxide and metal layer. The smallest structure used in this study contained about 15,000 elements and the largest structure contained about 68,000 elements. Each structure was divided into several subarrays. The structures are placed a number of times on each wafer. From a yield analysis of the subarrays, the elements per defect were found to be typically in excess of 50,000 elements/defect for the metal-poly oxide and 100,000 elements/defect for the gate oxide. From the switching behavior of the transistors, the gate oxide defects were tentatively identified as gate-to-body shorts rather than gate-to-diffusion shorts.