Conductive Polymer Binder-Enabled SiO–Sn x Co y C z Anode for High-Energy Lithium-Ion Batteries
Explore the source record for details and available documents.
SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Explore the source record for details and available documents.
Proton-conducting perovskites have been widely studied because of their potential application as solid electrolytes in intermediate temperature solid oxide fuel cells. Structural and chemical heterogeneities can develop during synthesis, device fabrication, or service, which can profoundly affect proton transport. Here, we use time-resolved Kelvin probe force microscopy, scanning transmission electron microscopy, atom probe tomography, and density functional theory calculations to intentionally introduce Ba-deficient planar and spherical defects and link the resultant atomic structure with proton transport behavior in both stoichiometric and nonstoichiometric epitaxial, yttrium-doped barium zirconate thin films. The defects were intentionally induced through high-temperature annealing treatment, while maintaining the epitaxial single crystalline structure of the films, with an overall relaxation in the atomic structure. As a result, the annealed samples showed smaller magnitudes of local lattice distortions because of the formation of proton polarons, thereby leading to decreased proton-trapping effect. This resulted in a decrease in the activation energy for proton transport, leading to faster proton transport.
Layered perovskites with the formula (R–NH 3 ) 2 PbI 4 have excellent environmental stability but poor photovoltaic function due to the preferential orientation of the semiconducting layer parallel to the substrate and the typically insulating nature of the R–NH 3 + cation. Here, we report a series of these n = 1 layered perovskites with the form (aromatic-O-linker-NH 3 ) 2 PbI 4 where the aromatic moiety is naphthalene, pyrene, or perylene and the linker is ethyl, propyl, or butyl. These materials achieve enhanced conductivity perpendicular to the inorganic layers due to better energy level matching between the inorganic layers and organic galleries. The enhanced conductivity and visible absorption of these materials led to a champion power conversion efficiency of 1.38%, which is the highest value reported for any n = 1 layered perovskite, and it is an order of magnitude higher efficiency than any other n = 1 layered perovskite oriented with layers parallel to the substrate. Furthermore, these findings demonstrate the importance of leveraging the electronic character of the organic cation to improve optoelectronic properties and thus the photovoltaic performance of these chemically stable low n layered perovskites.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
The electron-phonon interaction is well known to create major resistance to electron transport in metals and semiconductors, whereas fewer studies are directed to its effect on phonon transport, especially in semiconductors. Herein we calculate the phonon lifetimes due to scattering with electrons (or holes), combine them with the intrinsic lifetimes due to the anharmonic phonon-phonon interaction, all from first principles, and evaluate the effect of the electron-phonon interaction on the lattice thermal conductivity of silicon. Unexpectedly, we find a significant reduction of the lattice thermal conductivity at room temperature as the carrier concentration goes above 1019 cm –3 (the reduction reaches up to 45% in p-type silicon at around 1021 cm –3 ), a range of great technological relevance to thermoelectric materials.
The safe handling of powdered composite energetic materials requires an understanding of their response to electrostatic ignition stimuli. A binary composite comprised of Al and polytetrafluoroethylene (PTFE) was tailored for ESD ignition sensitivity with varied concentrations of highly conductive nanofillers. The goal was to control the ESD ignition response of the Al+PTFE with small concentrations of nanofillers that may not significantly affect the overall combustion performance of the mixture. The nanofillers examined include carbon nanotubes (CNTs) and graphene nanoplatelets (GNPs). Adding CNTs created percolation at a lower volumetric percentage than GNPs and were found to be the controlling nanofiller, creating percolation for the mixture containing both CNTs and GNPs. Various mixing methods were examined. Ignition was achieved only for adding nanofillers at a volumetric percentage and mixing method that led to a bulk conductivity of approximately 5x10-3 ?S/cm.
PbSe is an attractive thermoelectric material due to its favorable electronic structure, high melting point, and lower cost compared to PbTe. Herein, the hitherto unexplored alloys of PbSe with NaSbSe 2 (NaPb m SbSe m+2 ) are described and the most promising p-type PbSe-based thermoelectrics are found among them. Surprisingly, it is observed that below 500 K, NaPb m SbSe m+2 exhibits unorthodox semiconducting-like electrical conductivity, despite possessing degenerate carrier densities of ≈10 20 cm -3 . Here, it is shown that the peculiar behavior derives from carrier scattering by the grain boundaries. It is further demonstrated that the high solubility of NaSbSe 2 in PbSe augments both the thermoelectric properties while maintaining a rock salt structure. Namely, density functional theory calculations and photoemission spectroscopy demonstrate that introduction of NaSbSe 2 lowers the energy separation between the L- and Σ-valence bands and enhances the power factors under 700 K. The crystallographic disorder of Na + , Pb 2+ , and Sb 3+ moreover provides exceptionally strong point defect phonon scattering yielding low lattice thermal conductivities of 1–0.55 W m -1 K -1 between 400 and 873 K without nanostructures. As a consequence, NaPb 10 SbSe 12 achieves maximum ZT ≈1.4 near 900 K when optimally doped. More importantly, NaPb 10 SbSe 12 maintains high ZT across a broad temperature range, giving an estimated record ZT avg of ≈0.64 between 400 and 873 K, a significant improvement over existing p-type PbSe thermoelectrics.
The effect of variation in thermal conductivity of light water reactor fuel elements on core response during loss-of-coolant accident scenarios is examined. Initially, a simplified numerical analysis is utilized to determine the time scales associated with dissipation of stored energy from the fuel into the coolant once the fission reaction is stopped. The analysis is then followed by full reactor system thermal-hydraulics analysis of a typical boiling and pressurized water reactor subjected to a large break loss-of-coolant accident scenario using the TRACE code. Accordingly, sensitivity analyses to examine the effect of an increase in fuel thermal conductivity, up to 500%, on fuel temperature evolution during these transients are performed. Given the major differences in thermal-hydraulics design aspects of boiling and pressurized water reactors, different fuel and temperature responses during the simulated loss-of-coolant transients are observed.
Here, we developed circularly polarized light-time-resolved microwave conductivity (CPL-TRMC) for investigation of the CPL-dependent photoinduced charge carrier dynamics in chiral materials with chiroptical properties. Chiral R- or S-perylenediimide (PDI) molecular thin films were paired with handedness-sorted (6,5) and (11,-5) single-walled carbon nanotube (SWCNT) films to compose a donor (D)-acceptor (A) system for the spin-dependent charge separation process, and the D-A system was examined through linear and circular polarization-dependent steady-state and time-resolved measurements. The R-PDI-(6,5) film exhibited strong enhancement in circular dichroism (CD) and revealed a reversed transient conductivity signal, relative to the polarity of CD in CPL-TRMC measurement upon excitation of the E 11 state, which is interpreted as arising from a spin-dependent initial charge separation process. Through linear polarization-dependent flash photolysis TRMC and circular polarization-resolved femtosecond transient absorption, we could deduce that sub-picosecond intertubular charge separation upon E 11 excitation in SWCNT was responsible for the spin-dependent photoconductivity transients observed in CPL-TRMC measurements.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
We have used conductive atomic force microscopy to investigate the influence of growth temperature on local current flow in GaAs pn junctions with embedded ErAs nanoparticles grown by molecular beam epitaxy. Three sets of samples, one with 1 ML ErAs deposited at different growth temperatures and two grown at 530 deg. C and 575 deg. C with varying ErAs depositions, were characterized. Statistical analysis of local current images suggests that the structures grown at 575 deg. C have about 3 times thicker ErAs nanoparticles than structures grown at 530 deg. C, resulting in degradation of conductivity due to reduced ErAs coverage. These findings explain previous studies of macroscopic tunnel junctions.
Abstract not provided